Spar varnish

Last updated

Spar varnish (occasionally also called boat varnish or yacht varnish) is a wood-finishing varnish, originally developed for coating the spars of sailing ships, which formed part of the masts and rigging. These had to withstand rough condition, being flexed by the wind loads they supported, attacked by sea and bad weather, and suffering from UV degradation from long-term exposure to sunlight.

The most important condition for such varnishes was resistance to flexing. This required a varnish that was flexible and elastic. Without elasticity, the varnish would soon crack, allowing water to penetrate the wood beneath. Prior to the development of modern polymer chemistry, varnish production was rudimentary. Originally, spar varnish was a "long oil" varnish, composed primarily of drying oil with a small proportion of resin, usually boiled linseed oil and rosin. [1] This gave flexibility, [2] even though its weather resistance was still poor, and thus re-coating was required relatively frequently.

In modern times, "spar varnish" has become a genericised term in North America for any outdoor wood finish. Owing to modern varnish materials, their weather and UV resistance is likely to be good, but the original requirement for flexibility has largely been forgotten.[ citation needed ] A common form of modern spar varnish is spar urethane, a polyurethane-based finish intended for outdoor use, where sunlight-, heat-, and water-resistance are desirable qualities.[ citation needed ]

See also

Related Research Articles

<span class="mw-page-title-main">Paint</span> Pigment applied over a surface that dries as a solid film

Paint is any pigmented liquid, liquefiable, or solid mastic composition that, after application to a substrate in a thin layer, converts to a solid film. It is most commonly used to protect, color, or provide texture. Paint can be made in many colors—and in many different types. Paint is typically stored, sold, and applied as a liquid, but most types dry into a solid. Most paints are either oil-based or water-based and each has distinct characteristics. For one, it is illegal in most municipalities to discard oil-based paint down household drains or sewers. Clean-up solvents are also different for water-based paint than they are for oil-based paint. Water-based paints and oil-based paints will cure differently based on the outside ambient temperature of the object being painted. Usually, the object being painted must be over 10 °C (50 °F), although some manufacturers of external paints/primers claim they can be applied when temperatures are as low as 2 °C (35 °F).

<span class="mw-page-title-main">Shellac</span> Resin secreted by the female lac bug

Shellac is a resin secreted by the female lac bug on trees in the forests of India and Thailand. Chemically, it is mainly composed of aleuritic acid, jalaric acid, shellolic acid, and other natural waxes. It is processed and sold as dry flakes and dissolved in alcohol to make liquid shellac, which is used as a brush-on colorant, food glaze and wood finish. Shellac functions as a tough natural primer, sanding sealant, tannin-blocker, odour-blocker, stain, and high-gloss varnish. Shellac was once used in electrical applications as it possesses good insulation qualities and seals out moisture. Phonograph and 78 rpm gramophone records were made of shellac until they were replaced by vinyl long-playing records from 1948 onwards.

<span class="mw-page-title-main">Plywood</span> Manufactured wood panel made from thin sheets of wood veneer

Plywood is a material manufactured from thin layers or "plies" of wood veneer that are glued together with adjacent layers having their wood grain rotated up to 90 degrees to one another. It is an engineered wood from the family of manufactured boards which include medium-density fibreboard (MDF), oriented strand board (OSB) and particle board (chipboard).

<span class="mw-page-title-main">Floor</span> Walking surface of a room

A floor is the bottom surface of a room or vehicle. Floors vary from simple dirt in a cave to many layered surfaces made with modern technology. Floors may be stone, wood, bamboo, metal or any other material that can support the expected load.

<span class="mw-page-title-main">Varnish</span> Transparent hard protective finish or film

Varnish is a clear transparent hard protective coating or film. It is not a stain. It usually has a yellowish shade due to the manufacturing process and materials used, but it may also be pigmented as desired. It is sold commercially in various shades.

<span class="mw-page-title-main">Lacquer</span> Liquid or powder coating material which is applied thinly to objects to form a hard finish

Lacquer is a type of hard and usually shiny coating or finish applied to materials such as wood or metal. It is most often made from resin extracted from trees and waxes and has been in use since antiquity.

<span class="mw-page-title-main">Teak</span> Tree species native to south and southeast Asia

Teak is a tropical hardwood tree species in the family Lamiaceae. It is a large, deciduous tree that occurs in mixed hardwood forests. Tectona grandis has small, fragrant white flowers arranged in dense clusters (panicles) at the end of the branches. These flowers contain both types of reproductive organs. The large, papery leaves of teak trees are often hairy on the lower surface. Teak wood has a leather-like smell when it is freshly milled and is particularly valued for its durability and water resistance. The wood is used for boat building, exterior construction, veneer, furniture, carving, turnings, and other small wood projects.

