| CAMS 54 | |
|---|---|
 | |
| Role | Long range flying boat |
| National origin | France |
| Manufacturer | Chantiers Aéro-Maritimes de la Seine (CAMS) |
| First flight | Late March 1928 |
| Number built | 1 |
| Developed from | CAMS 51 |
The CAMS 54 was a strengthened and more powerful version of the French CAMS 51 civil transport and naval reconnaissance flying boat, developed for transatlantic flights. It is sometimes referred to as the 54 GR (Grand Raid or very long range flight).
The last CAMS 51 prototype, the naval reconnaissance CAMS 51 GR, had set a world weight-to-height record in August 1927 [1] and demonstrated that it could take-off with one engine whilst carrying a load equal to that of the fuel required for a transatlantic crossing. [2] The CAMS 54 was strengthened to carry the 4,110 l (900 imp gal; 1,090 US gal) needed for a range of 4,300 km (2,700 mi) and provided with significantly increased engine power. [3]
The CAMS 54 was a single-bay biplane with equal span, rectangular plan wings mounted without stagger. The upper wing was in three parts, a short centre section and two long outer panels; the lower wing had two inner panels, mounted on the upper fuselage and strengthened by short, parallel pairs of struts to mid-fuselage, and two outer panels. Only the lower wing had dihedral. Both upper and lower wings carried narrow-chord ailerons, linked externally by wires, out to their tips. Both were wooden structures based on pairs of spruce box spars and fabric covered, braced together with parallel pairs of interplane struts to the spars. [3] [4]
The flying boat was powered by a pair of engines in push-pull configuration, mounted above the fuselage and just below the upper wing on two inward-leaning pairs of tubular N-struts, with further transverse cross-bracing. Their mounting also supported the wing centre-section with parallel pairs of struts outwards to the spars. Two types of engine could be used, either 370 kW (500 hp) Hispano-Suiza 12Mbr V12 enclosed in a common streamlined cowling and cooled with tubular radiators on the wing undersides on either side of the engines or 360 kW (480 hp) Gnome-Rhône 9Akx Jupiter nine-cylinder radials, mounted uncowled for cooling, with a circular section cowling between them. Both were geared-down. The forward propeller was well ahead of the wing leading edge but the rear turned in a shallow cut-out in the upper trailing edge. [3] [4] These engines were much more powerful than the 280 kW (380 hp) Gnome et Rhône 9Aas of the CAMS 51 and to accommodate them and their propellers on new mountings required the inter-plane gap to be increased. [5]
Structurally the hull was identical with that of the CAMS 51, with longerons and transverse oak frames. It was covered with double teak and plywood planking below the waterline and ply elsewhere. At the nose the underside had a sharp V-section but this softened aft into a double curvature section; there were two steps, the forward one below the rear of the wing. Stability on the water was provided by a pair of unstepped floats, strut-mounted below the interplane struts. Internally the hull was divided into five compartments by reinforced bulkheads, the first forming a hold. The next contained the pilots' enclosed cabin, which was well forward and ahead of the leading propeller, with side-by-side seats, multiple front and side windows and access panels over the seats. Behind the pilots, the radio operator's and navigator's positions were on opposite sides of the aircraft. The fourth compartment housed eight 620 l (140 imp gal; 160 US gal) fuel tanks, with a central corridor between them providing access to the final compartment which held a toilet on one side and a bunk on the other. Behind the last bulkhead was a long, empty hold which reached back to the tail and was easily accessed though an upper, port-side hatch. [3] [4]
The CAMS 54 had a tall, straight-edged fin and balanced rudder. Its rectangular plan, wire braced tailplane was mounted about halfway up the fin. Its constant chord, balanced elevators were also essentially rectangular, separated by a cut-out for rudder movement. All the rear surfaces were fabric covered; the fixed parts were wood-framed and the control surfaces metal. [3] [4]
The CAMS 54's first flights were made in late March 1928, powered with the Hispano-Suiza engines. [4] By 12 May 1928 it was making long test flights with the Gnome et Rhône radials, flown by Lt. Paris. [6] On 15 May it took off with a record load of 4,400 kg (9,700 lb). [7]
The east-west South Atlantic crossing was begun in July 1928, a year which saw many such attempts. [8] On 22 July the CAMS 54, with the radial engines, named La Frégate and crewed by Paris, second pilot and wireless operator Cadou and flight engineer Marot, flew to Horta, Azores. [9] [10] The first eight hours were uneventful at speeds around 175 km/h (109 mph; 94 kn) but failure of the rear engine then seriously slowed the aircraft and the 2,080 km (1,290 mi; 1,120 nmi) flight lasted about 14 hr 15 min, an average speed of about 145 km/h (90 mph; 78 kn). [8] Inspection of the engine after landing showed it could not be repaired and also that the heavy loads sustained by the forward engine operating alone had caused serious wear, ruling out further long flights. The French Marine Ministry therefore decided to bring La Frégate back to the mainland by boat. [9]
In February 1929 La Frégate was being prepared for another flight over the South Atlantic, equipped with 450 kW (600 hp) V-12 Hispano engines. [11]
Data from Les Ailes, May 1928 [3]
General characteristics
Performance
The Latécoère 350 was a trimotor development of the Latécoère 28, a successful single-engined French monoplane of around 1930. The three engines were intended to provide the reliability needed for overnight flights, but the 350 came out very overweight. Only one was built.
