| Bonney Gull | |
|---|---|
 | |
| Role | Experimental aircraft |
| National origin | United States |
| Designer | Leonard Warden Bonney |
| First flight | 4 May 1928 |
| Introduction | 1928 |
| Status | Crashed on first flight |
| Number built | 1 |
The Bonney Gull was an experimental aircraft that used variable incidence wings with bird-like shapes. [1]
Leonard Warden Bonney was an early aviator, who flew with the Wright Exhibition Team as early as 1910. An experienced aviator with service in the First World War, Bonney set out to develop a plane with more efficient wings and controls than contemporary aircraft. Noting the gull's two to one lift to weight ratio, he set about molding gull wings for their shape. Construction took place over the course of five years. The ideas were tested in MIT and the Daniel Guggenheim School of Aeronautics wind tunnels. [2]
A 1928 issue of Time magazine described the unusual aircraft:
It was fat in body with graceful curving wings. Bonney followed the bird principle, abandoned the aileron, or balancing contrivance which airplane designers have always considered an essential feature of stability in the air. His plane had new features: an expanding and contracting tail, like a blackbird's, for varying loads; variable camber in the wings, so that they could flatten out like a gull's when flying level; a varying angle of incidence to its wings, so that they could turn sideways into the wind on landing... [3]
The Gull was assembled at the Kirkham facility in Garden City, New York and Mitchel Field. It used conventional landing gear, a mid-wing arrangement, corrugated aluminum skins, and a radial engine. The cockpit featured a large streamlined greenhouse bubble with two seats. The large tailwheel was steerable and fully faired. The tail used small vertical stabilizers, with large elevators that could be swept back in flight. [4] The aircraft profile was not unusual for the era with the exception of the highly tapered and swept back wings with a large dihedral and large tapered tail surfaces.
Some features seemed far-fetched, but were actually ahead of their time. [2] The wings mounted flush with the aircraft, but had a mechanism which allowed them to rotate in angle of incidence, as well as fold rearward from ten degrees of sweep to forty five degrees for braking and storage. [5] These features were incorporated on future carrier aircraft such as the Fairey Firefly for storage rather than braking and flight control. Variable incidence mechanisms are used commonly to trim tail surfaces, however some aircraft such as the Vought F-8 Crusader have deployed the concept in practical use. The variable sweep mechanism can be seen on some high-speed aircraft such as the General Dynamics F-111 Aardvark to expand their flight envelope. Bonney used differential sweep for roll control. [4]
Bonney was unable to find a willing test pilot and chose to fly the aircraft himself. [6] He performed a test hop, damaging the landing gear once. On 4 May 1928 Bonney took up another aircraft on a flight, then announced he would test fly the Gull that day. Bonney was killed during the maiden flight when the aircraft nosedived into the ground from about 50 feet of altitude, seconds after taking off from Curtiss Field on Long Island. [7] Pathé News was onsite to film the first flight. The newsreel shows the aircraft experiencing a roll to the left which was corrected, and a single oscillation in pitch before nosing straight down into the ground tossing out Bonney. Bonney was taken to Mineola Hospital where he died. [8] [9]
Data from Long Island Aircraft Manufacturers
General characteristics
Related development
A fixed-wing aircraft is a heavier-than-air flying machine, such as an airplane, which is capable of flight using wings that generate lift caused by the aircraft's forward airspeed and the shape of the wings. Fixed-wing aircraft are distinct from rotary-wing aircraft, and ornithopters. The wings of a fixed-wing aircraft are not necessarily rigid; kites, hang gliders, variable-sweep wing aircraft and airplanes that use wing morphing are all examples of fixed-wing aircraft.
A flying boat is a type of fixed-winged seaplane with a hull, allowing it to land on water. It differs from a floatplane in having a fuselage that is purpose-designed for floatation, while floatplanes rely on fuselage-mounted floats for buoyancy. It differs from an amphibious aircraft by lacking wheels, skis, or skids to land on a solid surface rather than water.
A seaplane is a powered fixed-wing aircraft capable of taking off and landing (alighting) on water. Seaplanes are usually divided into two categories based on their technological characteristics: floatplanes and flying boats; the latter are generally far larger and can carry far more. Seaplanes that can also take off and land on airfields are in a subclass called amphibious aircraft, or amphibians. Seaplanes were sometimes called hydroplanes, but currently this term applies instead to motor-powered watercraft that use the technique of hydrodynamic lift to skim the surface of water when running at speed.
