Eagle Helicycle

Last updated
Helicycle
Helicycle N727X Flying.JPG
Helicycle N727X at Homer Bell's 22nd Annual Helicopter Fly-in, July 14, 2006
RoleHomebuilt helicopter
ManufacturerEagle R&D
DesignerB.J. Schramm
First flightSeptember, 1997
Number built85+

The Helicycle is a single-seat, semi-rigid 2 bladed main rotor, helicopter powered by a Solar T62-32 engine. Manufactured by Helicycle Ventures LLC in Mesilla, New Mexico as a kit, the aircraft is intended to be assembled by the owner and is considered a homebuilt aircraft. The Helicycle was conceived and designed by B.J. Schramm, the founder of RotorWay International.

Contents

Development

Schramm's concept for the Helicycle was to provide a kit for building a reliable, high-performance, real helicopter for a reasonable cost to individuals (on the order of a mid-priced SUV). Fabrication and assembly skills only require being able to accurately drill holes, bend sheet metal and tubing, install fasteners, run wiring, etc.; no welding or highly specialized aviation-specific tools are required. Kits are delivered in six increments, including the frame and skids, engine, transmission, main rotor subassembly, tail rotor subassembly, controls and linkages, cockpit exterior/interior, and fuel and electrical subsystems. Assembly instructions are provided in the form of video clips on video CDs (Video CDs) or DVDs, blueprints, and checklists.

Design

Specific design features include a fully harmonized rotor, a modulated collective pitch system, very low twice-per-revolution vibration level due to elastomeric thrust bearings, a sufficient flapping angle for low-"G" maneuvers and slope landings, control friction devices, and an electronic throttle control (governor).

The feel of the controls in the Helicycle is modeled after that of the Robinson R22, such that quick stops and autorotations are performed similarly in both aircraft, reportedly allowing new pilots to transition to flying their kits with minimal adjustments.

Operational history

The Helicycle helicopter is the first experimental helicopter kit in mass-production to be powered by a turbine engine, the military surplus Solar T62-T32, capable of producing 150 shaft horsepower. The engine is limited to 95 horsepower due to torque limits on the main gearbox and rotor system.

As of June 2010, five runs of about 30 kits each have been delivered to builders, for a total of 160 kits, of which more than 80 have been completed and are flying, with another kit being completed every other month, on average (delivery of a sixth run is scheduled to start in 2010). A unique feature of the kits is that a factory checkout must be completed by a factory-designated airframe and power plant (A&P) technician and test pilot before the builder is allowed to fly the aircraft. The factory withholds a few critical components needed for flight, such as the main rotor bearings, which the factory representative brings to the checkout. [1] In order to ensure that prospective pilots have the necessary flight skills, builders must have at least a solo endorsement from a certified flight instructor (CFI) for flying a commercially-built Robinson R22 helicopter.[ citation needed ]

The total number of hours accumulated on all Helicycles flying is estimated to be well in excess of 3,000 flight hours, with three fatal accidents, the latest occurring on 28 September 2014 in rural Sumner county, Tennessee.

The NTSB report on the fatal accident indicates extensive damage to the helicopter due to impact with a body of water. An examination of the anti-torque pedal assembly by the NTSB Materials Laboratory revealed that the fracture surface patterns found on it were consistent with a bending overstress separation. It could not be determined whether the overstress condition was the result of a precrash or postcrash event. According to the probable cause report, N3275Q suffered "inflight collision with terrain/water", and "reason for occurrence undetermined - Pilot In Command". [2]

There have been several accidents and incidents where Helicycles have lost power in/near hover, resulting in minor damage to the skids and some airframes, but no serious injuries. Most of these were attributed to a radio-frequency interference (RFI) problem with the electronic governor, and the issue was reportedly solved with better shielding in 2005.[ citation needed ] At least one accident may have been caused by a crack in a fuel line due to lack of mechanical support between a manifold and a fuel injection port.[ citation needed ] Another accident involved flight into high-voltage power distribution wires, but the aircraft was able to fly again, following repairs, and the pilot was not seriously injured.

Specifications (Helicycle)

Data from Eagle R&D [3]

General characteristics

Performance

See also

Related Research Articles

Aircraft Vehicle that is able to fly by gaining support from the air

An aircraft is a vehicle that is able to fly by gaining support from the air. It counters the force of gravity by using either static lift or by using the dynamic lift of an airfoil, or in a few cases the downward thrust from jet engines. Common examples of aircraft include airplanes, helicopters, airships, gliders, paramotors and hot air balloons.

Autogyro Rotorcraft with unpowered rotor

An autogyro, also known as a gyroplane or gyrocopter, is a type of rotorcraft that uses an unpowered rotor in free autorotation to develop lift. Forward thrust is provided independently, by an engine-driven propeller. While similar to a helicopter rotor in appearance, the autogyro's rotor must have air flowing across the rotor disc to generate rotation, and the air flows upwards through the rotor disc rather than down.

For fixed-wing aircraft, ground effect is the reduced aerodynamic drag that an aircraft's wings generate when they are close to a fixed surface. Reduced drag when in ground effect during takeoff can cause the aircraft to "float" whilst below the recommended climb speed. The pilot can then fly just above the runway while the aircraft accelerates in ground effect until a safe climb speed is reached.

The CarterCopter is an experimental compound autogyro developed by Carter Aviation Technologies in the United States to demonstrate slowed rotor technology. On 17 June 2005, the CarterCopter became the first rotorcraft to achieve mu-1 (μ=1), an equal ratio of airspeed to rotor tip speed, but crashed on the next flight and has been inoperable since. It is being replaced by the Carter Personal Air Vehicle.

