Flats boat

Last updated
Flats boat with poling platform Small center console fishing boat anchored near a beach in The Bahamas.jpg
Flats boat with poling platform

Flats boats are a category of boat designed primarily for fishing in protected, shallow water areas [1] often referred to as "flats" by anglers. [2]

Contents

While the name may be misconstrued to mean the boat hull is flat, this is not generally the case and include various v-hull designs. [3] However some flats boats designs, sometimes called skiffs are truly a flat-bottomed boat design. [4]

The deadrise (which, simplified, is a measure of the angle of bottom in v-hull boats) of most flats boats is generally a small angle because larger deadrise often requires more water displacement which increase the boat's draft and is not desirable for flats boats in shallow water. However, lower deadrise may produce a rougher ride in choppy water than a comparable boat with larger deadrise angle. [5]

Common Features

Flats boats are often small easily trailerable boats although some may reach up to 23 ft in length [6] or more. They are typically equipped with outboard motors and offer a relatively shallow draft compared to other boats of the same length, to allow for passage over sandbars, oyster beds or other submerged objects or underwater features with less risk of damaging the hull or engine.

Some flats boats may be equipped with features such as a "jack plate" which allow the operator of the boat to lift the outboard vertically in addition to the tilt and trim mechanisms generally offered by many outboard motors. [7] They may also be equipped with trim tabs. Both jack plates and trim tabs can offer an advantage in shallow water starts to plane among other uses. Additionally, some flats boats may be equipped with a "poling platform" which allows for a fishing guide or other person to push the boat in shallow water while an angler fishes from the bow. [8]

Flats boats may be designed as an open cockpit and tiller controlled outboard motor, a side console or center console.

Micro-skiffs

Micro-skiffs (which are, generally, a smaller and lighter, no-frills design similar to a number of flats boats) may be considered by some as a subcategory of flats boat. [9]

Safety Concerns

Some concerns have been raised about the safety of certain designs of flats boats, particularly the tunnel vee, according to a USCG study in 2013. [6]

Tunnel vee boats, sometimes referred to as tunnel hull boats, are a design in which the center of the boat hull is essentially cut out for some length into a shape which may be somewhat similar to a catamaran in that in that section the boat hull may resemble sponsons instead of coming to a "vee" shape at the bottom. This design allows for mounting (or raising with a jack plate) the outboard motor higher while still allowing significant water flow to the propeller and the motor's cooling water intake. One advantage of this design is when operating the boat at speed in shallow waters with the engine raised where there is less restriction for the upward flow of water to the outboard motor's cooling water intake.

See also

Related Research Articles

<span class="mw-page-title-main">Outboard motor</span> Self-contained propulsion system for boats

An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft. As well as providing propulsion, outboards provide steering control, as they are designed to pivot over their mountings and thus control the direction of thrust. The skeg also acts as a rudder when the engine is not running. Unlike inboard motors, outboard motors can be easily removed for storage or repairs.

<span class="mw-page-title-main">Dory</span> Type of boat

A dory is a small, shallow-draft boat, about 5 to 7 metres or 16 to 23 feet long. It is usually a lightweight boat with high sides, a flat bottom and sharp bows. It is easy to build because of its simple lines. For centuries, the dory has been used as a traditional fishing boat, both in coastal waters and in the open sea.

<span class="mw-page-title-main">Rigid inflatable boat</span> Boat with rigid hull and inflatable tubes

A rigid inflatable boat (RIB), also rigid-hull inflatable boat or rigid-hulled inflatable boat (RHIB), is a lightweight but high-performance and high-capacity boat constructed with a rigid hull bottom joined to side-forming air tubes that are inflated with air to a high pressure so as to give the sides resilient rigidity along the boat's topsides. The design is stable, light, fast and seaworthy. The inflated collar acts as a life jacket, ensuring that the vessel retains its buoyancy, even if the boat is taking on water. The RIB is an evolutionary development of the inflatable boat with a rubberized fabric bottom that is stiffened with flat boards within the collar to form the deck or floor of the boat.

<span class="mw-page-title-main">Motorboat</span> Boat which is powered by an engine

A motorboat, speedboat or powerboat is a boat that is exclusively powered by an engine.

A chine in boat design is a sharp change in angle in the cross section of a hull. The chine typically arises from the use of sheet materials as the mode of construction.

<span class="mw-page-title-main">Johnboat</span>

A johnboat is a flat-bottomed boat constructed of aluminum, fiberglass, wood, or polyethelene with one, two, or three seats, usually bench type. They are suitable for fishing, hunting and cruising. The nearly flat hull of a johnboat tends to ride over the waves rather than cut through them as a V-hull might; this shallow draft – only a few inches – enables the johnboat to operate in very shallow water, but limits its use to calm waters. Johnboats typically have a transom onto which an outboard motor can be mounted. They are simple and easy to maintain, and inexpensive, though with many options to upgrade. Typical options may include live wells/bait wells, side or center consoles, factory installed decks and floors, electrical wiring, accessory pads/mountings, and casting and poling platforms.

