Foxjet ST600

Last updated
ST600
Foxjetbrochure.jpg
RoleLight business jet
Manufacturer Tony Team Industries
StatusAbandoned project
Number builtNone

The Foxjet ST600 was a small business jet under development in the United States in the late 1970s. Problems with development, particularly in finding a suitable powerplant, caused the project to be abandoned before any substantial work on the prototype had been done, but the concept proved to be ahead of its time, foreshadowing the very light jets of thirty years later.

Contents

Design and development

The ST600 was of familiar business jet configuration, with a low wing, cruciform tail, swept flying surfaces, and engines mounted on pods on the sides of the rear fuselage. The intentions of the project were to create a practical business jet small enough and light enough to take advantage of smaller airfields at a cost of around half of what full-size business jets of the day were selling for. Fuel costs were touted as being as low as nine cents a mile in 1977, compared to fifty cents a mile or higher for contemporary aircraft. [1]

73 orders for the aircraft were taken with Bill Lear ordering the first example.

Three mockups were constructed and were widely displayed at aviation shows around the United States in the late 1970s by Tony Fox with slipping first flight schedules. [2] [3] The project got as far as Foxjet contracting Aeronca to construct the prototype. The engines, however, proved a major stumbling block. The tiny Williams Research type WR44 turbofan that had made the project possible received certification for use in a passenger-carrying aircraft, but due to its selection as the powerplant for cruise missiles, the United States government blocked non-military use of the engine.[ citation needed ] Without a suitable alternative available, the project could not proceed.

In 2006, a Foxjet mockup was exhibited at the AOPA expo at Palm Springs, Florida by Millennium Aerospace, which had purchased rights to the design in May. The company announced plans to resurrect the design and market it with Pratt & Whitney Canada PW615 engines.

The original prototype was eventually purchased by Lyle Anderson, of Princeton, Minnesota from a used motorcycle dealership in Minneapolis and prior to that, it stood in front of a car dealership. In 2010 it was put in Anderson's front yard, and was a participant in the Rum River Festival parade prior to relocation to Princeton Airport. [4]

Specifications (as designed)

Data from Jane's All The World's Aircraft 1980–81 [5]

General characteristics

Performance

See also

Aircraft of comparable role, configuration, and era

Related Research Articles

<span class="mw-page-title-main">Raytheon T-1 Jayhawk</span> US military training aircraft based on Beechjet/Hawker 400A

The Raytheon T-1 Jayhawk is a twin-engined jet aircraft used by the United States Air Force for advanced pilot training. T-1A students go on to fly airlift and tanker aircraft. The T-400 is a similar version for the Japan Air Self-Defense Force.

<span class="mw-page-title-main">CASA C-101 Aviojet</span> Trainer aircraft family by CASA

The CASA C-101 Aviojet is a low-wing single engine jet-powered advanced trainer and light attack aircraft designed and manufactured by Spanish aircraft company Construcciones Aeronáuticas SA (CASA).

<span class="mw-page-title-main">IAI Westwind</span> Type of aircraft

The IAI Westwind is a business jet initially produced by Aero Commander as the 1121 Jet Commander. Powered by twin GE CJ610 turbojets, it first flew on January 27, 1963, and received its type certification on November 4, 1964, before the first delivery. The program was bought by Israel Aircraft Industries (IAI) in 1968, which stretched it slightly into the 1123 Westwind, and then re-engined it with Garrett TFE731 turbofans into the 1124 Westwind. The 16,800–23,500 lb (7.6–10.7 t) MTOW aircraft can carry up to 8 or 10 passengers, and 442 were produced until 1987.

<span class="mw-page-title-main">Piaggio PD.808</span> Type of aircraft

The Piaggio PD.808 was an Italian business jet built by Piaggio. It was designed as a joint venture between Piaggio and Douglas Aircraft Company of Long Beach, California, United States.

<span class="mw-page-title-main">Williams V-Jet II</span> Type of aircraft

The Williams V-Jet II was designed and built by Burt Rutan's Scaled Composites for Williams International as a test bed and demonstrator aircraft for Williams' new FJX-1 turbofan engine.

<span class="mw-page-title-main">Scaled Composites Triumph</span> Type of aircraft

The Scaled Composites Triumph is a twin-engine, business jet prototype designed and built by Burt Rutan's Scaled Composites for Beechcraft. It was known officially as the Model 143, and internally at Scaled as the "Tuna". The aircraft is a three lifting surface design, with both a small canard, and a small conventional horizontal stabilizer in a T-tail configuration.

<span class="mw-page-title-main">Learjet 40</span> Type of aircraft

The Learjet 40 (LJ40) is a light business jet produced by Bombardier Aerospace.

