Carrier aggregation

Last updated

In wireless communication, carrier aggregation is a technique used to increase the data rate per user, whereby multiple frequency blocks (called component carriers) are assigned to the same user. [1] The maximum possible data rate per user is increased the more frequency blocks are assigned to a user. The sum data rate of a cell is increased as well because of a better resource utilization. In addition, load balancing [2] : p.42  is possible with carrier aggregation. Channel selection schemes for CA systems taking into account the optimal values for the training length and power, the number of the probed sub-channels and the feedback threshold such that the sum rate is also important for optimal achievable capacity. [3]

Contents

Types of carrier aggregation

Types of carrier aggregation CarrierAggregationTypes.svg
Types of carrier aggregation

Depending on the positions of the component carriers three cases of carrier aggregation are distinguished: [1] : p. 113 

There is no difference between these three cases from a baseband perspective. However, the complexity from an radio frequency (RF) point of view is increased in the case inter-band carrier aggregation.

Applications

UMTS/HSPA+

The channel bandwidth for UMTS/HSPA+ is about 3.8 MHz with a carrier spacing of 5 MHz. Carrier aggregation is also called Dual Cell in the context of UMTS/HSPA+.

Through carrier aggregation (part of the UMTS extension HSPA+) two downlink carriers may be assigned to one user since Release 8. Release 10 supports four-carrier aggregation and eight-carrier-aggregation is supported since Release 11. 3GPP standardized carrier aggregation for HSPA+ for the uplink for up to two component carriers since Release 9. [5] : p.157 

LTE/LTE-Advanced

LTE supports since its first release channel bandwidths of 1.4 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz and 20 MHz. Since LTE-Advanced Rel. 10 any two channels (of possibly different bandwidths) may be aggregated and be assigned to a single user. [2] : p.30  A difference between two aggregated 10 MHz component carriers and a single ordinary 20 MHz channel is that in the case of carrier aggregation the control information is transmitted on both component carriers.

LTE Advanced with carrier aggregation allows Gigabit LTE. This is made possible through higher-order modulation (256QAM), carrier aggregation and 4x4  MIMO. Since LTE Release 10 up to 5 component carriers may be aggregated, allowing for transmission bandwidths of up to 100 MHz. [1] : p.113  Using five aggregated component carriers, MIMO and 256QAM allows theoretical data rates of up to 2 gigabits per second. A management architecture that can aggregate particular systems, networks, and terminals in view of better managing the collection of available resources on a heterogeneous system level, taking into account all systems', networks', and terminals' traffic requirements and technical capabilities is considered for LTE-A system with potential deployment to 5G networks. [6]

Related Research Articles

<span class="mw-page-title-main">GSM</span> Cellular telephone network standard

The Global System for Mobile Communications (GSM) is a standard developed by the European Telecommunications Standards Institute (ETSI) to describe the protocols for second-generation (2G) digital cellular networks used by mobile devices such as mobile phones and tablets. GSM is also a trade mark owned by the GSM Association. GSM may also refer to the Full Rate voice codec.

<span class="mw-page-title-main">Orthogonal frequency-division multiplexing</span> Method of encoding digital data on multiple carrier frequencies

In telecommunications, orthogonal frequency-division multiplexing (OFDM) is a type of digital transmission used in digital modulation for encoding digital (binary) data on multiple carrier frequencies. OFDM has developed into a popular scheme for wideband digital communication, used in applications such as digital television and audio broadcasting, DSL internet access, wireless networks, power line networks, and 4G/5G mobile communications.

The Universal Mobile Telecommunications System (UMTS) is a third generation mobile cellular system for networks based on the GSM standard. Developed and maintained by the 3GPP, UMTS is a component of the International Telecommunication Union IMT-2000 standard set and compares with the CDMA2000 standard set for networks based on the competing cdmaOne technology. UMTS uses wideband code-division multiple access (W-CDMA) radio access technology to offer greater spectral efficiency and bandwidth to mobile network operators.

<span class="mw-page-title-main">WiMAX</span> Wireless broadband standard

Worldwide Interoperability for Microwave Access (WiMAX) is a family of wireless broadband communication standards based on the IEEE 802.16 set of standards, which provide physical layer (PHY) and media access control (MAC) options.

4G is the fourth generation of broadband cellular network technology, succeeding 3G and preceding 5G. A 4G system must provide capabilities defined by ITU in IMT Advanced. Potential and current applications include amended mobile web access, IP telephony, gaming services, high-definition mobile TV, video conferencing, and 3D television.

