Autovon

Last updated
AUTOVON telephone AUTOVON telephone - Telephone Museum - Waltham, Massachusetts.agr.jpg
AUTOVON telephone

The Automatic Voice Network (AUTOVON, military designation 490-L) [1] was a worldwide American military telephone system. The system was built starting in 1963, based on the Army's existing Switch Communications Automated Network (SCAN) system.

Contents

In June 1966, the Air Defense Command voice network was cut over to the new service. [2] In 1969, AUTOVON switching centers opened in the United Kingdom, and later in other European countries, Asia, the Middle East, and Panama. It was a major part of the Defense Communications System (DCS), providing non-secure switched voice services. The system was replaced in the early 1990s by the Defense Switched Network.

Defense Switched Network

The digitization of and upgrade of AUTOVON began in 1992 and took several years to complete. Equipment is housed in a network of redundant and distributed deep underground facilities spread across the globe, each of which are capable of withstanding multiple direct nuclear attacks of very significant yield. All equipment is housed in such a way that it can absorb multiple blast waves propagating underground whilst still maintaining continuous operation. The engineering is still impressive by today's standards and it is still in use today. [3]

In the 90s whilst the new AUTOVON was still under construction, it suffered a significant incursion. It is rumoured that the incursion rendered major portions of the network inoperable and put at risk significant infrastructure. As recently as 2021, numerous distinguished engineers & scientists with knowledge of the incident have been unable to get clarity as to whether the system was properly rectified with the necessary architecture changes one would expect to defend such a system, as equivalent equipment available for civilian use still has significant defects.

Circuits

AUTOVON used a combination of its own constructed circuits and other lines operated by AT&T Corporation and smaller independent telephone companies, connected by high-speed switching centers produced by Automatic Electric Company [1] to exchanges located far from other civilian or military targets. In the US the cables were predominantly L-carrier coaxial multiplex built by AT&T, who also used them to carry about one third of all civilian long-distance calls, as their capacity was much higher than the military needed. Although unused, some of the cables remain today and the routes are visible on satellite photos. The system's traffic was transported over many media other than underground cable, including microwave links, open wire and, near the end of the system's life, fiber optic.

Contrary to stories of underground concrete cable ducts,[ citation needed ] most of the cable was directly buried without added concrete, relying instead on the natural protection of soil. In some areas, however, cables from the AUTOSEVOCOM network were laid in parallel. These were often concrete-encased when the traffic they were carrying was not encrypted.

Most of the cable repeater huts have been sold to private interests, to round out existing parcels, or as possible build-to-suit tower sites, etc. AT&T has been filling the small underground portion before sale, unless they sell to a major company. The junctions for AUTOVON are also being sold into private ownership, with a few exceptions. Most are stripped of all the equipment, although the AUTOVON junction in Mounds, Oklahoma was sold with all the old equipment in place.

The telephone switches used were initially a 4 wire version of Number Five Crossbar Switching System, replaced in the early 1970s after the more versatile 1ESS switch had shown its reliability. (Note that this paragraph disagrees in part with an earlier paragraph regarding the manufacturer of switching equipment. In general, switches in Bell operating territories were made by AT&T, and most others by Automatic Electric; see the Autovon switch location map cited in External Links, below, for a snapshot listing of locations (some of the names in the map have been anonymized) and equipment manufacturer.)

Multilevel precedence and preemption

An Autovon telephone keypad with three of the four precedence levels (excluding Routine), plus Flash Override 66a3aDTMFpad.jpg
An Autovon telephone keypad with three of the four precedence levels (excluding Routine), plus Flash Override

The AUTOVON system provided a facility for placing calls with multilevel precedence and preemption (MLPP). If in the public switched telephone network a caller encounters congestion because no circuits are available, the caller typically receives the reorder tone ("fast-busy" signal) and is unable to reach the called party. In military networks such an event was not acceptable, as some calls must always be completed.

AUTOVON included four message precedence levels: Routine, Priority, Immediate and Flash, and had an additional capability called Flash Override. [4] These levels were activated using the buttons in an additional column of the keypad, which produced the dual-tone multi-frequency (DTMF) signals A, B, C, and D:

Routine was the level of calls without priority and required no special signaling; the user would only dial the telephone number. Calls with precedence required preceding the telephone number with the desired precedence signal. Calls of increasing precedence could preempt calls of lower priority, giving them a special tone, if need be. For example, if a call was placed with Flash precedence and the route had no available trunks, the switch would preempt a Routine call, and if none in progress, would search for Priority and Immediate type calls. Only when all lines of a switch were already used with Flash or Flash Override precedence would the caller receive a reorder signal.

