Muddy flood

Last updated
Muddy flood occurring in Chaumont-Gistoux, Belgium Orage 05-05-2006 008.jpg
Muddy flood occurring in Chaumont-Gistoux, Belgium

A muddy flood is produced by an accumulation of run-off over agricultural land. Sediments are picked up by the run-off and carried as suspended matter or bed-load. Muddy floods are typically a hill-slope process, and should not be confused with mudflows produced by mass movements.

Contents

Muddy floods can damage the road infrastructure and may deposit layers of mud blanket and may also clog sewers and damage private property.

It has been referred to 'muddy floods' since the 1980s. [1] A similar designation appeared in French ('inondations boueuses' [2] ) during the same period.

Muddy flood generation

Difference of soil cover by vegetation for two crops (winter wheat vs. maize) at the end of May, in central Belgium Cultures-Ath.jpg
Difference of soil cover by vegetation for two crops (winter wheat vs. maize) at the end of May, in central Belgium

Muddy runoff is generated on agricultural land when the soil surface is exposed or sparsely covered by vegetation. Large quantities of run-off usually generated by heavy storms is needed to start such a flood. [3]

Muddy flood occurrence

Muddy floods have been observed in the entire European loess belt. Other affected areas include Normandy and Picardy (France), central Belgium and southern Limburg, the Netherlands.

Muddy floods have also been observed in Slovakia and Poland.

Temporal evolution

An increase in muddy flood frequency has been observed during the last twenty years (e.g. in central Belgium, [4] ). This increase in their frequency may be due to a number of factors including:

Control measures

Grassed waterway during a beautiful day in Velm, Belgium Chenal-beautemps.jpg
Grassed waterway during a beautiful day in Velm, Belgium
Grassed waterway in Velm, Belgium, after a thunderstorm Chenal-mauvaistemps.jpg
Grassed waterway in Velm, Belgium, after a thunderstorm

Preventive measures consist in limiting runoff generation and sediment production at the source. Alternative farming practices (e.g. reduced tillage) to increase runoff infiltration and limit erosion in their fields may assist.

Curative measures generally consist in installing retention ponds at the boundary between cropland and inhabited areas. [5]

An alternative is to apply other measures than can be referred to as intermediate measures. Grass buffer strips along or within fields, a grassed waterway (in the thalwegs of dry valleys) or earthen dams are good examples of this type of measures. They act as a buffer within landscape, retaining runoff temporarily and trapping sediments. [6]

Implementation of these measures is best coordinated at the catchment scale.

See also

Related Research Articles

Erosion Natural processes that remove soil and rock

Erosion is the action of surface processes that removes soil, rock, or dissolved material from one location on the Earth's crust, and then transports it to another location where it is deposited. Erosion is distinct from weathering which involves no movement. Removal of rock or soil as clastic sediment is referred to as physical or mechanical erosion; this contrasts with chemical erosion, where soil or rock material is removed from an area by dissolution. Eroded sediment or solutes may be transported just a few millimetres, or for thousands of kilometres.

Soil erosion Displacement of soil by water, wind, and lifeforms

Soil erosion is the denudation of the upper layer of soil. It is a form of soil degradation. This natural process is caused by the dynamic activity of erosive agents, that is, water, ice (glaciers), snow, air (wind), plants, and animals. In accordance with these agents, erosion is sometimes divided into water erosion, glacial erosion, snow erosion, wind (aeolean) erosion, zoogenic erosion and anthropogenic erosion such as tillage erosion. Soil erosion may be a slow process that continues relatively unnoticed, or it may occur at an alarming rate causing a serious loss of topsoil. The loss of soil from farmland may be reflected in reduced crop production potential, lower surface water quality and damaged drainage networks. Soil erosion could also cause sinkholes.

Interior Plains Physiographic and geologic region of the United States and Canada

The Interior Plains are a vast physiographic region that spreads across the Laurentian craton of central North America, extending along the east flank of the Rocky Mountains from the Gulf Coast region to the Arctic Beaufort Sea. In Canada, it encompasses the Canadian Prairies separating the Canadian Rockies from the Canadian Shield, as well as the Boreal Plains and Taiga Plains east of the Mackenzie and Richardson Mountains; while in the United States, it includes the Great Plains of the West/Midwest and the tallgrass prairie region to the south of the Great Lakes extending east to the Appalachian Plateau region.

