The Warrego Highway is located in southern Queensland, Australia. It connects coastal centres to the south western areas of the state, and is approximately 715km in length. It takes its name from the Warrego River, which is the endpoint of the highway. The entire highway is part of the National Highway system linking Darwin and Brisbane: formerly National Highway 54, Queensland began to convert to the alphanumeric system much of Australia had adopted in the early-2000s and this road is now designated as National Highway A2.
Warrego Highway is a state-controlled road, divided into seven sections for administrative and funding purposes. Six of the seven sections (numbers 18A to 18F) are part of the National Highway, while section 18G is a regional road.[1][2][3][4] The sections are:
18A – Ipswich to Toowoomba
18B – Toowoomba to Dalby
18C – Dalby to Miles
18D – Miles to Roma
18E – Roma to Mitchell
18F – Mitchell to Morven
18G – Morven to Charleville
State-controlled roads that intersect with the highway are listed in the main article.
The section of highway between Ipswich and Charlton is mostly motorway grade; a four lane divided highway with motorway-style on-ramps and off-ramps. At a point between Charlton and Oakey the highway merges from 4 to 2 lanes (however, throughout 2017–2019, the highway was planned to be duplicated up until Oakey)[5] Then, the highway mostly continues in a straight line with minimal turns. At Dalby, the highway briefly returns to 4 lanes (where a longer stretch of the highway was planned to be duplicated in 2017). The Warrego then continues as a rural 2 lane highway, until Charleville.
Terrain
The Warrego Highway's lowest point along its length is 3.69m just east of where it crosses the Bremer River near Ipswich, and its highest elevation is at the top of the Great Dividing Range on the Toowoomba Bypass.[6]
Speed zones
Ipswich Motorway – Blacksoil 100km/h
Blacksoil – Toowoomba Bypass merge 100km/h, with a drop to 80km/h and/or 60km/h through some towns
Great Dividing Range (Toowoomba Bypass to Charlton) 80km/h to 100km/h
Charlton – Kingsthorpe 90km/h
Kingsthorpe – Dalby 100km/h except through Jondaryan, which is 80km/h.
Dalby – 60km/h
Dalby – Chinchilla 100km/h except running through towns, which speeds can drop to 60km/h
Chinchilla – Charleville 110km/h except running through towns, which speeds can drop to 60km/h
Towns along the route
Approximate road distances (in kilometres) of towns from Brisbane along the highway
From east to west, the highway passes through or close to the cities and major towns of:
In January 2011, the former highway was extensively damaged where it crossed the Toowoomba Range. This included land slips, shoulder and embankment erosion, the erosion of drains and damaged rock fall netting.[7] The road wasn't fully repaired with all four lanes open until September 2011.[8]
The Toowoomba Bypass was completed in September 2019 and bypasses the urban area of Toowoomba and provides a better crossing of the Great Dividing Range. Warrego Highway (A2) was rerouted via the bypass between Helidon Spa (in the east) and the interchange at Charlton (in the west). The bypass continues as the Gore Highway (A39) and is 41km in length. The original section of Warrego Highway through Toowoomba was renamed Toowoomba Connection Road (A21).[9]
Major works
1957 – Helidon bypass. New road built to bypass Helidon including a steel and concrete bridge over Lockyer Creek. Construction started in 1954, and the bypass was opened by the end of June 1957.
1959 – Ipswich bypass. New 8 mile long bypass including a steel and concrete bridge over the Bremer River built to bypass Ipswich City, shortening the highway by 2 miles. Also completed this year was the first bridge over Laidley Creek at Crowley Vale.[10]
1966 - Lockyer Creek deviation. 3.6 mile section of road bypassing a series of sharp curves between Gatton and Grantham, including a steel and concrete bridge 370 ft long over Lockyer Creek was completed and a was opened to traffic.[11] The old alignment followed Wells Road and Armstrongs Road.
1968 - The final 16 mile section of highway between Morven and Charleville was sealed. Work was completed late in the year.[12]
1970 - Construction of a four-lane section, 1.7 miles in length, from Withcott to join with the four-lane section on the Toowoomba Range was completed.[13]
1971 – Marburg bypass. 1.9 miles (3.1 km) of new road built to bypass Marburg, including bridges over Queen Street and Black Snake Creek.[14]
1971 – Blanchview deviation. 5.15 miles (8.3 km) of new road that replaced the old twisting route built in the late 1920s. The deviation opened to traffic in December of that year.[15]
1973 - Tenthill Creek bridge. New new prestressed concrete girder bridge over Tenthill Creek to replace the old truss structure known as Robinson's Bridge.[16]
1974 – Minden Range deviation. 2.6 km of new road built to bypass a sub-standard section of road over the Minden Range.
