Kick start

Last updated
A kick start lever highlighted on a Kawasaki two-stroke motorcycle Kick-start.jpg
A kick start lever highlighted on a Kawasaki two-stroke motorcycle

Kick start is a method of starting an internal combustion engine (usually that of a motorcycle) by pushing a ratcheting lever with one's foot. Kick start mechanisms were almost universally a part of motorcycle engines before the mid-1970s, and were phased out of production over the next twenty years or so as electric starters became standard equipment. There are still some motorcycles produced that have both kick and electric starters.

Contents

Many mopeds and scooters also carry both a kick start and an electric start, the former being useful in case the latter fails, as scooter and moped batteries tend to be smaller and, as a result, run down much faster than other forms of automotive batteries. Also, it is usually not possible to push start a moped or scooter with automatic transmission.

Larger motorcycles featured a manual compression release mechanism that made starting easier while modern units did this automatically through a cable attached to the kick start lever.

Today, dedicated off-road motorcycles and many ATVs use kick start systems, to avoid the weight of electric starters. The majority of the inexpensive two-wheelers and sometimes three-wheelers in developing countries, also use kick start systems.

Operation

Before starting, kickstart levers are generally unfolded from the side of the motorcycle so that the rider can clear the side of the engine as it rotates. As the lever begins to descend under the rider's foot, the rachet engages a gear linked to the crankshaft causing it to spin past top dead center so that an ignition spark can ignite the compressed fuel mixture. Upon starting, the rachet disengages and the rider folds the lever back.

On some large displacement twins or singles, 'kickback' can occur if the fuel ignites before the piston reaches top dead center. This causes the crank to spin backwards and can be painful for the rider as the lever kicks back on their foot.

The first kick start motorcycle was a British Scott Motorcycle two-stroke twin manufactured in 1910. [1]

Some scooters have kick starters with a tendency not to always work, if not performed correctly. Some manufacturers have also included kick starters in their models, only for a purpose of introducing apparent convenience for ignition, as opposed to offering a reliable alternative for an electric starter.[ citation needed ]

See also

Related Research Articles

<span class="mw-page-title-main">Clutch</span> Mechanical device that connects and disconnects two rotating shafts or other moving parts

A clutch is a mechanical device that allows the output shaft to be disconnected from the rotating input shaft. The clutch's input shaft is typically attached to a motor, while the clutch's output shaft is connected to the mechanism that does the work.

<span class="mw-page-title-main">Motorcycle</span> Two- or three-wheeled motor vehicle

A motorcycle is a two or three-wheeled motor vehicle steered by a handlebar from a saddle-style seat.

<span class="mw-page-title-main">Starter (engine)</span> Device used to start an internal combustion engine

A starter is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power. Starters can be electric, pneumatic, or hydraulic. The starter can also be another internal-combustion engine in the case, for instance, of very large engines, or diesel engines in agricultural or excavation applications.

<span class="mw-page-title-main">Freewheel</span> Mechanism which disconnects a driveshaft from a faster-rotating driven shaft

In mechanical or automotive engineering, a freewheel or overrunning clutch is a device in a transmission that disengages the driveshaft from the driven shaft when the driven shaft rotates faster than the driveshaft. An overdrive is sometimes mistakenly called a freewheel, but is otherwise unrelated.

<span class="mw-page-title-main">Malaguti</span> Italian motorcycle manufacturer

Malaguti is an Italian bicycle, scooter and motorcycle company based in San Lazzaro di Savena, founded by Antonino Malaguti in 1930. Producing bicycles until 1958, they then entered the motorcycle market. Noted for their use of small engines in their bikes. In October 2011, Malaguti laid off its remaining employees in Bologna, Italy as the company eventually folded.

<span class="mw-page-title-main">Honda Super Cub</span> Light motorcycle

The Honda Super Cub or Honda Cub is a Honda underbone motorcycle with a four-stroke single-cylinder engine ranging in displacement from 49 to 124 cc.

<span class="mw-page-title-main">Motorcycle engine</span> Engine that powers a motorcycle

A motorcycle engine is an engine that powers a motorcycle. Motorcycle engines are typically two-stroke or four-stroke internal combustion engines, but other engine types, such as Wankels and electric motors, have been used.

<span class="mw-page-title-main">Types of motorcycles</span> Types of motorcycles

The six main types of motorcycles are generally recognized as standard, cruiser, touring, sports, off-road, and dual-purpose. Sport touring is sometimes recognized as a seventh category or integrated with the touring category.