<span class="mw-page-title-main">Center console (boat)</span> Type of boat

Center console sometimes abbreviated as CC, is a type of single-decked open hull boat where the helm is in the center. There is a cabin on some models; these are usually located in the bow and hold small berths for sleeping. Small berths may also be located inside the console and under the deck of larger center console boats. An advantage of this type of boat, especially in fishing, underway, and at rest, is that person can walk all around the boat from stern to bow with ease which aids in various activities by removing obstacles which may be encountered with other boat designs.

<span class="mw-page-title-main">Fishing vessel</span> Boat or ship used to catch fish on a body of water

A fishing vessel is a boat or ship used to catch fish in the sea, or on a lake or river. Many different kinds of vessels are used in commercial, artisanal and recreational fishing.

<span class="mw-page-title-main">Recreational boat fishing</span> Recreational fishing on water vessels

Recreational fishermen usually fish either from a boat or from a shoreline or river bank. When fishing from a boat, or fishing vessel, most fishing techniques can be used, from nets to fish traps, but some form of angling is by far the most common. Compared to fishing from the land, fishing from a boat allows more access to different fishing grounds and different species of fish.

<span class="mw-page-title-main">Panga (skiff)</span>

The panga is a type of modest-sized, open, outboard-powered, fishing boat common throughout much of the developing world, including Central America, the Caribbean, parts of Africa, the Middle East, and much of Asia. The original panga design was developed by Yamaha as part of a World Bank project circa 1970. Pangas are commonly operated directly off beaches. The name comes from the panga fish, which is commonly netted. The upswept bow of the boat resembles the machete or knife called a panga.

<span class="mw-page-title-main">Bass boat</span> Motor powered boat

A bass boat is a small boat that is designed and equipped primarily for bass fishing, usually in freshwater bodies such as lakes, rivers and wetlands. The modern bass boats are motorboats that feature an elevated flat front deck with swivel chairs that permit the angler to readily cast to any direction around the boat, large storage containers for fishing tackles and equipment such as rods, reels and lures, high-performance fishfinders, and a recirculating livewell where caught fish may be stored and kept alive for prolonged periods of time.

The Dovekie 21, often called just the Dovekie, is an American sailing dinghy, named for the sea bird. It was designed by Phil Bolger as a cruiser and first built in 1978.

The Bay Hen 21 is an American trailerable sailboat that was designed by Reuben Trane as a pocket cruiser and first built in 1984.

Flats fishing is a method of fishing where anglers target species of fish specifically in shallow, saltwater bodies of water.

The Herreshoff America, also called the Herreshoff America 18, is an American trailerable sailboat that was designed by Halsey Chase Herreshoff as a cruiser and first built in 1971.

The Menger Oysterman 23 is an American trailerable skipjack that was designed by Bill Menger as a daysailer and cruiser and first built in 1977.

The Nimble 25 Arctic, also called just the Nimble 25, is an American trailerable sailboat that was designed by Ted Brewer as a cruiser and first built in 1988.

The Balboa 26 is an American trailerable sailboat that was designed by Lyle C. Hess as cruiser and first built in 1969.

The S2 6.8 is an American trailerable sailboat that was designed by Don Wennersten and Arthur Edmunds as a racer-cruiser and first built in 1976. The designation indicates the approximate length overall in meters.

The Terrapin 24 is an American trailerable sailboat that was designed by Dave Westphal as a cruiser and first built in 1973.

References

  1. Mack, Ben (2009-07-07). "Crossing a Very Big Sea In a Very Small Boat". Wired. ISSN   1059-1028 . Retrieved 2020-05-27.
  2. "How to Fish the Flats". Sport Fishing Magazine. 26 January 2017. Retrieved 2020-06-02.
  3. "Best Flats Boats". Salt Water Sportsman. 5 February 2016. Retrieved 2020-05-27.
  4. "A Second for the Shallows". Florida Sportsman. 2013-06-19. Retrieved 2020-06-02.
  5. "What is Deadrise on a Boat? Boat Deadrise Explained". Boating Magazine. 6 January 2010. Retrieved 2020-06-02.
  6. 1 2 Wray, Dianna (2016-12-13). "As Regulation Lags, Texas Flats Boat Casualties Mount". Houston Press. Retrieved 2020-05-27.
  7. "Inshore/Coastal: 2020 Boat Buyers Guide". Sport Fishing Magazine. 17 December 2019. Retrieved 2020-06-02.
  8. "Andros Island: An Offshore and Inshore Fishing Mecca". Sport Fishing Magazine. 14 May 2020. Retrieved 2020-05-27.
  9. "Saltwater Fishing Boat Reviews, Tips & Maintenance". Sport Fishing Magazine. Retrieved 2020-05-27.