Snatch (weightlifting)

Last updated

The snatch is the first of two lifts contested in the sport of weightlifting (also known as Olympic weightlifting) followed by the clean and jerk. The objective of the snatch is to lift the barbell from the ground to overhead in one continuous motion. There are four main styles of snatch used: snatch (or full snatch), split snatch, power snatch, and muscle snatch. The full lift is the most common style used in competition, while power snatches and muscle snatches are mostly used for training purposes, and split snatches are rarely used. Any of these lifts can be performed from the floor, from the hang position, or from blocks. In competition, only lifts from the floor are allowed.

Contents

In the snatch, the lifter lifts the bar as high as possible and pulls themselves under it in a squat position, receiving the bar overhead with the arms straight, decreasing the necessary height of the bar, therefore increasing the amount of weight that the lifter may successfully lift. The lifter finally straightens to a fully upright position with the bar above their head and arms fully extended.

In the split snatch, the lifter lifts the bar as high as possible and pulls themselves under the bar similar to the squat snatch but in the split snatch the lifter "splits" their legs, placing one foot in front of them and one behind, allowing themselves to receive the bar lower as in the squat snatch. The split snatch has become much less common but is occasionally performed by some lifters.

In the power snatch, the lifter lifts the barbell as high as possible and receives the bar overhead with only a slight bend in the knee and hip, increasing the height that the bar must be lifted and decreasing the amount of weight that may be successfully lifted.

In the muscle snatch, the lifter lifts the bar all the way overhead with arms locked out and the hip and knee fully extended. [1]

Technique

Snatch2.gif

While the snatch is commonly referred to in three phases, Arthur Drechsler identifies six distinct phases of the pull in the snatch.

First phase

The lifter begins the first phase of the pull, or "Pre-lift off", with the feet placed approximately hip width apart, toes turned out slightly with the bar above the midfoot. The shins will be inclined toward the bar so that the shin is touching or close to the bar. Hips are placed so that the top of the thigh is approximately parallel to the ground but may also be slightly higher or lower depending on the lifter. [2] The lifter’s back should be straight, no excessive curvature or rounding in the lumbar spine, with slight extension of the thoracic spine and shoulders slightly pulled back. [2] The shoulders should be positioned so that they are directly over or slightly forward of the bar. [2] The bar is gripped with a very wide grip. The neck should be positioned in line with the torso or slightly more vertical. During the first pull, the lifter begins to exert force on the bar, separating the weight from the platform. [2]

Second phase

The second phase of the pull, or "preliminary acceleration" begins with the weight separated from the floor. In the second phase, the lifter begins by extending the knee and moving the hip upward while maintaining a constant back angle relative to the floor. [2] During this phase, the lifter pulls the bar closer to their body and the center of gravity of the lifter shifts toward the heel. [2] During this phase, the lifter begins to accelerate the bar and towards the end of the phase, the torso begins to assume a more vertical position.

Third phase

During the third phase, or "adjustment phase", the lifter begins to position their body appropriately for the final explosive pull. The knees typically perform a "double knee bend", where the knee bends from the previous extension of the knee during the second phase, and the torso continues to become more vertical. [2] During this phase, the lifter doesn't apply as great a force on the bar as in the previous phases. [2]

Fourth phase

During the fourth phase of the pull, or "final acceleration" the lifter performs the final acceleration on the bar. This is executed by explosively extending the hip, knee, and ankles (or plantar-flexing). This is followed by an upward elevation of the shoulders (the "shrug"), [2] and simultaneously lifting the heels or the whole foot off the ground. The lifter’s torso will usually lean slightly backwards during this phase, and the bar is accelerated upward with a slightly arced trajectory. [2]

Fifth phase

The fifth phase of the pull, or "unsupported squat phase", occurs when the lifter has fully extended their knees, hips, and ankle. The lifter bends their arms at the elbow, pulling themselves under the bar. Simultaneously they move their feet slightly apart into the squat position and begins to move downward into the squat position. [2]

Sixth phase

The sixth phase, or supported squat under, occurs when the lifters feet have landed flatfooted on the platform and the lifter pulls themselves into a squat position. The lifter then receives the bar overhead with the arms completely straight. From this position, the lifter recovers by squatting the weight to a fully erect position while maintaining the bar position overhead. [2]

Application to other sports

The snatch is also commonly used as a tool for training athletes in a variety of sports especially with athletes in sports where powerful full body movement is required such as throwing, sprinting, running, and jumping. The triple-extension in the snatch (simultaneous extension of the knee and hip, and plantar flexion at the ankle) mimics the movements previously mentioned while requiring the athlete to produce large amounts of power at high velocities. The snatch has an average velocity of 1.52–1.67 m/s. [3] This makes it a quality lift for training speed-strength in which the athlete aims to move a light weight (25–40% 1RM) at its fastest velocity (1.1–1.65 m/s) [3]

