The RCA Type 77-DX microphone is a poly-directional ribbon microphone, or pressure-gradient microphone, introduced by the RCA Corporation in 1954. It was preceded by the Type 77-D introduced in 1948. [1] Its popularity and classic design has resulted in the 77-DX becoming an iconic microphone, used by broadcasters and media personalities such as Edward R. Murrow, David Letterman and Larry King. [2] [3]
The directionality of the 77-DX is variable. A rotating backshutter on the acoustic labyrinth, controlled by a screwdriver-operated slot at the rear of the microphone, allows the user to vary the microphone's pattern from omnidirectional in the fully closed position, to cardioid, to figure-8 (bidirectional) in the fully open position. A 3-position switch at the bottom end of the microphone allows the user to control the amount of low-frequency rolloff. [4]
At 1 kHz, the 77-DX has an output of -50 to -56dbm, depending on the pattern selection. The output impedance is user-selectable; factory preset at 250 ohms, and changeable to 30 or 150 ohms. The microphone has a fairly flat response. In the cardioid (unidirectional) pattern, it is level from approximately 150 Hz to 2 kHz, with a slight rise peaking at just under 5 kHz, then dropping approximately 3 dB/octave to 20 kHz. [4]
The 77-DX has been used on countless vocal recordings by Bing Crosby, Kate Smith, Frank Sinatra, Elvis Presley, Johnny Cash, Al Green, and many others. It is still sought after today for use in recording brass instruments.
Audio engineers experienced with the 77-DX can position the microphone at different angles to modify its frequency response. For example, with the microphone suspended, tilting it on the horizontal axis will cause the ribbon to sag slightly, resulting in a noticeable boost in the lower-midrange frequencies. [5]
The ribbon is positioned inside the housing in such a way that "p" sounds (plosives) may cause popping sounds, due to the explosion of air directly into the ribbon. [2] A common solution to this problem has been to attach a pencil vertically across the front of the microphone. The pencil deflects a vocalist's breath as it reaches the microphone, and prevents it from hitting the ribbon directly. [6]
A microphone, colloquially called a mic, or mike, is a transducer that converts sound into an electrical signal. Microphones are used in many applications such as telephones, hearing aids, public address systems for concert halls and public events, motion picture production, live and recorded audio engineering, sound recording, two-way radios, megaphones, and radio and television broadcasting. They are also used in computers and other electronic devices, such as mobile phones, for recording sounds, speech recognition, VoIP, and other purposes, such as ultrasonic sensors or knock sensors.
A tweeter or treble speaker is a special type of loudspeaker that is designed to produce high audio frequencies, typically deliver high frequencies up to 100 kHz. The name is derived from the high pitched sounds made by some birds (tweets), especially in contrast to the low woofs made by many dogs, after which low-frequency drivers are named (woofers).
Headphones are a pair of small loudspeaker drivers worn on or around the head over a user's ears. They are electroacoustic transducers, which convert an electrical signal to a corresponding sound. Headphones let a single user listen to an audio source privately, in contrast to a loudspeaker, which emits sound into the open air for anyone nearby to hear. Headphones are also known as earphones or, colloquially, cans. Circumaural and supra-aural headphones use a band over the top of the head to hold the speakers in place. Another type, known as earbuds or earpieces, consists of individual units that plug into the user's ear canal. A third type are bone conduction headphones, which typically wrap around the back of the head and rest in front of the ear canal, leaving the ear canal open. In the context of telecommunication, a headset is a combination of a headphone and microphone.
Surround sound is a technique for enriching the fidelity and depth of sound reproduction by using multiple audio channels from speakers that surround the listener. Its first application was in movie theaters. Prior to surround sound, theater sound systems commonly had three screen channels of sound that played from three loudspeakers located in front of the audience. Surround sound adds one or more channels from loudspeakers to the side or behind the listener that are able to create the sensation of sound coming from any horizontal direction around the listener.
A ribbon microphone, also known as a ribbon velocity microphone, is a type of microphone that uses a thin aluminum, duraluminum or nanofilm of electrically conductive ribbon placed between the poles of a magnet to produce a voltage by electromagnetic induction. Ribbon microphones are typically bidirectional, meaning that they pick up sounds equally well from either side of the microphone.
