Primary Rate Interface

Last updated

The Primary Rate Interface (PRI) is a telecommunications interface standard used on an Integrated Services Digital Network (ISDN) for carrying multiple DS0 voice and data transmissions between the network and a user.

Contents

PRI is the standard for providing telecommunication services to enterprises and offices. It is based on T-carrier (T1) transmission in the US, Canada, and Japan, while the E-carrier (E1) is common in Europe and Australia. The T1 line consists of 23 bearer (B) channels and one data (D) channel for control purposes, [1] for a total bandwidth of 24x64-kbit/s or 1.544 Mbit/s. The E1 carrier provides 30 B- and one D-channel for a bandwidth of 2.048 Mbit/s. [2] The first timeslot on the E1 is used for synchronization purposes and is not considered to be a B- or D-channel. The D-channel typically uses timeslot 16 on an E1, while it is timeslot 24 for a T1. Fewer active bearer channels, sometimes called user channels, may be used in fractional T1 or E1 services.

ISDN service types

The Integrated Services Digital Network (ISDN) prescribes two levels of service: [3]

Each B-channel carries data, voice, and other services. The D-channel carries control and signaling information. Larger connections are possible using PRI pairing. A dual T1-PRI could have 24 + 23 = 47 B-channels and 1 D-channel (often called "47B + D"), but more commonly has 46 B-channels and 2 D-channels thus providing a backup signaling channel. The concept applies to E1s as well and both can include more than 2 PRIs. When configuring multiple T1's as ISDN-PRI's, it's possible to use NFAS (non-facility associated signaling) to enable one or two D-channels to support additional B-channels on separate T1 circuits.

Application

The Primary Rate Interface channels are typically used by medium to large enterprises with digital private branch exchange (PBX) telephone systems to provide digital access to the public switched telephone network (PSTN). The B-channels may be used flexibly and reassigned when necessary to meet special needs such as video conferences.

PRI channels and direct inward dialing are also common as a means of delivering inbound calls to voice over IP gateways from the PSTN.

See also

Related Research Articles

<span class="mw-page-title-main">ISDN</span> Set of communication standards

Integrated Services Digital Network (ISDN) is a set of communication standards for simultaneous digital transmission of voice, video, data, and other network services over the digitalised circuits of the public switched telephone network. Work on the standard began in 1980 at Bell Labs and was formally standardized in 1988 in the CCITT "Red Book". By the time the standard was released, newer networking systems with much greater speeds were available, and ISDN saw relatively little uptake in the wider market. One estimate suggests ISDN use peaked at a worldwide total of 25 million subscribers at a time when 1.3 billion analog lines were in use. ISDN has largely been replaced with digital subscriber line (DSL) systems of much higher performance.

Digital subscriber line is a family of technologies that are used to transmit digital data over telephone lines. In telecommunications marketing, the term DSL is widely understood to mean asymmetric digital subscriber line (ADSL), the most commonly installed DSL technology, for Internet access.

In the Integrated Services Digital Network (ISDN), a high-speed communication channel comprising multiple aggregated low-speed channels to accommodate bandwidth-intensive applications such as file transfer, videoconferencing, and high-quality audio. An H channel is formed of multiple bearer B channels bonded together in a primary rate access (PRA) or primary rate interface (PRI) frame in support of applications with bandwidth requirements that exceed the B channel rate of 64 kbit/s. The channels, once bonded, remain so end-to-end, from transmitter to receiver, through the ISDN network. The feature is known variously as multirate ISDN, Nx64, channel aggregation, and bonding. H channels are implemented as:

<span class="mw-page-title-main">T-carrier</span> Carrier system for digital transmission of multiplexed telephone calls.

The T-carrier is a member of the series of carrier systems developed by AT&T Bell Laboratories for digital transmission of multiplexed telephone calls.

<span class="mw-page-title-main">Time-division multiplexing</span> Multiplexing technique for digital signals

Time-division multiplexing (TDM) is a method of transmitting and receiving independent signals over a common signal path by means of synchronized switches at each end of the transmission line so that each signal appears on the line only a fraction of time in an alternating pattern. It can be used when the bit rate of the transmission medium exceeds that of the signal to be transmitted. This form of signal multiplexing was developed in telecommunications for telegraphy systems in the late 19th century, but found its most common application in digital telephony in the second half of the 20th century.

The U interface or U reference point is a Basic Rate Interface (BRI) in the local loop of an Integrated Services Digital Network (ISDN), connecting the network terminator (NT1/2) on the customer's premises to the line termination (LT) in the carrier's local exchange, in other words providing the connection from subscriber to central office.

The E-carrier is a member of the series of carrier systems developed for digital transmission of many simultaneous telephone calls by time-division multiplexing. The European Conference of Postal and Telecommunications Administrations (CEPT) originally standardised the E-carrier system, which revised and improved the earlier American T-carrier technology, and this has now been adopted by the International Telecommunication Union Telecommunication Standardization Sector (ITU-T). It was widely used in almost all countries outside the US, Canada, and Japan. E-carrier deployments have steadily been replaced by Ethernet as telecommunication networks transition towards all IP.

