Split magnet

Last updated

A Split Magnet is a resistive [1] electromagnet that is separated into two halves, with the small gap that divides the two sides allowing access to a strong magnetic field. The combination of an accessible gap and strong magnetic field allows for the research of how far-infrared particles scatter. [2] In addition, the magnet can also rotate up to 90°, [1] allowing for the magnet to become parallel to the floor. The magnet uses a combination of 28 MW, a current of 160,000 amps and 13380 liters of water (for cooling purposes) per minute used. [2] The strongest (and only) split helix magnet in the world is currently located in Florida State University at the National High Magnetic Field Laboratory, and can generate a field of 25 Tesla. [2]

Contents

Applications

The magnet is well suited for studies into far-infrared scattering experiments, [2] allowing for insight into the properties of certain materials. This includes the material’s electronic structure, which determines its usefulness in electronics. This information can be used to further the development of smaller, more efficient computers. [1]

However, the magnet is not limited to just infrared scattering experiments and can be used for much more, such as Fourier-transform infrared spectroscopy and Electron paramagnetic resonance. [1] These techniques allow for a greater understanding of different materials, with applications ranging from analysis of biological compounds to microscopic imaging.

As recently as 2019, an additional function has been added to the magnet, an “Ultrafast Time-Domain Spectrometer”. [3] This spectrometer can withstand the 25 tesla magnetic fields produced by the magnet and allows for precise control over the material's charge, lattice, orbital, and spin degrees of freedom. This is especially useful for two dimensional materials (such as semiconductor wafers), as the spectrometer can analyze them in time frames around 200 femtoseconds, [3] which is significantly shorter than what traditional systems use.

Development

The concept of the magnet began in 2005 [2] as a request for a resistive magnet that could operate from 25-30 tesla with a split down the middle to give more access during experiments and research. Development of the device took place at the National High Magnetic Field Laboratory and took approximately 4 years to build, with prototypes being tested in 2007. [4] To facilitate this design the team behind the magnet developed a new kind of component, the "Split Florida-Helix", to help deal with the immense stress and pressure the vacuum and magnet apply on the structure. The Split Florida-Helix is a unique component of the magnet that allows for an open vacuum space to exist in the magnet. [4] Normally, only conductive material and water cooling tubes would be present in the area where the Split Florida-Helix resides, but because of the special design over 50% of this space is now opened up for access, while still being able to account for the various forces and torques that would be applied. [4] The magnet itself consists of 5 coils, 2 of which are connected in series, and 3 in parallel, which results in the 160kA current being split 4 ways, allowing for optimal division of stress.

Related Research Articles

<span class="mw-page-title-main">Superconductivity</span> Electrical conductivity with exactly zero resistance

Superconductivity is a set of physical properties observed in certain materials where electrical resistance vanishes and magnetic flux fields are expelled from the material. Any material exhibiting these properties is a superconductor. Unlike an ordinary metallic conductor, whose resistance decreases gradually as its temperature is lowered even down to near absolute zero, a superconductor has a characteristic critical temperature below which the resistance drops abruptly to zero. An electric current through a loop of superconducting wire can persist indefinitely with no power source.

<span class="mw-page-title-main">Spectroscopy</span> Study involving matter and electromagnetic radiation

Spectroscopy is the field of study that measures and interprets the electromagnetic spectra that result from the interaction between electromagnetic radiation and matter as a function of the wavelength or frequency of the radiation. Matter waves and acoustic waves can also be considered forms of radiative energy, and recently gravitational waves have been associated with a spectral signature in the context of the Laser Interferometer Gravitational-Wave Observatory (LIGO)

Superconducting magnetic energy storage (SMES) systems store energy in the magnetic field created by the flow of direct current in a superconducting coil which has been cryogenically cooled to a temperature below its superconducting critical temperature.

<span class="mw-page-title-main">Magnetic field</span> Spatial distribution of vectors allowing the calculation of the magnetic force on a test particle

A magnetic field is a vector field that describes the magnetic influence on moving electric charges, electric currents, and magnetic materials. A moving charge in a magnetic field experiences a force perpendicular to its own velocity and to the magnetic field. A permanent magnet's magnetic field pulls on ferromagnetic materials such as iron, and attracts or repels other magnets. In addition, a nonuniform magnetic field exerts minuscule forces on "nonmagnetic" materials by three other magnetic effects: paramagnetism, diamagnetism, and antiferromagnetism, although these forces are usually so small they can only be detected by laboratory equipment. Magnetic fields surround magnetized materials, and are created by electric currents such as those used in electromagnets, and by electric fields varying in time. Since both strength and direction of a magnetic field may vary with location, it is described mathematically by a function assigning a vector to each point of space, called a vector field.

