Muzzle rise

Last updated
Illustration of forces in muzzle rise. Projectile and propellant gases act on barrel along barrel centerline A. Forces are resisted by shooter contact with gun at grips and stock B. Height difference between barrel centerline and average point of contact is height C. Forces A and B operating over moment arm / height C create torque or moment D, which rotates the firearm's muzzle up as illustrated at E. MuzzleRise.png
Illustration of forces in muzzle rise. Projectile and propellant gases act on barrel along barrel centerline A. Forces are resisted by shooter contact with gun at grips and stock B. Height difference between barrel centerline and average point of contact is height C. Forces A and B operating over moment arm / height C create torque or moment D, which rotates the firearm's muzzle up as illustrated at E.

Muzzle rise, muzzle flip or muzzle climb refers to the tendency of a firearm's or airgun's muzzle (front end of the barrel) to rise up after firing. [1] It more specifically refers to the seemingly unpredictable "jump" of the firearm's muzzle, caused by combined recoil from multiple shots being fired in quick succession. It has an adverse effect on maintaining accuracy with using automatic weapons or rapid-firing semi-automatic firearms, as a moving muzzle can throw off the shooter's aim, causing subsequent shots to miss the intended target.

Contents

Reason

The primary reason for muzzle rise is that for nearly all guns, the bore axis (longitudinal centerline of the barrel) is above the gun's center of mass, while the contact points between the shooter and the gun (e.g. grips and stock) are often all below the center of mass. When the gun is fired, the bullet motion and the escaping propellant gases exert a reactional recoil directly backwards along the bore axis, while the countering forward push from the shooter's hands and body are well below it. This creates a rotational couple, exerting a torque around the center of mass that causes the gun to pitch upwards, causing the muzzle to elevate.

Muzzle rise can be reduced, though generally only through trading off other qualities. Methods include

Designs

A number of firearms have been designed specifically to address the issue of muzzle rise. The Jatimatic submachine gun is an example of a firearm where the bore axis is inclined against the bolt and the rest of the firearm in order to redirect the recoil force slightly upwards. The KRISS Vector submachine gun uses a more elaborate mechanical articulated mechanism which allows the block and bolt to recoil not just rearward like most other firearms, but back and then 'vectored' down off-axis along a rail system behind the weapon's magazine well to reduce muzzle rise and felt recoil.

The Hudson H9, introduced in 2017, is based on the M1911 but has the recoil spring down in front of the trigger guard, resulting in a barrel very close to the top of the shooter's grip, with the creator claiming that, "the recoil impulse from that recoil spring is directed into the meat of your hand." [2]

Related Research Articles

<span class="mw-page-title-main">Firearm</span> Gun for an individual

A firearm is any type of gun designed to be readily carried and used by an individual. The term is legally defined further in different countries.

<span class="mw-page-title-main">Muzzle brake</span> Anti-recoil gunbarrel attachment

A muzzle brake or recoil compensator is a device connected to, or a feature integral to the construction of, the muzzle or barrel of a firearm or cannon that is intended to redirect a portion of propellant gases to counter recoil and unwanted muzzle rise. Barrels with an integral muzzle brake are often said to be ported.

<span class="mw-page-title-main">Action (firearms)</span> Functional mechanism of breech-loading

In firearms terminology, an action is the functional mechanism of a breech-loading firearm that handles the ammunition cartridges, or the method by which that mechanism works. Actions are technically not present on muzzleloaders, as all those are single-shot firearms with a closed off breech with the powder and projectile manually loaded from the muzzle. Instead, the muzzleloader ignition mechanism is referred to as the lock.

<span class="mw-page-title-main">Recoil</span> Backward momentum of a gun when it is discharged

Recoil is the rearward thrust generated when a gun is being discharged. In technical terms, the recoil is a result of conservation of momentum, as according to Newton's third law the force required to accelerate something will evoke an equal but opposite reactional force, which means the forward momentum gained by the projectile and exhaust gases (ejectae) will be mathematically balanced out by an equal and opposite momentum exerted back upon the gun. In hand-held small arms, the recoil momentum will be eventually transferred to the ground, but will do so through the body of the shooter hence resulting in a noticeable impulse commonly referred to as a "kick".

<span class="mw-page-title-main">Flash suppressor</span> Exhaust gas light-dimming gunbarrel attachment

A flash suppressor, also known as a flash guard, flash eliminator, flash hider, or flash cone, is a muzzle device attached to the muzzle of a rifle that reduces its visible signature while firing by cooling or dispersing the burning gases that exit the muzzle, a phenomenon typical of carbine-length weapons. Its primary intent is to reduce the chances that the shooter will be blinded in low-light shooting conditions. Contrary to popular belief, it is only a minor secondary benefit if a flash suppressor reduces the intensity of the flash visible to the enemy.