Buffer zone Intermediate region, typically between belligerent entities

A buffer zone is a neutral zonal area that lies between two or more bodies of land, usually pertaining to countries. Depending on the type of buffer zone, it may serve to separate regions or conjoin them. Common types of buffer zones are demilitarized zones, border zones and certain restrictive easement zones and green belts. Such zones may be comprised by a sovereign state, forming a buffer state.

Palouse Geographic region of Northwestern United States dominated by wheat-based agriculture

The Palouse is a distinct geographic region of the northwestern United States, encompassing parts of north central Idaho, southeastern Washington, and, by some definitions, parts of northeast Oregon. It is a major agricultural area, primarily producing wheat and legumes. Situated about 160 miles (260 km) north of the Oregon Trail, the region experienced rapid growth in the late 19th century.

Soil conservation Preservation of soil nutrients

Soil conservation is the prevention of loss of the top most layer of the soil from erosion or prevention of reduced fertility caused by over usage, acidification, salinization or other chemical soil contamination.

Retention basin Artificial pond for stormwater runoff

A retention basin, sometimes called a wet pond,wet detention basin, or stormwater management pond (SWMP), is an artificial pond with vegetation around the perimeter, and includes a permanent pool of water in its design. It is used to manage stormwater runoff, for protection against flooding, for erosion control, and to improve water quality in an adjacent bodies of water.

Riparian zone Interface between land and a river or stream

A riparian zone or riparian area is the interface between land and a river or stream. Riparian is also the proper nomenclature for one of the terrestrial biomes of the Earth. Plant habitats and communities along the river margins and banks are called riparian vegetation, characterized by hydrophilic plants. Riparian zones are important in ecology, environmental resource management, and civil engineering because of their role in soil conservation, their habitat biodiversity, and the influence they have on fauna and aquatic ecosystems, including grasslands, woodlands, wetlands, or even non-vegetative areas. In some regions, the terms riparian woodland, riparian forest, riparian buffer zone,riparian corridor, and riparian strip are used to characterize a riparian zone. The word riparian is derived from Latin ripa, meaning "river bank".

Nonpoint source pollution Pollution resulting from multiple sources

Nonpoint source (NPS) pollution refers to diffuse contamination of water or air that does not originate from a single discrete source. This type of pollution is often the cumulative effect of small amounts of contaminants gathered from a large area. It is in contrast to point source pollution which results from a single source. Nonpoint source pollution generally results from land runoff, precipitation, atmospheric deposition, drainage, seepage, or hydrological modification where tracing pollution back to a single source is difficult. Nonpoint source water pollution affects a water body from sources such as polluted runoff from agricultural areas draining into a river, or wind-borne debris blowing out to sea. Nonpoint source air pollution affects air quality, from sources such as smokestacks or car tailpipes. Although these pollutants have originated from a point source, the long-range transport ability and multiple sources of the pollutant make it a nonpoint source of pollution; if the discharges were to occur to a body of water or into the atmosphere at a single location, the pollution would be single-point.

Rill Shallow channel cut by water

In hillslope geomorphology, a rill is a shallow channel cut into soil by the erosive action of flowing water. Similar but smaller incised channels are known as microrills; larger incised channels are known as gullies.

Surface runoff Flow of excess rainwater not infiltrating in the ground over its surface

Surface runoff is the flow of water occurring on the ground surface when excess rainwater, stormwater, meltwater, or other sources, can no longer sufficiently rapidly infiltrate in the soil. This can occur when the soil is saturated by water to its full capacity, and the rain arrives more quickly than the soil can absorb it. Surface runoff often occurs because impervious areas do not allow water to soak into the ground. Furthermore, runoff can occur either through natural or man-made processes. Surface runoff is a major component of the water cycle. It is the primary agent of soil erosion by water. The land area producing runoff that drains to a common point is called a drainage basin.

Conservation Reserve Program U.S. federal aid program

The Conservation Reserve Program (CRP) is a cost-share and rental payment program of the United States Department of Agriculture (USDA). Under the program, the government pays farmers to take certain agriculturally used croplands out of production and convert them to vegetative cover, such as cultivated or native bunchgrasses and grasslands, wildlife and pollinators food and shelter plantings, windbreak and shade trees, filter and buffer strips, grassed waterways, and riparian buffers. The purpose of the program is to reduce land erosion, improve water quality and effect wildlife benefits.

