FAA Practical Test

Last updated

A practical test, more commonly known as a checkride, is the Federal Aviation Administration examination which one must undergo in the United States to receive an aircraft pilot's certification, or a rating for additional flight privileges. The name refers to the portion of the examination in which the candidate being examined flies in an aircraft with the Designated Pilot Examiner or other authorized examiner to demonstrate competency in the skills that are required for the certification. Although "checkride" is the most commonly used term, it is considered informal and is technically known as a Practical Test by the FAA and in all its literature, and the specific objectives which the candidate must meet are called the Airman Certification Standards, or ACS. However, some Practical Tests, notably those for balloon ratings, and those for certificates such as flight instructor, and aircraft mechanic, are still conducted using the older Practical Test Standards, or PTS. Other positions that often include checkrides include air traffic controllers and flight dispatchers.

In addition to successfully completing a checkride, one must also complete an oral examination (which happens before, and often, to some extent, during the checkride) and meet certain basic aeronautical experience requirements (such as number of hours flown) as well as pass a separate multiple-choice computer-administered test that is quite consistently called the "written test."

During a checkride, an examiner takes on a role more like that of a passenger rather than an instructor. It is the examiner's job to observe that the candidate demonstrates good decision-making skills, rather than teach or to act as a crewmember, although an examiner is likely to offer advice during the ride if inclined. The examiner usually does not touch any of the aircraft controls unless necessary to maintain the safety of the flight, in which case the candidate usually fails the examination instantly, except for the part when the examiner acts as a safety pilot during operations with a view limiting device.

While the Airman Certification Standards outline very specific tolerances that a prospect must adhere to, the examiner has a certain amount of subjective control over whether the student passes or fails.

When a candidate fails a checkride, the examiner has the discretion to end the checkride immediately or to allow the student to complete the remaining objectives of the checkride to and defer the failed task to a retake. The checkride may not continue without the consent of the applicant. During the retake, the examiner is required to test only the previously-failed or uncompleted items but may retest any items previously passed or to fail the candidate again based on them.

If the checkride has to be stopped due to any reason besides student pilot failure, such as weather setting in, the examiner will issue a letter of discontinuance, which will state the maneuvers that have been completed so that the retake checkride can be limited to the maneuvers that have not yet been completed.

Related Research Articles

<span class="mw-page-title-main">Spin (aerodynamics)</span> Aviation term for a corkscrew downward path

In flight dynamics a spin is a special category of stall resulting in autorotation about the aircraft's longitudinal axis and a shallow, rotating, downward path approximately centred on a vertical axis. Spins can be entered intentionally or unintentionally, from any flight attitude if the aircraft has sufficient yaw while at the stall point. In a normal spin, the wing on the inside of the turn stalls while the outside wing remains flying. It is possible for both wings to stall, but the angle of attack of each wing, and consequently its lift and drag, are different.

A flight review is a study program and flight instructor examination of aviation piloting skills. Periodic flight reviews are a pilot licensing requirement mandated by the aviation authorities of many countries. These reviews take different forms in different countries.

<span class="mw-page-title-main">Private pilot licence</span> Type of pilot license

A private pilot licence (PPL) or private pilot certificate is a type of pilot licence that allows the holder to act as pilot in command of an aircraft privately. The basic licence requirements are determined by the International Civil Aviation Organization (ICAO), but implementation varies from country to country. According to ICAO, an applicant must be at least 17 years old, demonstrate appropriate knowledge and skill, and hold at least a Class 3 medical certificate. Different PPLs are available for different categories of aircraft, such as aeroplane, helicopter, airship, etc., and are not interchangeable, although experience from a PPL in one category may be credited towards the issue of another.

The airline transport pilot license (ATPL), or in the United States of America, an airline transport pilot (ATP) certificate, is the highest level of aircraft pilot certificate.

<span class="mw-page-title-main">Touch-and-go landing</span> Flying maneuver

In aviation, a touch-and-go landing (TGL) or circuit and bump is a maneuver that is common when learning to fly a fixed-wing aircraft. It involves landing on a runway and taking off again without coming to a full stop. Usually the pilot then circles the airport in a defined pattern known as a circuit and repeats the maneuver. This allows many landings to be practiced in a short time.

