A.P. Mine No. 3

Last updated
A.P. Mine No.3
No. 3 ap mine.png
Cross section of mine with safety and wing-nut fitted
TypeAnti-personnel mine
Place of originBritish India
Service history
Used byGreat Britain
WarsWorld War II
Specifications
Height6.125 inches (15.56 cm)
Diameter2.5 inches (6.4 cm)

Filling TNT
Filling weight3.5 ounces (99 g)

The A.P. Mine No. 3 was a British anti-personnel mine of World War II. The mine was developed and produced by the Royal Engineers in India due to a shortage of mines for the Burma campaign. The mine was simpler to lay than previous devices and could be placed by infantrymen, rather than sappers. The A.P. Mine No. 3 was a bounding shrapnel mine that was lethal at ranges of up to 30 yards (27 m).

Contents

History

The mine was developed during the Second World War. Anti-personnel mines proved valuable in jungle warfare against the Japanese in the Burma campaign but the British troops, with supply lines in India, had only small numbers of Hong Kong Pineapple Mines. These were complicated weapons that had to be set by trained sappers (Royal Engineers) and not by the infantry. [1] To solve this issue the A.P. Mine No. 3 was developed and produced by the Royal Engineers in India. [2] [1] Initially each battalion was issued 72 of the mines, but this was later doubled to 144. [1] The A.P. Mine No. 3 was described as obsolescent by a 1946 United States Navy publication. [3]

Action

The A.P. Mine No. 3 was a shrapnel-based bounding mine. [4] A pressure-actuated mine, it had a 1–2 second fuse that was intended to allow the enemy soldier to remove his foot from the pressure plate and advance. The mine would then be propelled into the air and explode at a height of 2–4 feet (60–120 cm), where the shrapnel could be lethal to personnel within a 30 yards (30 m) radius. [2] The mine was set by being buried underground on top of a block of wood, to support its base. The mine was detonated when an operating sleeve was pressed down by the pressure plate. In the disarmed state the operating sleeve was held in place by a "safety spider" that fitted around a threaded bar in the centre of the mine and had four prongs that protruded into the body and bore on the main case. The spider was held in place by a wing nut on the threaded bar. The nut and spider were removed to arm the mine. It could be neutralised by replacing the nut and spider. [2]

Physical description

The A.P. Mine No. 3 was housed in a cylindrical steel case that was segmented, and seemingly derived from that of the No. 36 Mills bomb. The case measured 2.5 inches (6.4 cm) in diameter and was 6.125 inches (15.56 cm) high. [4] The case was black with a 0.5-inch (1.3 cm) high ring of red crosses near to the top and a green band of the same height near the base. The pressure plate was circular and sat at the top of the cylinder. It required 38 pounds (17 kg) of pressure to detonate if the weight was applied at the centre of the plate and 7 pounds (3.2 kg) at the edge. [3] The fuse was different than that employed in earlier British anti-personnel mines and relied on a "retaining ball" being displaced. [4]

The mine was propelled into the air by a 100-grain (6.5 g) charge of G-20 gunpowder. [2] The mine contained 3.5 ounces (99 g) of TNT explosive [3] [4] The entire mine weighed around 2 pounds 4 ounces (1.0 kg). [1]

Related Research Articles

<span class="mw-page-title-main">Land mine</span> Explosive weapon, concealed under or on the ground

A land mine, or landmine, is an explosive weapon concealed under or camouflaged on the ground, and designed to destroy or disable enemy targets, ranging from combatants to vehicles and tanks, as they pass over or near it.

<span class="mw-page-title-main">Shrapnel shell</span> Anti-personnel artillery munitions

Shrapnel shells were anti-personnel artillery munitions which carried many individual bullets close to a target area and then ejected them to allow them to continue along the shell's trajectory and strike targets individually. They relied almost entirely on the shell's velocity for their lethality. The munition has been obsolete since the end of World War I for anti-personnel use; high-explosive shells superseded it for that role. The functioning and principles behind Shrapnel shells are fundamentally different from high-explosive shell fragmentation. Shrapnel is named after Lieutenant-General Henry Shrapnel (1761–1842), a British artillery officer, whose experiments, initially conducted on his own time and at his own expense, culminated in the design and development of a new type of artillery shell.

