Digital circuit multiplication equipment

Last updated

Digital circuit multiplication equipment (DCME) was a type of voice compression equipment that is installed at both ends of a long-distance telecommunication link, typically a link via communications satellite or submarine communications cable. The main characteristics of DCME are defined in ITU-T recommendation G.763. DCME consists of a time-assignment speech interpolation (TASI) voice interpolation stage, which is a form of statistical multiplexor applied to voiceband signals, and a low rate encoding stage which exploits correlation between successive voiceband samples on an individual input channel to reduce the transmitted bitrate from that required by PCM of equivalent quality.

Under heavy loading conditions, for example when a large number of channels show continuous activity due to voiceband data or Group III facsimile signals, the voice interpolation may not be able to operate within a satisfactory quality range – discontinuous signals such as speech being affected by competitive clipping of the initial part of the activity. To combat this DCME may incorporate Dynamic Load Control on a range of input channels. [1] Dynamic load control is a form of back busying to the telephone switch.

The DCME's functionality, from the point of view of the telephone switch attached to its local interface, is standardised by ITU-T Recommendation Q.50.

See also

Related Research Articles

<span class="mw-page-title-main">Dual-tone multi-frequency signaling</span> Telecommunication signaling system

Dual-tone multi-frequency signaling (DTMF) is a telecommunication signaling system using the voice-frequency band over telephone lines between telephone equipment and other communications devices and switching centers. DTMF was first developed in the Bell System in the United States, and became known under the trademark Touch-Tone for use in push-button telephones supplied to telephone customers, starting in 1963. DTMF is standardized as ITU-T Recommendation Q.23. It is also known in the UK as MF4.

<span class="mw-page-title-main">Amplifier</span> Electronic device/component that increases the strength of a signal

An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the power of a signal. It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude of a signal applied to its input terminals, producing a proportionally greater amplitude signal at its output. The amount of amplification provided by an amplifier is measured by its gain: the ratio of output voltage, current, or power to input. An amplifier is a circuit that has a power gain greater than one.

Speech coding is an application of data compression of digital audio signals containing speech. Speech coding uses speech-specific parameter estimation using audio signal processing techniques to model the speech signal, combined with generic data compression algorithms to represent the resulting modeled parameters in a compact bitstream.

In the 1980s, the telecommunications industry expected that digital services would follow much the same pattern as voice services did on the public switched telephone network, and conceived an end-to-end circuit switched service, known as Broadband Integrated Services Digital Network (B-ISDN).

Digital subscriber line is a family of technologies that are used to transmit digital data over telephone lines. In telecommunications marketing, the term DSL is widely understood to mean asymmetric digital subscriber line (ADSL), the most commonly installed DSL technology, for Internet access.

In telecommunication, a time-assignment speech interpolation (TASI) was an analog technique used on certain long transmission links to increase voice-transmission capacity.

Signalling System No. 7 (SS7) is a set of telephony signaling protocols developed in 1975, which is used to set up and tear down telephone calls in most parts of the world-wide public switched telephone network (PSTN). The protocol also performs number translation, local number portability, prepaid billing, Short Message Service (SMS), and other services.

This is an index of articles relating to electronics and electricity or natural electricity and things that run on electricity and things that use or conduct electricity.

In telecommunication, common-channel signaling (CCS), or common-channel interoffice signaling (CCIS), is the transmission of control information (signaling) via a separate channel than that used for the messages, The signaling channel usually controls multiple message channels.

The public switched telephone network (PSTN) provides infrastructure and services for public telecommunication. The PSTN is the aggregate of the world's circuit-switched telephone networks that are operated by national, regional, or local telephony operators. These consist of telephone lines, fiber optic cables, microwave transmission links, cellular networks, communications satellites, and undersea telephone cables, all interconnected by switching centers which allow most telephones to communicate with each other.

<span class="mw-page-title-main">Telephone hybrid</span>

A telephone hybrid is the component at the ends of a subscriber line of the public switched telephone network (PSTN) that converts between two-wire and four-wire forms of bidirectional audio paths. When used in broadcast facilities to enable the airing of telephone callers, the broadcast-quality telephone hybrid is known as a broadcast telephone hybrid or telephone balance unit.

