BMW VI

Last updated
BMW VI
BMW VI Berlin 02.jpg
BMW VI at the Technik-Museum Berlin
Type V engine
Manufacturer BMW
First run1926
Major applications Heinkel He 51
Kawasaki Ki-10
Developed from BMW IV
Developed into BMW VII
Mikulin M-17

The BMW VI was a water-cooled V-12 aircraft engine built in Germany in the 1920s. It was one of the most important German aero engines in the years leading up to World War II, with thousands built. It was further developed as the BMW VII and BMW IX, although these saw considerably less use. It was also produced in the Soviet Union as the M-17 and Japan as the Kawasaki Ha-9.

Contents

Design and development

Front view of the BMW VI BMW VI Front Side.jpg
Front view of the BMW VI

The BMW VI was the first twelve-cylinder engine built by the BMW. It essentially consisted of two cylinder banks from the six-cylinder BMW IV bolted to a common cast aluminium crankcase at a 60-degree included angle between the cylinder banks. Series production commenced in 1926 after type approval had been granted. From 1930 on, after 1000 engines of the BMW VI type had already been delivered, Germany was again permitted to construct military aircraft. The sudden additional demand resulted in the production figures increasing rapidly. In 1933 the BMW VI was used for BMW's first experiments with direct fuel injection.

The BMW VI was the chosen source of power for numerous record-breaking and long-distance flights, including an east-to-west crossing of the Atlantic in 1930 and a round-the world flight in 1932, both by Wolfgang von Gronau in an open Dornier Wal flying boat powered by two BMW VI engines.

The BMW VI was put to unusual use as a power unit for the "Rail Zeppelin" high-speed railcar. Many versions of the BMW VI engine were developed, and it was built under license in Japan and the Soviet Union. This was further evidence of the reliability of an engine with which BMW made a fundamental contribution to the build-up of German air transport. At least 9,200 were built between 1926 and 1938. The engine was license-built in the Soviet Union under the supervision of Mikulin, who then further developed it as the M-17. More license built engines were produced by Kawasaki Heavy Industries in Japan as the Kawasaki Ha9 (long designation:- Army Type 98 850hp Liquid Cooled In-line).

Variants

5.5, 6 or 7.3 denotes compression ratio. No additional letter denotes BMW carburetor and direct-drive propeller (7.3), u denotes a propeller reduction gear (7.3u), z denotes Zenith carburetor (7.3z), zu denotes Zenith carburetor and propeller reduction gear (7.3zu).

BMW VI at the Technik-Museum Berlin BMW VI right side front.jpg
BMW VI at the Technik-Museum Berlin
BMW VI 5.5
Compression ratio 5.5:1, 600–650 PS (592–641 hp) at up to 1600 rpm at sea level
BMW VI 6.0
Compression ratio 6:1, 630–660 PS (621–651 hp) at up to 1650 rpm at sea level, 80 Octane fuel
BMW VI 7.3
Compression ratio 7.3:1 680–750 PS (671–740 hp) at up to 1700 rpm at sea level, 87 Octane fuel
Mikulin M-17
Licence production in the USSR
Kawasaki Ha9
(long designation:- Army Type 98 850hp Liquid Cooled In-line) licence production in Japan by Kawasaki

Applications

BMW VI head detail BMW VI valve covers.jpg
BMW VI head detail

Specifications (BMW VI 7.3z)

Side view of the BMW VI BMW VI-106.jpg
Side view of the BMW VI

Data fromFlugzeug-Typenbuch. Handbuch der deutschen Luftfahrt- und Zubehör-Industrie 1944 [1]

General characteristics

Components

Performance

  • 750 PS (740 hp; 552 kW) for takeoff at 1,700 rpm (1 minute) at sea level
  • 690 PS (681 hp; 507 kW) at 1,650 rpm (5 minutes) at sea level
  • 620 PS (612 hp; 456 kW) at 1,590 rpm (30 minutes) at sea level
  • 550 PS (542 hp; 405 kW) at 1,530 rpm (max. duration) at sea level
  • 0.23 kg/PSh (0.514 lb/(hp⋅h); 0.313 kg/kWh) at 1,590 rpm
  • 0.225 kg/PSh (0.503 lb/(hp⋅h); 0.306 kg/kWh) at 1,530 rpm

See also

Related development

Comparable engines

Related lists

Related Research Articles

<span class="mw-page-title-main">Junkers Jumo 211</span> German inverted V-12 aircraft engine

The Jumo 211 was a German inverted V-12 aircraft engine, Junkers Motoren's primary aircraft engine of World War II. It was the direct competitor to the Daimler-Benz DB 601 and closely paralleled its development. While the Daimler-Benz engine was mostly used in single-engined and twin-engined fighters, the Jumo engine was primarily used in bombers such as Junkers' own Ju 87 and Ju 88, and Heinkel's H-series examples of the Heinkel He 111 medium bomber. It was the most-produced German aero engine of the war, with almost 70,000 examples completed.

<span class="mw-page-title-main">Daimler-Benz DB 601</span> German aircraft engine

The Daimler-Benz DB 601 was a German aircraft engine built during World War II. It was a liquid-cooled inverted V12, and powered the Messerschmitt Bf 109, Messerschmitt Bf 110, and many others. Approximately 19,000 601's were produced before it was replaced by the improved Daimler-Benz DB 605 in 1942.

<span class="mw-page-title-main">Bramo 323</span>

The Bramo 323 Fafnir is a nine-cylinder radial aircraft engine of the World War II era. Based heavily on Siemens/Bramo's earlier experience producing the Bristol Jupiter under licence, the Bramo 323 saw limited use.

