Death roll

Last updated

In a keel boat, a death roll is the act of broaching to windward, putting the spinnaker pole into the water and causing a crash-jibe of the boom and mainsail, which sweep across the deck and plunge down into the water. The death roll often results in the destruction of the spinnaker pole and sometimes even the dismasting of the boat. Serious injury to crew is possible due to the swift and uncontrolled action of the boom and associated gear sweeping across the boat and crashing to the (now) leeward side. [1] [ better source needed ]

For dinghy sailors, a death roll is a common type of oscillation while running downwind. It may, and often will, result in a capsize and even a full inversion if the skipper does not take quick action to prevent one. [2]

During a death roll, the boat rolls from side to side, becoming gradually more unstable until either it capsizes or the skipper reacts correctly to prevent it. While on the dead run, off the wind, the force exerted by the sail lies almost parallel to the center line of the boat. There is little or no force causing the boat to heel to leeward, unlike most other points of sailing, and, if the sail is out past perpendicular to the center line, or the sail is incorrectly shaped, there may be a force causing the boat to heel to windward. Instabilities in the wind, and turbulence caused by the sail, which 'fouls' the wind on such a tack, may cause this force to change rapidly. Most sailors also retract the centerboards of their dinghies while on the run, to reduce drag and increase speed. The lack of resistance to the rolling motion can enhance it.

IOR (International Offshore Racing) boats in the 1970s and 1980s were known for death rolls due to their small mains that made them unbalanced downwind. Many boats put up spankers, big A-type sails set to leeward and flown away from the boat, to balance the boat. The higher the wind speed, the more important the spanker was to balance the boat.

Boats prone to death rolls

High-performance racing dinghies are most prone to death roll situations.

These include skiff designs, such as the Musto Skiff, 29er, 49er and International 14. Sailors of these boats generally prefer to sail on the broad reach rather than on the dead run because the boat is more stable and actually faster. Additionally, as their speed increases on the broad reach, their apparent wind changes to allow them to point lower. Often they can point as low as the other boats, only faster. See Sailing faster than the wind . [3]

More traditional racing dinghies such as the Laser and Laser Radial are also prone to death rolls. Singlehanders without shrouds will actually sail faster downwind when sailing slightly "by the lee", or past dead downwind, where stability improves and death rolls are less likely. [4]

Related Research Articles

<span class="mw-page-title-main">Sailing</span> Propulsion of a vehicle by wind power

Sailing employs the wind—acting on sails, wingsails or kites—to propel a craft on the surface of the water, on ice (iceboat) or on land over a chosen course, which is often part of a larger plan of navigation.

<span class="mw-page-title-main">Dinghy sailing</span> Sailing of small boats, usually for sport

Dinghy sailing is the activity of sailing small boats by using five essential controls:

<span class="mw-page-title-main">Point of sail</span> Direction of travel under sail relative to true wind direction over surface

A point of sail is a sailing craft's direction of travel under sail in relation to the true wind direction over the surface.

<span class="mw-page-title-main">Jibe</span> Basic sailing maneuver, where ship turns its stern through the wind

A jibe (US) or gybe (Britain) is a sailing maneuver whereby a sailing vessel reaching downwind turns its stern through the wind, which then exerts its force from the opposite side of the vessel. Because the mainsail boom can swing across the cockpit quickly, jibes are potentially dangerous to person and rigging compared to tacking. Therefore, accidental jibes are to be avoided while the proper technique must be applied so as to control the maneuver. For square-rigged ships, this maneuver is called wearing ship.

<span class="mw-page-title-main">Daggerboard</span>

A daggerboard is a retractable centreboard used by various sailing craft. While other types of centreboard may pivot to retract, a daggerboard slides in a casing. The shape of the daggerboard converts the forward motion into a windward lift, countering the leeward push of the sail. The theoretical centre of lateral resistance is on the trailing edge of the daggerboard.

<span class="mw-page-title-main">Dinghy racing</span> Racing Dinghy boats as a sport.

Dinghy racing is a competitive sport using dinghies, which are small boats which may be rowboats, have an outboard motor, or be sailing dinghies. Dinghy racing has affected aspects of the modern sailing dinghy, including hull design, sail materials and sailplan, and techniques such as planing and trapezing.

<span class="mw-page-title-main">Spinnaker</span> Sail designed for sailing off the wind

A spinnaker is a sail designed specifically for sailing off the wind on courses between a reach to downwind. Spinnakers are constructed of lightweight fabric, usually nylon, and are often brightly colored. They may be designed to perform best as either a reaching or a running spinnaker, by the shaping of the panels and seams. They are attached at only three points and said to be flown.

<span class="mw-page-title-main">Running rigging</span> Lines that control sails

Running rigging is the rigging of a sailing vessel that is used for raising, lowering, shaping and controlling the sails on a sailing vessel—as opposed to the standing rigging, which supports the mast and bowsprit. Running rigging varies between vessels that are rigged fore and aft and those that are square-rigged.

<span class="mw-page-title-main">Tacking (sailing)</span> A sailing maneuver

Tacking or coming about is a sailing maneuver by which a sailing craft, whose next destination is into the wind, turns its bow toward and through the wind so that the direction from which the wind blows changes from one side of the boat to the other, allowing progress in the desired direction. Sailing vessels are unable to sail higher than a certain angle towards the wind, so "beating to windward" in a zig-zag fashion with a series of tacking maneuvers, allows a vessel to sail towards a destination that is closer to the wind that the vessel can sail directly.