<span class="mw-page-title-main">Cellular network</span> Communication network

A cellular network or mobile network is a telecommunications network where the link to and from end nodes is wireless and the network is distributed over land areas called cells, each served by at least one fixed-location transceiver. These base stations provide the cell with the network coverage which can be used for transmission of voice, data, and other types of content. A cell typically uses a different set of frequencies from neighboring cells, to avoid interference and provide guaranteed service quality within each cell.

<span class="mw-page-title-main">Orthogonal frequency-division multiple access</span> Multi-user version of OFDM digital modulation

Orthogonal frequency-division multiple access (OFDMA) is a multi-user version of the popular orthogonal frequency-division multiplexing (OFDM) digital modulation scheme. Multiple access is achieved in OFDMA by assigning subsets of subcarriers to individual users. This allows simultaneous low-data-rate transmission from several users.

<span class="mw-page-title-main">E-UTRA</span> 3GPP interface

E-UTRA is the air interface of 3rd Generation Partnership Project (3GPP) Long Term Evolution (LTE) upgrade path for mobile networks. It is an acronym for Evolved UMTS Terrestrial Radio Access, also known as the Evolved Universal Terrestrial Radio Access in early drafts of the 3GPP LTE specification. E-UTRAN is the combination of E-UTRA, user equipment (UE), and a Node B.

<span class="mw-page-title-main">Femtocell</span> Small, low-power cellular base station

In telecommunications, a femtocell is a small, low-power cellular base station, typically designed for use in a home or small business. A broader term which is more widespread in the industry is small cell, with femtocell as a subset. It connects to the service provider's network via broadband ; current designs typically support four to eight simultaneously active mobile phones in a residential setting depending on version number and femtocell hardware, and eight to sixteen mobile phones in enterprise settings. A femtocell allows service providers to extend service coverage indoors or at the cell edge, especially where access would otherwise be limited or unavailable. Although much attention is focused on WCDMA, the concept is applicable to all standards, including GSM, CDMA2000, TD-SCDMA, WiMAX and LTE solutions.

<span class="mw-page-title-main">High Speed Packet Access</span> Communications protocols

High Speed Packet Access (HSPA) is an amalgamation of two mobile protocols—High Speed Downlink Packet Access (HSDPA) and High Speed Uplink Packet Access (HSUPA)—that extends and improves the performance of existing 3G mobile telecommunication networks using the WCDMA protocols. A further-improved 3GPP standard called Evolved High Speed Packet Access was released late in 2008, with subsequent worldwide adoption beginning in 2010. The newer standard allows bit rates to reach as high as 337 Mbit/s in the downlink and 34 Mbit/s in the uplink; however, these speeds are rarely achieved in practice.

<span class="mw-page-title-main">Mobile broadband</span> Marketing term

Mobile broadband is the marketing term for wireless Internet access via mobile networks. Access to the network can be made through a portable modem, wireless modem, or a tablet/smartphone or other mobile device. The first wireless Internet access became available in 1991 as part of the second generation (2G) of mobile phone technology. Higher speeds became available in 2001 and 2006 as part of the third (3G) and fourth (4G) generations. In 2011, 90% of the world's population lived in areas with 2G coverage, while 45% lived in areas with 2G and 3G coverage. Mobile broadband uses the spectrum of 225 MHz to 3700 MHz.

<span class="mw-page-title-main">Evolved High Speed Packet Access</span> Technical standard

Evolved High Speed Packet Access, HSPA+, HSPA (Plus) or HSPAP, is a technical standard for wireless broadband telecommunication. It is the second phase of HSPA which has been introduced in 3GPP release 7 and being further improved in later 3GPP releases. HSPA+ can achieve data rates of up to 42.2 Mbit/s. It introduces antenna array technologies such as beamforming and multiple-input multiple-output communications (MIMO). Beam forming focuses the transmitted power of an antenna in a beam towards the user's direction. MIMO uses multiple antennas at the sending and receiving side. Further releases of the standard have introduced dual carrier operation, i.e. the simultaneous use of two 5 MHz carriers. HSPA+ is an evolution of HSPA that upgrades the existing 3G network and provides a method for telecom operators to migrate towards 4G speeds that are more comparable to the initially available speeds of newer LTE networks without deploying a new radio interface. HSPA+ should not be confused with LTE though, which uses an air interface based on orthogonal frequency-division modulation and multiple access.