Buffer strip

A buffer strip is an area of land maintained in permanent vegetation that helps to control air quality, soil quality, and water quality, along with other environmental problems, dealing primarily on land that is used in agriculture. Buffer strips trap sediment, and enhance filtration of nutrients and pesticides by slowing down surface runoff that could enter the local surface waters. The root systems of the planted vegetation in these buffers hold soil particles together which alleviate the soil of wind erosion and stabilize stream banks providing protection against substantial erosion and landslides. Farmers can also use buffer strips to square up existing crop fields to provide safety for equipment while also farming more efficiently.

Riparian buffer

A riparian buffer or stream buffer is a vegetated area near a stream, usually forested, which helps shade and partially protect the stream from the impact of adjacent land uses. It plays a key role in increasing water quality in associated streams, rivers, and lakes, thus providing environmental benefits. With the decline of many aquatic ecosystems due to agriculture, riparian buffers have become a very common conservation practice aimed at increasing water quality and reducing pollution.

Grassed waterway

A grassed waterway is a 2-metre (6.6 ft) to 48-metre-wide native grassland strip of green belt. It is generally installed in the thalweg, the deepest continuous line along a valley or watercourse, of a cultivated dry valley in order to control erosion. A study carried out on a grassed waterway during 8 years in Bavaria showed that it can lead to several other types of positive impacts, e.g. on biodiversity.

A Vegetative Treatment System (VTS) is a combination of treatment steps for managing runoff. It treats runoff by settling, infiltrating, and nutrient usage. Individual components of a VTS include, a settling structure, an outlet structure, a distribution system, and a Vegetative Treatment Area (VTA). All these components when used together are considered to be a Vegetative Treatment System.

Mississippi Alluvial Plain (ecoregion) Ecoregion in the southern United States

The Mississippi Alluvial Plain is a Level III ecoregion designated by the Environmental Protection Agency (EPA) in seven U.S. states, though predominantly in Arkansas, Louisiana, and Mississippi. It parallels the Mississippi River from the Midwestern United States to the Gulf of Mexico.

May Shoate River in the Tembien highlands of Ethiopia

May Sho’ate is a river of the Nile basin. Rising in the mountains of Dogu’a Tembien in northern Ethiopia, it flows southward to empty finally in Giba and Tekezé River.

Western Corn Belt Plains

The Western Corn Belt Plains is a Level III ecoregion designated by the Environmental Protection Agency (EPA) in seven U.S. states, though predominantly in Iowa.

Loess Plateau Plateau in north/northwest China

The Chinese Loess Plateau, or simply the Loess Plateau, is a plateau in north-central China formed of loess, a clastic silt-like sediment formed by the accumulation of wind-blown dust. It is located southeast of the Gobi Desert and is surrounded by the Yellow River. It includes parts of the Chinese provinces of Gansu, Shaanxi and Shanxi. The depositional setting of the Chinese Loess Plateau was shaped by the tectonic movement in the Neogene period, after which strong southeast winds caused by the East Asian Monsoon transported sediment to the plateau during the Quaternary period. The three main morphological types in the Loess Plateau are loess platforms, ridges and hills, formed by the deposition and erosion of loess. Most of the loess comes from the Gobi Desert and other nearby deserts. The sediments were transported to the Loess Plateau during interglacial periods by southeasterly prevailing winds and winter monsoon winds. After the deposition of sediments on the plateau, they were gradually compacted to form loess under the arid climate.

References

  1. Boardman, J. (1984). Soil erosion and flooding on downland areas. The Surveyor, 164, 8-11.
  2. Auzet, A.V. (1987). L'érosion des sols cultivés en France sous l'action du ruissellement. Annales de Géographie, 537, 529-555.
  3. Evrard, O., Vandaele, K., Bielders, C.L., van Wesemael, B. (2008). Seasonal evolution of runoff generation on agricultural land in the Belgian loess belt and implications for muddy flood triggering. Earth Surface Processes & Landforms 33(8), 1285-1301.
  4. Evrard, O., Bielders, C., Vandaele, K., van Wesemael, B. (2007). Spatial and temporal variation of muddy floods in central Belgium, off-site impacts and potential control measures. Catena 70 (3), 443-454.
  5. Verstraeten, G., Poesen, J., (2001). The nature of small-scale flooding, muddy floods and retention pond sedimentation in central Belgium. Geomorphology, 29, 275–292.
  6. Evrard, O., Vandaele, K., van Wesemael, B., Bielders, C.L, 2008. A grassed waterway and earthen dams to control muddy floods from a cultivated catchment of the Belgian loess belt. Geomorphology 100, 419-428.