The authority of a caller to use the precedence levels was granted by complex regulations. [5] Flash Override was not designated as a precedence level, but a capability designed to allow the President of the United States or other National Command Authority to preempt any other traffic in the network in an emergency.

The International Telecommunication Union accepted the MLPP specification as recommendation Q.955.3 in March 1993. [6]

Numbering plan

AUTOVON used a numbering scheme similar to the North American Numbering Plan. The network had its own three-digit area codes for various geographic regions around the world. Each area code covered several three-digit exchange codes, usually corresponding to the central office telephone switches serving each installation. Thus, almost any telephone on a military base could be direct-dialed via AUTOVON. A selected set of telephones were four-wire AUTOVON phones, wired directly into the AUTOVON network. Others could initiate AUTOVON calls with operator assistance.

Though the numbering plan was similar to the U.S. civilian scheme, the routing structure was a very complex polygrid system unlike the civilian office classification scheme, which used a 5-level hierarchical system in which longer-distance traffic, in general, was handled by higher-level switches. It was barely within the information processing capabilities of the Number Five Crossbar switching system which implemented it. The non-hierarchical routing structure was intended to get around any number of nodes destroyed in war. This system inspired similarly survivable ones for message networks, including in future decades the Internet.

Local base switches would be connected to a few AUTOVON trunks, which the user would access by dialing 8 (or in some cases, 88) before the telephone number. To dial locally a user would dial 9, and to dial using commercial long-distance, 1 (where this was supported). The United States Department of Defense (DoD) charged access to AUTOVON according to a complex billing system, and each base budgeted according to local practice.

See also

Related Research Articles

<span class="mw-page-title-main">DTMF</span> Telecommunication signaling system

Dual-tone multi-frequency signaling (DTMF) is a telecommunication signaling system using the voice-frequency band over telephone lines between telephone equipment and other communications devices and switching centers. DTMF was first developed in the Bell System in the United States, and became known under the trademark Touch-Tone for use in push-button telephones supplied to telephone customers, starting in 1963. DTMF is standardized as ITU-T Recommendation Q.23. It is also known in the UK as MF4.

Direct distance dialing (DDD) is a telecommunication service feature in North America by which a caller may, without operator assistance, call any other user outside the local calling area. Direct dialing by subscribers typically requires extra digits to be dialed as prefixes to the directory telephone number of the destination. International Direct Distance Dialing (IDDD) extends the system beyond the geographic boundaries of the North American Numbering Plan (NANP).

In telecommunication, signaling is the use of signals for controlling communications. This may constitute an information exchange concerning the establishment and control of a telecommunication circuit and the management of the network.

<span class="mw-page-title-main">Emergency telephone number</span> Telephone number that allows caller to contact local emergency services for assistance

An emergency telephone number is a number that allows a caller to contact local emergency services for assistance. The emergency number differs from country to country; it is typically a three-digit number so that it can be easily remembered and dialed quickly. Some countries have a different emergency number for each of the different emergency services; these often differ only by the last digit.

Plain Old Telephone Service (POTS), or Plain Ordinary Telephone System, is a retronym for voice-grade telephone service employing analog signal transmission over copper loops. Originally POTS stood for Post Office Telephone Service as early phone lines in most parts of the world were operated directly by the local Post Office.

A dial tone is a telephony signal sent by a telephone exchange or private branch exchange (PBX) to a terminating device, such as a telephone, when an off-hook condition is detected. It indicates that the exchange is working and is ready to initiate a telephone call. The tone stops when the first dialed digit is recognized. If no digits are forthcoming, the partial dial procedure is invoked, often eliciting a special information tone and an intercept message, followed by the off-hook tone, requiring the caller to hang up and redial.

Caller identification is a telephone service, available in analog and digital telephone systems, including voice over IP (VoIP), that transmits a caller's telephone number to the called party's telephone equipment when the call is being set up. The caller ID service may include the transmission of a name associated with the calling telephone number, in a service called Calling Name Presentation (CNAM). The service was first defined in 1993 in International Telecommunication Union – Telecommunication Standardization Sector (ITU-T) Recommendation Q.731.3.

<span class="mw-page-title-main">Blue box</span> Device for hacking telephone networks

A blue box is an electronic device that produces tones used to generate the in-band signaling tones formerly used within the North American long-distance telephone network to send line status and called number information over voice circuits. This allowed an illicit user, referred to as a "phreaker", to place long-distance calls, without using the network's user facilities, that would be billed to another number or dismissed entirely as an incomplete call. A number of similar "color boxes" were also created to control other aspects of the phone network.

<span class="mw-page-title-main">Silver box</span>

A silver box is a modified DTMF keypad that adds four additional keys. This gives four columns of four keys each instead of three columns.

