Rooftop water tower

Last updated
Rooftop water towers atop apartment buildings on East 57th Street in New York City showing differing kinds of tank Rooftop water towers on New York apartment buildings.jpg
Rooftop water towers atop apartment buildings on East 57th Street in New York City showing differing kinds of tank
A highrise residential building with integrated water tank in Bremerhaven, Germany Bhv wohnwasserturm hg.jpg
A highrise residential building with integrated water tank in Bremerhaven, Germany

A rooftop water tower is a variant of a water tower, consisting of a water container placed on the roof of a tall building.

Contents

This structure supplies water pressure to floors at higher elevation than public water towers. [1]

As building height increases, the vertical height of its plumbing also increases. This produces a large water column and the weight of this water produces very high pressure at the bottom of the column. Normally, this would require very thick (heavy-duty) plumbing to survive the pressure. Fittings at the bottom of the column would need pressure reducing valves to operate normally, and municipal water pressure would need to be very high to supply pressure to the top of the column.

Instead, the plumbing at various levels of the building are often sequestered, with pressure supplied from a rooftop water tower instead of the municipal supply. The tower itself is fed by a pump and a relatively high pressure line that carries water to the top of the building from the pipes below.

Wooden water towers on rooftops in New York City George Washington Bridge, on a late winter afternoon.jpg
Wooden water towers on rooftops in New York City

Beside this, also tall buildings with water tanks in the structure of the building exist. The tanks of such buildings usually do not serve only for keeping water pressure in higher floors, but often also for the public water supply.

Maintenance

Regular cleaning of tanks in use is necessary, in order to prevent possible water contamination. [2] Cleaning a water tank usually takes about six hours depending on the size of the tank. Most tanks in New York City are around 12 ft high and similar in diameter. This process includes scraping away the sediment and any debris that the tank has accumulated, then the interior surfaces are cleaned with a chlorine solution. Routine inspection for holes and cracks is also necessary, to prevent the intrusion of contaminants. Any holes are calked with epoxy and the metal hoops used to secure the walls of the tank are tightened to spec. [3]

In 2009, New York City passed new laws forcing property owners to have their tanks inspected annually, with proof of inspection. Inspection reports must also be available to all tenants in the building. If any unsatisfactory results are found, the individual responsible for the building must immediately have the tank cleaned up to city safety standards. Failure to comply with these rules can lead to the imposition of fines on the property owner. [2] [4]

See also

Related Research Articles

<span class="mw-page-title-main">Pressure</span> Force distributed over an area

Pressure is the force applied perpendicular to the surface of an object per unit area over which that force is distributed. Gauge pressure is the pressure relative to the ambient pressure.

<span class="mw-page-title-main">Skyscraper</span> Tall habitable building

A skyscraper is a tall continuously habitable building having multiple floors. Modern sources currently define skyscrapers as being at least 100 metres (330 ft) or 150 metres (490 ft) in height, though there is no universally accepted definition. Skyscrapers are very tall high-rise buildings. Historically, the term first referred to buildings with between 10 and 20 stories when these types of buildings began to be constructed in the 1880s. Skyscrapers may host offices, hotels, residential spaces, and retail spaces.

<span class="mw-page-title-main">Plumbing</span> Systems for conveying fluids

Plumbing is any system that conveys fluids for a wide range of applications. Plumbing uses pipes, valves, plumbing fixtures, tanks, and other apparatuses to convey fluids. Heating and cooling (HVAC), waste removal, and potable water delivery are among the most common uses for plumbing, but it is not limited to these applications. The word derives from the Latin for lead, plumbum, as the first effective pipes used in the Roman era were lead pipes.

<span class="mw-page-title-main">Water tower</span> Elevated structure supporting a tank

A water tower is an elevated structure supporting a water tank constructed at a height sufficient to pressurize a distribution system for potable water, and to provide emergency storage for fire protection. Water towers often operate in conjunction with underground or surface service reservoirs, which store treated water close to where it will be used. Other types of water towers may only store raw (non-potable) water for fire protection or industrial purposes, and may not necessarily be connected to a public water supply.

<span class="mw-page-title-main">Flush toilet</span> Toilet that uses water to convey human waste down a pipe

A flush toilet is a toilet that disposes of human waste by using the force of water to flush it through a drainpipe to another location for treatment, either nearby or at a communal facility, thus maintaining a separation between humans and their waste. Flush toilets can be designed for sitting or squatting, in the case of squat toilets. Most modern sewage treatment systems are also designed to process specially designed toilet paper. The opposite of a flush toilet is a dry toilet, which uses no water for flushing.

<span class="mw-page-title-main">Fire hydrant</span> Connection point by which firefighters can tap into a water supply

A fire hydrant, fireplug, or firecock (archaic) is a connection point by which firefighters can tap into a water supply. It is a component of active fire protection. Underground fire hydrants have been used in Europe and Asia since at least the 18th century. Above-ground pillar-type hydrants are a 19th-century invention.

<span class="mw-page-title-main">Hydrostatic test</span> Non-destructive test of pressure vessels

A hydrostatic test is a way in which pressure vessels such as pipelines, plumbing, gas cylinders, boilers and fuel tanks can be tested for strength and leaks. The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection, and pressurization of the vessel to the specified test pressure. Pressure tightness can be tested by shutting off the supply valve and observing whether there is a pressure loss. The location of a leak can be visually identified more easily if the water contains a colorant. Strength is usually tested by measuring permanent deformation of the container.

