| Paulhan biplane | |
|---|---|
 | |
| Paulhan biplane at the Royal Aircraft Factory, Farnborough. | |
| Role | Experimental aircraft |
| National origin | France |
| Designer | Louis Paulhan |
| First flight | 1910 |
| Number built | 3 |
The Paulhan biplane was a French experimental aircraft designed in 1910 by the successful aviator Louis Paulhan in collaboration with Henri Fabre. The prototype became the second aircraft bought by the British War Office: [1] two further examples, differing in constructional detail, were built. [2]
Although the general arrangement of the aircraft was conventional for the time, being a pusher biplane with a front-mounted elevator and a rear-mounted horizontal stabiliser and rudder, it had a number of extremely unorthodox constructional details. The most obvious was the construction of the wings, which had a single spar forming the leading edges of the wings which was an exposed warren truss of a type designed and patented by Fabre. The ribs were cantilevered from this spar, each rib being enclosed in a pocket in the covering, which was laced to the leading edge and attached to the trailing edge end of each rib by a spring clip. [3] The other flying surfaces were similar. The wings were connected by four single interplane struts, the central pair attached to booms (also Fabre girders) bearing the forward-mounted elevator and a rear-mounted rudder mounted in front of an adjustable horizontal stabilising surface. The aluminium-covered nacelle, in which the pilot and passenger were seated side by side) in front of the 37 kW (50 hp) Gnome Omega rotary engine, was suspended between the wings by steel cables which were attached to the ends of the central pair of interplane struts. The undercarriage consisted of a pair of long skids mounted on extensions of the inner interplane struts and connected to the forward extremities of the fuselage booms, each bearing a pair of wheels on a short axle. A tailskid which could be moved by the pilot to act as a brake was carried on the lower end of the rudder mounting. [3]
The second example retained the same general arrangement but differed considerably in constructional detail. The Fabre lattice girders were replaced by conventional spars, the single interplane struts replaced by more conventional paired struts and the tail surfaces altered to a cruciform arrangement, with the rudder divided into two sections above and below the stabiliser. The trim of the aircraft could be altered on the ground by adjusting the bracing cables for the tail surfaces. [4]
After being exhibited at the 1910 Paris Aero Salon, [5] a few short flights were made by Paulhan at the end of October at Saint-Cyr-l'Ecole and showed what Flight described as "satisfying flight behavior". [6] A public demonstration of the aircraft was later made on 26 November by Albert Caillé, including two return flights betewwen St Cyr and Buc. Paulhan wanted this demonstration of his aircraft to be made by someone other than himself, in case its success was attributed solely to his skill as a pilot. [7] (Caillé was a former pupil at Paulhan's flying school who had only been awarded his Aero Club de France license at the beginning of September.) Commercial rights for Great Britain had been acquired by George Holt Thomas, who succeeded in interesting the British War Office in the aircraft. After a demonstration flight during which it met the War Office's demands of a two-hour flight with a passenger and (200 kg (441 lb) of ballast in a 40 kmh (25 mph) wind and a gliding flight from a height of 200 m (626 ft), an example was ordered and early January 1911 Caillé successfully put it through a series of tests at Buc. [8] Captain Fulton from the British Army witnessed the tests and accepted the aircraft on January 11, 1911. It was subsequently flown at the Royal Aircraft Factory, where it did not impress,. [1]
Data from Munson, 1969.
General characteristics
The Boxkite was the first aircraft produced by the British and Colonial Aeroplane Company. A pusher biplane based on the successful Farman III, it was one of the first aircraft types to be built in quantity. As the type was used by Bristol for instruction purposes at their flying schools at Larkhill and Brooklands many early British aviators learned to fly in a Boxkite. Four were purchased in 1911 by the War Office and examples were sold to Russia and Australia. It continued to be used for training purposes until after the outbreak of the First World War.
Fabre Hydravion is the name used in English-language sources for an originally unnamed experimental floatplane designed by Henri Fabre. The aircraft is notable as the first to take off from water under its own power.