AMD Zodiac Family of Canadian light airplanes

The Zodiac is a family of Canadian all-metal, two-seat, fixed landing gear airplanes that first flew in 1984. The aircraft have been produced as kits and completed aircraft by Zenair in Canada and Zenith Aircraft Company in the USA.

Helicopter Type of rotor craft in which lift and thrust are supplied by rotors

A helicopter is a type of rotorcraft in which lift and thrust are supplied by horizontally-spinning rotors. This allows the helicopter to take off and land vertically, to hover, and to fly forward, backward and laterally. These attributes allow helicopters to be used in congested or isolated areas where fixed-wing aircraft and many forms of VTOL aircraft cannot perform.

Bréguet-Dorand Gyroplane Laboratoire

The Gyroplane Laboratoire was an early helicopter. Its designer, Frenchman Louis Bréguet, had already experimented with rotorcraft in 1909; however, he chose to concentrate on airplanes until the end of the 1920s. In 1929 he announced a set of patents which addressed the flight stabilization of rotorcraft, and, in 1931, Bréguet created the Syndicat d'Etudes de Gyroplane, together with Rene Dorand as technical director. Their goal was the development of an experimental helicopter, the Gyroplane Laboratoire.

Fairey FB-1 Gyrodyne

The Fairey FB-1 Gyrodyne is an experimental British rotorcraft that used single lifting rotor and a tractor propeller mounted on the tip of the starboard stub wing to provide both propulsion and anti-torque reaction.

Buford John Schramm, better-known as B.J. Schramm, was a businessman and developer of light personal helicopters. He was killed in the crash of a single-seat helicopter of his own design near Montour, about six miles southwest of Horseshoe Bend, Idaho. Schramm founded RotorWay Aircraft in 1961, a kit helicopter manufacturing company. At the time of his death he operated a company called Eagle R&D, based in Caldwell, Idaho, manufacturing a kit helicopter called the Helicycle.

Guimbal Cabri G2

The Guimbal Cabri G2 is a two-seat light helicopter produced by Hélicoptères Guimbal, and powered by a reciprocating engine. Designed by Bruno Guimbal, a former Eurocopter engineer, it had its origins in the 1980s, and the first demonstrator flew in 1992. Following the granting of regulatory approval, the Cabri entered commercial service in 2008. In addition to its use within the general aviation sector and as a training rotorcraft, the Cabri G2 has also been used as the basis for unmanned aerial vehicles (UAVs).

Revolution Mini-500

The Revolution Mini-500 is a 1990s American single-seat light helicopter, designed and built by Revolution Helicopter Corporation as a kit for homebuilding.

de Lackner HZ-1 Aerocycle

The HZ-1 Aerocycle, also known as the YHO-2 and by the manufacturer's designation DH-5 Aerocycle, was an American one-man "personal helicopter" developed by de Lackner Helicopters in the mid-1950s. Intended to be operated by inexperienced pilots with a minimum of 20 minutes of instruction, the HZ-1 was expected to become a standard reconnaissance machine with the United States Army. Although early testing showed that the craft had promise for providing mobility on the atomic battlefield, more extensive evaluation proved that the aircraft was in fact too difficult to control for operation by untrained infantrymen, and after a pair of crashes the project was abandoned. A single model of the craft was put on display.

Sikorsky S-97 Raider American high-speed scout and attack compound helicopter

The Sikorsky S-97 Raider is a high-speed scout and attack compound helicopter based on the Advancing Blade Concept (ABC) with a coaxial rotor system under development by Sikorsky Aircraft. Sikorsky planned to offer it for the United States Army's Armed Aerial Scout program, along with other possible uses. The S-97 made its maiden flight on 22 May 2015.

Powered aircraft

A powered aircraft is an aircraft that uses onboard propulsion with mechanical power generated by an aircraft engine of some kind.

CHI KC 518 Adventourer

The Composite Helicopters International KC 518 Adventourer is a composite fuselage, 5-6 place turbine kit helicopter.

The Vortech A/W 95 is an American helicopter that was designed by Adams-Wilson as the Adams-Wilson Choppy and now produced in an improved version by Vortech of Fallston, Maryland. The aircraft is supplied in the form of plans for amateur construction. Vortech also supplies rotor blades and other key parts for the design.

The Vortech Shadow is an American autogyro that was designed by Tyler Flight, Inc. and produced by Vortech of Fallston, Maryland. The aircraft is supplied as a kit and also in the form of plans for amateur construction. Vortech also supplies rotor blades for the design.

The Hillberg Turbine Exec is an American helicopter that was designed and produced by Hillberg Helicopters of Fountain Valley, California. Now out of production, when it was available the aircraft was supplied as a conversion kit, for amateur construction.

The Hillberg EH1-01 RotorMouse is an American helicopter that was designed by Donald Gene Hillberg and produced by Hillberg Helicopters of Fountain Valley, California, first flying in 1993. Now out of production, when it was available the aircraft was supplied as a kit for amateur construction.

The Winner B150 is a Belgian helicopter that was designed and produced by Winner SBS of Dinant. Now out of production, when it was available the aircraft was supplied complete and ready-to-fly-aircraft or as a kit for amateur construction.

References

  1. ↑ "Build-it-Yourself Helicopters".
  2. ↑ "NTSB accident investigation probable cause finding (.pdf)" (PDF).[ permanent dead link ]
  3. ↑ "Helicycle Specs" . Retrieved 2008-04-13.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.