Ellehammer helicopter

Last updated
"Helicopter"
Ellehammer 1914.jpg
1914 photo of Ellehammer's coaxial helicopter hovering
RoleExperimental helicopter
Manufacturer Jacob Ellehammer
Designer Jacob Ellehammer
First flight28 September 1912
Number built1

The Ellehammer helicopter was an otherwise-unnamed experimental aircraft built in Denmark in 1912. Based on experiments with models, Jacob Ellehammer constructed a full-size machine equipped with two contra-rotating discs, each of which was fitted with six vanes around its circumference. The pitch of these vanes could be varied in operation by the pilot, an early example of cyclic control. The same engine that drove the rotors also powered a propeller mounted tractor-wise to the aircraft's frame.

1935 photo of Ellehammer's disc-rotor compound helicopter model Ellehammer 1935.jpg
1935 photo of Ellehammer's disc-rotor compound helicopter model

After a number of indoor tests, the aircraft was demonstrated outdoors and made a number of free take-offs. One of these trials was witnessed by Prince Axel of Denmark. Experiments with the helicopter continued until September 1916, when it tipped over during take-off, destroying its rotors.

A famous photo shows it hovering in 1914, though there is no evidence that it was successful in achieving translational flight. Ellehammer later studied a disc-rotor configuration - a compound helicopter with coaxial blades that extended from the hub for hover, and retracted for high speed vertical flight. Although a wind tunnel model was constructed, there's no evidence that anything more was studied.


Specifications

General characteristics

Related Research Articles

<span class="mw-page-title-main">Fairey Rotodyne</span> 1950s British compound gyroplane

The Fairey Rotodyne was a 1950s British compound gyroplane designed and built by Fairey Aviation and intended for commercial and military uses. A development of the earlier Gyrodyne, which had established a world helicopter speed record, the Rotodyne featured a tip-jet-powered rotor that burned a mixture of fuel and compressed air bled from two wing-mounted Napier Eland turboprops. The rotor was driven for vertical takeoffs, landings and hovering, as well as low-speed translational flight, but autorotated during cruise flight with all engine power applied to two propellers.

<span class="mw-page-title-main">Bell XV-15</span> American experimental tiltrotor aircraft

The Bell XV-15 is an American tiltrotor VTOL aircraft. It was the second successful experimental tiltrotor aircraft and the first to demonstrate the concept's high speed performance relative to conventional helicopters.

<span class="mw-page-title-main">Robinson R22</span> Type of aircraft

The Robinson R22 is a two-seat, two-bladed, single-engined, light utility helicopter manufactured by Robinson Helicopter Company. It was designed in 1973 by Frank D. Robinson, and has been in production since 1979.

<span class="mw-page-title-main">Bensen B-8</span> Small, single-seat autogyro

The Bensen B-8 is a small, single-seat autogyro developed in the United States in the 1950s. Although the original manufacturer stopped production in 1987, plans for homebuilders are still available as of 2019. Its design was a refinement of the Bensen B-7, and like that aircraft, the B-8 was initially built as an unpowered rotor-kite. It first flew in this form in 1955, and on 6 December a powered version, designated B-8M first flew. The design proved to be extremely popular and long-lasting, with thousands of sets of plans sold over the next thirty years.

<span class="mw-page-title-main">Flettner Fl 282</span> Type of aircraft

The Flettner Fl 282 Kolibri ("Hummingbird") is a single-seat intermeshing rotor helicopter, or synchropter, produced by Anton Flettner of Germany. According to Yves Le Bec, the Flettner Fl 282 was the world's first series production helicopter.

<span class="mw-page-title-main">Cierva C.30</span> 1933 autogyro family by Cierva

The Cierva C.30 is an autogyro designed by Juan de la Cierva and built under licence from the Cierva Autogiro Company by A V Roe & Co Ltd (Avro), Lioré-et-Olivier and Focke-Wulf.

<span class="mw-page-title-main">Quadcopter</span> Helicopter with four rotors

A quadcopter or quadrotor is a type of helicopter with four rotors.

<span class="mw-page-title-main">Gyrodyne</span>

A gyrodyne is a type of VTOL aircraft with a helicopter rotor-like system that is driven by its engine for takeoff and landing only, and includes one or more conventional propeller or jet engines to provide forward thrust during cruising flight. During forward flight the rotor is unpowered and free-spinning, like an autogyro, and lift is provided by a combination of the rotor and conventional wings. The gyrodyne is one of a number of similar concepts which attempt to combine helicopter-like low-speed performance with conventional fixed-wing high-speeds, including tiltrotors and tiltwings.

<span class="mw-page-title-main">Helicopter</span> Type of rotorcraft in which lift and thrust are supplied by horizontally-spinning rotors

A helicopter is a type of rotorcraft in which lift and thrust are supplied by horizontally spinning rotors. This allows the helicopter to take off and land vertically, to hover, and to fly forward, backward and laterally. These attributes allow helicopters to be used in congested or isolated areas where fixed-wing aircraft and many forms of STOL or STOVL aircraft cannot perform without a runway.