<span class="mw-page-title-main">Claymore mine</span> American directional anti-personnel mine

The Claymore mine is a directional anti-personnel mine developed for the United States Armed Forces. Its inventor, Norman MacLeod, named the mine after a large medieval Scottish sword. Unlike a conventional land mine, the Claymore is command-detonated and directional, meaning it is fired by remote-control and shoots a wide pattern of metal balls into the kill zone. The Claymore can also be victim-activated by booby-trapping it with a tripwire firing system for use in area denial operations.

A Bangalore torpedo is an explosive charge placed within one or several connected tubes. It is used by combat engineers to clear obstacles that would otherwise require them to approach directly, possibly under fire. It is sometimes colloquially referred to as a "Bangalore mine", "banger" or simply "Bangalore" as well as a pole charge.

<span class="mw-page-title-main">Shell (projectile)</span> Payload-carrying projectile

A shell, in a military context, is a projectile whose payload contains an explosive, incendiary, or other chemical filling. Originally it was called a bombshell, but "shell" has come to be unambiguous in a military context. Modern usage sometimes includes large solid kinetic projectiles, which are more properly termed shot. Solid shot may contain a pyrotechnic compound if a tracer or spotting charge is used.

<span class="mw-page-title-main">Anti-tank mine</span> Type of land mine designed to destroy tanks

In anti-tank warfare, an anti-tank mine is a type of land mine designed to damage or destroy vehicles including tanks and armored fighting vehicles.

<span class="mw-page-title-main">S-mine</span> Bounding anti-personnel mine

The German S-mine, also known as the "Bouncing Betty" on the Western Front and "frog-mine" on the Eastern Front, is the best-known version of a class of mines known as bounding mines. When triggered, these mines are launched into the air and then detonated at about one metre (3 ft) from the ground. The explosion projects a lethal spray of shrapnel in all directions. The S-mine was an anti-personnel mine developed by Germany in the 1930s and used extensively by German forces during World War II. It was designed to be used in open areas against unshielded infantry. Two versions were produced, designated by the year of their first production: the SMi-35 and SMi-44. There are only minor differences between the two models.

<span class="mw-page-title-main">Glasmine 43</span> Minimum metal anti-personnel mine

The Glasmine 43 was an anti-personnel mine with a glass body used by the Nazi Germany during World War II.

<span class="mw-page-title-main">PMN mine</span> Series of Soviet anti-personnel mines

The PMN series of blast anti-personnel mines were designed and manufactured in the Soviet Union. They are one of the most widely used and commonly found devices during demining operations. They are sometimes nicknamed "black widow" because of their dark casings.

The M7 is a small, metal-cased United States anti-tank blast mine that was used during the Second World War. It was based on the British Hawkins grenade. Approximately 2.5 million were produced before production ceased, and although it has long since been withdrawn from U.S. service, it can be found in Angola, Burma, Cambodia, Chad, Eritrea, Ethiopia, Korea, Lebanon, Myanmar, Somalia, Thailand, and Zambia.

<span class="mw-page-title-main">Riegel mine 43</span> German anti-tank bar mine

The Riegel mine 43 or is a German steel cased anti-tank bar mine used during the Second World War. The mine is a long thin rectangle. It consists of a lower and upper metal tray, and an internal metal-cased explosive block. It uses two ZZ42 fuzes inserted into either end of the internal block, although it can be used with an additional pressure fuze on the top. The mine is similar to the Italian B-2 mine. A variant, the Riegel mine 44 was also produced with a different fuze. Approximately 3,051,400 were produced between 1943 and 1945.