<span class="mw-page-title-main">Boat building</span> Design and construction of floating vessels

Boat building is the design and construction of boats and their systems. This includes at a minimum a hull, with propulsion, mechanical, navigation, safety and other systems as a craft requires.

<span class="mw-page-title-main">Linoleum</span> Type of floor covering

Linoleum, sometimes shortened to lino, is a floor covering made from materials such as solidified linseed oil (linoxyn), pine resin, ground cork dust, sawdust, and mineral fillers such as calcium carbonate, most commonly on a burlap or canvas backing. Pigments are often added to the materials to create the desired colour finish. Commercially, the material has been largely replaced by sheet vinyl flooring, although in the UK this is often still referred to as lino.

<span class="mw-page-title-main">Flat roof</span> Type of roof

A flat roof is a roof which is almost level in contrast to the many types of sloped roofs. The slope of a roof is properly known as its pitch and flat roofs have up to approximately 10°. Flat roofs are an ancient form mostly used in arid climates and allow the roof space to be used as a living space or a living roof. Flat roofs, or "low-slope" roofs, are also commonly found on commercial buildings throughout the world. The U.S.-based National Roofing Contractors Association defines a low-slope roof as having a slope of 3 in 12 (1:4) or less.

<span class="mw-page-title-main">Wood stain</span> Type of paint used to colour wood

Wood stain is a type of paint used to colour wood and consists of colourants dissolved and/or suspended in a 'vehicle' or solvent. Vehicle is the preferred term, as the contents of a stain may not be truly dissolved in the vehicle, but rather suspended, and thus the vehicle may not be a true solvent. The vehicle often may be water, alcohol, a petroleum distillate, or a finishing agent such as shellac, lacquer, varnish and polyurethane. Coloured or stained finishes do not typically deeply penetrate the pores of the wood and may largely disappear when the finish deteriorates or is removed.

<span class="mw-page-title-main">Primer (paint)</span> Preparatory coating put on materials before painting

A primer or undercoat is a preparatory coating put on materials before painting. Priming ensures better adhesion of paint to the surface, increases paint durability, and provides additional protection for the material being painted.

<span class="mw-page-title-main">Wood finishing</span> Process of refining or protecting a wooden surface

Wood finishing refers to the process of refining or protecting a wooden surface, especially in the production of furniture where typically it represents between 5 and 30% of manufacturing costs.

Conformal coating is a protective coating of thin polymeric film applied to printed circuit boards (PCB). The coating is named conformal since it conforms to the contours of the PCB. Conformal coatings are typically applied at 25-250 μm to the electronic circuitry and provides protection against moisture, dust, chemicals and temperature extremities.

<span class="mw-page-title-main">Sealant</span> Substance used to block the passage of fluids through openings

Sealant is a substance used to block the passage of fluids through openings in materials, a type of mechanical seal. In building construction sealant is sometimes synonymous with caulk and also serve the purposes of blocking dust, sound and heat transmission. Sealants may be weak or strong, flexible or rigid, permanent or temporary. Sealants are not adhesives but some have adhesive qualities and are called adhesive-sealants or structural sealants.

<span class="mw-page-title-main">Decorative concrete</span>

Decorative concrete is the use of concrete as not simply a utilitarian medium for construction but as an aesthetic enhancement to a structure, while still serving its function as an integral part of the building itself such as floors, walls, driveways, and patios.

<span class="mw-page-title-main">Wood flooring</span>

Wood flooring is any product manufactured from timber that is designed for use as flooring, either structural or aesthetic. Wood is a common choice as a flooring material and can come in various styles, colors, cuts, and species. Bamboo flooring is often considered a form of wood flooring, although it is made from bamboo rather than timber.

<span class="mw-page-title-main">Aircraft fabric covering</span> Material and method used to cover open aircraft structures

Aircraft fabric covering is a term used for both the material used and the process of covering aircraft open structures. It is also used for reinforcing closed plywood structures. The de Havilland Mosquito is an example of this technique, as are the pioneering all-wood monocoque fuselages of certain World War I German aircraft like the LFG Roland C.II in its wrapped Wickelrumpf plywood strip and fabric covering.

A finishing oil is a vegetable oil used for wood finishing.

References

  1. Allen, Sam (1995). Classic Finishing Techniques. New York: Sterling Publishing. p. 70. ISBN   0-8069-0513-1.
  2. Haynes, Williams (1946). "XIX: Materials for To-morrow". This Chemical Age. London: Secker and Warburg. p. 247.