<span class="mw-page-title-main">Aircraft maintenance technician</span> Profession and licensed qualification

An aircraft mechanic, aviation mechanic or aircraft maintenance technician (AMT) is a tradesperson who carries out aircraft maintenance and repairs. AMTs inspect and perform or supervise maintenance, preventive maintenance, repairs and alteration of aircraft and aircraft systems.

In the United States, a student pilot certificate is issued to a pilot in training, and is a prerequisite for the student to fly alone in the aircraft.

Pilot licensing or certification refers to permits for operating aircraft. Flight crew licences are issued by the civil aviation authority of each country, which must establish that the holder has met minimum knowledge and experience before issuing licences. The licence, along with the required class or type rating, allows a pilot to fly aircraft registered in the licence issuing state.

<span class="mw-page-title-main">Pilot certification in the United States</span> Pilot certification

Pilot certification in the United States is typically required for an individual to act as a pilot-in-command of an aircraft. It is regulated by the Federal Aviation Administration (FAA), a branch of the U.S. Department of Transportation (USDOT). A pilot may be certified under 14 Code of Federal Regulations (CFR) Part 61 or 14 CFR Part 141. Pilots may also be certified under 14 CFR Part 107 for commercial drone operations.

An instrument rating is an authorization required for a pilot to fly under instrument flight rules (IFR). In the United States, the rating is issued by the Federal Aviation Administration.

<span class="mw-page-title-main">Complex airplane</span> Aircraft term

A complex airplane is defined by the United States Federal Aviation Administration as an aircraft that has all of the following:

<span class="mw-page-title-main">Flight instructor</span> Person who teaches others to operate aircraft

A flight instructor is a person who teaches others to operate aircraft. Specific privileges granted to holders of a flight instructor qualification vary from country to country, but very generally, a flight instructor serves to enhance or evaluate the knowledge and skill level of an aviator in pursuit of a higher pilot's license, certificate or rating.

<span class="mw-page-title-main">WINGS Pilot Proficiency Program</span> Recurring flight training initiative in the United States

The WINGS Pilot Proficiency Program is a voluntary pilot training and safety initiative supported by the FAA Safety Team division of the Federal Aviation Administration in the United States. The program was created by advisory circular AC 61.91 on May 21, 1979 as the Pilot Proficiency Award Program, and it has been continuously developed to promote air safety by encouraging general aviation pilots to maintain flying proficiency through the use of online learning, in-person seminars, and tailored flight training.

Practical Test Standards or PTS are sets of guidelines, standards, and criteria formerly used in the United States by Federal Aviation Administration (FAA) Safety Inspectors or Designated Pilot Examiners to determine the suitability of airmen to be issued an airman certificate by conducting a checkride. Each certification level features unique criteria published by the FAA both electronically and in hard copy format. The system was partially superseded, beginning on June 15, 2016, by a new set of publications called Airman Certification Standards, though the PTS is still used for select FAA practical tests.

Medical certifications for aircraft pilots are specified by the International Civil Aviation Organization (ICAO). ICAO sets standards and recommended practices (SARPS), which are specified in Annex 1 to the Convention on International Civil Aviation.

Ground Instructor is a certificate issued in the United States by the Federal Aviation Administration (FAA). There are three classes of holder, licensed to provide the ground instruction element in the training of three groups:

In the United States, a Designated Pilot Evaluator (DPE) is a senior pilot who examines applicants for a Pilot Certificate on behalf of the Federal Aviation Administration (FAA). The DPE must check applicants’ qualifications, conduct an oral test of their mental skills and judgment, and perform a practical test in flight.

<span class="mw-page-title-main">Civil Aerospace Medical Institute</span>

Civil Aerospace Medical Institute (CAMI) is the medical certification, education, research, and occupational medicine wing of the Office of Aerospace Medicine (AAM) under the auspices of the Federal Aviation Administration Office of Aviation Safety. The Institute's primary goal is to enhance aviation safety.

A check pilot is an aircraft pilot who performs an oversight, safety, and qualification role for commercial pilots undergoing evaluation. The role of the check pilot is to ensure that the flight crew member has met competency standards before the check airman releases the crew member from training and to ensure that those standards are maintained while the crew member remains in line service.

A power-off accuracy approach, also known as a glide approach, is an aviation exercise used to simulate a landing with an engine failure. The purpose of this training technique is to better develop one's ability to estimate distance and glide ratios. The variation in each angle refers to the degrees an aircraft must turn to be aligned with the runway. Consideration of the wind and use of flaps are important factors in executing power-off accuracy approaches.

References

This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.