Concentration ratio

Last updated

In economics, concentration ratios are used to quantify market concentration and are based on companies' market shares in a given industry.

Contents

A concentration ratio (CR) is the sum of the percentage market shares of (a pre-specified number of) the largest firms in an industry. An n-firm concentration ratio is a common measure of market structure and shows the combined market share of the n largest firms in the market. For example, if n = 5, CR5 defines the combined market share of the five largest firms in an industry.

Competition economists and competition authorities typically employ concentration ratios (CRn) and the Herfindahl-Hirschman Index (HHI) as measures of market concentration.[ citation needed ]

Calculation

The concentration ratio is calculated as follows: [1]

where defines the market share of the th largest firm in an industry as a percentage of total industry market share, and defines the number of firms included in the concentration ratio calculation.

The and concentration ratios are commonly used. Concentration ratios show the extent of largest firms' market shares in a given industry. Specifically, a concentration ratio close to 0% denotes a low concentration industry, and a concentration ratio near 100% shows that an industry has high concentration.

Concentration levels

Concentration ratios range from 0%–100%. Concentration levels are explained as follows: [2]

Concentration LevelConcentration RatioExplanation
Perfect competitionPerfect competition exists where an industry's concentration ratio is CRn = n/N, where N is the number of firms in the industry. That is, all firms have an equal market share.
Low concentration – 40%A concentration ratio of close to 0% implies perfect competition at the least. This is only possible in an industry where there is a very large number of firms.
Medium concentration40% – 70%An industry in this range is likely an oligopoly. An oligopoly describes a market structure which is dominated by a small number of firms each with significant market shares.
High concentration70% – 100%This category ranges from an oligopoly to a monopoly.

Benefits and shortfalls

Concentration ratios can readily be calculated from industry data, but they are a simplistic, single parameter statistic. They can be used to quantify market concentration in a given industry in a relevant and succinct manner, but do not capture all available information about the distribution of market shares. In particular, the definition of the concentration ratio does not use the market shares of all the firms in the industry and does not account for the distribution of firm size. Also, it does not provide much detail about competitiveness of an industry. [1]

The following example exposes the aforementioned shortfalls of the concentration ratio.

Example

The table below shows the market shares of the largest firms in two different industries (Industry A and Industry B). Aside from the tabulated market shares for Industry A and Industry B, both industries are the same in terms of the number of firms operating in the industry and their respective market shares. In this example, in both cases, all other firms have a share of less than 10%.

Percentage market shares for two different industries
FirmIndustry AIndustry B
Firm 120%35%
Firm 220%25%
Firm 320%10%
Firm 420%10%


It is evident from these figures that Industry B is more concentrated than Industry A, since the market share is distributed more heavily towards the more dominant firms. However, Industry A and Industry B both have CR4 ratios of 80%. This shows that the CR ratio does not fully take into account the distribution of market share amongst the most dominant firms.

Related Research Articles

<span class="mw-page-title-main">Gini coefficient</span> Measure of inequality of a distribution

In economics, the Gini coefficient, also known as the Gini index or Gini ratio, is a measure of statistical dispersion intended to represent the income inequality, the wealth inequality, or the consumption inequality within a nation or a social group. It was developed by Italian statistician and sociologist Corrado Gini.

An oligopoly is a market in which control over an industry lies in the hands of a few large sellers who own a dominant share of the market. Oligopolistic markets have homogenous products, few market participants, and inelastic demand for the products in those industries. As a result of their significant market power, firms in oligopolistic markets can influence prices through manipulating the supply function. Firms in an oligopoly are also mutually interdependent, as any action by one firm is expected to affect other firms in the market and evoke a reaction or consequential action. As a result, firms in oligopolistic markets often resort to collusion as means of maximising profits.

<span class="mw-page-title-main">Relative density</span> Ratio of two densities

Relative density, sometimes called specific gravity, is a dimensionless quantity defined as the ratio of the density of a substance to the density of a given reference material. Specific gravity for liquids is nearly always measured with respect to water at its densest ; for gases, the reference is air at room temperature. The term "relative density" is often preferred in scientific usage, whereas the term "specific gravity" is deprecated.