<span class="mw-page-title-main">G.726</span> ITU-T Recommendation

G.726 is an ITU-T ADPCM speech codec standard covering the transmission of voice at rates of 16, 24, 32, and 40 kbit/s. It was introduced to supersede both G.721, which covered ADPCM at 32 kbit/s, and G.723, which described ADPCM for 24 and 40 kbit/s. G.726 also introduced a new 16 kbit/s rate. The four bit rates associated with G.726 are often referred to by the bit size of a sample, which are 2, 3, 4, and 5-bits respectively. The corresponding wide-band codec based on the same technology is G.722.

Voice activity detection (VAD), also known as speech activity detection or speech detection, is the detection of the presence or absence of human speech, used in speech processing. The main uses of VAD are in speech coding and speech recognition. It can facilitate speech processing, and can also be used to deactivate some processes during non-speech section of an audio session: it can avoid unnecessary coding/transmission of silence packets in Voice over Internet Protocol (VoIP) applications, saving on computation and on network bandwidth.

<span class="mw-page-title-main">G.723</span> ITU-T Recommendation

G.723 is an ITU-T standard speech codec using extensions of G.721 providing voice quality covering 300 Hz to 3400 Hz using Adaptive Differential Pulse Code Modulation (ADPCM) to 24 and 40 kbit/s for digital circuit multiplication equipment (DCME) applications. The standard G.723 is obsolete and has been superseded by G.726.

Perceptual Evaluation of Speech Quality (PESQ) is a family of standards comprising a test methodology for automated assessment of the speech quality as experienced by a user of a telephony system. It was standardized as Recommendation ITU-T P.862 in 2001. PESQ is used for objective voice quality testing by phone manufacturers, network equipment vendors and telecom operators. Its usage requires a license. The first edition of PESQ's successor POLQA entered into force in 2011.

Signaling System No. 6 (SS6) was introduced in the 1970s as an early common channel signalling method for telecommunication trunks between international switching centers (ISCs). It is specified in CCITT Recommendations Q.251-Q.300.

<span class="mw-page-title-main">Asymmetric digital subscriber line</span> DSL service where downstream bandwidth exceeds upstream bandwidth

Asymmetric digital subscriber line (ADSL) is a type of digital subscriber line (DSL) technology, a data communications technology that enables faster data transmission over copper telephone lines than a conventional voiceband modem can provide. ADSL differs from the less common symmetric digital subscriber line (SDSL). In ADSL, bandwidth and bit rate are said to be asymmetric, meaning greater toward the customer premises (downstream) than the reverse (upstream). Providers usually market ADSL as an Internet access service primarily for downloading content from the Internet, but not for serving content accessed by others.

Wideband audio, also known as wideband voice or HD voice, is high definition voice quality for telephony audio, contrasted with standard digital telephony "toll quality". It extends the frequency range of audio signals transmitted over telephone lines, resulting in higher quality speech. The range of the human voice extends from 100 Hz to 17 kHz but traditional, voiceband or narrowband telephone calls limit audio frequencies to the range of 300 Hz to 3.4 kHz. Wideband audio relaxes the bandwidth limitation and transmits in the audio frequency range of 50 Hz to 7 kHz. In addition, some wideband codecs may use a higher audio bit depth of 16 bits to encode samples, also resulting in much better voice quality.

Echo suppression and echo cancellation are methods used in telephony to improve voice quality by preventing echo from being created or removing it after it is already present. In addition to improving subjective audio quality, echo suppression increases the capacity achieved through silence suppression by preventing echo from traveling across a telecommunications network. Echo suppressors were developed in the 1950s in response to the first use of satellites for telecommunications.

References

  1. Ingham, A. R.; Cope, G. A. (April 1991). "The performance of digital circuit multiplication equipment (DCME)". IEE Eighth UK Teletraffic Symposium: 20/1–20/7.