<span class="mw-page-title-main">Cessna CH-1 Skyhook</span> American helicopter built by Cessna

The Cessna CH-1 Skyhook is the only helicopter ever built by the Cessna Aircraft Company. It was the first helicopter to land on the summit of Pike's Peak and the last piston-engined helicopter to set the helicopter altitude record. The CH-1 had a single, two-bladed main rotor, and a front-mounted reciprocating engine which gave the aircraft a stable center of gravity (CG). Its semi-monocoque airframe greatly resembles its light airplane siblings built by Cessna. The CH-1 was named Skyhook for the civil market, similar to the marketing names used in the Cessna single engine airplane line, such as Skyhawk, Skylane and Skywagon. The United States Army designated the CH-1C as the YH-41 Seneca. While the CH-1 achieved several helicopter firsts and set a world record, it never became a commercial or military success.

<span class="mw-page-title-main">Cierva W.11 Air Horse</span> Type of aircraft

The Cierva W.11 Air Horse was a helicopter developed by the Cierva Autogiro Company in the United Kingdom during the mid-1940s. The largest helicopter in the world at the time of its debut, the Air Horse was unusual for using three rotors mounted on outriggers, and driven by a single engine mounted inside the fuselage.

<span class="mw-page-title-main">Bell HSL</span> Type of aircraft

The Bell HSL was an American 1950s anti-submarine warfare (ASW) helicopter built by the Bell Helicopter company, the only tandem rotor type designed by Bell.

<span class="mw-page-title-main">Bell H-12</span> Type of aircraft

The Bell R-12 was an American 1940s military utility helicopter built by the Bell Helicopter company.

<span class="mw-page-title-main">Doman LZ-5</span> Utility helicopter prototype

The Doman LZ-5 was a utility helicopter developed in the United States in the early 1950s by Doman Helicopters Inc. of Danbury, Connecticut. Despite the procurement of international manufacturing agreements, no series production of the aircraft ever occurred, and only three prototypes were built. Two of these were purchased by the United States Army as the YH-31, but eventually becoming VH-31.

<span class="mw-page-title-main">McDonnell XV-1</span> American experimental gyrodyne

The McDonnell XV-1 is an experimental Convertiplane developed by McDonnell Aircraft for a joint research program between the United States Air Force and the United States Army to explore technologies to develop an aircraft that could take off and land like a helicopter but fly at faster airspeeds, similar to a conventional airplane. The XV-1 would reach a speed of 200 mph, faster than any previous rotorcraft, but the program was terminated due to the tip-jet noise and complexity of the technology which gave only a modest gain in performance.

<span class="mw-page-title-main">Cornu helicopter</span> Type of aircraft

The Cornu helicopter was an experimental helicopter built in France, and is widely credited with the first free flight of a rotary-wing aircraft when it took to the air on 13 November 1907. Built by bicycle-maker Paul Cornu, it was an open-framework structure built around a curved steel tube that carried a rotor at either end, and the engine and pilot in the middle. Power was transmitted to the rotors by a drive belt that linked both rotors and spun them in opposite directions. Control was to be provided by cables that could alter the pitch of the rotor blades, and by steerable vanes at either end of the machine intended to direct the downwash of the rotors.

<span class="mw-page-title-main">Ellehammer semi-biplane</span> Type of aircraft

The Ellehammer Semi-biplane was a pioneering aircraft flown in Denmark in 1906. Jacob Ellehammer built the aircraft based on his monoplane design of the previous year. Like that aircraft, it featured a large, triangular wing, with a motor mounted beneath it. The pilot sat on a seat that was suspended like a pendulum, allowing him to shift his weight to control the aircraft, similar in concept to the control of a modern hang-glider. Unlike his monoplane, however, the semi-biplane's main wing formed a constant, unbroken span. Additionally, it was fitted with an upper wing of the same triangular shape, which connected to the main wing at its three corners and to an arch above the aircraft's centreline.

<span class="mw-page-title-main">Jacob Ellehammer</span>

Jacob Christian Hansen-Ellehammer was a Danish watchmaker and inventor born in Bakkebølle, Denmark. He is remembered chiefly for his contributions to powered flight.

<span class="mw-page-title-main">Bell 30</span> Type of aircraft

The Bell 30 was the prototype for the first commercial helicopter, and the first helicopter built by the Bell Aircraft Company. Designed by Arthur M. Young, the type served as a demonstration testbed for the successful Bell 47.

<span class="mw-page-title-main">Berliner Helicopter</span> Type of aircraft

The Berliner Helicopter was a series of experimental helicopters built by Henry Berliner between 1922 and 1925. The helicopters had only limited controllability but were the most significant step forward in helicopter design in the US, until the production of the Vought-Sikorsky VS-300 helicopter in 1940. The 1922 flights of the Berliner and the de Bothezat H1 were the first by manned helicopters.

References