Full Rate

Last updated

Full Rate (FR or GSM-FR or GSM 06.10 or sometimes simply GSM) was the first digital speech coding standard used in the GSM digital mobile phone system. It uses linear predictive coding (LPC). The bit rate of the codec is 13 kbit/s, or 1.625 bits/audio sample (often padded out to 33 bytes/20 ms or 13.2 kbit/s). The quality of the coded speech is quite poor by modern standards, but at the time of development (early 1990s) it was a good compromise between computational complexity and quality, requiring only on the order of a million additions and multiplications per second. The codec is still widely used in networks around the world. Gradually FR will be replaced by Enhanced Full Rate (EFR) and Adaptive Multi-Rate (AMR) standards, which provide much higher speech quality with lower bit rate.

Contents

Technology

GSM-FR is specified in ETSI 06.10 (ETS 300 961) and is based on RPE-LTP (Regular Pulse Excitation - Long Term Prediction) speech coding paradigm. Like many other linear predictive coding (LPC) speech codecs, linear prediction is used in the synthesis filter. However, unlike most modern speech codecs, the order of the linear prediction is only 8. In modern narrowband speech codecs the order is usually 10 and in wideband speech codecs the order is usually 16.

The speech encoder accepts 13 bit linear PCM at an 8 kHz sample rate. This can be direct from an analog-to-digital converter in a phone or computer, or converted from G.711 8-bit nonlinear A-law or μ-law PCM from the PSTN with a lookup table. In GSM, the encoded speech is passed to the channel encoder specified in GSM 05.03. In the receive direction, the inverse operations take place.

The codec operates on 160 sample frames that span 20 ms, so this is the minimum transcoder delay possible even with infinitely fast CPUs and zero network latency. The operational requirement is that the transcoder delay should be less than 30 ms. The transcoder delay is defined as the time interval between the instant a speech frame of 160 samples has been received at the encoder input and the instant the corresponding 160 reconstructed speech samples have been out-put by the speech decoder at an 8 kHz sample rate. [1]

Implementations

The free libgsm codec can encode and decode GSM Full Rate audio. [2] [3] "libgsm" was developed 1992–1994 by Jutta Degener and Carsten Bormann, then at Technische Universität Berlin. [4] Since a GSM speech frame is 32.5 bytes, this implementation also defined a 33-byte nibble-padded representation of a GSM frame (which, at a frame rate of 50/s, is the basis for the incorrect claim that the GSM bit rate is 13.2 kbit/s). This codec can also be compiled into Wine to provide GSM audio support.

There is also a Winamp plugin for raw GSM 06.10 based on the libgsm. [5] [6]

The GSM 06.10 is also used in VoIP software, for example in Ekiga, QuteCom, Linphone, Asterisk (PBX), Ventrilo and others.

See also

Related Research Articles

Speech coding is an application of data compression of digital audio signals containing speech. Speech coding uses speech-specific parameter estimation using audio signal processing techniques to model the speech signal, combined with generic data compression algorithms to represent the resulting modeled parameters in a compact bitstream.

Speex is an audio compression codec specifically tuned for the reproduction of human speech and also a free software speech codec that may be used on VoIP applications and podcasts. It is based on the CELP speech coding algorithm. Speex claims to be free of any patent restrictions and is licensed under the revised (3-clause) BSD license. It may be used with the Ogg container format or directly transmitted over UDP/RTP. It may also be used with the FLV container format.

G.711 ITU-T recommendation

G.711 is a narrowband audio codec originally designed for use in telephony that provides toll-quality audio at 64 kbit/s. G.711 passes audio signals in the range of 300–3400 Hz and samples them at the rate of 8,000 samples per second, with the tolerance on that rate of 50 parts per million (ppm). Non-uniform (logarithmic) quantization with 8 bits is used to represent each sample, resulting in a 64 kbit/s bit rate. There are two slightly different versions: μ-law, which is used primarily in North America and Japan, and A-law, which is in use in most other countries outside North America.

Personal Digital Cellular (PDC) was a 2G mobile telecommunications standard used exclusively in Japan.

The Adaptive Multi-Rateaudio codec is an audio compression format optimized for speech coding. AMR speech codec consists of a multi-rate narrowband speech codec that encodes narrowband (200–3400 Hz) signals at variable bit rates ranging from 4.75 to 12.2 kbit/s with toll quality speech starting at 7.4 kbit/s.

Enhanced Full Rate or EFR or GSM-EFR or GSM 06.60 is a speech coding standard that was developed in order to improve the quality of GSM.

Half Rate is a speech coding system for GSM, developed in the early 1990s.