<span class="mw-page-title-main">BMW 132</span>

The BMW 132 was a nine-cylinder radial aircraft engine produced by BMW starting in 1933.

<span class="mw-page-title-main">Daimler-Benz DB 600</span> 1930s German piston aircraft engine

The Daimler-Benz DB 600 was a German aircraft engine designed and built before World War II as part of a new generation of German engine technology. It was a liquid-cooled inverted V12 engine, and powered the Messerschmitt Bf 110 and Heinkel He 111 among others.

<span class="mw-page-title-main">Daimler-Benz DB 603</span> German aircraft engine

The Daimler-Benz DB 603 was a German aircraft engine used during World War II. It was a liquid-cooled 12-cylinder inverted V12 enlargement of the 33.9 Liter DB 601, which was in itself a development of the DB 600. Production of the DB 603 commenced in May 1942, and with a 44.5 liter displacement figure, was the largest displacement inverted V12 aviation engine to be produced and used in front line aircraft of the Third Reich during World War II.

<span class="mw-page-title-main">Argus As 10</span> 1920s German piston aircraft engine

The Argus As 10 was a German-designed and built, air-cooled 90° cylinder bank-angle inverted V8 "low power" aircraft engine, used mainly in training aircraft such as the Arado Ar 66 and Focke-Wulf Fw 56 Stösser and other small short-range reconnaissance and communications aircraft like the Fieseler Fi 156 Storch during, and shortly after World War II. It was first built in 1928.

<span class="mw-page-title-main">Siemens-Halske Sh 14</span> Seven-cylinder air-cooled radial engine for aircraft

The Siemens-Halske Sh 14 was a seven-cylinder air-cooled radial engine for aircraft produced in Germany in the 1920s and 1930s. First run in 1928, it was rated at 93 kW (125 hp).

<span class="mw-page-title-main">Argus As 8</span> 1930s German piston aircraft engine

The Argus As 8 was a four-cylinder, air-cooled, inverted inline aircraft engine produced in Germany by Argus Motoren in the 1930s.

<span class="mw-page-title-main">Hirth HM 508</span>

The Hirth HM 508 was an air-cooled, eight-cylinder, 60° cylinder bank angle inverted-V aircraft engine built in Germany in the 1930s. It had a bore and stroke of 105 mm × 115 mm and developed 210 kW (280 hp) at 3,000 rpm.

<span class="mw-page-title-main">Hirth HM 504</span> 1930s German aircraft engine

The Hirth HM 504 is a four-cylinder air-cooled inverted inline engine. The HM 504 was a popular engine for light aircraft of the 1930s-1940s, and it was used to power a number of Germany's trainer aircraft of World War II. The engine featured a cast magnesium alloy crankcase made of Elektron The Hitachi Hatsukaze Model 11 was a Japanese licensed version.

<span class="mw-page-title-main">Argus As 410</span> 1930s German piston aircraft engine

The Argus As 410 was a German air-cooled inverted V-12 light aircraft engine that was first produced by Argus Motoren in 1938.

The Hirth HM 506 was a six-cylinder air-cooled inverted inline engine that was developed from the earlier four-cylinder HM 504. The HM 506 was a popular engine for light aircraft of the 1930s to 1940s and powered the Bücker Bü 133A model trainer. The engine featured a cast magnesium alloy crankcase.

<span class="mw-page-title-main">Hirth HM 60</span> 1920s German aircraft engine

The Hirth HM 60 was a four-cylinder inverted air-cooled inline aircraft engine designed in 1923 and first sold in 1924. The engine was of very high quality, and its sales success contributed to Hirth's rapid pre-war expansion. It was a popular engine for light aircraft delivering 80 hp (60 kW) at 2,300 rpm. Later Hirth engines built upon the HM 60's success and provided greater power with many of the same design features.

The BMW VII was a water-cooled twelve-cylinder engine derived from the successful BMW VI. The engine was not as popular as the VI, due in no small part to the Great Depression, and only a small number were built. Experiments with supercharging led to the related BMW IX.

<span class="mw-page-title-main">BMW X (engine)</span> 1920s German aircraft piston engine

The BMW X is a small five-cylinder radial engine for sport and training aircraft. Although this engine proved successful at several large-scale events in 1930, including that year's round-Europe flight, only a few were built.

The Siemens-Halske Sh 22 was a nine-cylinder aircraft radial engine manufactured by Siemens & Halske in Germany in the 1930s. Following the reorganization of its manufacturer and change in military nomenclature, the engine became known as the Bramo 322.

The Hirth HM 512 was a 12-cylinder development of the earlier, 6-cylinder HM 506, produced in the late 1930s. Both were supercharged, inverted V, air-cooled engines.

<span class="mw-page-title-main">Kawasaki Ha40</span>

The Kawasaki Ha40, also known as the Army Type 2 1,100 hp Liquid Cooled In-line and Ha-60, was a license-built Daimler-Benz DB 601Aa 12-cylinder liquid-cooled inverted-vee aircraft engine. The Imperial Japanese Army Air Service (IJAAS) selected the engine to power its Kawasaki Ki-61 fighter.

The Hirth HM 501 was a 6-cylinder air-cooled inverted in-line engine that was developed by Hirth Motoren GmbH in the late 1930s, from the 4-cylinder HM 500 and used principally on the submarine-born Arado Ar 231.

References

  1. Schneider, Helmut (Dipl.Ing.) (1944). Flugzeug-Typenbuch. Handbuch der deutschen Luftfahrt- und Zubehör-Industrie 1944 (in German) (Facsimile reprint 1986 ed.). Leipzig: Herm. Beyer Verlag. p. 365. ISBN   381120484X.

Further reading