Solubility equilibrium is a type of dynamic equilibrium that exists when a chemical compound in the solid state is in chemical equilibrium with a solution of that compound. The solid may dissolve unchanged, with dissociation, or with chemical reaction with another constituent of the solution, such as acid or alkali. Each solubility equilibrium is characterized by a temperature-dependent solubility product which functions like an equilibrium constant. Solubility equilibria are important in pharmaceutical, environmental and many other scenarios.

The Herfindahl index is a measure of the size of firms in relation to the industry they are in and is an indicator of the amount of competition among them. Named after economists Orris C. Herfindahl and Albert O. Hirschman, it is an economic concept widely applied in competition law, antitrust regulation, and technology management. HHI has continued to be used by antitrust authorities, primarily to evaluate and understand how mergers will affect their associated markets. HHI is calculated by squaring the market share of each competing firm in the industry—expressed as either fractions, decimals, or whole numbers—and then summing the resulting numbers. The result is proportional to the average market share, weighted by market share. As such, it can range from 0 to 1.0, moving from a huge number of very small firms to a single monopolistic producer. Increases in the HHI generally indicate a decrease in competition and an increase of market power, whereas decreases indicate the opposite. Alternatively, the index can be expressed per 10,000 "points". For example, an index of .25 is the same as 2,500 points.

An odds ratio (OR) is a statistic that quantifies the strength of the association between two events, A and B. The odds ratio is defined as the ratio of the odds of A in the presence of B and the odds of A in the absence of B, or equivalently, the ratio of the odds of B in the presence of A and the odds of B in the absence of A. Two events are independent if and only if the OR equals 1, i.e., the odds of one event are the same in either the presence or absence of the other event. If the OR is greater than 1, then A and B are associated (correlated) in the sense that, compared to the absence of B, the presence of B raises the odds of A, and symmetrically the presence of A raises the odds of B. Conversely, if the OR is less than 1, then A and B are negatively correlated, and the presence of one event reduces the odds of the other event.

A pre-money valuation is a term widely used in the private equity and venture capital industries. It refers to the valuation of a company or asset prior to an investment or financing. If an investment adds cash to a company, the company will have a valuation after the investment that is equal to the pre-money valuation plus the cash amount. That is, the pre-money valuation refers to the company's valuation before the investment. It is used by equity investors in the primary market, such as venture capitalists, private equity investors, corporate investors and angel investors. They may use it to determine how much equity they should be issued in return for their investment in the company. This is calculated on a fully diluted basis. For example, all warrants and options issued are taken into account.

In environmental chemistry, the chemical oxygen demand (COD) is an indicative measure of the amount of oxygen that can be consumed by reactions in a measured solution. It is commonly expressed in mass of oxygen consumed over volume of solution which in SI units is milligrams per litre (mg/L). A COD test can be used to easily quantify the amount of organics in water. The most common application of COD is in quantifying the amount of oxidizable pollutants found in surface water or wastewater. COD is useful in terms of water quality by providing a metric to determine the effect an effluent will have on the receiving body, much like biochemical oxygen demand (BOD).

<span class="mw-page-title-main">Bond duration</span> Weighted term of future cash flows

In finance, the duration of a financial asset that consists of fixed cash flows, such as a bond, is the weighted average of the times until those fixed cash flows are received. When the price of an asset is considered as a function of yield, duration also measures the price sensitivity to yield, the rate of change of price with respect to yield, or the percentage change in price for a parallel shift in yields.

Total shareholder return (TSR) is a measure of the performance of different companies' stocks and shares over time. It combines share price appreciation and dividends paid to show the total return to the shareholder expressed as an annualized percentage. It is calculated by the growth in capital from purchasing a share in the company assuming that the dividends are reinvested each time they are paid. This growth is expressed as a percentage as the compound annual growth rate.