<span class="mw-page-title-main">Telephone keypad</span> Keypad that appears on some telephones

A telephone keypad is a keypad installed on a push-button telephone or similar telecommunication device for dialing a telephone number. It was standardized when the dual-tone multi-frequency signaling (DTMF) system was developed in the Bell System in the United States in the 1960s that replaced rotary dialing originally developed in electromechanical switching systems. Because of the installed abundance of rotary dial equipment well into the 1990s, many telephone keypads were also designed to produce loop-disconnect pulses electronically, and some could be optionally switched to produce either DTMF or pulses.

<span class="mw-page-title-main">Telephone call</span> Connection between two or more people over a telephone network

A telephone call or telephone conversation, also known as a phone call or voice call, is a connection over a telephone network between the called party and the calling party. Telephone calls started in the late 19th century. As technology has improved, a majority of telephone calls are made over a cellular network through mobile phones or over the internet with Voice over IP. Telephone calls are typically used for real-time conversation between two or more parties, especially when the parties cannot meet in person.

Call waiting is a telephone service where a subscriber can accept a second incoming telephone call by placing an in-progress call on hold—and may also switch between calls. With some providers it can be combined with additional features such as conferencing, call forwarding, and caller ID. Call waiting is intended to alleviate the need to have more than one telephone line or number for voice communications.

The Defense Switched Network (DSN) is a primary information transfer network for the Defense Information Systems Network (DISN) of the United States Department of Defense. The DSN provides the worldwide non-secure voice, secure voice, data, facsimile, and video teleconferencing services for DOD Command and Control (C2) elements, their supporting activities engaged in logistics, personnel, engineering, and intelligence, as well as other Federal agencies.

<span class="mw-page-title-main">Business telephone system</span> Telephone system typically used in business environments

A business telephone system is a telephone system typically used in business environments, encompassing the range of technology from the key telephone system (KTS) to the private branch exchange (PBX).

GSM services are a standard collection of applications and features available over the Global System for Mobile Communications (GSM) to mobile phone subscribers all over the world. The GSM standards are defined by the 3GPP collaboration and implemented in hardware and software by equipment manufacturers and mobile phone operators. The common standard makes it possible to use the same phones with different companies' services, or even roam into different countries. GSM is the world's most dominant mobile phone standard.

Direct inward dialing (DID), also called direct dial-in (DDI) in Europe and Oceania, is a telecommunication service offered by telephone companies to subscribers who operate private branch exchange (PBX) systems. The feature provides service for multiple telephone numbers over one or more analog or digital physical circuits to the PBX, and transmits the dialed telephone number to the PBX so that a PBX extension is directly accessible for an outside caller, possibly by-passing an auto-attendant.

In telephony, call progress tones are audible tones that provide an indication of the status of a telephone call to the user. The tones are generated by a central office or a private branch exchange (PBX) to the calling party.

Ringing tone is a signaling tone in telecommunication that is heard by the originator of a telephone call while the destination terminal is alerting the receiving party. The tone is typically a repeated cadence similar to a traditional power ringing signal (ringtone), but is usually not played synchronously. Various telecommunication groups, such as the Bell System and the General Post Office (GPO) developed standards, in part taken over by the European Telecommunications Standards Institute (ETSI) and other standards bodies. With modern cell phone and smartphone technology ringing tone can be customized and even used for advertising.

<span class="mw-page-title-main">Telephone exchange</span> Interconnects telephones for calls

A telephone exchange, also known as a telephone switch or central office, is a crucial component in the public switched telephone network (PSTN) or large enterprise telecommunications systems. It facilitates the interconnection of telephone subscriber lines or digital system virtual circuits, enabling telephone calls between subscribers.

Dialling is the action of initiating a telephone call by operating the rotary dial or the telephone keypad of a telephone.

References

  1. 1 2 "Filter Center". Aviation Week & Space Technology . Vol. 79, no. 13. September 23, 1963. pp. 97–101.
  2. ↑ AT&T (1974) Events in Telephone History
  3. ↑ Suelette Dreyfus, Digital Underground, ch. 10 (edited by Julian Assange)
  4. ↑ Graff, Garrett M. (2017). Raven Rock: The Story of the U.S. Government's Secret Plan to Save Itself - While the Rest of Us Die. Simon & Schuster.
  5. ↑ Copy of a 1971 "Official Global Autovon Telephone Directory"
  6. ↑ "Clause 3 - Multi-Level Precedence and Preemption (MLPP) International Telecommunication Union Recommendation Q.955.3". 1994-09-27.

PD-icon.svg This article incorporates public domain material from Federal Standard 1037C. General Services Administration. Archived from the original on 2022-01-22.

This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.