| Antoinette III | |
|---|---|
 | |
| Antoinette 3 in her hangar | |
| Role | Pioneer aircraft |
| National origin | France |
| Manufacturer | Antoinette |
| Designer | Léon Levavasseur |
| First flight | 1908 |
| Number built | 1 |
| Developed from | Gastambide-Mengin II |
Tha Antoinette III was a pioneer aircraft developed in France during 1908.[ citation needed ]
After the limited success of the Gastambide-Mengin monoplane Levavasseur completely revised the design resulting in the Antoinette III. The inadequate roll control was not greatly improved, retaining the wing warping of the Gastambide-Mengin. Ground handling and take-off / landing performance was improved, however, by revising the complex inadequate quadricycle undercarriage of the Gastambide-Mengin, with strut supported wheels forward and aft on the centre-line and side-by-side wheels midway between the singles. Other improvements came in the form of the cruciform tail unit with large triangular fins above and below the rear fuselage, as well as the large tailplane, all of which supported triangular control surfaces. [1]
Control was found to be marginal at best, but short flights were made regularly. [1]
 | Wikimedia Commons has media related to Antoinette III . |
Related lists List of aircraft (pre-1914)
A monoplane is a fixed-wing aircraft configuration with a single mainplane, in contrast to a biplane or other types of multiplanes, which have multiple planes.
Albatros Flugzeugwerke GmbH was a German aircraft manufacturer best known for supplying the German airforces during World War I.
Antoinette was a French manufacturer of light petrol engines. Antoinette also became a pioneer-era builder of aeroplanes before World War I, most notably the record-breaking monoplanes flown by Hubert Latham and René Labouchère. Based in Puteaux, the Antoinette concern was in operation between 1903 and 1912. The company operated a flying school at Chalons for which it built one of the earliest flight simulators.
Wing warping was an early system for lateral (roll) control of a fixed-wing aircraft. The technique, used and patented by the Wright brothers, consisted of a system of pulleys and cables to twist the trailing edges of the wings in opposite directions. In many respects, this approach is similar to that used to trim the performance of a paper airplane by curling the paper at the back of its wings.
Blériot Aéronautique was a French aircraft manufacturer founded by Louis Blériot. It also made a few motorcycles between 1921 and 1922 and cyclecars during the 1920s.
The Antoinette IV was an early French monoplane. It was a high-wing aircraft with a fuselage of extremely narrow triangular cross-section and a cruciform tail. Power was provided by a V8 engine of Léon Levavasseur's own design driving a paddle-bladed tractor propeller. Lateral control was at first effected with large triangular, and shortly afterwards trapezoidal-planform ailerons hinged to the trailing edge of the wings, although wing-warping was substituted at an early stage in flight trials, and in this type proved more effective.
The Antoinette V was an early French aircraft, first flown on 20 December 1908.
The Antoinette VI was an early French aircraft, flown in 1909. It was a development of the Antoinette IV, its major technological advance being that it was fitted with true ailerons, whereas the former aircraft had ailerons mounted as separate surfaces on the trailing edges of the wings. Nevertheless, Levavasseur was not satisfied with this innovation and later modified the aircraft to use a wing warping system similar to that fitted to the Antoinette V.
The Antoinette VII was an early French aircraft, flown in 1909.
The Antoinette military monoplane, also known as the Antoinette Monobloc or the Antoinette-Latham was an early 3-seat monoplane built in France in 1911 by the Antoinette company in the hope of attracting orders from the French military. It featured a futuristic and aerodynamic design with innovative elements that were ahead of its time, including unbraced cantilever wings, an enclosed fuselage and wheel fairings, and an engine with steam cooling and direct fuel injection. However, due to an under-powered engine, it was barely able to fly and failed to attract orders.
The Blackburn Second Monoplane was strongly influenced by the French Antoinette and was much more successful than Robert Blackburn's first aircraft. The lone aircraft was built in Leeds, UK in 1910.
The Blackburn Type D, sometimes known as the Single Seat Monoplane, was built by Robert Blackburn at Leeds in 1912. It is a single-engine mid-wing monoplane. Restored shortly after the Second World War, it remains part of the Shuttleworth Collection and is the oldest British flying aeroplane.
Léon Levavasseur was a French powerplant engineer, aircraft designer and inventor. His innovations included the V8 engine, direct fuel injection, and liquid engine cooling. Primarily associated with the Antoinette company, he continued to experiment with aircraft design after the company went bankrupt.
The Blackburn Type E was a development of the earlier Blackburn Mercury single-engined monoplanes, but was innovative in its use of steel tubing to construct the fuselage. It was built during 1912 to compete in the Military Aeroplane Trials. A single-seat version flew, but the military two-seater did not.
The Gastambide-Mengin monoplane was an early French experimental aircraft designed by Léon Levavasseur, and was the first aircraft built by the Antoinette company. The name came from Jules Gastambide, who financed the company, and Gabriel Mengin, the aircraft engineer.
The Martin Handasyde No.3 was an early British single-seat monoplane design, built in partnership by H.P. Martin and George Handasyde. Only one was built.
The Star Monoplane was an early British aircraft built by the Star Engineering Company of Wolverhampton. A tractor configuration monoplane resembling the French Antoinette aircraft, its most remarkable feature was the arrangement of the rear control surfaces. It was exhibited at the Aero Exhibition at Olympia in London, in 1910.