Tobin's q, is the ratio between a physical asset's market value and its replacement value. It was first introduced by Nicholas Kaldor in 1966 in his paper: Marginal Productivity and the Macro-Economic Theories of Distribution: Comment on Samuelson and Modigliani. It was popularised a decade later by James Tobin, who in 1970, described its two quantities as:

One, the numerator, is the market valuation: the going price in the market for exchanging existing assets. The other, the denominator, is the replacement or reproduction cost: the price in the market for newly produced commodities. We believe that this ratio has considerable macroeconomic significance and usefulness, as the nexus between financial markets and markets for goods and services.

In economics, market power refers to the ability of a firm to influence the price at which it sells a product or service by manipulating either the supply or demand of the product or service to increase economic profit. In other words, market power occurs if a firm does not face a perfectly elastic demand curve and can set its price (P) above marginal cost (MC) without losing revenue. This indicates that the magnitude of market power is associated with the gap between P and MC at a firm's profit maximising level of output. The size of the gap, which encapsulates the firm's level of market dominance, is determined by the residual demand curve's form. A steeper reverse demand indicates higher earnings and more dominance in the market. Such propensities contradict perfectly competitive markets, where market participants have no market power, P = MC and firms earn zero economic profit. Market participants in perfectly competitive markets are consequently referred to as 'price takers', whereas market participants that exhibit market power are referred to as 'price makers' or 'price setters'.

Price–sales ratio, P/S ratio, or PSR, is a valuation metric for stocks. It is calculated by dividing the company's market capitalization by the revenue in the most recent year; or, equivalently, divide the per-share stock price by the per-share revenue.

The Lerner index, formalized in 1934 by British economist of Russian origin Abba Lerner, is a measure of a firm's market power.

<span class="mw-page-title-main">Market structure</span> Differentiation of firms by goods and operations

Market structure, in economics, depicts how firms are differentiated and categorised based on the types of goods they sell (homogeneous/heterogeneous) and how their operations are affected by external factors and elements. Market structure makes it easier to understand the characteristics of diverse markets.

A diversity index is a quantitative measure that reflects how many different types there are in a dataset, and that can simultaneously take into account the phylogenetic relations among the individuals distributed among those types, such as richness, divergence or evenness. These indices are statistical representations of biodiversity in different aspects.

In finance, return is a profit on an investment. It comprises any change in value of the investment, and/or cash flows which the investor receives from that investment over a specified time period, such as interest payments, coupons, cash dividends and stock dividends. It may be measured either in absolute terms or as a percentage of the amount invested. The latter is also called the holding period return.

In economics, market concentration is a function of the number of firms and their respective shares of the total production in a market. Market concentration is the portion of a given market's market share that is held by a small number of businesses. To ascertain whether an industry is competitive or not, it is employed in antitrust law and economic regulation. When market concentration is high, it indicates that a few firms dominate the market and oligopoly or monopolistic competition is likely to exist. In most cases, high market concentration produces undesirable consequences such as reduced competition and higher prices.

Market dominance is the control of a economic market by a firm. A dominant firm possesses the power to affect competition and influence market price. A firms' dominance is a measure of the power of a brand, product, service, or firm, relative to competitive offerings, whereby a dominant firm can behave independent of their competitors or consumers, and without concern for resource allocation. Dominant positioning is both a legal concept and an economic concept and the distinction between the two is important when determining whether a firm's market position is dominant.

The public market equivalent (PME) is a collection of performance measures developed to assess private equity funds and to overcome the limitations of the internal rate of return and multiple on invested capital measurements. While the calculations differ, they all attempt to measure the return from deploying a private equity fund's cash flows into a stock market index.

References

  1. 1 2 Besanko, David (1 July 2017). Economics of Strategy. Wiley. p. 162. ISBN   978-1-119-04231-0.
  2. "IBIS World". Archived from the original on 8 December 2018. Retrieved 21 July 2017.

See also