T-MPLS

Last updated

T-MPLS or Transport MPLS is a transport network layer technology that uses extensions to a subset of the existing MPLS standards and is designed specifically for application in transport networks. Work to define T-MPLS was started by the ITU-T in February 2006. It was intended specifically as a connection-oriented packet-switched (co-ps) application offering a simpler implementation by removing MPLS features that are not relevant to co-ps applications and adding mechanisms that provide support of critical transport functionality.

ITU-T ceased work on T-MPLS in December 2008, in favour of MPLS-TP standardization. [1]

T-MPLS uses the same architectural principles of layered networking that are used in other technologies like SDH and OTN. Service providers have already developed management processes and work procedures based on these principles for use in networks that use those other technologies.

In this way T-MPLS was intended to provide a reliable packet-based technology that is familiar and also aligned with circuit-based transport networking; it supports current organizational processes and large-scale work procedures.

T-MPLS is a low cost Layer 2 technology that provides QoS, end-to-end OA&M and protection switching.

The following ITU-T Recommendations exist for T-MPLS. These Recommendations will be superseded (i.e., replaced) by new revisions that apply to MPLS-TP and reference the joint work being undertaken by the ITU-T and IETF.

RecommendationTitle
G.8110.1 [2] Architecture of Transport MPLS (T-MPLS) Layer Network
G.8112 [3] Interfaces for the Transport MPLS (T-MPLS) Hierarchy
G.8121 [4] Characteristics of Transport MPLS equipment functional blocks
G.8131 [5] Linear protection switching for Transport MPLS (T-MPLS) networks
Y.Sup4 [6]

ex G.8113 (draft)

Requirements for OAM function in T-MPLS based networks

A further set of ITU-T Recommendations were at a draft stage when work on T-MPLS was halted. These may be resumed at a later stage to reference the material developed as part of the MPLS-TP effort.

Draft RecommendationTitle
G.8114 (draft)Operation & Maintenance mechanisms for T-MPLS layer networks
G.8132 (draft)Shared Protection Ring switching for T-MPLS networks

After IETF raised concerns over T-MPLS technology, mainly about incompatibility with the already established IP/MPLS, the ITU-T and the IETF started a joint activity to solve potential issues. The decision was to transfer control to IETF to develop a new MPLS profile specialized for transport (MPLS-TP) with input from ITU recommendations [7] A new activity was added to the charter of the MPLS working group of IETF.

Related Research Articles

<span class="mw-page-title-main">ITU-T</span> Standardization Sector of the ITU

The ITU Telecommunication Standardization Sector (ITU-T) is one of the three Sectors (branches) of the International Telecommunication Union (ITU). It is responsible for coordinating standards for telecommunications and Information Communication Technology such as X.509 for cybersecurity, Y.3172 and Y.3173 for machine learning, and H.264/MPEG-4 AVC for video compression, between its Member States, Private Sector Members, and Academia Members.

Multiprotocol Label Switching (MPLS) is a routing technique in telecommunications networks that directs data from one node to the next based on labels rather than network addresses. Whereas network addresses identify endpoints the labels identify established paths between endpoints. MPLS can encapsulate packets of various network protocols, hence the multiprotocol component of the name. MPLS supports a range of access technologies, including T1/E1, ATM, Frame Relay, and DSL.

<span class="mw-page-title-main">OSI model</span> Model of communication of seven abstraction layers

The Open Systems Interconnection model is a conceptual model, originally conceived as the 7 layer onion skin architecture by Jack Holdsworth of ICL, that 'provides a common basis for the coordination of [ISO] standards development for the purpose of systems interconnection'. In the OSI reference model, the communications between a computing system are split into seven different abstraction layers: Physical, Data Link, Network, Transport, Session, Presentation, and Application.

Quality of service (QoS) is the description or measurement of the overall performance of a service, such as a telephony or computer network, or a cloud computing service, particularly the performance seen by the users of the network. To quantitatively measure quality of service, several related aspects of the network service are often considered, such as packet loss, bit rate, throughput, transmission delay, availability, jitter, etc.

A virtual circuit (VC) is a means of transporting data over a data network, based on packet switching and in which a connection is established within the network between two endpoints. The network, rather than having a fixed data rate reservation per connection, like in circuit switching, takes advantage of the statistical multiplexing on its transmission links. In addition, VCs standardized by the CCITT in 1976 impose per-connection flow controls at all user-to-network and network-to-network interfaces. They thus eliminate the need for the network to lose user packets in heavily loaded network zones, an intrinsic feature of datagram networks for their congestion control.

<span class="mw-page-title-main">X.25</span> Standard protocol suite for packet switched wide area network (WAN) communication

X.25 is an ITU-T standard protocol suite for packet-switched data communication in wide area networks (WAN). It was originally defined by the International Telegraph and Telephone Consultative Committee in a series of drafts and finalized in a publication known as The Orange Book in 1976.

E.164 is an international standard, titled The international public telecommunication numbering plan, that defines a numbering plan for the worldwide public switched telephone network (PSTN) and some other data networks.

