A V-drive is a power transmission system for boats that consists (usually) of two gearboxes, two drive shafts, and a propeller.
Whereas the conventional arrangement sites the engine with its gearbox aft, driving the propeller shaft directly, in a "V-drive" layout, the engine is reversed, to have the gearbox in front. This primary gearbox typically drives a short shaft forward to a transfer gearbox which reverses the transmission to the main tailshaft which is directed rearwards the propeller, at a "V" angle to the short shaft.
A V-drive system variation is for the tailshaft to drive a saildrive propeller, mounted on a skeg below the hull. This is common on Lagoon catamarans.
A variation of the two-shaft V-Drive layout is the "close-coupled V-drive" whereby the engine is still mounted "back-to-front", but the main gearbox incorporates an output flange that has already been reversed. This system obviates the need for any short primary shaft. [1]
Counter-intuitively, a V-drive system will not necessarily mean that the engine is sited further rearward; the whole engine/transmission may be sited forward than in a conventional arrangement.
V-drives are typically fitted to (i) sport motorboats or (ii) cruising yachts and catamarans. The pros and cons tend to be different for each type.
For sportboats, a V-drive may be an alternative to an inboard/outboard (I/O) drive. Here the V-drive will allow the engine to be moved further forwards and the propeller (& rudder) will be under the boat. This can give a flatter ride (getting the boat planing earlier), greater choice of propellers, and a safer stern access for swimmers.
For cruising yachts, the rationale of the V-drive installation may include: [2]
In all cases, maintenance may be more difficult with a V-drive, since the main propshaft beneath the engine may be somewhat inaccessible. Also, when installing a V-drive, it can be a difficult process to ensure accurate alignment.
Fred Cooper's 1935 design for Malcolm Campbell's Blue Bird used a v-drive designed by Reid Railton for its 2,000 bhp engine. [3]
A yacht is a sail- or motor-propelled watercraft made for pleasure, cruising, or racing. There is no standard definition, though the term generally applies to vessels with a cabin intended for overnight use. To be termed a yacht, as opposed to a boat, such a pleasure vessel is likely to be at least 33 feet (10 m) in length and may have been judged to have good aesthetic qualities.
An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft. As well as providing propulsion, outboards provide steering control, as they are designed to pivot over their mountings and thus control the direction of thrust. The skeg also acts as a rudder when the engine is not running. Unlike inboard motors, outboard motors can be easily removed for storage or repairs.
A jetboat is a boat propelled by a jet of water ejected from the back of the craft. Unlike a powerboat or motorboat that uses an external propeller in the water below or behind the boat, a jetboat draws the water from under the boat through an intake and into a pump-jet inside the boat, before expelling it through a nozzle at the stern.
An automatic transmission is a multi-speed transmission used in motor vehicles that does not require any input from the driver to change forward gears under normal driving conditions. Vehicles with internal combustion engines, unlike electric vehicles, require the engine to operate in a narrow range of rates of rotation, requiring a gearbox, operated manually or automatically, to drive the wheels over a wide range of speeds.
Overdrive is the operation of an automobile cruising at sustained speed with reduced engine speed (rpm), leading to better fuel consumption, lower noise, and lower wear. The term is ambiguous. The most fundamental meaning is that of an overall gear ratio between engine and wheels, such that the car is over-geared, and cannot reach its potential top speed, i.e. the car could travel faster if it were in a lower gear, with the engine turning at higher RPM.
A motorboat or powerboat is a boat that is exclusively powered by an engine; faster examples may be called "speedboats".
A manual transmission (MT), also known as manual gearbox, standard transmission, or stick shift, is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch.
A drive shaft, driveshaft, driving shaft, tailshaft, propeller shaft, or Cardan shaft is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to allow for relative movement between them.
A Z-drive is a type of marine propulsion unit. Specifically, it is an azimuth thruster. The pod can rotate 360 degrees allowing for rapid changes in thrust direction and thus vessel direction. This eliminates the need for a conventional rudder.
A sterndrive or inboard/outboard drive (I/O) is a form of marine propulsion which combines inboard power with outboard drive. The engine sits just forward of the transom while the drive unit lies outside the hull.
The tail rotor is a smaller rotor mounted vertically or near-vertically at the tail of a traditional single-rotor helicopter, where it rotates to generate a propeller-like horizontal thrust in the same direction as the main rotor's rotation. The tail rotor's position and distance from the helicopter's center of mass allow it to develop enough thrust leverage to counter the reactional torque exerted on the fuselage by the spinning of the main rotor. Without the tail rotor or other anti-torque mechanisms, the helicopter would be constantly spinning in the opposite direction of the main rotor when flying.
Combined diesel–electric and gas (CODLAG) is a modification of the combined diesel and gas propulsion system for ships. A variant, called the combined diesel–electric or gas (CODLOG) system, contains the same basic elements but will not allow simultaneous use of the alternative drive sources.
Marine propulsion is the mechanism or system used to generate thrust to move a watercraft through water. While paddles and sails are still used on some smaller boats, most modern ships are propelled by mechanical systems consisting of an electric motor or internal combustion engine driving a propeller, or less frequently, in pump-jets, an impeller. Marine engineering is the discipline concerned with the engineering design process of marine propulsion systems.
A sailing yacht, is a leisure craft that uses sails as its primary means of propulsion. A yacht may be a sail or power vessel used for pleasure, cruising, or racing. There is no standard definition, so the term applies here to sailing vessels that have a cabin with amenities that accommodate overnight use. To be termed a "yacht", as opposed to a "boat", such a vessel is likely to be at least 33 feet (10 m) in length and have been judged to have good aesthetic qualities. Sailboats that do not accommodate overnight use or are smaller than 30 feet (9.1 m) are not universally called yachts. Sailing yachts in excess of 130 feet (40 m) are generally considered to be superyachts.
The Zeppelin-Lindau Rs.II was a biplane flying boat, designed by Claudius Dornier as a follow-on to his Zeppelin-Lindau Rs.I and built during 1914–1915 on the German side of Lake Constance. Initially this aircraft was powered by three engines mounted inside the hull driving three pusher propellers via gearboxes and shafts. The later version was powered by four engines in two push-pull nacelles mounted between the wings.
A motorcycle transmission is a transmission created specifically for motorcycle applications. They may also be found in use on other light vehicles such as motor tricycles and quadbikes, go-karts, offroad buggies, auto rickshaws, mowers, and other utility vehicles, microcars, and even some superlight racing cars.
A drivetrain or transmission system, is the group of components that deliver mechanical power from the prime mover to the driven components. In automotive engineering, the drivetrain is the components of a motor vehicle that deliver power to the drive wheels. This excludes the engine or motor that generates the power. In marine applications, the drive shaft will drive a propeller, thruster, or waterjet rather than a drive axle, while the actual engine might be similar to an automotive engine. Other machinery, equipment and vehicles may also use a drivetrain to deliver power from the engine(s) to the driven components.
Tank steering systems allow a tank, or other continuous track vehicle, to turn. Because the tracks cannot be angled relative to the hull, steering must be accomplished by speeding one track up, slowing the other down, or a combination of both. Half-track vehicles avoid this by combining steerable wheels and fixed-speed tracks.
The C&C Custom 62 is a Canadian sailboat, that was designed by Robert W. Ball of C&C Design for long range cruising and first built in 1981.
The Lagoon 420 is a French sailboat that was designed by Van Peteghem/Lauriot-Prevost as a cruiser and yacht charter boat, first built in 2006, as a 2007 model year introduction.