<span class="mw-page-title-main">Basic Rate Interface</span> ISDN configuration

Basic Rate Interface or Basic Rate Access is an Integrated Services Digital Network (ISDN) configuration intended primarily for use in subscriber lines similar to those that have long been used for voice-grade telephone service. As such, an ISDN BRI connection can use the existing telephone infrastructure at a business.

Signalling System No. 7 (SS7) is a set of telephony signaling protocols developed in the 1970s, which is used to set up and tear down telephone calls in most parts of the world-wide public switched telephone network (PSTN). The protocol also performs number translation, local number portability, prepaid billing, Short Message Service (SMS), and other services.

A symmetric digital subscriber line (SDSL) is a digital subscriber line (DSL) that transmits digital data over the copper wires of the telephone network, where the bandwidth in the downstream direction, from the network to the subscriber, is identical to the bandwidth in the upstream direction, from the subscriber to the network. This symmetric bandwidth can be considered to be the opposite of the asymmetric bandwidth offered by asymmetric digital subscriber line (ADSL) technologies, where the upstream bandwidth is lower than the downstream bandwidth. SDSL is generally marketed at business customers, while ADSL is marketed at private as well as business customers.

The public switched telephone network (PSTN) is the aggregate of the world's telephone networks that are operated by national, regional, or local telephony operators. It provides infrastructure and services for public telephony. The PSTN consists of telephone lines, fiber-optic cables, microwave transmission links, cellular networks, communications satellites, and undersea telephone cables interconnected by switching centers, such as central offices, network tandems, and international gateways, which allow telephone users to communicate with each other.

A leased line is a private telecommunications circuit between two or more locations provided according to a commercial contract. It is sometimes also known as a private circuit, and as a data line in the UK. Typically, leased lines are used by businesses to connect geographically distant offices.

Digital Signal 1 is a T-carrier signaling scheme devised by Bell Labs. DS1 is the primary digital telephone standard used in the United States, Canada and Japan and is able to transmit up to 24 multiplexed voice and data calls over telephone lines. E-carrier is used in place of T-carrier outside the United States, Canada, Japan, and South Korea. DS1 is the logical bit pattern used over a physical T1 line; in practice, the terms DS1 and T1 are often used interchangeably.

In communications, Circuit Switched Data (CSD) is the original form of data transmission developed for the time-division multiple access (TDMA)-based mobile phone systems like Global System for Mobile Communications (GSM). After 2010 many telecommunication carriers dropped support for CSD, and CSD has been superseded by GPRS and EDGE (E-GPRS).

Non-Facility Associated Signaling or NFAS is a Primary Rate Interface configuration whereby multiple T1 carriers share a signaling channel.

Multi-rate symmetric DSL is a proprietary, non-standardized symmetric digital subscriber line technology with a maximum distance of 29,000 feet (8,800 m). It is capable of multiple transfer rates, as set by the Internet service provider, typically based on the service and/or price. Eight data rates are available, ranging from 160 kbit/s to 2.32 Mbit/s.

ANSI T1.413 is a technical standard that defines the requirements for the single asymmetric digital subscriber line (ADSL) for the interface between the telecommunications network and the customer installation in terms of their interaction and electrical characteristics. ADSL allows the provision of voiceband services including plain old telephone service (POTS) and data services up to 56 kbit/s, and a variety of digital channels. In the direction from the network to the customer premises (downstream), the digital bearer channels may consist of full-duplex low-speed bearer channels and simpler high-speed bearer channels; in the other (upstream) direction, only low-speed bearer channels are provided.

An Integrated Access Device is a customer premises device that provides access to wide area networks and the Internet. Specifically, it aggregates multiple channels of information including voice and data across a single shared access link to a carrier or service provider PoP. The access link may be a T1 line, a DSL connection, a cable (CATV) network, a broadband wireless link, or a metro-Ethernet connection.

High-bit-rate digital subscriber line (HDSL) is a telecommunications protocol standardized in 1994. It was the first digital subscriber line (DSL) technology to use a higher frequency spectrum over copper, twisted pair cables. HDSL was developed to transport DS1 services at 1.544 Mbit/s and 2.048 Mbit/s over telephone local loops without a need for repeaters. Successor technology to HDSL includes HDSL2 and HDSL4, proprietary SDSL, and G.SHDSL.

References

  1. Newton, Harry (15 January 2019). "Newton's Telecom Dictionary: The Official Dictionary of Telecommunications & the Internet". Telecom via Google Books.
  2. "I.412:ISDN user-network interfaces - Interface structures and access capabilities". www.itu.int.
  3. "A Technical Coverage of Primary Rate Interface (PRI)". ISPFast. Retrieved 18 June 2015.