Richter tuning

Last updated

Richter tuning is a system of choosing the reeds for a diatonic wind instrument (such as a harmonica or accordion). It is named after Joseph Richter, a Bohemian instrument maker who adopted the tuning for his harmonicas in the early 19th century and is credited with inventing the blow/draw mechanism that allows the harmonica to play different notes when the air is drawn instead of blown.

Contents

Richter tuning is designed as a compromise between diatonic melody and harmony. The lower portion of the harmonica is designed to play the tonic and dominant chords on the blow and draw respectively (in the key of C, this would be the C major and G major chords). The remainder of the instrument is tuned to, in this example, blow entirely in the key of C major, with each successive note following the sequence

C E G

and the four notes not in the C major chord arranged on the draw in the sequence

D F A B.

For example:

hole 1 2 3 4 5 6 7 8 910111213141516
blow noteGCEGCEGCEGCEGCEG
draw noteBDGBDFABDFABDFAB

The above diagram shows that Richter tuning has some missing notes, notably A and F are absent from the lowest octave (draw notes in holes 3 and 4). By comparison, solo tuning includes all the major scale notes (C D E F G A B C) for all octaves.

Variants

There have been many variants of Richter tuning.

Country tuning

Country tuning raises the initial F by a semitone to an F. This primarily aids in harmony in the key of G, facilitating easy play of the G-C-D (I-IV-V) chord progression, while maintaining a partial G7 (minus the root) higher on the harmonica. It can occasionally be helpful in some melodies, most notably "The Star-Spangled Banner," which has a low F# and a high F. For example:

hole 1 2 3 4 5 6 7 8 910
blow noteCEGCEGCEGC
draw noteDGBDFABDFA

(Compare this to major seventh tuning, below.)

Harmonic minor tuning

Harmonic minor tuning is a variation in which E is replaced by E and A is replaced by A. Thus the blow notes repeat a sequence of

C E G

(perhaps shifted to begin with E or with G) and draw notes at some point begin to follow a repeating sequence of

D F A B

though perhaps with a different initial sequence.

For example:

hole 1 2 3 4 5 6 7 8 910111213141516
blow noteGCEGCEGCEGCEGCEG
draw noteBDGBDFABDFABDFAB

Major seventh tuning

Major seventh tuning raised each F by a semitone to F♯. For example

hole 1 2 3 4 5 6 7 8 910111213141516
blow noteGCEGCEGCEGCEGCEG
draw noteBDGBDFABDFABDFAB

(Compare this to country tuning, above.)

Melody Maker tuning

Melody Maker tuning raises the third Blow (Exhale) note by a full note, and raises the #5 Draw by a semitone to F. For example:

hole 1 2 3 4 5 6 7 8 910
blow noteCEACEGCEGC
draw noteDGBDF#ABDF#A

Note: the Melody Maker tuning is key labeled from the Draw (Inhale) Second Position. The example above shows a Melody Maker in the Key of G.

The Melody Maker tuning was developed by Lee Oskar Harmonicas in the early 1980s.[ citation needed ]

Natural minor tuning

Natural minor tuning is a variation in which E is replaced by E and B is replaced by B. Thus the blow notes repeat a sequence of

C E G

(perhaps shifted to begin with E or with G) and draw notes at some point begin to follow a repeating sequence of

D F A B

though perhaps with a different initial sequence.

For example:

hole 1 2 3 4 5 6 7 8 910111213141516
blow noteGCEGCEGCEGCEGCEG
draw noteBDGBDFABDFABDFAB

Paddy Richter tuning

Paddy Richter tuning (developed by Brendan Power) allows a two octave scale suitable for melody-based music. It was developed with Irish jigs, reels and hornpipes in mind but is suitable for other melodic music also; it allows pentatonic scales in the stated key and up a fifth; for instance, an instrument in the key of G can play both the G and D major pentatonic scales throughout the length of the instrument). The tuning raises the 3 blow by a whole step e.g. from D to E on a G harp; this addition of the sixth also allows melodies on a harmonica's corresponding minor scale (e.g. E minor on a G harmonica) to be played an octave lower than would otherwise be possible without bending. The addition of this, however, adds an additional complication to playing harmonic music on the harmonica, requiring the 3 hole to be blocked when playing a tonic chord. The lower octave requires a bend on the 2 draw to achieve a missing note (on a G harmonica, a C when playing in G, or a C# when playing in D), which is also required on standard Richter-tuned harmonicas.