<span class="mw-page-title-main">A.T. Mine G.S. Mark V</span> Anti-tank mine

The Anti-Tank Mine, General Service, Mk V was a cylindrical, metal-cased United Kingdom anti-tank blast mine that entered service in 1943, during the Second World War. It was replaced in British service with the Mk 7 mine. Two versions of the mine were produced, the Mk. V and the Mk. VC with the same external dimensions. The only difference was that the Mk. VC had a half-sized explosive charge.

<span class="mw-page-title-main">Valmara 59</span>

The Valmara 59 is a large cylindrical Italian bounding anti-personnel mine. It is the first in the "Valmara" family of mines produced by Valsella Meccanotecnica, and was followed by the Valmara 69 and VS-JAP. The mine's body is plastic with a distinctive five-pronged metal head. The central prong has a hole, to allow the threading a trip wire. The inner body of the mine has a main charge surrounded with approximately 1,000 steel cubes, below which is a steel wire connecting it to the base of the mine. When the mine is triggered a small charge launches the mine into the air approximately 45 cm before the steel wire is pulled taut, the jolt of which pulls a striker into the detonator. A secondary time fuse triggers the mine after three seconds if it has not detonated after being triggered.

The C3A1 and C3A2 are Canadian minimum metal anti-personnel mines. The difference between them is very minor and hard to distinguish visually. Elsie mines were first deployed by Canada in 1962, by the United States in 1965 and by Japan in 1967.

The Min AP NM AE T1 is a small Brazilian minimum metal anti-personnel mine. The mine has a plastic case in the form of a truncated cone. with a small protruding fuse and pressure plate. The small size of the pressure plate gives the mine some blast resistance. The main charge is in the form of a small inverted cone which generates a shaped charge effect when detonated.

<span class="mw-page-title-main">Modèle 1939 (mine)</span> French anti-personnel bounding mine

The Mle 1939 was a French anti-personnel bounding mine used at the start of the Second World War, it was developed largely in response to the German S-mine bounding mine. It saw very little service before the fall of France. The plans escaped to the US via Major Pierre Delalande, a member of the French Corps of Engineers, and were used as the basis for the American M2 bounding mine which saw wider service during the war but was considered largely ineffective. The M2 mine was replaced almost immediately afterwards with the M16 bounding mine, an almost exact copy of the German S-mine. The French also later produced a copy of the S-mine, the Mle 1951 mine.

<span class="mw-page-title-main">Fragmentation (weaponry)</span> Explosive weapon that inflicts injury through fragments

Fragmentation is the process by which the casing, shot, or other components of an anti-personnel weapon, bomb, barrel bomb, land mine, IED, artillery, mortar, tank gun, or autocannon shell, rocket, missile, grenade, etc. are dispersed and/or shattered by the detonation of the explosive filler.

<span class="mw-page-title-main">A.P. Shrapnel Mine</span> Bounding mine

The A.P. (anti-personnel) Shrapnel Mine is a British bounding mine of World War II.

The A.P. Mine E.P. No. 4 was a landmine used by the United Kingdom and other Commonwealth countries during World War II.

The A.P. Mine No. 5 was a British anti-personnel mine of World War II.

References

  1. 1 2 3 4 Roy, Kaushik (2016). Sepoys against the Rising Sun: The Indian Army in Far East and South-East Asia, 1941–45. BRILL. p. 240. ISBN   978-90-04-30678-3.
  2. 1 2 3 4 British Explosive Ordnance (PDF). Washington DC: US Department of the Navy. 10 June 1946. p. 413. Archived from the original (PDF) on 4 March 2016. Retrieved 18 January 2021.
  3. 1 2 3 British Explosive Ordnance (PDF). Washington DC: US Department of the Navy. 10 June 1946. p. 411. Archived from the original (PDF) on 4 March 2016. Retrieved 18 January 2021.
  4. 1 2 3 4 Banks, Eddie (1997). Anti-personnel Landmines: Recognising & Disarming. Brassey's. p. 33. ISBN   978-1-85753-228-9.