Royal Aircraft Factory R.E.5

Last updated

Royal Aircraft Factory R.E.5
RAF R.E.5i.jpg
RoleReconnaissance and artillery observation biplane
Manufacturer Royal Aircraft Factory
First flight1914
Introduction1914
Primary user Royal Flying Corps
Number built24
Variants Royal Aircraft Factory R.E.7

The Royal Aircraft Factory R.E.5 was a British two-seat reconnaissance and artillery observation biplane designed and built by the Royal Aircraft Factory for the Royal Flying Corps.

Contents

Development

The R.E.5 was designed as a reconnaissance biplane using the experience of earlier R.E. series aircraft. It was a two-bay equal-span biplane with a fixed tailskid landing gear, with the wheels supported on skids and powered by a nose-mounted 120 hp (89 kW) Austro-Daimler engine driving a four-bladed propeller. The aircraft had two open cockpits with the observer/gunner in the forward cockpit under the upper wing and the pilot aft. The larger more capable Royal Aircraft Factory R.E.7 was a further development of the design. Some modified single-seat high altitude aircraft were built with extended-span (57 ft 2⅓ in or 17.43 m) upper wings supported by a pair of outward-leaning struts. [1] Other R.E.5s were used for experimentation with airbrakes and for test flying the Royal Aircraft Factory 4 engine. [2]

Twenty four R.E.5s were built at the Royal Aircraft Factory for the RFC, paid for by money given to the British Army to compensate for the transfer of the army's airships to the Royal Navy. [3]

Operational history

Six R.E.5s deployed to France in September 1914, partly equipping No. 2 Squadron RFC, with further examples being by other squadrons, with no unit being completely equipped with the R.E.5. In total, eleven R.E.5s were sent to France, with a further nine being used by training units.

The R.E.5s were used for reconnaissance and bombing missions over France, although at first they were not fitted with bomb-sights or bomb racks, bombs being carried in the observer's cockpit and dropped by hand when the aircraft was over the target. [3]

Captain John Aidan Liddell was awarded the Victoria Cross for an action on 31 July 1915, being badly wounded when flying an R.E.5 but successfully recovering the aircraft and saving his observer. [2] The R.E.5 was gradually phased out from front-line service during that year, only two remaining at the front on 25 September 1915. [2]

Preparations for the altitude record flight on 14 May 1914 RAF R.E.5ii.jpg
Preparations for the altitude record flight on 14 May 1914

One of the aircraft with extended upper wings set a new world altitude record of 18,900 ft (5,760 m) on 14 May 1914, piloted by Norman Spratt. [1]

Operator

Flag of the United Kingdom.svg  United Kingdom

Specifications

General characteristics

Performance

Armament

See also

Related lists

Related Research Articles

Royal Aircraft Factory B.E.2

The Royal Aircraft Factory B.E.2 was a British single-engine tractor two-seat biplane designed and developed at the Royal Aircraft Factory. Most production aircraft were constructed under contract by various private companies, both established aircraft manufacturers and firms that had not previously built aircraft. Around 3,500 were manufactured in all.

Royal Aircraft Factory F.E.2

Between 1911 and 1914, the Royal Aircraft Factory used the F.E.2 designation for three quite different aircraft that shared only a common "Farman" pusher biplane layout.

Royal Aircraft Factory R.E.8 Royal Aircraft Factory First World War reconnaissance biplane

The Royal Aircraft Factory R.E.8 was a British two-seat biplane reconnaissance and bomber aircraft of the First World War designed and produced at the Royal Aircraft Factory. It was also built under contract by Austin Motors, Daimler, Standard Motors, Siddeley-Deasy and the Coventry Ordnance Works.

Sopwith 1½ Strutter British WW1 biplane fighter, bomber and reconnaissance aircraft

The Sopwith 1+12 Strutter was a British single- or two-seat multi-role biplane aircraft of the First World War. It was the first British two-seat tractor fighter and the first British aircraft to enter service with a synchronised machine gun. It was given the name 1+12 Strutter because of the long and short cabane struts that supported the top wing. The type was operated by both British air services and was in widespread but lackluster service with the French Aéronautique Militaire.

Vickers F.B.5 Fighter aircraft; first operational purpose-built fighter

The Vickers F.B.5 was a British two-seat pusher military biplane of the First World War. Armed with a single .303 in (7.7 mm) Lewis gun operated by the observer in the front of the nacelle, it was the first aircraft purpose-built for air-to-air combat to see service, making it the world's first operational fighter aircraft.