For example:

hole 1 2 3 4 5 6 7 8 910
blow noteGBEGBDGBDG
draw noteADF#ACEF#ACE

(above Paddy Richter tuning was checked on a Paddy Richter G Harp using an electronic Chromatic Tuner)

Richter Extended tuning

So-called Richter Extended tuning is in fact a significant departure from Richter tuning. In "Richter extended tuning," all Fs and As are removed from the instrument, and the dominant (G) chord is, like C on the blow, extended through all of the holes on the draw, following the sequence

D G B.

For example:

hole 1 2 3 4 5 6 7 8 9101112
blow noteCEGCEGCEGCEG
draw noteDGBDGBDGBDGB

Powerbender tuning

Powerbender tuning was created by Brendan Power and utilises the standard Richter layout on the first four holes, but modifies holes 5 to 10 to enable more useful draw bends (in terms of blues and jazz melodies) on all of the upper register notes. [1]

This tuning also negates the need for overblows to achieve the blues scale throughout the whole two octaves of the harmonica, which would be required on a standard Richter tuned harp. [2]

For example:

hole 1 2 3 4 5 6 7 8 910
blow noteCEGCDFACEA
draw noteDGBDEGBDGC

See also

Related Research Articles

<span class="mw-page-title-main">Harmonica</span> Free reed wind musical instrument

The harmonica, also known as a French harp, mouth harp or mouth organ, is a free reed wind instrument used worldwide in many musical genres, notably in blues, American folk music, classical music, jazz, country, and rock. The many types of harmonica include diatonic, chromatic, tremolo, octave, orchestral, and bass versions. A harmonica is played by using the mouth to direct air into or out of one holes along a mouthpiece. Behind each hole is a chamber containing at least one reed. The most common is the diatonic Richter-tuned with ten air passages and twenty reeds, often called the blues harp. A harmonica reed is a flat, elongated spring typically made of brass, stainless steel, or bronze, which is secured at one end over a slot that serves as an airway. When the free end is made to vibrate by the player's air, it alternately blocks and unblocks the airway to produce sound.

<span class="mw-page-title-main">Musical keyboard</span> Musical instrument component

A musical keyboard is the set of adjacent depressible levers or keys on a musical instrument. Keyboards typically contain keys for playing the twelve notes of the Western musical scale, with a combination of larger, longer keys and smaller, shorter keys that repeats at the interval of an octave. Pressing a key on the keyboard makes the instrument produce sounds—either by mechanically striking a string or tine, plucking a string (harpsichord), causing air to flow through a pipe organ, striking a bell (carillon), or, on electric and electronic keyboards, completing a circuit. Since the most commonly encountered keyboard instrument is the piano, the keyboard layout is often referred to as the piano keyboard.

In music theory, a scale is any set of musical notes ordered by fundamental frequency or pitch. A scale ordered by increasing pitch is an ascending scale, and a scale ordered by decreasing pitch is a descending scale.

In music theory, an interval is a difference in pitch between two sounds. An interval may be described as horizontal, linear, or melodic if it refers to successively sounding tones, such as two adjacent pitches in a melody, and vertical or harmonic if it pertains to simultaneously sounding tones, such as in a chord.

In music theory, the key of a piece is the group of pitches, or scale, that forms the basis of a musical composition in Western classical music, art music, and pop music.

Tonality or key: Music which uses the notes of a particular scale is said to be "in the key of" that scale or in the tonality of that scale.

In music, two written notes have enharmonic equivalence if they produce the same pitch but are notated differently. The enharmonic relation extends to pitch classes, intervals, chords, and key signatures. The term derives from Latin enharmonicus, in turn from Late Latin enarmonius, from Ancient Greek ἐναρμόνιος, from ἐν ('in') and ἁρμονία ('harmony').

<span class="mw-page-title-main">Circle of fifths</span> Relationship among tones of the chromatic scale

In music theory, the circle of fifths is a way of organizing the 12 chromatic pitches as a sequence of perfect fifths.. If C is chosen as a starting point, the sequence is: C, G, D, A, E, B, F, C, A, E, B, F. Continuing the pattern from F returns the sequence to its starting point of C. This order places the most closely related key signatures adjacent to one another. It is usually illustrated in the form of a circle.