Signalling System No. 7 (SS7) is a set of telephony signaling protocols developed in the 1970s, which is used to set up and tear down telephone calls in most parts of the world-wide public switched telephone network (PSTN). The protocol also performs number translation, local number portability, prepaid billing, Short Message Service (SMS), and other services.


In computer networking and telecommunications, a pseudowire is an emulation of a point-to-point connection over a packet-switched network (PSN).

The Open Systems Interconnection protocols are a family of information exchange standards developed jointly by the ISO and the ITU-T. The standardization process began in 1977.

In computer networking and telecommunications, TDM over IP (TDMoIP) is the emulation of time-division multiplexing (TDM) over a packet-switched network (PSN). TDM refers to a T1, E1, T3 or E3 signal, while the PSN is based either on IP or MPLS or on raw Ethernet. A related technology is circuit emulation, which enables transport of TDM traffic over cell-based (ATM) networks.

<span class="mw-page-title-main">H.248</span>

The Gateway Control Protocol is an implementation of the media gateway control protocol architecture for providing telecommunication services across a converged internetwork consisting of the traditional public switched telephone network (PSTN) and modern packet networks, such as the Internet. H.248 is the designation of the recommendations developed by the ITU Telecommunication Standardization Sector (ITU-T) and Megaco is a contraction of media gateway control protocol used by the earliest specifications by the Internet Engineering Task Force (IETF). The standard published in March 2013 by ITU-T is entitled H.248.1: Gateway control protocol: Version 3.

The next-generation network (NGN) is a body of key architectural changes in telecommunication core and access networks. The general idea behind the NGN is that one network transports all information and services by encapsulating these into IP packets, similar to those used on the Internet. NGNs are commonly built around the Internet Protocol, and therefore the term all IP is also sometimes used to describe the transformation of formerly telephone-centric networks toward NGN.

Automatically Switched Optical Network (ASON) is a concept for the evolution of transport networks which allows for dynamic policy-driven control of an optical or SDH network based on signaling between a user and components of the network. Its aim is to automate the resource and connection management within the network. The IETF defines ASON as an alternative/supplement to NMS based connection management.

Automatic Switched Transport Network (ASTN) allows traffic paths to be set up through a switched network automatically. The term ASTN replaces the term ASON and is often used interchangeably with GMPLS. This is not completely correct as GMPLS is a family of protocols, but ASON/ASTN is an optical/transport network architecture. The requirements of the ASON/ASTN architecture can be satisfied using GMPLS protocols developed by the IETF or by GMPLS protocols that have been modified by the ITU. Furthermore, the GMPLS protocols are applicable to optical and non-optical networks, and can be used in transport or client networks. Thus, GMPLS is a wider concept than ASTN.

<span class="mw-page-title-main">H.323</span> Audio-visual communication signaling protocol

H.323 is a recommendation from the ITU Telecommunication Standardization Sector (ITU-T) that defines the protocols to provide audio-visual communication sessions on any packet network. The H.323 standard addresses call signaling and control, multimedia transport and control, and bandwidth control for point-to-point and multi-point conferences.

Connection-oriented Ethernet refers to the transformation of Ethernet, a connectionless communication system by design, into a connection-oriented system. The aim of connection-oriented Ethernet is to create a networking technology that combines the flexibility and cost-efficiency of Ethernet with the reliability of connection-oriented protocols. Connection-oriented Ethernet is used in commercial carrier grade networks.

Circuit emulation service (CES) is a telecommunication technology used to send information over asynchronous data networks like ATM, Ethernet or MPLS, so that it is received error-free with constant delay, similar to a leased line.

In telecommunications, Multiprotocol Label Switching - Transport Profile (MPLS-TP) is a variant of the MPLS protocol that is used in packet switched data networks. MPLS-TP is the product of a joint Internet Engineering Task Force (IETF) / International Telecommunication Union Telecommunication Standardization Sector (ITU-T) effort to include an MPLS Transport Profile within the IETF MPLS and PWE3 architectures to support the capabilities and functionalities of a packet transport network.

A communication protocol is a system of rules that allows two or more entities of a communications system to transmit information via any kind of variation of a physical quantity. The protocol defines the rules, syntax, semantics and synchronization of communication and possible error recovery methods. Protocols may be implemented by hardware, software, or a combination of both.

References

  1. Clarifications on MPLS for transport network - ITU-T newslog, 10 March 2009
  2. "Architecture of Transport MPLS (T-MPLS) layer network". International Telecommunication Union. November 2006.
  3. "Interfaces for the Transport MPLS (T-MPLS) hierarchy". International Telecommunication Union. October 2006.
  4. "Characteristics of Transport MPLS (T-MPLS) equipment functional blocks". International Telecommunication Union. March 2006.
  5. "Linear protection switching for Transport MPLS (T-MPLS) networks". International Telecommunication Union. February 2007.
  6. "ITU-T Y.1300 series - Supplement on transport requirements for T-MPLS OAM and considerations for the application of IETF MPLS technology". International Telecommunication Union. January 2008.
  7. "ITU-T/IETF interoperability issues addressed". ITU-T Study Group 15.