Yoal

Last updated

The yoal, often referred to as the ness yoal, is a clinker-built craft used traditionally in Shetland, Scotland. It is designed primarily for rowing, but also handles well under its traditional square sail when running before the wind or on a broad reach.

Contents

The word is cognate with yawl and yole.

Construction

Oselvar under construction Oselver3.jpg
Oselvar under construction

Until about 1860, yoals were imported in kit form from the area around Bergen in Norway. The traditional small wooden boats were known as either Strandebarmer or Oselvar from Os in Hordaland, Norway. [1] The wooden boats were taken apart and then 'flat packed' for shipping to the Shetland Islands. [2] Instead of sending complicated assembly instructions, they sent Norwegian boatbuilders to re-build them. However, increasing customs duty meant that Shetland builders took over the building but stayed mostly with the original Norwegian design. [3]

All the parts of a yoal have a name, perhaps to make assembly easier when they came in kit form, or to make it easier to order spare parts. In many cases, the names of the parts bear a closer relationship to Norwegian than British usage. The descriptive text on this page names most of these parts.

There are six boards to the construction of a yoal, they are from the keel up, the gabbard straik; the Hassen Straik; the lower sool; the upper sool; the sand straik, and the upper wup.

The boards were fixed to three main frames baands which curved across the keel between gunwales, underneath the tafts (seats), and also to the stammerin or cant frame, near both bow and stern, before fixing to the fore and aft stems. The upper wups were joined by the hinny spot where they met the horn, at the top of the stem, for added strength.

The baands were not fixed to the keel, this again adding to the flexibility of the yoal.

The baands divided the boat into four sections: the fore room, for fishing tackle etc.; the mid room, for ballast; the owsin room, which was kept clear for bailing, owsin, any water which came aboard, using an owsekerri; and the shot room, which is where the catch was stored.

To save the gunwales from wear, at each aer, (oar), position a block of hard wood, the routh, was fixed in position with two wooden pegs called routh pins. Sticking up from the routh was the kabe, a hardwood peg, against which the oar was rowed. The oar was held in position against the kabe by a loop of rope called the humlieband.

One notable feature of yoal construction are the gunwales which stop short at both bow and stern leaving several inches of upper board with no gunwale. This is supposed to give the craft more flexibility in heavy seas.

The yoal was rowed by three men with a pair of oars each. The men were seated on tafts, which rested on the wearin a wooden support which ran across the three main baands, and for purchase they could brace their feet against a fitlinn, a piece of wood across between the baands. The floorboards of the boat were called tilfers.

When wind conditions were baand yoal carried a square sail, hoisted on a wooden mast which was stepped through the mid taft and braced at its base to the mid 'baand'

History

The yoal was the main vessel used for haaf (open water within sight of land, up to 10 miles from shore) fishing for cod, ling and tusk until the fish shoals moved further offshore at the end of the 17th century, probably due to climatic change. [4] Although yoals were not designed for the far haaf, Shetland fishermen continued to use them for relatively deep sea fishing with attendant accidents and loss of life until the introduction in the mid 18th century of the larger, heavier and deeper sixareen designed for fishing further offshore. Although there were some variations in size the yoal was generally 21 ft 5in overall, 15 ft keel, 21in inside depth amidships and 5 ft 5in beam. [5]

George Johnson of Skelberry, Dunrossness, was one of the most prolific builders of ness yoals. Among the yoals built by Johnson, in his later years, were several larger ones up to 23 ft 10in overall. One of these, which has now gone, was the Oceans Gift, so named because all the wood for her construction came from driftwood. Unusual features of these larger yoals were that their gunwales did not stop short of the stem and stern like the normal yoals, and some of them had a full fourth 'baand'.

Present day

Throughout Shetland many traditional yoals, built by Johnson, and others of his era, still exist. Very few are still in regular use, although in the Virkie Marina there are 2 which are used for pleasure fishing.

In recent years the advent of yoal rowing regattas [6] has seen an upsurge in the building of these traditional craft. [7]

Ian Best of Fair Isle, [8] and Tommy Isbister of Trondra, are the most prolific yoal builders today.

See also

Related Research Articles

Longship Warship used by Vikings

Longships were a type of specialised Scandinavian warships that have a long history in Scandinavia, with their existence being archaeologically proven and documented from at least the fourth century BC. Originally invented and used by the Norsemen for commerce, exploration, and warfare during the Viking Age, many of the longship's characteristics were adopted by other cultures, like Anglo-Saxons, and continued to influence shipbuilding for centuries.

Yawl Type of sailboat

A yawl is a type of boat. The term has several meanings. It can apply to the rig, to the hull type or to the use which the vessel is put.

Boat building Design and construction of floating vessels

Boat building is the design and construction of boats and their systems. This includes at a minimum a hull, with propulsion, mechanical, navigation, safety and other systems as a craft requires.

Gig (boat)

A gig is a type of boat optimised for speed under oar, but usually also fitted with a sailing rig for appropriate conditions. The type was in use by Deal boatmen in the 18th century. It first occurred as a naval ship's boat after Deal boatbuilders recommended a different design to boats ordered from them by the Royal Navy to equip the cutters purchased in the 1760s to combat smuggling. The captains of larger warships soon sought permission to substitute a gig for one of the heavier boats which were then used; some even had a gig built at their own expense. The gig therefore became part of the usual complement of ship's boats used in warships.

Clinker (boat building)

Clinker built is a method of boat building where the edges of hull planks overlap each other. Where necessary in larger craft, shorter planks can be joined end to end, creating a longer strake or hull plank. The technique originated in Scandinavia, and was successfully used by the Anglo-Saxons, Frisians, Scandinavians, typically in the vessels known as cogs employed by the Hanseatic League. Carvel construction, where plank edges are butted smoothly, seam to seam, supplanted clinker construction in large vessels as the demand for capacity surpassed the limits of clinker construction..

