I-Suit

Last updated
The I-suit during field trials at the 2004 Desert RATS Isuit.jpg
The I-suit during field trials at the 2004 Desert RATS

The I-Suit is a spacesuit model constructed by ILC Dover. The suit began as an EVA mobility demonstrator, developed to meet a contract awarded by NASA to ILC in 1997 for an all-soft suit.

Contents

The I-Suit is designed for multiple roles, including planetary excursion and microgravity EVA. The first generation I-Suit is configured to work with the existing Space Shuttle EMU helmet assembly and wrist bearing/disconnect, and incorporates a 2-bearing hip, hard waist entry, and walking boots. The suit meets requirements imposed by NASA for pressure, structural loads, joint mobility (torque and range of motion), and resizing capability. [1]

Improvements over EMU

The I-Suit incorporates improvements in materials and manufacturing techniques which make it both lighter and more mobile than the EMU.

While the EMU is solely intended for the microgravity environment, where weight is not an issue, the I-Suit's planetary role makes weight a critical factor. By replacing the EMU's fiberglass Hard Upper Torso (HUT) section with a soft upper torso, or SUT, and by using lightweight titanium in place of stainless steel for load-bearing metal components, the I-suit weighs only 65 pounds (29 kg) without its life support backpack or thermal/micrometeoroid layer, compared to 107 lbs (49 kg) for the EMU. The suit also features a graphite-epoxy shoulder bearing housing, demonstrating the use of this material in place of aluminum. Replacing all the suit's bearing housings with graphite-epoxy would save a further ten pounds (5 kg). [2]

Joint torque in fabric spacesuits is minimized by the careful placement of gores, convolutes, and pleats into the fabric structure. Improvements in joint torque in the I-Suit are primarily the result of refinement of these techniques, rather than the result of new technologies, though the suit does incorporate Vectran in its restraint cords, which has somewhat improved thermal properties over the Spectra used in shuttle suits. [2]

Versions

After the original I-Suit was delivered to NASA, improvements to the design were incorporated into a second generation suit, including a new helmet with improved visibility range, a redesigned hip/thigh joint, and improved boots and waist hardware. The second generation I-suit incorporates a rear-entry hatch.

Technologies evaluated with the second generation suit include electronic textiles for use as buttons incorporated into the suit, a heads-up display, GPS capability, and speech recognition software to allow the suit occupant to receive information from the suit and external hardware. [1]

The I-Suit, as well as ILC's Mark III suit, has been involved in field testing during NASA's annual Desert Research and Technology Studies (D-RATS) field trials, during which suit occupants interact with one another, and with rovers and other equipment. [3]

Generation I (1997–1998) [4]

Generation 2 (2000–2005) [4]

Generation 3 (2005–present) [4]

Related Research Articles

<span class="mw-page-title-main">Space suit</span> Garment worn to keep a human alive in the harsh environment of outer space

A space suit or spacesuit is a garment worn to keep a human alive in the harsh environment of outer space, vacuum and temperature extremes. Space suits are often worn inside spacecraft as a safety precaution in case of loss of cabin pressure, and are necessary for extravehicular activity (EVA), work done outside spacecraft. Space suits have been worn for such work in Earth orbit, on the surface of the Moon, and en route back to Earth from the Moon. Modern space suits augment the basic pressure garment with a complex system of equipment and environmental systems designed to keep the wearer comfortable, and to minimize the effort required to bend the limbs, resisting a soft pressure garment's natural tendency to stiffen against the vacuum. A self-contained oxygen supply and environmental control system is frequently employed to allow complete freedom of movement, independent of the spacecraft.

<span class="mw-page-title-main">STS-69</span> 1995 American crewed spaceflight

STS-69 was a Space Shuttle Endeavour mission, and the second flight of the Wake Shield Facility (WSF). The mission launched from Kennedy Space Center, Florida on 7 September 1995. It was the 100th successful crewed NASA spaceflight, not including X-15 flights.

<span class="mw-page-title-main">Mechanical counterpressure suit</span> Spacesuit providing mechanical pressure using elastic garments

A mechanical counterpressure (MCP) suit, partial pressure suit, direct compression suit, or space activity suit (SAS) is an experimental spacesuit which applies stable pressure against the skin by means of skintight elastic garments. The SAS is not inflated like a conventional spacesuit: it uses mechanical pressure, rather than air pressure, to compress the human body in low-pressure environments. Development was begun by NASA and the Air Force in the late 1950s and then again in the late 1960s, but neither design was used. Research is under way at the Massachusetts Institute of Technology (MIT) on a "Bio-Suit" System which is based on the original SAS concept.

<span class="mw-page-title-main">Extravehicular Mobility Unit</span> Series of semi-rigid two-piece space suit models from the United States

The Extravehicular Mobility Unit (EMU) is an independent anthropomorphic spacesuit that provides environmental protection, mobility, life support, and communications for astronauts performing extravehicular activity (EVA) in Earth orbit. Introduced in 1981, it is a two-piece semi-rigid suit, and is currently one of two types of EVA spacesuits used by crew members on the International Space Station (ISS), the other being the Russian Orlan space suit. It was used by NASA's Space Shuttle astronauts prior to the end of the Shuttle program in 2011.

<i>Quest</i> Joint Airlock Primary airlock for the International Space Station

The Quest Joint Airlock, previously known as the Joint Airlock Module, is the primary airlock for the International Space Station. Quest was designed to host spacewalks with both Extravehicular Mobility Unit (EMU) spacesuits and Orlan space suits. The airlock was launched on STS-104 on July 14, 2001.