A boundary microphone is one or more small omnidirectional or cardioid condenser mic capsule(s) positioned near or flush with a boundary (surface) such as a floor, table, or wall. The capsule(s) are typically mounted in a flat plate or housing. The arrangement provides a directional half-space pickup pattern while delivering a relatively phase-coherent output signal.
The Shure SM57 is a low-impedance cardioid dynamic microphone made by Shure Incorporated and commonly used in live sound reinforcement and studio recording. It is one of the best-selling microphones in the world. It is used extensively in amplified music and has been used for speeches by every U.S. president since its introduction in 1965. In 2004, honoring its four decades of "solid, dependable performance", it was inducted into the first-ever TEC Awards TECnology Hall of Fame.
Georg Neumann GmbH is a manufacturer of professional recording microphones. It was founded in by Georg Neumann in 1928 and is based in Berlin, Germany. Their best-known products are condenser microphones for recording, broadcast, and live music production purposes. For several decades Neumann was also a leading manufacturer of cutting lathes for phonograph disks, and even ventured into the field of mixing desks. Today Neumann also manufactures preamplifiers, studio monitors, headphones, and audio interfaces.
The RCA Type 77-A microphone was a simplex (uni-directional) ribbon microphone, the forerunner of the RCA Type 77-DX microphone. The 77-A was designed Dr. Harry F. Olson in the late 1920s or early 1930s; prototypes are rumored to have existed in 1929 and 1930, but the 77-A was not announced until 1932.
The H4 Handy Recorder is a handheld digital audio recorder from Zoom, featuring built-in condenser microphones in an X-Y stereo pattern, priced from around US$280 depending upon memory capacity as of 2011.
The Roland MS-1 digital sampler was a compact, 16-bit digital audio phrase sampler produced by Roland in 1994 as a straightforward, inexpensive, entry-level sampler. In 1998, the MS-1 was succeeded by the Boss SP-202 sampler.
The H2 Handy Recorder is a handheld digital audio recorder from Zoom first announced at the NAMM Show in February 2007. It records very high quality digital stereo or 4-channel audio on a hand-held unit, and has been called "the studio on a stick."
The proximity effect in audio is an increase in bass or low frequency response when a sound source is close to a directional or cardioid microphone. Proximity effect is a change in the frequency response of a directional pattern microphone that results in an emphasis on lower frequencies. It is caused by the use of ports to create directional polar pickup patterns, so omni-directional microphones do not exhibit the effect
.
The Coles 4038 is a ribbon microphone produced by Coles Electroacoustics. The microphone was designed and patented by the BBC in the 1950s and was originally known as the STC 4038. The sound of the microphone has been described as "British" with a "BBC politeness", and its appearance has been likened to that of a waffle iron. It is used in both sound recording and radio broadcasting.
A valve microphone is a condenser microphone which uses a valve amplifier rather than a transistor circuit.
The Shure MV7 is a cardioid dynamic microphone used for podcasting and home studio applications. The MV7 was developed in 2020 by Shure as a digital audio reworking of the classic SM7B professional broadcasting microphone. The MV7 was rated the best podcasting microphone by Rolling Stone in their 2021 Audio Awards.
The Shure SM7 is a professional cardioid dynamic microphone, commonly used in broadcasting applications since 1973. Designed by Shure, it has been described as an "iconic" industry standard microphone for its focused, directional sound and its widespread adoption in radio, television and recording studios. In 2007–2008, the SM7B model became popular for professional podcasting.
The Electro-Voice RE20 is an American professional cardioid dynamic microphone, commonly used in broadcasting applications since 1968. Designed by Electro-Voice using the company's patented Variable-D technology and a large-diaphragm element, it has been described as an industry standard "iconic" microphone for its natural sound and its wide usage in radio, television and recording studios. In 2015, the RE20 was inducted into the TEC Awards Technology Hall of Fame.
The RCA Type 44 microphone is a bi-directional ribbon microphone, or pressure-gradient microphone, first introduced by the RCA Corporation in 1931.
RCA 77DX ribbon microphone, one of those iconic capsule-shaped mikes similar to the ones that Larry King and David Letterman keep on their desks.