The United States 700 MHz FCC wireless spectrum auction, officially known as Auction 73, was started by the Federal Communications Commission (FCC) on January 24, 2008 for the rights to operate the 700 MHz radio frequency band in the United States. The details of process were the subject of debate among several telecommunications companies, including Verizon Wireless, AT&T Mobility, as well as the Internet company Google. Much of the debate swirled around the open access requirements set down by the Second Report and Order released by the FCC determining the process and rules for the auction. All bidding was required by law to commence by January 28.

<span class="mw-page-title-main">LTE Advanced</span> Mobile communication standard

LTE Advanced is a mobile communication standard and a major enhancement of the Long Term Evolution (LTE) standard. It was formally submitted as a candidate 4G to ITU-T in late 2009 as meeting the requirements of the IMT-Advanced standard, and was standardized by the 3rd Generation Partnership Project (3GPP) in March 2011 as 3GPP Release 10.

<span class="mw-page-title-main">LTE (telecommunication)</span> Standard for wireless broadband communication for mobile devices

In telecommunications, long-term evolution (LTE) is a standard for wireless broadband communication for mobile devices and data terminals, based on the GSM/EDGE and UMTS/HSPA standards. It improves on those standards' capacity and speed by using a different radio interface and core network improvements. LTE is the upgrade path for carriers with both GSM/UMTS networks and CDMA2000 networks. Because LTE frequencies and bands differ from country to country, only multi-band phones can use LTE in all countries where it is supported.

International Mobile Telecommunications-Advanced are the requirements issued by the ITU Radiocommunication Sector (ITU-R) of the International Telecommunication Union (ITU) in 2008 for what is marketed as 4G mobile phone and Internet access service.

The UMTS channels are communication channels used by third generation (3G) wireless Universal Mobile Telecommunications System (UMTS) networks. UMTS channels can be divided into three levels:

Long-Term Evolution (LTE) telecommunications networks use several frequency bands with associated bandwidths.

Frequency bands for 5G New Radio, which is the air interface or radio access technology of the 5G mobile networks, are separated into two different frequency ranges. First there is Frequency Range 1 (FR1), which includes sub-6 GHz frequency bands, some of which are traditionally used by previous standards, but has been extended to cover potential new spectrum offerings from 410 MHz to 7125 MHz. The other is Frequency Range 2 (FR2), which includes frequency bands from 24.25 GHz to 71.0 GHz. Frequency bands are also available for non-terrestrial networks in the sub-6 GHz range.

5G NR is a new radio access technology (RAT) developed by the 3rd Generation Partnership Project (3GPP) for the 5G mobile network. It was designed to be the global standard for the air interface of 5G networks. It is based on orthogonal frequency-division multiplexing (OFDM), as is the 4G long-term evolution (LTE) standard.

References

  1. 1 2 3 Dahlman, Erik; Parkvall, Stefan; Sköld, Johann (2014). 4G LTE / LTE-Advanced for Mobile Broadband. Elsevier. ISBN   9780124199859.
  2. 1 2 Holma, Harri; Toskala, Antti; Tapia, Pablo (2012). LTE-Advanced: 3GPP Solution for IMT-Advanced. Wiley. ISBN   9781119974055.
  3. ↑ S. C. G. Tsinos, F. Foukalas, T. Khattab and L. Lai "On Channel Selection for Carrier Aggregation Systems." IEEE Transactions on Communications, 66(2), Sep.2017, 808-818.
  4. ↑ F. Foukalas and T. Tsiftsis, "Energy Efficient Power Allocation for Carrier Aggregation in Heterogeneous Networks: Partial Feedback and Circuit Power Consumption." IEEE Transactions on Green Communications and Networking, vol. 2, no. 3, Sept. 2018 ) 623-634.
  5. ↑ Holma, Harri; Toskala, Antti; Tapia, Pablo (2014). HSPA+ Evolution to Release 12. Wiley. ISBN   9781118503218.
  6. ↑ S. O. Holland, A. Aijaz, F. Kaltenberger, F. Foukalas, G. Vivier, M. Buczkowski and S. Pietrzyk "Management architecture for aggregation of heterogeneous systems and spectrum bands." IEEE Communications Magazine, vol. 54, no. 9, Sep. 2016 ) 112- 118.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.