1976 – Hattonvale to Laidley Creek duplication. 8 km of road widened to four lanes at a cost of $870,000.
1982 - Construction to four lanes on an improved alignment was completed for 2.8 km from the Brisbane Valley Highway junction to the Walloon turnoff.[17]
1986 - Glenore Grove to Gatton duplication Stage 1. 5.6 km of road between Glenore Grove and the Queensland Agricultural College was duplicated, and the second bridge over Laidley Creek at Crowley Vale was constructed.
1987 - Glenore Grove to Gatton duplication Stage 2. 3.9 km between the Queensland Agricultural College and the Gatton-Esk Road was completed.[18]
1989 – Gatton bypass. 20 km of new road built to bypass Gatton, Grantham and Helidon at a cost of $20 million opened in November 1989.[19]
1991 - Helidon Spa to Withcott Duplication opened on 21 October 1991.
1993 - Bremer River Bridge Duplication. Second bridge over the Bremer River opened by Federal Minister for Transport Bob Brown on 29 January 1993.
1994 – Dinmore Duplication. 2.7 km of road duplicated to four lanes from the railway at Dinmore to the Bremer River bridge. A grade-separated interchange at River Road was also built. [20]
1996 - 2.8 km section between Greenwattle Street and Nugent Pinch Road in Toowoomba duplicated to relieve traffic congestion at a cost of $2.5 million.
1997 - Oakey Bypass.
2002 – Yaralla Deviation. 18.5 km realignment built to bypass a notorious section prone to flooding west of Dalby.[21]
2017 – Toowoomba to Oakey Duplication Stage 1. Highway duplicated from Nugent Pinch Road to Charlton.
2018 – Toowoomba to Oakey Duplication Stage 2. Highway duplicated from Charlton to Kingsthorpe including an interchange at Kingsthorpe–Haden Road
These projects began in 2017 to fully duplicate the highway to 4 lanes, between Cecil Plains Road and Black Street. 4 new traffic signals were added at Black Street, Jandowae Road, Orpen Street and a pedestrian signal near Owen Street. Both projects were completed in November 2018, at a combined cost of $115 million.[22]
Roads of Strategic Importance
The Roads of Strategic Importance initiative, last updated in March 2022, includes the following project for the Warrego Highway.
Priority section projects
A project to upgrade priority sections of the Toowoomba to Ipswich corridor, including the Warrego Highway and surrounding state and council roads, at an estimated cost of $75 million, was in planning in May 2020.[23]
Other projects
Brimblecombe Road intersection
A project to upgrade the Brimblecombe Road intersection between Toowoomba and Dalby, at a cost of $2,75 million, was completed in December 2021.[24]
Gatton heavy vehicle decoupling facility
A project to provide a heavy vehicle decoupling facility at Gatton was completed by November 2021.[25]
Master plan Ipswich to Toowoomba
A master plan for the upgrade of the highway between Ipswich and Toowoomba has been developed at a cost of $6.78 million.[26]
Haigslea–Amberley Road intersection
A project to plan the upgrade of the Haigslea-Amberley Road intersection, at a cost of $799,000, was in progress in May 2022.[27]
Mount Crosby Road intersection
A project to plan the upgrade of the Mount Crosby Road intersection, at a cost of $5 million, was in progress in July 2021.[28]
Other items of interest
Darren Lockyer Way
"Welcome to Darren Lockyer Way" signage at Ipswich end of Warrego Highway heading westbound.
On 28 September 2011 the Queensland Main Roads Minister, Craig Wallace, announced that an 85km stretch of the Warrego Highway was to be renamed Darren Lockyer Way, in honour of the retired Brisbane Broncos, Queensland and Australian rugby league captain. The section of road renamed is from Riverview to the bottom of the Toowoomba Range at Withcott. Special signage including "Welcome to Darren Lockyer Way" has been erected.[29]
No entry from Toowoomba Connection Road eastbound and no exit to Toowoomba Connection Road westbound (except via a U-turn facility further east on the Warrego Highway) Warrego Highway runs north–west on the Toowoomba Bypass
↑ "Toowoomba to Ipswich". Department of Infrastructure, Transport, Regional Development and Communications. 28 May 2020. Archived from the original on 30 April 2022. Retrieved 6 May 2022.
This page is based on this Wikipedia article Text is available under the CC BY-SA 4.0 license; additional terms may apply. Images, videos and audio are available under their respective licenses.
National Highway 54 
National Highway A2
Ipswich Motorway /
Cunningham Highway, Ipswich, Queensland 
Mitchell Highway, Charleville, Queensland 
