Solicited-node multicast address

Last updated

A solicited-node multicast address is an IPv6 multicast address used by the Neighbor Discovery Protocol to determine the link layer address associated with a given IPv6 address, which is also used to check if an address is already being used by the local-link or not, through a process called DAD (Duplicate Address Detection). The solicited-node multicast addresses are generated from the host's IPv6 unicast or anycast address, and each interface must have a solicited-node multicast address associated with it.

Contents

A solicited-node address is created by taking the least-significant 24 bits of an unicast or anycast address and appending them to the prefix ff02::1:ff00:0/104. [1]

Example

Assume a host with an unicast/anycast IPv6 address of 2001:db8::2aa:ff:fe28:9c5a. Its solicited-node multicast address will be ff02::1:ff28:9c5a.

2001:db8::2aa:ff:fe28:9c5a                  IPv6 unicast/anycast address (compressed notation) 2001:0db8:0000:0000:02aa:00ff:fe28:9c5a     IPv6 unicast/anycast address (uncompressed notation)                                 -- ----     The least-significant 24 bits  ff02::1:ff00:0/104                          Solicited-node multicast address prefix (compressed notation) ff02:0000:0000:0000:0000:0001:ff00:0000/104 Solicited-node multicast address prefix (uncompressed notation) ---- ---- ---- ---- ---- ---- --            The most-significant 104 bits ff02:0000:0000:0000:0000:0001:ff28:9c5a     Solicited-node multicast address (uncompressed notation) ff02::1:ff28:9c5a                           Solicited-node multicast address (compressed notation)

Solicited-node multicast MAC address

A solicited-node multicast MAC address is an Ethernet multicast address used by the Neighbor Discovery Protocol as a destination MAC address when communicating to hosts using a solicited-node multicast address. Each interface must be listening to its solicited-node multicast MAC address associated to them.

It is created by taking the least-significant 24 bits of a solicited-node multicast address and appending them to the prefix 33:33:FF:xx:xx:xx. [2]

Example

Assume a host with a solicited-node multicast address of ff02::1:ff28:9c5a. Its solicited-node multicast MAC address will be 33:33:FF:28:9C:5A.

ff02::1:ff28:9c5a Solicited-node multicast address           -- ---- The least-significant 24 bits  33:33:FF:xx:xx:xx Solicited-node multicast MAC address prefix 33:33:FF:28:9C:5A Solicited-node multicast MAC address          -- -- -- The least-significant 24 bits

Efficiency compared to IPv4 and ARP

Solicited-node multicast addresses are used with IPv6 neighbor discovery to provide the same function as the Address Resolution Protocol in IPv4. ARP uses broadcasts to send an ARP request to the broadcast MAC address FF:FF:FF:FF:FF:FF, which is received by all hosts on the local link, although only one host—the one being queried—would need to respond. The other hosts still have to process and discard the request.

Since a solicited-node multicast address is a function of the last 24 bits of an IPv6 unicast/anycast address, the number of hosts that are subscribed to each solicited-node multicast address is very small. This number would typically be one, but there could be a few because the mapping function is not a 1:1 mapping, like for example if the same host bear the same last 24 bits of their IPv6 address (2001:db8:1::55 and 2001:db8:2::55 has the same solicited-node multicast address). This means that a host should not need to be interrupted as often to neighbor solicitation requests, compared to ARP in IPv4.

Related Research Articles

An Internet Protocol address is a numerical label such as 192.0.2.1 that is assigned to a device connected to a computer network that uses the Internet Protocol for communication. IP addresses serve two main functions: network interface identification, and location addressing.

<span class="mw-page-title-main">IPv6</span> Version 6 of the Internet Protocol

Internet Protocol version 6 (IPv6) is the most recent version of the Internet Protocol (IP), the communications protocol that provides an identification and location system for computers on networks and routes traffic across the Internet. IPv6 was developed by the Internet Engineering Task Force (IETF) to deal with the long-anticipated problem of IPv4 address exhaustion, and was intended to replace IPv4. In December 1998, IPv6 became a Draft Standard for the IETF, which subsequently ratified it as an Internet Standard on 14 July 2017.

A MAC address is a unique identifier assigned to a network interface controller (NIC) for use as a network address in communications within a network segment. This use is common in most IEEE 802 networking technologies, including Ethernet, Wi-Fi, and Bluetooth. Within the Open Systems Interconnection (OSI) network model, MAC addresses are used in the medium access control protocol sublayer of the data link layer. As typically represented, MAC addresses are recognizable as six groups of two hexadecimal digits, separated by hyphens, colons, or without a separator.

Classless Inter-Domain Routing is a method for allocating IP addresses for IP routing. The Internet Engineering Task Force introduced CIDR in 1993 to replace the previous classful network addressing architecture on the Internet. Its goal was to slow the growth of routing tables on routers across the Internet, and to help slow the rapid exhaustion of IPv4 addresses.

A multicast address is a logical identifier for a group of hosts in a computer network that are available to process datagrams or frames intended to be multicast for a designated network service. Multicast addressing can be used in the link layer, such as Ethernet multicast, and at the internet layer for Internet Protocol Version 4 (IPv4) or Version 6 (IPv6) multicast.