<span class="mw-page-title-main">Meissner effect</span> Expulsion of a magnetic field from a superconductor

The Meissner effect is the expulsion of a magnetic field from a superconductor during its transition to the superconducting state when it is cooled below the critical temperature. This expulsion will repel a nearby magnet.

<span class="mw-page-title-main">Rotating magnetic field</span> Resultant magnetic field

A rotating magnetic field is the resultant magnetic field produced by a system of coils symmetrically placed and supplied with polyphase currents. A rotating magnetic field can be produced by a poly-phase current or by a single phase current provided that, in the latter case, two field windings are supplied and are so designed that the two resulting magnetic fields generated thereby are out of phase.

<span class="mw-page-title-main">Superconducting magnet</span> Electromagnet made from coils of superconducting wire

A superconducting magnet is an electromagnet made from coils of superconducting wire. They must be cooled to cryogenic temperatures during operation. In its superconducting state the wire has no electrical resistance and therefore can conduct much larger electric currents than ordinary wire, creating intense magnetic fields. Superconducting magnets can produce stronger magnetic fields than all but the strongest non-superconducting electromagnets, and large superconducting magnets can be cheaper to operate because no energy is dissipated as heat in the windings. They are used in MRI instruments in hospitals, and in scientific equipment such as NMR spectrometers, mass spectrometers, fusion reactors and particle accelerators. They are also used for levitation, guidance and propulsion in a magnetic levitation (maglev) railway system being constructed in Japan.

<span class="mw-page-title-main">History of superconductivity</span>

Superconductivity is the phenomenon of certain materials exhibiting zero electrical resistance and the expulsion of magnetic fields below a characteristic temperature. The history of superconductivity began with Dutch physicist Heike Kamerlingh Onnes's discovery of superconductivity in mercury in 1911. Since then, many other superconducting materials have been discovered and the theory of superconductivity has been developed. These subjects remain active areas of study in the field of condensed matter physics.

<span class="mw-page-title-main">National High Magnetic Field Laboratory</span> Magnetism research institute in the United States

The National High Magnetic Field Laboratory (MagLab) is a facility at Florida State University, the University of Florida, and Los Alamos National Laboratory in New Mexico, that performs magnetic field research in physics, biology, bioengineering, chemistry, geochemistry, biochemistry. It is the only such facility in the US, and is among twelve high magnetic facilities worldwide. The lab is supported by the National Science Foundation and the state of Florida, and works in collaboration with private industry.

<span class="mw-page-title-main">Niobium–tin</span> Superconducting intermetallic compound

Niobium–tin is an intermetallic compound of niobium (Nb) and tin (Sn), used industrially as a type II superconductor. This intermetallic compound has a simple structure: A3B. It is more expensive than niobium–titanium (NbTi), but remains superconducting up to a magnetic flux density of 30 teslas [T] (300,000 G), compared to a limit of roughly 15 T for NbTi.

Niobium–titanium (Nb-Ti) is an alloy of niobium and titanium, used industrially as a type II superconductor wire for superconducting magnets, normally as Nb-Ti fibres in an aluminium or copper matrix.

The Modular Neutron Array (MoNA) is a large-area, high efficiency neutron detector that is used in basic research of rare isotopes at Michigan State University's National Superconducting Cyclotron Laboratory (NSCL), a nuclear physics research facility. It is specifically designed for detecting neutrons stemming from breakup reactions of fast fragmentation beams.

Flux pumping is a method for magnetising superconductors to fields in excess of 15 teslas. The method can be applied to any type II superconductor and exploits a fundamental property of superconductors, namely their ability to support and maintain currents on the length scale of the superconductor. Conventional magnetic materials are magnetised on a molecular scale which means that superconductors can maintain a flux density orders of magnitude bigger than conventional materials. Flux pumping is especially significant when one bears in mind that all other methods of magnetising superconductors require application of a magnetic flux density at least as high as the final required field. This is not true of flux pumping.

<span class="mw-page-title-main">Superconducting wire</span> Wires exhibiting zero resistance

Superconducting wires are electrical wires made of superconductive material. When cooled below their transition temperatures, they have zero electrical resistance. Most commonly, conventional superconductors such as niobium-titanium are used, but high-temperature superconductors such as YBCO are entering the market.