<span class="mw-page-title-main">Hiking (sailing)</span> Sailing action

In sailing, hiking is the action of moving the crew's body weight as far to windward (upwind) as possible, in order to decrease the extent the boat heels. By moving the crew's weight to windward, the moment of that force around the boat's center of buoyancy is increased. This opposes the heeling movement of the wind pushing sideways against the boat's sails. It is usually done by leaning over the edge of the boat as it heels. Some boats are fitted with equipment such as hiking straps and trapezes to make hiking more effective.

<span class="mw-page-title-main">Laser 4000</span> Racing dinghy designed by Phil Morrison

The Laser 4000(now "4000") is a racing dinghy designed by Phil Morrison crewed by two persons. Its one-design weight-equalised system enables physically differing sailors to compete on a level playing field. It is most popular in Europe, particularly the UK, France and Italy.

<span class="mw-page-title-main">18ft Skiff</span>

The 18 ft Skiff is considered the fastest class of sailing skiffs. The class has a long history beginning with races on Sydney Harbour, Australia in 1892 and later in New Zealand. The boat has changed significantly since the early days, bringing in new technology as it became available. Because of the need of strength, agility and skill, the class is considered to be the top level of small boat sailing. Worldwide this boat is called the "18 Foot Skiff". It is the fastest conventional non-foiling monohull on the yardstick rating, with a score of 675, coming only third after the Tornado and Inter 20.

<span class="mw-page-title-main">Fractional rig</span> Sailing rig type

A fractional rig on a sailing vessel consists of a foresail, such as a jib or genoa sail, that does not reach all the way to the top of the mast.

Weather helm is the tendency of sailing vessels to turn towards the source of wind, creating an unbalanced helm that requires pulling the tiller to windward in order to counteract the effect.

An asymmetrical spinnaker is a sail used when sailing downwind. Also known as an "asym", "aspin", or "A-sail" it can be described as a cross between a genoa jib and a spinnaker. It is asymmetric like a genoa, but, the asymmetrical spinnaker is not attached to the forestay over the full length of its luff, being rigged like a spinnaker. The asymmetrical spinnaker has a larger camber than a genoa, making it optimal for generating lift at larger angles of attack, but the camber is significantly less than that of a spinnaker.

<span class="mw-page-title-main">Sportsboat</span>

The term sportsboat first appeared in the late 1980s and early 1990s to describe trailer sailers that were optimised for high performance at the expense of accommodation and ballast. The very definition of the term "sportsboat" is evolving.

<span class="mw-page-title-main">Sailing (sport)</span> Amateur or professional competitive sport

The sport of sailing involves a variety of competitive sailing formats that are sanctioned through various sailing federations and yacht clubs. Racing disciplines include matches within a fleet of sailing craft, between a pair thereof or among teams. Additionally, there are specialized competitions that include setting speed records. Racing formats include both closed courses and point-to-point contests; they may be in sheltered waters, coast-wise or on the open ocean. Most competitions are held within defined classes or ratings that either entail one type of sailing craft to ensure a contest primarily of skill or rating the sailing craft to create classifications or handicaps.

<span class="mw-page-title-main">Forces on sails</span>

Forces on sails result from movement of air that interacts with sails and gives them motive power for sailing craft, including sailing ships, sailboats, windsurfers, ice boats, and sail-powered land vehicles. Similar principles in a rotating frame of reference apply to windmill sails and wind turbine blades, which are also wind-driven. They are differentiated from forces on wings, and propeller blades, the actions of which are not adjusted to the wind. Kites also power certain sailing craft, but do not employ a mast to support the airfoil and are beyond the scope of this article.

<span class="mw-page-title-main">Farr 3.7</span>

The Farr 3.7 is a one-person sailing dinghy designed by Bruce Farr in 1971. The design plans are sold by the 3.7 Class Owners Association and they are built by a mix of professionals and home built by amateurs. The 3.7 Class is recognised by Yachting New Zealand as a national class and yachts are sailed in New Zealand, Australia and Great Britain. Full sets of plans have been sold worldwide to a number of individuals with greatest numbers in Germany, Japan, USA, South Korea, Poland, France, Belgium, Russia, Spain, Uruguay.

<span class="mw-page-title-main">B&R 23</span> Sailing boat

The B&R 23 is a sailing boat designed in the early 1990s. It has an ultralight construction with a very large sail plane. Typical crew is a helmsman and two deck hands in trapezes. The boat is predominantly used for racing.

References

  1. "Death roll". 25 July 2009.
  2. Isler, J. J; Isler, Peter, 1955- (2006), Sailing for dummies (2nd ed.), Wiley, ISBN   978-0-471-79143-0 {{citation}}: CS1 maint: multiple names: authors list (link)
  3. Holmes, Rupert; Evans, Jeremy, 1949- (2014), The dinghy bible : the complete guide to dinghy sailing (First ed.), Adlard Coles Nautical, ISBN   978-1-4081-8800-2 {{citation}}: CS1 maint: multiple names: authors list (link)
  4. Cox, Dave (2007), The sailing handbook (2nd ed.), New Holland, ISBN   978-1-84537-752-6