Open Shortest Path First (OSPF) is a routing protocol for Internet Protocol (IP) networks. It uses a link state routing (LSR) algorithm and falls into the group of interior gateway protocols (IGPs), operating within a single autonomous system (AS).

<span class="mw-page-title-main">Subnet</span> Logical subdivision of an IP network

A subnetwork, or subnet, is a logical subdivision of an IP network. The practice of dividing a network into two or more networks is called subnetting.

<span class="mw-page-title-main">Classful network</span> Early system for organizing the IPv4 address space

A classful network is an obsolete network addressing architecture used in the Internet from 1981 until the introduction of Classless Inter-Domain Routing (CIDR) in 1993. The method divides the IP address space for Internet Protocol version 4 (IPv4) into five address classes based on the leading four address bits. Classes A, B, and C provide unicast addresses for networks of three different network sizes. Class D is for multicast networking and the class E address range is reserved for future or experimental purposes.

<span class="mw-page-title-main">Anycast</span> Network addressing and routing methodology

Anycast is a network addressing and routing methodology in which a single IP address is shared by devices in multiple locations. Routers direct packets addressed to this destination to the location nearest the sender, using their normal decision-making algorithms, typically the lowest number of BGP network hops. Anycast routing is widely used by content delivery networks such as web and name servers, to bring their content closer to end users.

A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts.

6to4 is an Internet transition mechanism for migrating from Internet Protocol version 4 (IPv4) to version 6 (IPv6) and a system that allows IPv6 packets to be transmitted over an IPv4 network without the need to configure explicit tunnels. Special relay servers are also in place that allow 6to4 networks to communicate with native IPv6 networks.

The Neighbor Discovery Protocol (NDP), or simply Neighbor Discovery (ND), is a protocol of the Internet protocol suite used with Internet Protocol Version 6 (IPv6). It operates at the internet layer of the Internet model, and is responsible for gathering various information required for network communication, including the configuration of local connections and the domain name servers and gateways.

In computer networking, the multicast DNS (mDNS) protocol resolves hostnames to IP addresses within small networks that do not include a local name server. It is a zero-configuration service, using essentially the same programming interfaces, packet formats and operating semantics as unicast Domain Name System (DNS). It was designed to work as either a stand-alone protocol or compatibly with standard DNS servers. It uses IP multicast User Datagram Protocol (UDP) packets and is implemented by the Apple Bonjour and open-source Avahi software packages, included in most Linux distributions. Although the Windows 10 implementation was limited to discovering networked printers, subsequent releases resolved hostnames as well. mDNS can work in conjunction with DNS Service Discovery (DNS-SD), a companion zero-configuration networking technique specified separately in RFC 6763.

IP multicast is a method of sending Internet Protocol (IP) datagrams to a group of interested receivers in a single transmission. It is the IP-specific form of multicast and is used for streaming media and other network applications. It uses specially reserved multicast address blocks in IPv4 and IPv6.

6over4 is an IPv6 transition mechanism meant to transmit IPv6 packets between dual-stack nodes on top of a multicast-enabled IPv4 network. IPv4 is used as a virtual data link layer on which IPv6 can be run.

The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network. It is not just the IPv6 equivalent of the Dynamic Host Configuration Protocol for IPv4.

Internet Control Message Protocol version 6 (ICMPv6) is the implementation of the Internet Control Message Protocol (ICMP) for Internet Protocol version 6 (IPv6). ICMPv6 is an integral part of IPv6 and performs error reporting and diagnostic functions.

In computer networking, a link-local address is a network address that is valid only for communications on a local link, i.e. within a subnetwork that a host is connected to. Link-local addresses are most often unicast network addresses assigned automatically through a process known as stateless address autoconfiguration (SLAAC) or link-local address autoconfiguration, also known as automatic private IP addressing (APIPA) or auto-IP. Link-local addresses are not all unicast; e.g. IPv6 addresses beginning with ff02:, and IPv4 addresses beginning with 224.0.0. are multicast addresses that are link-local.

The Link-Local Multicast Name Resolution (LLMNR) is a protocol based on the Domain Name System (DNS) packet format that allows both IPv4 and IPv6 hosts to perform name resolution for hosts on the same local link. It is included in Windows Vista, Windows Server 2008, Windows 7, Windows 8, Windows 10. It is also implemented by systemd-resolved on Linux. LLMNR is defined in RFC 4795 but was not adopted as an IETF standard.

<span class="mw-page-title-main">IPv6 address</span> Label to identify a network interface of a computer or other network node

An Internet Protocol version 6 address is a numeric label that is used to identify and locate a network interface of a computer or a network node participating in a computer network using IPv6. IP addresses are included in the packet header to indicate the source and the destination of each packet. The IP address of the destination is used to make decisions about routing IP packets to other networks.

References

  1. ↑ R. Hinden; S. Deering (February 2006). IP Version 6 Addressing Architecture. Network Working Group. doi: 10.17487/RFC4291 . RFC 4291. Updated by: RFC 5952, RFC 6052, RFC 7136, RFC 7346, RFC 7371, RFC 8064.
  2. ↑ "IPv6 Real-Time Usage of IEEE 802.16: Problem Statement". www.ietf.org. Retrieved 2024-02-20.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.