A variable-sweep wing, colloquially known as a "swing wing", is an airplane wing, or set of wings, that may be swept back and then returned to its original straight position during flight. It allows the aircraft's shape to be modified in flight, and is therefore an example of a variable-geometry aircraft.
The Grumman XF10F Jaguar was a prototype swing-wing fighter aircraft offered to the United States Navy in the early 1950s. Although it never entered service, its research paved the way toward the later General Dynamics F-111 and Grumman's own F-14 Tomcat.
Waldo Dean Waterman was an inventor and aviation pioneer from San Diego, California. He developed a series of tailless swept-wing aircraft incorporating tricycle landing gear, culminating in a low-cost and simple-to-fly flying car.
A tandem wing is a wing configuration in which a flying craft or animal has two or more sets of wings set one behind another. All the wings contribute to lift.
The gull wing is an aircraft wing configuration, known also as Pulaski wings, with a prominent bend in the wing inner section towards the wing root. Its name is derived from the seabirds which it resembles. Numerous aircraft have incorporated such wings for a diverse range of purposes. The gull wing was commonly used to improve visibility in a high wing arrangement, because such wing could be thinnest by the fuselage, and in theory should limit pilot's view no more than A-pillars of a windscreen in a car body.
Charles Francis Walsh was an American pioneer aviator who died in a crash in Trenton, New Jersey.
The Messerschmitt P.1101 was a single-seat, single-jet fighter project of World War II, developed as part of the 15 July 1944 Emergency Fighter Program which sought a second generation of jet fighters for the Third Reich. A prominent feature of the P.1101 prototype was that the sweep angle of the wings could be changed before flight, a feature further developed in later variable-sweep aircraft such as the Bell X-5 and Grumman XF10F Jaguar.
Leonard Warden Bonney was a pioneering aviator with the Wright brothers.
In aeronautics, a canard is a wing configuration in which a small forewing or foreplane is placed forward of the main wing of a fixed-wing aircraft or a weapon. The term "canard" may be used to describe the aircraft itself, the wing configuration, or the foreplane. Canard wings are also extensively used in guided missiles and smart bombs.
The Curtiss No. 2, often known as the Reims Racer, was a racing aircraft built in the United States by Glenn Curtiss in 1909 to contest the Gordon Bennett Cup air race in Reims, France that year.
L'Oiseau Blanc was a French Levasseur PL.8 biplane that disappeared in 1927 during an attempt to make the first non-stop transatlantic flight between Paris and New York City to compete for the Orteig Prize. French World War I aviation heroes Charles Nungesser and François Coli took off from Paris on 8 May 1927 and were last seen over Ireland. Less than two weeks later, Charles Lindbergh successfully made the New York–Paris journey and claimed the prize in the Spirit of St. Louis.
The wing configuration of a fixed-wing aircraft is its arrangement of lifting and related surfaces.
The Loening S-1 Flying Yacht, also called the Loening Model 23, was an early light monoplane flying boat designed in the United States by Grover Loening in the early 1920s. The aircraft won the 1921 Collier Trophy.
The Kirkham Air Yacht, also called the Kirkham Gull, was an early monoplane executive transport seaplane.
The Oionus I was a tetrahedral triplane built for Alexander Graham Bell It was the culmination of Bell's experiments with kites built at Baddeck, Nova Scotia. The aircraft's design combined those of the Aerial Experiment Association (AEA)'s AEA Silver Dart biplane and his AEA Cygnet kite. It was Bell's final aviation pursuit and Canada's first and only triplane design. The aircraft attempted a test flight in March 1910, but failed to achieve flight.
The Curtiss-Reid Courier was designed in Canada in 1931 as a specialist, non-passenger carrying, mailplane capable of maintaining services in Canada's hard winters. The 1930s depression led to the end of government subsidised airmail contracts and only one prototype flew. It was lost in 1933 during preparations for a private, long distance flight.
Columbia Field, originally Curtiss Field, is a former airfield near Valley Stream within the Town of Hempstead on Long Island, New York. Between 1929 and 1933 it was a public airfield named Curtiss Field after the Curtiss-Wright aircraft corporation that owned it. The public airfield closed after 1933, but aircraft continued to be manufactured there primarily by Columbia Aircraft Corporation, which gave the private airfield its name.
Curtiss Field, Long Island, May 4, 1928. Leonard W. Bonney, pioneer aviator who learned to fly under Orville Wright in 1910, was fatally injured this afternoon in the first flight he had ever made with his Gull.