<span class="mw-page-title-main">Letter notation</span> Musical nomenclature with letters to indicate pitch

In music, letter notation is a system of representing a set of pitches, for example, the notes of a scale, by letters. For the complete Western diatonic scale, for example, these would be the letters A-G, possibly with a trailing symbol to indicate a half-step raise or a half-step lowering. This is the most common way of specifying a note in speech or in written text in English or German. In Germany, Scandinavia, and parts of Central and Eastern Europe, H is used instead of B, and B is used instead of B. In traditional Irish music, where almost all tunes are restricted to two octaves, for notes in the lower octave to written in lower case while those in the upper octave to be written in upper case.

<span class="mw-page-title-main">Richter-tuned harmonica</span> Musical instrument

The Richter-tuned harmonica, or 10-hole harmonica or blues harp, is the most widely known type of harmonica. It is a variety of diatonic harmonica, with ten holes which offer the player 19 notes in a three-octave range.

There are numerous techniques available for playing the harmonica, including bending, overbending, and tongue blocking.

Jazz chords are chords, chord voicings and chord symbols that jazz musicians commonly use in composition, improvisation, and harmony. In jazz chords and theory, most triads that appear in lead sheets or fake books can have sevenths added to them, using the performer's discretion and ear. For example, if a tune is in the key of C, if there is a G chord, the chord-playing performer usually voices this chord as G7. While the notes of a G7 chord are G–B–D–F, jazz often omits the fifth of the chord—and even the root if playing in a group. However, not all jazz pianists leave out the root when they play voicings: Bud Powell, one of the best-known of the bebop pianists, and Horace Silver, whose quintet included many of jazz's biggest names from the 1950s to the 1970s, included the root note in their voicings.

<span class="mw-page-title-main">Diatonic button accordion</span> Musical instrument of the free-reed aerophone family

A melodeon or diatonic button accordion is a member of the free-reed aerophone family of musical instruments. It is a type of button accordion on which the melody-side keyboard contains one or more rows of buttons, with each row producing the notes of a single diatonic scale. The buttons on the bass-side keyboard are most commonly arranged in pairs, with one button of a pair sounding the fundamental of a chord and the other the corresponding major triad.

The chromatic harmonica is a type of harmonica that uses a button-activated sliding bar to redirect air from the hole in the mouthpiece to the selected reed-plate desired. When the button is not pressed, an altered diatonic major scale of the key of the harmonica is available, while depressing the button accesses the same scale a semitone higher in each hole. Thus, the instrument is capable of playing the 12 notes of the Western chromatic scale. The chromatic harmonica can thus be contrasted with a standard harmonica, which can play only the notes in a given musical key.

A or La is the sixth note and the tenth semitone of the fixed-do solfège.

<span class="mw-page-title-main">Diatonic and chromatic</span> Terms in music theory to characterize scales

Diatonic and chromatic are terms in music theory that are most often used to characterize scales, and are also applied to musical instruments, intervals, chords, notes, musical styles, and kinds of harmony. They are very often used as a pair, especially when applied to contrasting features of the common practice music of the period 1600–1900.

In music, harmonization is the chordal accompaniment to a line or melody: "Using chords and melodies together, making harmony by stacking scale tones as triads".

Solo tuning is a system of choosing the reeds for a diatonic wind instrument to fit a pattern where blow notes repeat a sequence of

Diminished tuning is a system of choosing the reeds for a diatonic wind instrument in which the blow notes repeat a sequence of

<span class="mw-page-title-main">Major thirds tuning</span> Regular tuning among guitars

Among alternative tunings for guitar, a major-thirds tuning is a regular tuning in which each interval between successive open strings is a major third. Other names for major-thirds tuning include major-third tuning, M3 tuning, all-thirds tuning, and augmented tuning. By definition, a major-third interval separates two notes that differ by exactly four semitones.

<span class="mw-page-title-main">Anglo concertina</span> Musical instrument

The Anglo or Anglo-German concertina is a member of the concertina family of free-reed instruments.

References