The Couzinet 10 Arc-en-Ciel ('Rainbow') was built as a first example of the three-engined, aerodynamically refined, cantilever low wing monoplane designer René Couzinet thought offered the safest long range passenger transport, for example on the South Atlantic route. Only one was completed, though other, similar aircraft of different sizes and powers followed.
The Potez-CAMS 160 was a one-off 5/13 scale flight model built in France, first flown in the summer of 1938 to test aerodynamic and hydrodynamic qualities of the Potez-CAMS 161 airliner and mail carrier, which was too large for detailed modelling in existing wind tunnels.
The Potez 31 was a prototype French two-seat night fighter, flown in about 1928, intended to fill the Cn.2 specification for the Armee de l'Air. Only one was built.
The Caudron C.99 was a French light bomber and reconnaissance aircraft. The only example flew with different engines in the mid-1920s.
The Les Mureaux 3 C.2 and Les Mureaux 4 C.2 were French two seat, parasol winged fighters, flown in 1927-8, which differed only in their engines. They were developed into near identical army co-operation types, the ANF Les Mureaux 130 A.2 and ANF Les Mureaux 131 A.2, in 1929-31.
The Aviméta 88 was an all-metal French two-seat reconnaissance-fighter or heavy fighter tested in 1927.
The Amiot 110-S was an all-metal, amphibious military flying boat built in France in the 1930s. It was intended as a maritime reconnaissance and medium bomber aircraft but only two were built.
The Lioré et Olivier H-23-2 was an amphibious maritime reconnaissance flying boat, built in France in 1932. Three were produced for the Venezuelan Army Air Service.
The four-engined Lioré et Olivier LeO H-27 was one of three French flying boats competing to carry mail over Air France's South Atlantic routes. Flying later than its competitors, it was not selected and only one was built.
The Bloch MB.141 was a French all-metal two seat light aircraft derived from the Bloch MB.81 air ambulance. Only one was built.
The Potez 50 or Potez 50 A2 was a French two seat military multi-rôle aircraft, first flown in 1931. It did not go into service but seven variants using five different engines were produced, one of them setting several speed with useful load records and another, the Potez 506, setting three altitude world records.
The CAMS 110 was a French twin engine biplane flying boat built to fill a range of maritime military rôles including long range reconnaissance, bombing and general exploration. it was not selected for production and only one was built.
The Wibault 260 R.2 was a contender for a French government contract for a long range, two seat reconnaissance aircraft, issued in 1928. There were eight prototypes in the 1931-2 contest and the Wibault was not selected for production.
The CAMS 52 was a twin-engined floatplane torpedo-bomber. It was not ordered by the French Navy and only one CAMS 52 was completed. It first flew in the summer of 1930.
The CAMS 80 was an amphibious reconnaissance flying boat flown in the early 1930s. Two were built with different engines and were used by the Aéronavale for VIP transport and equipment development until 1938.
The Dornier Do S was a large, 22-passenger flying boat airliner flown in Germany in 1930. Only one was built.
The Lioré et Olivier LeO H-23 was a French military flying boat, primarily intended for coastal reconnaissance, though able to carry a small bomb load. Only one was built.
The CPA 1 was a French twin-engined, parasol-winged bomber designed and built in the mid-1920s.
The Hanriot H.38 was a French twin-engined sesquiplane flying boat built in the mid-1920s. Though the sole prototype was fitted with two defensive machine gun posts. the H.38 was described at the time as a utility aircraft.