World records

These are the official records in the new weight classes: [4]

Men

Weight classNameLift
55 kgWorld standard135 kg (298 lb)
61 kg Li Fabin 145 kg (320 lb)
67 kg Huang Minhao 155 kg (342 lb)
73 kg Shi Zhiyong 169 kg (373 lb)
81 kg Li Dayin 175 kg (386 lb)
89 kg Li Dayin 180 kg (400 lb)
96 kg Lesman Paredes 187 kg (412 lb)
102 kgWorld standard191 kg (421 lb)
109 kg Yang Zhe 200 kg (440 lb)
109+ kg Lasha Talakhadze 225 kg (496 lb)

Women

Weight classNameLift
45 kgWorld standard85 kg (187 lb)
49 kg Hou Zhihui 96 kg (212 lb)
55 kg Kang Hyong-yong 103 kg (227 lb)
59 kg Kim Il-gyong 111 kg (245 lb)
64 kg Deng Wei 117 kg (258 lb)
71 kg Angie Palacios 121 kg (267 lb)
76 kg Rim Jong-sim 124 kg (273 lb)
81 kgWorld standard127 kg (280 lb)
87 kgWorld standard132 kg (291 lb)
87+ kg Li Wenwen 148 kg (326 lb)

Variations

See also

Related Research Articles

<span class="mw-page-title-main">Olympic weightlifting</span> Sport

Weightlifting is a sport in which athletes compete in lifting a barbell loaded with weight plates from the ground to overhead, with the aim of successfully lifting the heaviest weights. Athletes compete in two specific ways of lifting the barbell overhead. The snatch is a wide-grip lift, in which the weighted barbell is lifted overhead in one motion. The clean and jerk is a combination lift, in which the weight is first taken from the ground to the front of the shoulders, and then from the shoulders to over the head. The sport formerly included a third lift/event known as clean and press.

<span class="mw-page-title-main">Powerlifting</span> Sport

Powerlifting is a strength sport that consists of three attempts at maximal weight on three lifts: squat, bench press, and deadlift. As in the sport of Olympic weightlifting, it involves the athlete attempting a maximal weight single-lift effort of a barbell loaded with weight plates. Powerlifting evolved from a sport known as "odd lifts", which followed the same three-attempt format but used a wider variety of events, akin to strongman competition. Eventually, odd lifts became standardized to the current three.

<span class="mw-page-title-main">Calisthenics</span> Form of strength training exercises

Calisthenics or callisthenics (/ˌkælɪsˈθɛnɪks/) is a form of strength training that utilizes an individual's body weight as resistance to perform multi-joint, compound movements with little or no equipment.

<span class="mw-page-title-main">Clean and jerk</span> Composite of two weightlifting movements

The clean and jerk is a composite of two weightlifting movements, most often performed with a barbell: the clean and the jerk. During the clean, the lifter moves the barbell from the floor to a racked position across the deltoids, without resting fully on the clavicles. During the jerk, the lifter raises the barbell to a stationary position above the head, finishing with straight arms and legs, and the feet in the same plane as the torso and barbell.

<span class="mw-page-title-main">Bench press</span> Exercise of the upper body

The bench press, or chest press, is a weight training exercise where a person presses a weight upwards while lying horizontally on a weight training bench. Although the bench press is a compound movement, the muscles primarily used are the pectoralis major, the anterior deltoids, and the triceps, among other stabilizing muscles. A barbell is generally used to hold the weight, but a pair of dumbbells can also be used.

Bicep curls are a group of weight training exercises in which a person bends their arm towards their body at the elbow in order to make their biceps stronger.

<span class="mw-page-title-main">Squat (exercise)</span> Workout that targets the legs

A squat is a strength exercise in which the trainee lowers their hips from a standing position and then stands back up. During the descent, the hip and knee joints flex while the ankle joint dorsiflexes; conversely the hip and knee joints extend and the ankle joint plantarflexes when standing up. Squats also help the hip muscles.

<span class="mw-page-title-main">Deadlift</span> Weight training exercise

The deadlift is a weight training exercise in which a loaded barbell or bar is lifted off the ground to the level of the hips, torso perpendicular to the floor, before being placed back on the ground. It is one of the three powerlifting exercises, along with the squat and bench press, as well as a frequent lift in strongman.