<span class="mw-page-title-main">.38 Super</span> Pistol cartridge designed by Colts Manufacturing Company, LLC

The .38 Super, also known as .38 Super +P, .38 Super Auto, .38 Super Automatic, .38 Super Automatic +P, or 9×23mmSR, is a pistol cartridge that fires a 0.356-inch-diameter (9.04 mm) bullet. It was introduced in the late 1920s as a higher pressure loading of the .38 ACP, also known as .38 Auto. The older .38 ACP cartridge propels a 130-grain (8.4 g) bullet at 1,050 ft/s (320.0 m/s), whereas the .38 Super pushes the same bullet at 1,280 ft/s (390.1 m/s). The .38 Super has gained distinction as the caliber of choice for many top practical shooting competitors; it remains one of the dominant calibers in IPSC competition.

<span class="mw-page-title-main">Gun barrel</span> Firearm component which guides the projectile during acceleration

A gun barrel is a crucial part of gun-type weapons such as small firearms, artillery pieces, and air guns. It is the straight shooting tube, usually made of rigid high-strength metal, through which a contained rapid expansion of high-pressure gas(es) is used to propel a projectile out of the front end (muzzle) at a high velocity. The hollow interior of the barrel is called the bore, and the diameter of the bore is called its caliber, usually measured in inches or millimetres.

<span class="mw-page-title-main">.22 Long Rifle</span> Common ammunition cartridge

The .22 Long Rifle or simply .22 LR is a long-established variety of .22 caliber rimfire ammunition originating from the United States. It is used in a wide range of rifles, pistols, revolvers, smoothbore shotguns, and submachine guns.

Internal ballistics, a subfield of ballistics, is the study of the propulsion of a projectile.

Blowback is a system of operation for self-loading firearms that obtains energy from the motion of the cartridge case as it is pushed to the rear by expanding gas created by the ignition of the propellant charge.

<span class="mw-page-title-main">Transitional ballistics</span>

Transitional ballistics, also known as intermediate ballistics, is the study of a projectile's behavior from the time it leaves the muzzle until the pressure behind the projectile is equalized, so it lies between internal ballistics and external ballistics.

<span class="mw-page-title-main">Accurizing</span> Process of improving the accuracy and precision of a gun

Accurizing is the process of improving the accuracy and precision of a gun.

<span class="mw-page-title-main">Gas-operated reloading</span> System of operation used to provide energy to operate autoloading firearms

Gas-operation is a system of operation used to provide energy to operate locked breech, autoloading firearms. In gas-operation, a portion of high-pressure gas from the cartridge being fired is used to power a mechanism to dispose of the spent case and insert a new cartridge into the chamber. Energy from the gas is harnessed through either a port in the barrel or a trap at the muzzle. This high-pressure gas impinges on a surface such as a piston head to provide motion for unlocking of the action, extraction of the spent case, ejection, cocking of the hammer or striker, chambering of a fresh cartridge, and locking of the action.

<span class="mw-page-title-main">Pistol</span> Type of handgun where the firing chamber is integral to the barrel

A pistol is a handgun, more specifically one with the chamber integral to its gun barrel, though in common usage the two terms are often used interchangeably. The English word was introduced in ca. 1570, when early handguns were produced in Europe, and is derived from the Middle French pistolet, meaning a small gun or knife. In colloquial usage, the word "pistol" is often used to describe any type of handgun, inclusive of revolvers and the pocket-sized derringers.

<span class="mw-page-title-main">KRISS Vector</span> Submachine gun

The KRISS Vector is a series of weapons based upon the parent submachine gun design developed by the American company KRISS USA, formerly Transformational Defense Industries (TDI). They use an unconventional delayed blowback system combined with in-line design to reduce perceived recoil and muzzle climb.

<span class="mw-page-title-main">Muzzle blast</span> Explosive shockwave from firearm muzzle

A muzzle blast is an explosive shockwave created at the muzzle of a firearm during shooting. Before a projectile leaves the gun barrel, it obturates the bore and "plugs up" the pressurized gaseous products of the propellant combustion behind it, essentially containing the gases within a closed system as a neutral element in the overall momentum of the system's physics. However, when the projectile exits the barrel, this functional seal is removed and the highly energetic bore gases are suddenly free to exit the muzzle and rapidly expand in the form of a supersonic shockwave, thus creating the muzzle blast.

The following are terms related to firearms and ammunition topics.

Recoil operation is an operating mechanism used to implement locked breech, autoloading firearms. Recoil operated firearms use the energy of recoil to cycle the action, as opposed to gas operation or blowback operation using the pressure of the propellant gas.

<span class="mw-page-title-main">Silencer (firearms)</span> Device which reduces sound intensity or muzzle flash on a firearm

A silencer, also known as a sound suppressor, suppressor, or sound moderator, is a muzzle device that reduces the acoustic intensity of the muzzle report and muzzle rise when a gun is discharged, by modulating the speed and pressure of the propellant gas from the muzzle and hence suppressing the muzzle blast. Like other muzzle devices, a silencer can be a detachable accessory mounted to the muzzle, or an integral part of the barrel.

The bore axis of a firearm is the longitudinal axis through the geometric center of the gun barrel. In a rifled barrel, the projectile will spin around the bore axis as it goes through the barrel.

References

  1. Recoil management: how you hold makes all the difference, Guns Magazine, Oct 2006 by Dave Anderson
  2. Slowik, Max (2017-01-11). "The Hudson Mfg. H9: Rethinking Handgun Design". GunsAmerica Digest. Retrieved 2017-01-30.