<span class="mw-page-title-main">Siphon</span> Device involving the flow of liquids through tubes

A siphon is any of a wide variety of devices that involve the flow of liquids through tubes. In a narrower sense, the word refers particularly to a tube in an inverted "U" shape, which causes a liquid to flow upward, above the surface of a reservoir, with no pump, but powered by the fall of the liquid as it flows down the tube under the pull of gravity, then discharging at a level lower than the surface of the reservoir from which it came.

<span class="mw-page-title-main">Water heating</span> Thermodynamic process that uses energy sources to heat water

Water heating is a heat transfer process that uses an energy source to heat water above its initial temperature. Typical domestic uses of hot water include cooking, cleaning, bathing, and space heating. In industry, hot water and water heated to steam have many uses.

<span class="mw-page-title-main">Pressure vessel</span> Vessel for pressurised gases or liquids

A pressure vessel is a container designed to hold gases or liquids at a pressure substantially different from the ambient pressure.

<span class="mw-page-title-main">Drain-waste-vent system</span>

In modern plumbing, a drain-waste-vent is a system that allows air to enter the plumbing system to maintain proper air pressure to enable the removal of sewage and greywater from a dwelling. Drain refers to water produced at fixtures such as sinks, and showers; waste refers to water from toilets. As the water runs down, proper venting is required to allow water to flow freely, and avoid a vacuum from being created. As the water runs down air must be allowed into the waste pipe either through a roof vent (external), or an internal vent.

<span class="mw-page-title-main">Gas holder</span> Large container for storing gaseous fuel

A gas holder or gasholder, also known as a gasometer, is a large container in which natural gas or town gas is stored near atmospheric pressure at ambient temperatures. The volume of the container follows the quantity of stored gas, with pressure coming from the weight of a movable cap. Typical volumes for large gas holders are about 50,000 cubic metres (1,800,000 cu ft), with 60-metre (200 ft) diameter structures.

<span class="mw-page-title-main">High Bridge (New York City)</span> Bridge between Manhattan and the Bronx, New York

The High Bridge is the oldest bridge in New York City, having originally opened as part of the Croton Aqueduct in 1848 and reopened as a pedestrian walkway in 2015 after being closed for over 45 years. A steel arch bridge with a height of 140 ft (43 m) over the Harlem River, it connects the New York City boroughs of the Bronx and Manhattan. The eastern end is located in the Highbridge section of the Bronx near the western end of West 170th Street, and the western end is located in Highbridge Park in Manhattan, roughly parallel to the end of West 174th Street.

<span class="mw-page-title-main">Water tank</span> Container for storing water

A water tank is a container for storing water.

Level sensors detect the level of liquids and other fluids and fluidized solids, including slurries, granular materials, and powders that exhibit an upper free surface. Substances that flow become essentially horizontal in their containers because of gravity whereas most bulk solids pile at an angle of repose to a peak. The substance to be measured can be inside a container or can be in its natural form. The level measurement can be either continuous or point values. Continuous level sensors measure level within a specified range and determine the exact amount of substance in a certain place, while point-level sensors only indicate whether the substance is above or below the sensing point. Generally the latter detect levels that are excessively high or low.

<span class="mw-page-title-main">Storage tank</span> Container for liquids or compressed gas

Storage tanks are containers that hold liquids, compressed gases or mediums used for the short- or long-term storage of heat or cold. The term can be used for reservoirs, and for manufactured containers. The usage of the word tank for reservoirs is uncommon in American English but is moderately common in British English. In other countries, the term tends to refer only to artificial containers.

<span class="mw-page-title-main">Potable water diving</span> Underwater diving in potable water systems

Potable water diving is diving inside a tank that is used for potable water. This is usually done for inspection and cleaning tasks. A person who is trained to do this work may be described as a potable water diver. The risks to the diver associated with potable water diving are related to the access, confined spaces and outlets for the water. The risk of contamination of the water is managed by isolating the diver in a clean dry-suit and helmet or full-face mask which are decontaminated before the dive.

A truckmount carpet cleaner is a carpet and upholstery cleaning unit that is generally mounted to the floor of a van or trailer. Its cleaning method is hot water extraction. The operator would park the van near the premises, connect the vacuum hose and solution line hose into the machine, bring the hoses into the building, and connect a carpet cleaning wand to the end of the hoses.

<span class="mw-page-title-main">Water distribution system</span>

A water distribution system is a part of water supply network with components that carry potable water from a centralized treatment plant or wells to consumers to satisfy residential, commercial, industrial and fire fighting requirements.

<span class="mw-page-title-main">Droitwich Water Tower</span> Prominent water tower in Droitwich, England

The Droitwich Water Tower, also known as Yew Tree Hill Water Tower, is a structure on Yew Tree Hill in Droitwich, England, owned and operated by Severn Trent as part of its water supply infrastructure. It was built in 1962 and stands at 110 feet (34 m) tall. The structure is prominent locally, being described as "one of the first things you see when you enter the town".

References

  1. Joseph, Sean (7 April 2009). "Water towers: NYC's misunderstood icons". amNewYork. Retrieved 6 August 2016.
  2. 1 2 Runyeon, Ray Rivera, Frank G.; Buettner, Russ (2014-01-27). "Inside City's Water Tanks, Layers of Neglect". The New York Times. ISSN   0362-4331 . Retrieved 2017-01-17.
  3. "Proper Maintenance is Essential - Rooftop Water Tanks". cooperator.com. Retrieved 2019-11-21.
  4. "water tanks | NYC Rules". rules.cityofnewyork.us. Retrieved 2019-11-21.