Aerial Engineering Corporation Standard 6W-3

Last updated
Standard 6W-3
Mercury Standard 6W-3 Les Ailes February 18,1926.jpg
RoleCommercial transport aircraft
National origin United States
ManufacturerAerial Engineering Corporation [1]
Designer Harvey C. Mummert
First flight1925
Number built<10

The Aerial Engineering Corporation Standard 6W-3 was a commercial transport modification of the US Standard J-1 biplane military trainer aircraft, with new wings, engine and accommodation for four passengers. First flown in 1925, it was built in small numbers.

Contents

Design and development

The Standard J-1 military trainer had been built in large numbers at the end of World War I. With many surplus after the war, it was a natural choice for adaptation by several manufacturers. Ariel Service, with the experienced designer Harvey Mummert who was an early collaborator with Glenn Curtiss, produced the Mercury Standard 6W-3 by combining a completely new wing with a Standard J fuselage and empennage, modified to accommodate four passengers rather than a student and with a new and more powerful engine. [2]

The Standard 6W-3 was a single bay biplane with constant chord, straight-edged wings swept at 5° and with a more modern, thicker airfoil than most of those used during WWI. Its upper wing was flat but the lower one had 1.5° of dihedral. There were balanced ailerons on the upper wing. Both wings were wooden structures based on twin spruce box spars with the lower wing attached to the lower fuselage longerons and the upper wing braced to it. without stagger, by a pair of vertical interplane struts on each side between the spars. The narrow centre section, where the chord was reduced to improve the pilot's upward field of view, was supported over the fuselage with pairs of N-form cabane struts. [2]

Its modified Standard fuselage, with new longerons and covering, now housed a 120 kW (160 hp) six-cylinder, water-cooled inline Curtiss C-6 engine with a honeycomb radiator in front of it and a fuel tank in the upper wing. Immediately behind it a new, large, under-wing cockpit with seats for four passengers, two in aft-facing side-by-side seats and two more opposite them. The seats were easily replaceable, allowing the 6W-3 to act as a mailplane. The pilot was in a separate cockpit behind the passengers with a large fairing behind his head. [2]

The empennage was conventional, with a low aspect ratio tailplane and generous elevators mounted on top of the fuselage. The fin was triangular, with a rounded rudder. The 6W-3 had conventional, fixed, tailskid landing gear with wheels on a single axle held by twin V-struts to the lower fuselage longerons. Rubber cord shock absorbers were fitted. [2]

The first flight was in 1925. Fewer than ten were built. [1]

Specifications

Mercury Standard 6W-3 3-view drawing from Les Ailes February 18,1926 Mercury Standard 6W-3 3-view Les Ailes February 18,1926.png
Mercury Standard 6W-3 3-view drawing from Les Ailes February 18,1926

Data from Les Ailes, February 1926 [2]

General characteristics

Performance

Related Research Articles

<span class="mw-page-title-main">Aero A.23</span> Type of aircraft

The Aero A.23 was a Czechoslovakian airliner of the 1920s. Aero Vodochody had produced the first Czech airliner, the A.10, four of which had served with ČSA, the national airline. The A.23, another biplane, was bigger, more powerful and could carry more passengers.

The Koolhoven F.K.42 was a parasol-wing, two-seat training monoplane manufactured by Koolhoven in the Netherlands. Only one was built.

The Nakajima P-1 was a 1930s Japanese single engine, single seat biplane intended for night mail flights, derived from the Nakajima E4N3 Naval reconnaissance seaplane. Nine were built.

<span class="mw-page-title-main">Pander E</span> Dutch training aircraft

The Pander E was the first indigenous Dutch training aircraft, used by clubs and also privately owned. A two-seat, single-engine biplane, 17 were built in the Netherlands from 1926 with engines of increasing power.

The Caudron C.251 Et-2 was a French tandem seat, open cockpit biplane designed as an intermediate trainer and built in 1931. It did not go into production.

<span class="mw-page-title-main">Feiro Dongó</span> Type of aircraft

The Feiro Dongó was a Hungarian side-by-side trainer biplane. It was notable for its high aspect ratio wings, aerodynamic clearness and high lift/drag ratio.

<span class="mw-page-title-main">Heinkel HD 20</span> Type of aircraft

The Heinkel HD 20 was a twin engine, three seat German biplane built in 1926 for civil survey work.

<span class="mw-page-title-main">Morane-Saulnier MS.350</span> Type of aircraft

The Morane-Saulnier MS.350 was a French aerobatic trainer flown in 1936. Only one was built but it had a long career, flying post-war until the 1960s.

<span class="mw-page-title-main">Volland V-10</span> Type of aircraft

The Volland V-10 was a French two seat, low-powered biplane notable for its extreme stagger. It first flew in 1936 and appeared at the Paris Aero Salon that year.

The Caproni Ca.61 was an Italian heavy day bomber aircraft of 1922. It was the final development of the Caproni three engine, twin boom biplane types developed during World War I, but it was not put into production.

The Peyret-le Prieur seaplane was a low power, two seat biplane floatplane trainer flown in France in 1924. It did not reach production.

The Potez 24 A.2 was a mid-1920s French biplane intended to replace the Potez 15 as an army observation aircraft. The further improved and larger Potez 25 was preferred for production.

The Caproni Ca.66 was an Italian night bomber designed to reequip the post-World War I Italian Air Force. Only two examples of the four-engined biplane were built.

<span class="mw-page-title-main">Skraba S.T.3</span> Type of aircraft

The Skraba S.T.3 was a two-seat Polish biplane built in 1928. It was the first all-metal aircraft designed in Poland; only one was completed.

The Medwecki and Nowakowski M.N.3 or just M.N.3 was a low-powered, four seat, Polish aircraft flown in 1928. The sole example was modified into a more powerful two-seater which served aeroclubs until World War II.

<span class="mw-page-title-main">Medwecki and Nowakowski M.N.5</span> Type of aircraft

The Medwecki and Nowakowski M.N.5 was an economical Polish trainer aircraft initially aimed at the club market, though there was also some military interest. It performed well but lacked a constructor after Samolot became insolvent in 1930, so only one was completed.

The Gabriel P 6 was a Polish training aircraft and the P 7 a tourer. The difference between them was the wing configuration, chosen to optimise their speed range for their role, so the P 6 was a biplane and the P 7 a parasol wing aircraft.

The Brown 1926 parasol monoplane was a 1920s US, three seat, parasol wing civil aircraft developed from a biplane wartime scout. It was intended for either the private or commercial passenger markets, though one was used as a crop-duster.

The Kawanishi K-3 was a Japanese, fast, multi-purpose civil transport aircraft from the early 1920s. Despite its good performance it was eclipsed by the release of Army surplus machines and only one was built.

<span class="mw-page-title-main">Huff-Daland HD.8A Petrel</span> 1920s American civil transport aircraft

The Huff-Daland HD.8A was a small civil transport biplane carrying two passengers built in the U.S. in 1922. The otherwise identical HD-9A offered an alternative engine.

References

  1. 1 2 K.O. Eckland (2 May 2009). "Aircraft Ma to Mg" . Retrieved 22 May 2017.
  2. 1 2 3 4 5 Serryer, J. (25 February 1926). "L'avion "Mercury" Standard 6W-3". Les Ailes (245): 2–3.