Armstrong Whitworth F.K.3 British military biplane

The Armstrong Whitworth F.K.3 was a British two-seat general-purpose biplane built by Armstrong Whitworth Aircraft during the First World War. By the end of the war it was considered obsolete for combat.

Armstrong Whitworth F.K.8 1916 utility aircraft by Armstrong Whitworth

The Armstrong Whitworth F.K.8 was a British two-seat general-purpose biplane built by Armstrong Whitworth during the First World War. The type served alongside the better known R.E.8 until the end of the war, at which point 694 F.K.8s remained on RAF charge.

Airco DH.5

The Airco DH.5 was a British First World War single-seat biplane fighter aircraft. It was designed and manufactured at British aviation company Airco. Development was led by aircraft designer Geoffrey de Havilland as a replacement for the obsolete Airco DH.2.

Airco DH.1

The Airco DH.1 was an early military biplane of typical "Farman" pattern flown by Britain's Royal Flying Corps during World War I. By the time the powerplant for which it was designed was sufficiently plentiful it was obsolete as an operational aircraft, and apart from a few examples sent to the Middle East it served as a trainer and Home Defence fighter.

Airco DH.6

The Airco DH.6 was a British military trainer biplane used by the Royal Flying Corps during the First World War. Known by various nicknames, including the "Clutching hand" and "Skyhook", many survived to be used as a civil light aircraft in the postwar era.

Martinsyde G.100

The Martinsyde G.100 "Elephant" and the G.102 were British fighter bomber aircraft of the First World War built by Martinsyde. The type gained the name "Elephant" from its relatively large size and lack of manoeuvrability. The G.102 differed from the G.100 only in having a more powerful engine.

Royal Aircraft Factory B.E.12

The Royal Aircraft Factory B.E.12 was a British single-seat aeroplane of The First World War designed at the Royal Aircraft Factory. It was essentially a single-seat version of the B.E.2.

Royal Aircraft Factory B.E.9 British experimental reconnaissance aircraft

The Royal Aircraft Factory B.E.9 was a British experimental reconnaissance aircraft of World War I.

Royal Aircraft Factory B.E.8

The Royal Aircraft Factory B.E.8 was a British two-seat single-engined general purpose biplane of the First World War, designed by John Kenworthy at the Royal Aircraft Factory in 1913. Small numbers were used by the Royal Flying Corps over the Western Front in the first year of the war, with the type being used as a trainer until 1916.

Royal Aircraft Factory R.E.7

The Royal Aircraft Factory R.E.7 was a British two-seat light bomber and reconnaissance biplane designed by the Royal Aircraft Factory and built under contracts by the Coventry Ordnance Works, Austin, Napier and Siddeley-Deasy for the Royal Flying Corps.

Royal Aircraft Factory F.E.9

The Royal Aircraft Factory F.E.9 was a prototype British two-seat fighter-reconnaissance aircraft of the First World War. A single-engined pusher biplane of 1917, the F.E.9 had poor performance and handling, and only three were built.

The Sopwith Three-seater was a British aircraft designed and built prior to the start of the First World War. One of the first aircraft built by the Sopwith Aviation Company, it was operated by both the Royal Naval Air Service (RNAS) and the Royal Flying Corps (RFC), being used briefly over Belgium by the RNAS following the start of the War.

Royal Aircraft Factory S.E.2

The Royal Aircraft Factory S.E.2 was an early British single-seat scout aircraft. Designed and built at the Royal Aircraft Factory in 1912–13 as the B.S.1, the prototype was rebuilt several times before serving with the Royal Flying Corps over the Western Front in the early months of the First World War.

Royal Aircraft Factory R.E.1

The Royal Aircraft Factory R.E.1 was an experimental two-seat single-engined biplane from before World War I, intended to develop reconnaissance aircraft.

Cody V biplane

The Cody V was a single-engined biplane built by the British-based American aviation pioneer Samuel Franklin Cody in 1912. It was built from the remains of two of Cody's earlier aircraft, and won the 1912 British Military Aeroplane Competition, with two aircraft being purchased for the Royal Flying Corps. It was abandoned after the mid air disintegration of one of the aircraft in April 1913.

References

Notes

  1. 1 2 Bruce 1992 pp.445-51.
  2. 1 2 3 Bruce 1957, pp.417-421.
  3. 1 2 Lewis 1974, p.35.
  4. 1 2 3 4 Lewis 1974, pp.402-403.

Bibliography

Further reading