![]() | This article has multiple issues. Please help improve it or discuss these issues on the talk page . (Learn how and when to remove these template messages)
|
.357/44 Bain & Davis | |
---|---|
Type | Revolver and Pistol |
Place of origin | United States |
Production history | |
Designer | Keith Davis |
Designed | 1964 |
Specifications | |
Parent case | .44 Magnum |
Case type | Rimmed, bottlenecked |
Bullet diameter | .357 in (9.1 mm) |
Maximum pressure | 42,000 psi (290 MPa) |
The .357/44 Bain & Davis is a centerfire pistol cartridge designed in 1964 by Keith Davis, a partner and pistolsmith of the Bain & Davis Gunshop of San Gabriel, California. The purpose was to give improved velocity over the .357 Magnum by using the larger .44 Magnum case necked down to hold a 0.357 diameter bullet. [1]
Initially, Smith and Wesson Model 27 revolver cylinders were modified to accept the necked case. Two conditions were observed: The velocity produced at a moderate pressure was impressive, and the brass tended to set back if not scrupulously clean, tying up the action of the gun. As the cartridge was noticed by competitive silhouette shooters during the 1970s, Ruger Blackhawk revolvers were chambered for the round, and several barrels were made for the single shot Thompson/Center Contender Pistol. Rounds made for the Contender could utilize longer bullets seated further out than was possible with the revolvers.
Some interest in the load has persisted until today (2018), due to the better ballistic performance of the 357/44 B&D compared to the .357 Remington Maximum, a straight-walled cartridge resembling the .357 Magnum, but longer.
Hornady and RCBS both produced forming and loading dies that could be used to form and load using standard .44 Magnum brass.
A cartridge, also known as a round, is a type of pre-assembled firearm ammunition packaging a projectile, a propellant substance and an ignition device (primer) within a metallic, paper, or plastic case that is precisely made to fit within the barrel chamber of a breechloading gun, for convenient transportation and handling during shooting. Although in popular usage the term "bullet" is often used to refer to a complete cartridge, the correct usage only refers to the projectile.
The .38 Special, also commonly known as .38 S&W Special, .38 Smith & Wesson Special, .38 Spl, .38 Spc, or 9x29mmR is a rimmed, centerfire cartridge designed by Smith & Wesson.
A center-fire is a type of metallic cartridge used in firearms, where the primer is located at the center of the base of its casing. Unlike rimfire cartridges, the centerfire primer is typically a separate component seated into a recessed cavity in the case head and is replaceable by reloading the cartridge.
The .357 SIG is a bottlenecked rimless centerfire handgun cartridge developed by the Swiss-German firearms manufacturer SIG Sauer, in cooperation with ammunition manufacturer Federal Premium. The cartridge is used by a number of law enforcement agencies.
The .357 Smith & Wesson Magnum, .357 S&W Magnum, .357 Magnum, or 9×33mmR is a smokeless powder cartridge with a 0.357 in (9.07 mm) bullet diameter. It was created by Elmer Keith, Phillip B. Sharpe, and Douglas B. Wesson of firearm manufacturers Smith & Wesson and Winchester. The .357 Magnum cartridge is notable for its highly effective terminal ballistics.
A rim-fire is a type of metallic cartridge used in firearms where the primer is located within a hollow circumferential rim protruding from the base of its casing. When fired, the gun's firing pin will strike and crush the rim against the edge of the barrel breech, sparking the primer compound within the rim, and in turn ignite the propellant within the case. Invented in 1845 by Louis-Nicolas Flobert, the first rimfire metallic cartridge was the .22 BB Cap cartridge, which consisted of a percussion cap with a bullet attached to the top. While many other different cartridge priming methods have been tried since the early 19th century, such as teat-fire and pinfire, only small caliber rimfire cartridges have survived to the present day with regular use. The .22 Long Rifle rimfire cartridge, introduced in 1887, is by far the most common ammunition found in the world today in terms of units manufactured and sold.
A wadcutter is a special-purpose flat-fronted bullet specifically designed for shooting paper targets, usually at close range and at subsonic velocities typically under approximately 270 metres per second (890 ft/s). Wadcutters have also found favor for use in self-defense guns, such as .38 caliber snubnosed revolvers, due to shorter barrel lengths, lower bullet velocities, and improved lethality. Wadcutters are often used in handgun and airgun competitions.
The .45 Colt (11.43×33mmR), is a rimmed, straight-walled, handgun cartridge dating to 1872. It was originally a black-powder revolver round developed for the Colt Single Action Army revolver. This cartridge was adopted by the U.S. Army in 1873 and served as an official US military handgun cartridge for 19 years, before being replaced by the .38 Long Colt in 1892.