The superconducting tunnel junction (STJ) — also known as a superconductor–insulator–superconductor tunnel junction (SIS) — is an electronic device consisting of two superconductors separated by a very thin layer of insulating material. Current passes through the junction via the process of quantum tunneling. The STJ is a type of Josephson junction, though not all the properties of the STJ are described by the Josephson effect.

<span class="mw-page-title-main">Magnetic levitation</span> Method by which an object is suspended with no support other than magnetic fields

Magnetic levitation (maglev) or magnetic suspension is a method by which an object is suspended with no support other than magnetic fields. Magnetic force is used to counteract the effects of the gravitational force and any other forces.

<span class="mw-page-title-main">Laboratoire National des Champs Magnétiques Intenses</span>

The Laboratoire National des Champs Magnétiques Intenses is a research institution of the CNRS. It is based at two sites: one in Grenoble, specialised in static fields, and one in Toulouse, specialised in pulsed fields. The LNCMI provides a base for research related to high-strength magnetic fields by both resident scientists and visiting researchers from around the world. It is one of the three founding members of the European Magnetic Field Laboratory (EMFL) officially created in 2014.

The ARC fusion reactor is a design for a compact fusion reactor developed by the Massachusetts Institute of Technology (MIT) Plasma Science and Fusion Center (PSFC). ARC aims to achieve an engineering breakeven of three. The key technical innovation is to use high-temperature superconducting magnets in place of ITER's low-temperature superconducting magnets. The proposed device would be about half the diameter of the ITER reactor and cheaper to build.

<span class="mw-page-title-main">Rare-earth barium copper oxide</span> Chemical compounds known for exhibiting high temperature superconductivity

Rare-earth barium copper oxide is a family of chemical compounds known for exhibiting high temperature superconductivity (HTS). ReBCO superconductors have the potential to sustain stronger magnetic fields than other superconductor materials.

Hydrogen cryomagnetics is a term used to denote the use of cryogenic liquid hydrogen to cool the windings of an electromagnet. A key benefit of hydrogen cryomagnetics is that low temperature liquid hydrogen can be deployed simultaneously both as a cryogen to cool electromagnet windings and as an energy carrier. That is, powerful synergistic benefits are likely to arise when hydrogen is used as a fuel and as a coolant. Even without the fuel/coolant synergies, hydrogen cryomagnetics is an attractive option for the cooling of superconducting electromagnets as it eliminates dependence upon increasingly scarce and expensive liquid helium. For hydrogen cryomagnetic applications specialist hydrogen-cooled electromagnets are wound using either copper or superconductors. Liquid-hydrogen-cooled copper-wound magnets work well as pulsed field magnets. Superconductors have the property that they can operate continuously and very efficiently as electrical resistive losses are almost entirely avoided. Most commonly the term "hydrogen cryomagnetics" is used to denote the use of cryogenic liquid hydrogen directly, or indirectly, to enable high temperature superconductivity in electromagnet windings.

References

  1. 1 2 3 4 "Meet the Split Helix Magnet - MagLab". nationalmaglab.org. Retrieved 2020-11-17.
  2. 1 2 3 4 5 Toth, J.; Bird, M. D.; Bole, S.; O'Reilly, J. W. (June 2012). "Fabrication and Assembly of the NHMFL 25 T Resistive Split Magnet". IEEE Transactions on Applied Superconductivity. 22 (3): 4301604. doi:10.1109/TASC.2011.2174594. ISSN   1051-8223. S2CID   27199487.
  3. 1 2 Burch, Ashlyn D.; Curtis, Jeremy A.; Barman, Biplob; Linn, A. Garrison; McLintock, Luke M.; O’Beirne, Aidan L.; Stiles, Matthew J.; Reno, John. L.; McGill, Stephen A.; Karaiskaj, Denis; Hilton, David J. (2019). "Ultrafast Time-Domain Spectrometer in the 25 T Split Florida-Helix Magnet". Conference on Lasers and Electro-Optics. San Jose, California: OSA: STu4F.1. doi:10.1364/CLEO_SI.2019.STu4F.1. ISBN   978-1-943580-57-6.
  4. 1 2 3 Toth, J.; Bird, M.D. (June 2008). "FEA-Aided Design for a Working Model of a Split Florida-Helix". IEEE Transactions on Applied Superconductivity. 18 (2): 575–578. doi:10.1109/tasc.2008.921942. ISSN   1051-8223. S2CID   25027970.