<span class="mw-page-title-main">Motorized bicycle</span> Bicycle with an attached motor or engine and transmission

A motorized bicycle is a bicycle with an attached motor or engine and transmission used either to power the vehicle unassisted, or to assist with pedalling. Since it sometimes retains both pedals and a discrete connected drive for rider-powered propulsion, the motorized bicycle is in technical terms a true bicycle, albeit a power-assisted one. Typically they are incapable of speeds above 52 km/h (32 mph), however in recent years larger motors have been built, allowing bikes to reach speeds of upwards of 72 km/h.

<span class="mw-page-title-main">Honda Express</span> Type of motorcycle

The Honda Express or Honda NC50 is a scooter made by Honda between 1977 and 1983. Variants include the Express (NC50), Express II (NA50), Express SR (NX50) and Urban Express (NU50). All versions of the Express line are powered by an air-cooled 49 cc (3.0 cu in) two-stroke engine.

<span class="mw-page-title-main">Yamaha QT50</span>

The Yamaha QT50 Yamahopper was produced by the Yamaha Motor Company from 1979 through 1992. QT50s were popular in the late 1970s and 1980s, These small motorcycles are easy to ride, maintain, and are fuel efficient. The engine being slightly under 50cc, it was legal in some states to operate this diminutive motorcycle without a drivers licence thereby making the QT50 appealing to teenagers. The QT50 motorcycle resembles contemporary Mopeds and shares some features with Scooters.

<span class="mw-page-title-main">Electric motorcycles and scooters</span> Plug-in electric vehicles with two or three wheels

Electric motorcycles and scooters are plug-in electric vehicles with two or three wheels. Power is supplied by a rechargeable battery that drives one or more electric motors. Electric scooters are distinguished from motorcycles by having a step-through frame, instead of being straddled. Electric bicycles are similar vehicles, distinguished by retaining the ability to be propelled by the rider pedaling in addition to battery propulsion.

Motorcycle components and systems for a motorcycle are engineered, manufactured, and assembled in order to produce motorcycle models with the desired performance, aesthetics, and cost. The key components of modern motorcycles are presented below.

<span class="mw-page-title-main">Push start</span>

Push starting, also known as bump starting, roll starting, clutch starting, popping the clutch or crash starting, is a method of starting a motor vehicle with an internal combustion engine that has a manual transmission, a mechanical fuel pump, and a mechanically driven generator or alternator. By pushing or letting the vehicle roll downhill then engaging the clutch at the appropriate speed the engine will turn over and start. The technique is most commonly employed when other starting methods are unavailable.

<span class="mw-page-title-main">Honda PC50</span> Type of motorcycle

The Honda PC50 is a moped produced by the Honda Motor Company in Japan from May 1969 until at least 1983. The PC50, though much smaller and lighter, had some similar features to Honda's popular C50 /70 /90 Super Cub line, with a step-through pressed-steel frame, a fuel tank under the saddle, a chain cover, and optionally equipped with leg shields,

<span class="mw-page-title-main">Scooter (motorcycle)</span> Low-speed motorcycle

A scooter is a motorcycle with an underbone or step-through frame, a seat, and a platform for the rider's feet, emphasizing comfort and fuel economy. Elements of scooter design were present in some of the earliest motorcycles, and motor scooters have been made since at least 1914.

<span class="mw-page-title-main">Compression release</span>

A compression release mechanism works to ease the starting of internal combustion engines by allowing them to spin up to starting speed without having to work against the pumping action of the pistons. It does this through a release valve that is incorporated within the cylinder head that vents the cylinder pressure to the outside atmosphere until the engine has sufficient momentum to overcome it. At that point the valve closes and the ignition is engaged.

<span class="mw-page-title-main">Motorcycle transmission</span> Transmission for motorcycle applications

A motorcycle transmission is a transmission created specifically for motorcycle applications. They may also be found in use on other light vehicles such as motor tricycles and quadbikes, go-karts, offroad buggies, auto rickshaws, mowers, and other utility vehicles, microcars, and even some superlight racing cars.

<span class="mw-page-title-main">Motorized tricycle</span> Resembling a bicycle with two rear wheels and an engine

A motorized tricycle, motor trike, or motortrycle is a three-wheeled vehicle based on the same technology as a bicycle or motorcycle, and powered by an electric motor, motorcycle, scooter or car engine.

<span class="mw-page-title-main">Car controls</span> Car parts used to control the vehicle

Car controls are the components in automobiles and other powered road vehicles, such as trucks and buses, used for driving and parking.

References

  1. Brown, Roland (1996), The Encyclopedia of Motorcycles, Smithmark, p. 12, ISBN   0831728485