The .44 Remington Magnum, also known as .44 Magnum or 10.9x33mmR, is a rimmed, large-bore cartridge originally designed for revolvers and quickly adopted for carbines and rifles. Despite the ".44" designation, guns chambered for the .44 Magnum round, its parent case, the .44 Special, and its parent case, the .44 Russian all use 0.429 in (10.9 mm) diameter bullets. The .44 Magnum is based on the .44 Special case but lengthened and loaded to higher pressures for greater velocity and energy.
The .44 Smith & Wesson Special, also commonly known as .44 S&W Special, .44 Special, .44 Spl, .44 Spc, or 10.9×29mmR, is a smokeless powder center fire metallic revolver cartridge developed by Smith & Wesson in 1907 as the standard chambering for their New Century revolver, introduced in 1908.
The .357 Maximum, formally known as the .357 Remington Maximum or the .357 Max, is a super magnum handgun cartridge originally developed by Elgin Gates as the wildcat .357 SuperMag. The .357 Maximum was introduced into commercial production as a joint-venture by Remington Arms Company and Ruger in 1983 as a new chambering for the Ruger Blackhawk. Shortly thereafter, Dan Wesson Firearms and Thompson/Center Arms introduced firearms in this cartridge. United Sporting Arms chambered it in their Silhouette series single-action revolvers. It is a .357 Magnum case lengthened 0.300 inches (7.6 mm). Based on the .357 Magnum cartridge, a revolver or single-shot pistol designed for the .357 Remington Maximum will chamber and fire the .360 Dan Wesson, .357 Magnum, .38 Special, .38 Long Colt, and .38 Short Colt cartridges. Intended primarily as a silhouette cartridge, such high velocity and energy levels have hunting applications. SAAMI pressure level for this cartridge is set at 40,000 pounds per square inch (280 MPa).
The .256 Winchester Magnum is a firearms cartridge developed by Winchester, and was produced by necking-down a .357 Magnum cartridge to .257 diameter. It was designed for shooting small game and varmints.
A wildcat cartridge, often shortened to wildcat, is a custom cartridge for which ammunition and/or firearms are not mass-produced. These cartridges are often created in order to optimize a certain performance characteristic of an existing commercial cartridge, or may merely be intended as novelty items.
The .475 Wildey Magnum is a large semi-automatic pistol cartridge designed for big game hunting in the Wildey pistol.
Elmer Merrifield Keith was an American rancher, firearms enthusiast, and author. Keith was instrumental in the development of the first magnum revolver cartridge, the .357 Magnum (1935), as well as the later .44 Magnum (1956) and .41 Magnum (1964) cartridges, credited by Roy G. Jinks as "the father of big bore handgunning." Keith was born in Hardin, Missouri, and overcame serious injuries that he had sustained at age 12 in a fire when he was living in Missoula, Montana.
Overpressure ammunition, commonly designated as +P or +P+, is small arms ammunition that has been loaded to produce a higher internal pressure when fired than is standard for ammunition of its caliber, but less than the pressures generated by a proof round. This is done typically to produce ammunition with higher muzzle velocity, muzzle energy, and stopping power, such as ammunition used for security, defensive, or hunting purposes. Because of this, +P ammunition is typically found in handgun calibers which might be used for paramilitary forces, armed security, and defensive purposes.
A super magnum is a longer and/or more powerful version of a "magnum" cartridge. Although the term "super magnum" typically refers to a handgun cartridge, created by lengthening an existing straight-case design, it can also refer to rifle and shotgun cartridges, such as the .17 Winchester Super Magnum and the 31⁄2" 12 Gauge Super Magnum. In this case, it simply denotes that it is of greater power than existing "magnums" of a similar caliber or gauge, this is comparable to other designations, such as the "Remington Ultra Magnum". The most widespread of these cartridges are the "SuperMag" family of super-magnum handgun cartridges that were proposed and tested by Elgin Gates in the 1970s.
The 9×25mm Dillon is a pistol wildcat cartridge developed for use in USPSA/IPSC Open guns. The cartridge is made by necking down a 10mm Auto case to 9 mm.
The .40 Super (10.2x25mm) is a powerful automatic pistol cartridge developed through the collaboration of Fernando Coelho and Tom Burczynski and introduced by Triton Cartridge in 1996. It delivers ballistics comparable to the .41 Magnum revolver cartridge, yet functions in standard 1911s and other full-size pistols. A 5” 1911 chambered in the cartridge is capable of penetrating 46” of Clear Ballistics gel.
The .45 Black Powder Magnum is a black-powder firearm round. It is a wildcat cartridge of the .45 Colt family.