The Voisin Canard was an aircraft developed by Voisin brothers during 1910 and first flown early in 1911. It was named the Canard because of the resemblance of its forward fuselage to that of a duck's long neck while in flight. It was originally flown as a landplane: with the addition of floats it became one of the first seaplanes used by the French Navy.
Louis Ferdinand Ferber was a French Army officer who played an important role in the development of aviation during the early 1900s. Although his aircraft experiments were belatedly successful, his early recognition and publicizing of the work of the Wright Brothers was a major influence on the development of aviation in Europe.
The Maurice Farman MF.7 Longhorn is a French biplane developed before World War I which was used for reconnaissance by both the French and British air services in the early stages of the war before being relegated to service as a trainer.
The British Army Aeroplane No 1 or sometimes Cody 1 was a biplane built by Samuel Franklin Cody in 1907 at the Army Balloon Factory at Farnborough. It made the first recognised powered and sustained flight in the United Kingdom on 16 October 1908.
The Bréguet Type III was an early biplane built by Louis Bréguet in France in 1910.
The 1907 Voisin biplane, was Europe's first successful powered aircraft, designed by aeronautical engineer and manufacturer Gabriel Voisin. It was used by the French aviator Henri Farman to make the first heavier-than-air flight lasting more than a minute in Europe, and also to make the first full circle. The first examples of the aircraft were known by the name of their owners, for instance the Delagrange I, or the Henri Farman n°1. Farman made many modifications to his aircraft, and these were incorporated into later production aircraft built by Voisin. The type enjoyed widespread success, and around sixty were built.
The Farman III, also known as the Henry Farman 1909 biplane, was an early French aircraft designed and built by Henry Farman in 1909. Its design was widely imitated, so much so that aircraft of similar layout were generally referred to as being of the "Farman" type.
The ASL Viking was a single-engined two seater biplane aircraft designed and built by Horatio Barber's Aeronautical Syndicate Ltd. at Hendon. It was first flown in January 1912.
The Edwards Rhomboidal was an early British aircraft of extremely unorthodox configuration designed by E.W. Edwards.
The Bland Mayfly was an early aircraft constructed in 1910 by Lilian E. Bland in Carnmoney in Ireland. It is credited as the first aeroplane to be designed and constructed by a woman.
The Caudron Type A was the first successful aircraft built by René Caudron and his brother Gaston. During 1910 the Caudron brothers were briefly associated with the Société Anonyme Français d'Aviation (S.A.F.A.), and an example of the type was exhibited at the 1910 Paris Aero Salon as the S.A.F.A. Biplane.
The Voisin Type de Course was an early French aircraft built by Voisin Frères. It was first flown early in 1910.
The Voisin Type Bordeaux was an aircraft built by Voisin Frères in 1910, so named because it was used by Juan Bielovucic to make a record-breaking flight from Paris to Bordeaux in France. The design differed significantly from previous Voisin designs in eliminating the forward-mounted elevator.
The Bréguet Type II was the second fixed-wing aircraft design produced by Louis Bréguet. Built during late 1909, it was soon discarded in favour of his next design, the Bréguet Type III
The Hydroaéroplane Caudron-Fabre, (Caudron-Fabre), was a French amphibious seaplane that competed in the 1912 Monaco event. It was one of the first true amphibians, able to take-off from water and touch down on land.
The Caudron Type B was a 1911 development of the earliest Caudron type, the Caudron Type A, with a nacelle style fuselage and more powerful engine. Initially an equal span biplane, it was modified into a sesquiplane.
The Caudron Type C was a single seat French biplane, intended for military evaluation. Two were built in 1911.
The Caudron Type F was a French single seat biplane produced just before World War I. A dozen were bought by China and at least two other examples, with different engines, competed in 1913, coming first and second in the biplane category of the cross-country race at Reims. Flown by Pierre Chanteloup, one was the first biplane to loop-the-loop.