Rowing Act of propelling a boat using the motion of oars in the water

Rowing is the act of propelling a boat using the motion of oars in the water by displacing water to propel the boat forward. Rowing and paddling are similar. However, rowing requires oars to have a mechanical connection with the boat, while paddles are hand-held and have no mechanical connection.

Racing shell Rowing boat designed for sport

In watercraft, a racing shell is an extremely narrow, and often comparatively long, rowing boat specifically designed for racing or exercise. It is outfitted with long oars, outriggers to hold the oarlocks away from the boat, and sliding seats. The boat's long length and semicircular cross-section reduce drag to a minimum. This makes the boat both fast and unstable. It must be balanced by the rowers to avoid tipping. Being able to balance – or "set" – the boat while putting maximum effort into the oars is therefore an essential skill of sport rowing.

In competitive rowing, the following specialized terms are important in the corresponding aspects of the sport:

Scalloway Human settlement in Scotland

Scalloway is the largest settlement on the west coast of Mainland, the largest island of the Shetland Islands, Scotland. The village had a population of roughly 900, at the 2011 census. Now a fishing port, until 1708 it was the capital of the Shetland Islands.

Coastal and offshore rowing

Coastal and offshore rowing is a type of rowing performed at sea. Due to the harsher conditions encountered, the boats are wider and more robust than those used on rivers and lakes. In North America, this sport is often called open water rowing.

Harry Clasper

Harry Clasper was a professional rower and boat builder from Tyneside in England. He was an innovative boat designer who pioneered the development of the racing shell and the use of outriggers. He is said to have invented spoon-shaped oars.

Sixareen

The sixareen or sixern is a traditional fishing boat used around the Shetland Islands. It is a clinker-built boat, evolved as a larger version of the yoal, when the need arose for crews to fish further from shore. The first of the sixareens were, like the yoal, imported from Norway in kit form until the mid 19th century, when increasing import duty made it more cost effective to import the raw materials and build the boats in Shetland.

Nordland (boat)

The Nordland boat, is a type of fishing boat that has been used for centuries in northern counties of Nordland, Troms and Finnmark of Norway and derives its name from Nordland county where it has a long history. It has dominated the Lofoten and Vesterålen islands fishing industry for centuries and is closely related to the old Viking longships.

Thwart Seat and structural member of a boat

A thwart is a part of an undecked boat that provides seats for the crew and structural rigidity for the hull. A thwart goes from one side of the hull to the other. There might be just one thwart in a small boat, or many in a larger boat, especially if a several oarsmen need to be accommodated.

Oselvar Wooden rowing boat traditionally used in Norway

The Oselvar or Oselver is a small wooden rowing boat traditionally built and used along the west coast of Norway. The Oselvar is a clinker built boat with thin, very wide planks. Almost all parts of an Oselvar are made of pine, with only the keel of oak.

Falkuša Traditional Croatian fishing boat

A falkusa is a traditional fishing boat used by fishermen from the town of Komiža on the Adriatic island of Vis, Croatia. Falkuša is a subtype of gajeta, a traditional Dalmatian fishing sailboat, and is sometimes called gajeta falkuša. Its design was adapted to the specific needs of Komiža fishermen, who went to long fishing expeditions in the open seas, a unique practice in the Adriatic and Mediterranean.

Yal (boat)

Yal – Russian and Soviet Naval transom stern light weight rowing-boat with one removable mast and set with the sail. A small yal is sometimes called a yalik, the diminutive form of yal.

St. Ayles Skiff

The St. Ayles Skiff is a 4 oared rowing boat, designed by Iain Oughtred and inspired by the traditional Fair Isle skiff. The boat’s hull and frames are built using clinker plywood and it measures 22’ with a beam of 5’ 8”. It is normally crewed by four sweep rowers with a coxswain.

Lepa (ship)

Lepa, also known as lipa or lepa-lepa, are indigenous ships of the Sama-Bajau people in the Philippines and Malaysia. They were traditionally used as houseboats by the seagoing Sama Dilaut. Since most Sama have abandoned exclusive sea-living, modern lepa are instead used as fishing boats and cargo vessels.

Lerret Traditional fishing boat

A lerret is a type of rowing boat designed for use off the Chesil Beach in Dorset. It is of wooden, clinker construction and varied in size, depending on the number of oars – the largest would have up to eight. It was primarily used for fishing but, in emergencies, lerrets would be used as lifeboats.

References

  1. ↑ Chivers, Marc (1 February 2014). "The metamorphosis of the Norwegian model of boat into the Shetland model of boat: an analysis of the literature". The Shetland Boat: History; Folklore & Construction. Retrieved 21 May 2016.
  2. ↑ Baldwin (1978 , p. 53)
  3. ↑ Strilebåten (Oselvarverkstaden) in Norwegian}
  4. ↑ Baldwin (1978 , p. 55)
  5. ↑ Baldwin (1978 , p. 53)
  6. ↑ "Shetland Yoal Rowing Association - Rowing - Shetland Community Directory". Community Directory Shetland. 21 May 2013. Retrieved 21 May 2016.
  7. ↑ "Yoal design heads round world". The Shetland Times. 13 January 2013. Retrieved 21 May 2016.
  8. ↑ Wheeler, Dave (18 March 2010). "Ian Best Boat Builder". Fair Isle. Retrieved 21 May 2016.

This article incorporates text from the article Yoal on Shetlopedia, which was licensed under the GNU Free Documentation Licence until September 14, 2007.

This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.