<span class="mw-page-title-main">Learjet 28</span> Type of aircraft

The Learjet 28 is an American eight-to-ten-seat, twin-engine, high-speed business jet, intended to be the successor to the Learjet 25. The Learjet 29 is identical except for the addition of a long-range fuel tank, resulting in the reduction of the capacity to six. Both were manufactured by Learjet and were marketed under the Longhorn name.

<span class="mw-page-title-main">NDN Firecracker</span> Type of aircraft

The NDN Firecracker is a single-engine aircraft designed as a military trainer.

<span class="mw-page-title-main">Gulfstream American Hustler</span> Type of aircraft

The Gulfstream American Hustler was a 1970s American mixed-power executive/utility aircraft designed by American Jet Industries, which later changed to Gulfstream American Corporation. The aircraft had a nose-mounted turboprop and a tail-mounted turbofan.

<span class="mw-page-title-main">CMC Leopard</span> Type of aircraft

The CMC Leopard was a British light personal business jet developed in the 1980s. Two prototypes were built and flown, but the type was never put into production.

<span class="mw-page-title-main">Cessna Citation I</span> Business jet manufactured 1971–1985

The Cessna 500 Citation I is a small business jet produced by Cessna, the basis of the Citation family. The Fanjet 500 prototype was announced in October 1968, first flew on September 15, 1969, and was certified as the 500 Citation on September 9, 1971. It was upgraded in 1976 as the Citation I, and the 501 Citation I/SP single-pilot variant was introduced in 1977. Production ended in 1985 with 689 of all variants produced. The straight wing jet is powered by JT15D turbofans. The aircraft was developed into the Citation II.

<span class="mw-page-title-main">Grob GF 200</span> Type of aircraft

The Grob GF 200 was a business aircraft of unorthodox design developed in Germany during the 1990s.

The Hawk GafHawk was a small, turboprop-powered freighter aircraft developed in the United States in the 1980s but which only flew in prototype form. It was designed by Hawk International as a means of transporting drilling equipment in and out of remote locations, and was designed to be simple, rugged, and have good STOL and rough-field performance. The resulting design was a boxy aircraft with a rectangular-section fuselage with a high-set tail and rear loading ramp. The high aspect-ratio wings were high-set and braced with struts. The landing gear was fixed and of tricycle configuration, with the main units having dual wheels.

<span class="mw-page-title-main">Jeffair Barracuda</span> Sports monoplane

The Jeffair Barracuda is a high-performance sporting monoplane that was developed in the United States in the 1970s and is marketed for homebuilding. Designed and built by Geoffrey Siers, the prototype won the prize for "Most Outstanding New Design" at the EAA Fly-in in 1976. It was a low-wing cantilever monoplane of wooden construction with retractable tricycle undercarriage and side-by-side seating for two. Around 150 sets of plans had sold by 1977.

<span class="mw-page-title-main">Promavia Jet Squalus</span> Type of aircraft

The Promavia F.1300 Jet Squalus, also known as Promavia Jet Squalus F1300, was a two-seat light jet trainer designed by Italian Stelio Frati and built by Promavia in Belgium with support from the Belgian government.

The Viper Aircraft ViperJet is a small homebuilt jet aircraft by Viper Aircraft Corporation. It is a conventional, low-wing monoplane with swept wings and tail and two seats in tandem under a bubble canopy. The jet intakes are located at the sides of the fuselage and the tricycle undercarriage is retractable. Construction throughout is of composite materials.

<span class="mw-page-title-main">VisionAire Vantage</span> Type of aircraft

The VisionAire VA-10 Vantage is a prototype single-engined light business-jet designed and developed by the American company VisionAire Jets Corporation. Originally planned for production in the late 1990s, the original VisionAire Corporation failed in 2003. The project was acquired by Eviation Jets, which planned to produce it as the redesigned EV-20 Vantage Jet. Eviation also failed, and in 2012 the design was relaunched by a revived VisionAire under its original design.

The Taylor Bird is a homebuilt aircraft that was designed by C. G. Taylor, the designer of the Taylor Cub.

<span class="mw-page-title-main">KB SAT SR-10</span> Russian single-engine jet trainer aircraft

The KB SAT SR-10 is a prototype Russian single-engine jet trainer aircraft, fitted with forward-swept wings. It first flew in 2015 and is being offered to the Russian Air Force and for export.

References

  1. "9 cent a mile executive business jet". Popular Science. October 1977.
  2. Cliff Barnett (22 August 1977). "Oshkosh Sport Aircraft Galore" (PDF-2.3 Mb). Flight International : 573-. ISSN   0015-3710 . Retrieved 1 June 2014.
  3. Air Progress. 40 (11): 94. November 1978.{{cite journal}}: Missing or empty |title= (help) (40th Anniversary Issue)
  4. "Foxjet Now a Historic Lawn Ornament". EAA. 13 May 2010. Archived from the original on 16 May 2010. Retrieved 8 July 2019.
  5. Taylor 1980, p. 338.