Adaptive Multi-Rate Wideband (AMR-WB) is a patented wideband speech audio coding standard developed based on Adaptive Multi-Rate encoding, using a similar methodology to algebraic code-excited linear prediction (ACELP). AMR-WB provides improved speech quality due to a wider speech bandwidth of 50–7000 Hz compared to narrowband speech coders which in general are optimized for POTS wireline quality of 300–3400 Hz. AMR-WB was developed by Nokia and VoiceAge and it was first specified by 3GPP.

G.729 ITU-T Recommendation

G.729 is a royalty-free narrow-band vocoder-based audio data compression algorithm using a frame length of 10 milliseconds. It is officially described as Coding of speech at 8 kbit/s using code-excited linear prediction speech coding (CS-ACELP), and was introduced in 1996. The wide-band extension of G.729 is called G.729.1, which equals G.729 Annex J.

G.722 ITU-T recommendation

G.722 is an ITU-T standard 7 kHz wideband audio codec operating at 48, 56 and 64 kbit/s. It was approved by ITU-T in November 1988. Technology of the codec is based on sub-band ADPCM (SB-ADPCM). The corresponding narrow-band codec based on the same technology is G.726.

Extended Adaptive Multi-Rate – Wideband (AMR-WB+) is an audio codec that extends AMR-WB. It adds support for stereo signals and higher sampling rates. Another main improvement is the use of transform coding additionally to ACELP. This greatly improves the generic audio coding. Automatic switching between transform coding and ACELP provides both good speech and audio quality with moderate bit rates.

Selectable Mode Vocoder (SMV) is variable bitrate speech coding standard used in CDMA2000 networks. SMV provides multiple modes of operation that are selected based on input speech characteristics.

Variable-Rate Multimode Wideband (VMR-WB) is a source-controlled variable-rate multimode codec designed for robust encoding/decoding of wideband/narrowband speech. The operation of VMR-WB is controlled by speech signal characteristics and by traffic condition of the network. Depending on the traffic conditions and the desired quality of service (QoS), one of the 4 operational modes is used. All operating modes of the existing VMR-WB standard are fully compliant with cdma2000 rate-set II. VMR-WB modes 0, 1, and 2 are cdma2000 native modes with mode 0 providing the highest quality and mode 2 the lowest ADR. VMR-WB mode 3 is the AMR-WB interoperable mode operating at an ADR slightly higher than mode 0 and providing a quality equal or better than that of AMR-WB at 12.65 kbit/s when in an interoperable interconnection with AMR-WB at 12.65 kbit/s.

Vector sum excited linear prediction (VSELP) is a speech coding method used in several cellular standards. The VSELP algorithm is an analysis-by-synthesis coding technique and belongs to the class of speech coding algorithms known as CELP.

internet Speech Audio Codec (iSAC) is a wideband speech codec, developed by Global IP Solutions (GIPS). It is suitable for VoIP applications and streaming audio. The encoded blocks have to be encapsulated in a suitable protocol for transport, e.g. RTP.

G.729.1 ITU-T Recommendation

G.729.1 is an 8-32 kbit/s embedded speech and audio codec providing bitstream interoperability with G.729, G.729 Annex A and G.729 Annex B. Its official name is G.729-based embedded variable bit rate codec: An 8-32 kbit/s scalable wideband coder bitstream interoperable with G.729. It was introduced in 2006.

Transcoder and Rate Adaptation Unit or TRAU, performs transcoding function for speech channels and RA for data channels in the GSM network. The Transcoder/Rate Adaptation Unit (TRAU) is the data rate conversion unit. The PSTN/ISDN switch is a switch for 64 kbit/s voice. Current technology permits to decrease the bit-rate. Since MSC is basically a PSTN/ISDN switch its bit-rate is still 64 kbit/s. That is why a rate conversion is required in between the BSC and MSC...

G.718 ITU-T Recommendation

G.718 is an ITU-T Recommendation embedded scalable speech and audio codec providing high quality narrowband speech over the lower bit rates and high quality wideband speech over the complete range of bit rates. In addition, G.718 is designed to be highly robust to frame erasures, thereby enhancing the speech quality when used in internet protocol (IP) transport applications on fixed, wireless and mobile networks. Despite its embedded nature, the codec also performs well with both narrowband and wideband generic audio signals. The codec has an embedded scalable structure, enabling maximum flexibility in the transport of voice packets through IP networks of today and in future media-aware networks. In addition, the embedded structure of G.718 will easily allow the codec to be extended to provide a superwideband and stereo capability through additional layers which are currently under development in ITU-T Study Group 16. The bitstream may be truncated at the decoder side or by any component of the communication system to instantaneously adjust the bit rate to the desired value without the need for out-of-band signalling. The encoder produces an embedded bitstream structured in five layers corresponding to the five available bit rates: 8, 12, 16, 24 & 32 kbit/s.

Tandem Free Operation (TFO) is a part of ETSI's 3GPP standard specification, which has been included from R99 of the standards specifications onwards.

References

This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.