<span class="mw-page-title-main">Kettlebell</span> Cast iron or cast steel ball with a handle attached to the top

In weight training, a kettlebell is a cast-iron or cast-steel ball with a handle attached to the top. It is used to perform many types of exercises, including ballistic exercises that combine cardiovascular, strength and flexibility training. Kettlebells are the primary equipment used in the weight-lifting sport of kettlebell lifting.

The good-morning is a weight training exercise. It is known as a good morning because of the movement in the erector spinae which resembles the bow that traditionally begins a schoolday in some East-Asian countries. The erector spinae muscles of the lower back work isometrically to keep the spine in an extended position while the hamstrings and gluteus maximus work isotonically to perform hip extension. Other muscles are involved in stabilizing weight on the back and maintaining balance.

<span class="mw-page-title-main">Exercise equipment</span> Consists of one or more items and is used for applying a sport

Exercise equipment is any apparatus or device used during physical activity to enhance the strength or conditioning effects of that exercise by providing either fixed or adjustable amounts of resistance, or to otherwise enhance the experience or outcome of an exercise routine.

The clean and press is a two-part weight training exercise whereby a loaded barbell is lifted from the floor to the shoulders and pushed overhead. The lift was a component of the sport of Olympic weightlifting from 1928 to 1972, but was removed due to difficulties in judging proper technique.

A bent-over row is a weight training exercise that targets a variety of back muscles. Which ones are targeted varies on form. The bent over row is often used for both bodybuilding and powerlifting.

<span class="mw-page-title-main">Hook grip</span> Method of gripping a barbell

Hook grip is a method of gripping a barbell used in many strength-related sports such as Olympic weightlifting, Crossfit, and powerlifting by overlapping the index and middle finger over the thumb. This method of gripping the bar provides a secure bar grip while performing pulling motion with the barbell such as the clean and jerk, snatch, and deadlift. To perform a hook grip one must first wrap their thumb around the bar placing it parallel to the barbell and then wrap their index, and middle finger around the outside of the thumb. The pinky and ring finger typically ends up resting on the barbell. It is important to actively hooking on to the thumb with the index and middle finger while performing Hook grip compared to providing direct pressure on to the thumb.

<span class="mw-page-title-main">Push press</span> Weightlifting exercise

A push press is a weight training exercise for the anterior head of the deltoid (shoulder).

<span class="mw-page-title-main">Leg raise</span> Strength training exercise

The leg raise is a strength training exercise which targets the iliopsoas. Because the abdominal muscles are used isometrically to stabilize the body during the motion, leg raises are also often used to strengthen the rectus abdominis muscle and the internal and external oblique muscles.

The hang clean is a weightlifting exercise involving the use of a barbell to do a compound series of strength-building movements.

The Sumo deadlift is a variation of the conventional deadlift often adopted by powerlifters.

<span class="mw-page-title-main">Power training</span> Common type of speed and strength training

Power training typically involves exercises which apply the maximum amount of force as fast as possible; on the basis that strength + speed = power. Jumping with weights or throwing weights are two examples of power training exercises. Regular weight training exercises such as the clean and jerk and power clean may also be considered as being power training exercises due to the explosive speed required to complete the lifts. Power training may also involve contrasting exercises such as heavy lifts and plyometrics, known as complex training, in an attempt to combine the maximal lifting exertions with dynamic movements. This combination of a high strength exercise with a high speed exercise may lead to an increased ability to apply power. Power training frequently specifically utilises two physiological processes which increase in conjunction with one another during exercise. These are deep breathing, which results in increased intra-abdominal pressure; and post-activation potentation, which is the enhanced activation of the nervous system and increased muscle fibre recruitment. Power training programmes may be shaped to increase the trainee's ability to apply power in general, to meet sports specific criteria, or both.

References

  1. Starr, Bill (January 2010). "Learning How to Do Full Snatches" (PDF). CrossFit Journal: 1. Retrieved 12 April 2016.
  2. 1 2 3 4 5 6 7 8 9 10 11 12 Drechsler, Arthur (1998). The Weightlifting Encyclopedia: A Guide to World Class Performance. Flushing, NY: A is A Communication. pp. 23–28. ISBN   0965917924.
  3. 1 2 Ajhan, T; Lazar, Baroga (1988). Weightlifting: Fitness For all Sports. Budapest, Hungary: Budapest International Weightlifting Federation. ISBN   9632538072.
  4. "World Records (new bw)". International Weightlifting Federation.
  5. National Strength and Conditioning Association (2016). Exercise Technique Manual for Resistance Training (3rd ed.). Champaign: Human Kinetics. pp. XV, 12–14. ISBN   978-1-4925-0692-8.