<span class="mw-page-title-main">ILC Dover</span> American special engineering development and manufacturing company

ILC Dover, LP is a special engineering development and manufacturing company, globally headquartered in Frederica, Delaware. ILC Dover specializes in the use of high-performance flexible materials, serving the aerospace, personal protection, and pharmaceutical industries.

<span class="mw-page-title-main">Apollo/Skylab spacesuit</span> Space suit used in Apollo and Skylab missions

The Apollo/Skylab space suit is a class of space suits used in Apollo and Skylab missions. The names for both the Apollo and Skylab space suits were Extravehicular Mobility Unit (EMU). The Apollo EMUs consisted of a Pressure Suit Assembly (PSA) aka "suit" and a Portable Life Support System (PLSS) that was more commonly called the "backpack". The A7L was the PSA model used on the Apollo 7 through 14 missions.

<span class="mw-page-title-main">Advanced Crew Escape Suit</span> Full pressure suit

The Advanced Crew Escape Suit (ACES), or "pumpkin suit", is a full pressure suit that Space Shuttle crews began wearing after STS-65, for the ascent and entry portions of flight. The suit is a direct descendant of the U.S. Air Force high-altitude pressure suits worn by the two-man crews of the SR-71 Blackbird, pilots of the U-2 and X-15, and Gemini pilot-astronauts, and the Launch Entry Suits (LES) worn by NASA astronauts starting on the STS-26 flight, the first flight after the Challenger disaster. The suit is manufactured by the David Clark Company of Worcester, Massachusetts. Cosmetically the suit is very similar to the LES. ACES was first used in 1994.

<span class="mw-page-title-main">Mercury spacesuit</span>

The Mercury space suit was a full-body, high-altitude pressure suit originally developed by the B.F. Goodrich Company and the U.S. Navy for pilots of high-altitude fighter aircraft. It is best known for its role as the spacesuit worn by the astronauts of the Project Mercury spaceflights.

<span class="mw-page-title-main">Gemini spacesuit</span> Pressurized spacesuit used in the Gemini program

The Gemini spacesuit is a spacesuit worn by American astronauts for launch, in-flight activities and landing. It was designed by NASA based on the X-15 high-altitude pressure suit. All Gemini spacesuits were developed and manufactured by the David Clark Company in Worcester, Massachusetts.

<span class="mw-page-title-main">Primary life support system</span> Life support device for a space suit

A primarylife support system (PLSS), is a device connected to an astronaut or cosmonaut's spacesuit, which allows extra-vehicular activity with maximum freedom, independent of a spacecraft's life support system. A PLSS is generally worn like a backpack. The functions performed by the PLSS include:

<span class="mw-page-title-main">Spacesuits in fiction</span> Spacesuits in Science-Fiction

Science fiction authors have designed imaginary spacesuits for their characters almost since the beginning of fiction set in space.

<span class="mw-page-title-main">Hard Upper Torso</span> Space suit component

A Hard Upper Torso Assembly, or HUT, is a central component of several space suits, notably Roscosmos' Orlan and NASA's Extravehicular Mobility Unit (EMU). The fiberglass HUT forms a rigid enclosure about the upper body of the occupant, providing pressure containment for this part of the body. The HUT incorporates structural attachment points for the arms, Lower Torso Assembly (LTA), helmet, chest-mounted Display and Controls Module (DCM), and Primary Life Support Subsystem (PLSS) backpack.

<span class="mw-page-title-main">Mark III (space suit)</span> Space suit technology demonstrator

The Mark III or MK III (H-1) is a NASA space suit technology demonstrator built by ILC Dover. While heavier than other suits, the Mark III is more mobile, and is designed for a relatively high operating pressure.

<span class="mw-page-title-main">Krechet-94</span> Russian spacesuit model

The Krechet-94 is a space suit model developed for lunar excursion during the Soviet crewed lunar program. It was designed by NPP Zvezda. Development began in 1967, concurrently with the Orlan suit for microgravity spacewalks. The developmental model was known simply as Krechet.

<span class="mw-page-title-main">Desert Research and Technology Studies</span> Field trials of technologies for manned planetary exploration

NASA's Desert Research and Technology Studies is a group of teams which perform an annual series of field trials seeking to demonstrate and test candidate technologies and systems for human exploration of the surface of the Moon, Mars, or other rocky bodies.

<span class="mw-page-title-main">Constellation Space Suit</span> Planned full pressure space suit system

The Constellation Space Suit was a planned full pressure suit system that would have served as an intra-vehicular activity (IVA) and extra-vehicular activity (EVA) garment for the proposed Project Constellation flights. The design of the suit was announced by NASA on June 11, 2008, and it was to be manufactured by Houston, Texas-based Oceaneering International, the 4th company after the David Clark Company, Hamilton Sundstrand, and ILC Dover to produce life-support hardware, as a prime contractor, for in-flight space use.

<span class="mw-page-title-main">Launch Entry Suit</span>

The Launch Entry Suit (LES), known as the "pumpkin suit", is a partial-pressure suit that was worn by all Space Shuttle crews for the ascent and entry portions of flight from STS-26 (1988) to STS-65 (1994). It was completely phased out by STS-88 and replaced by the ACES suit. The suit was manufactured by the David Clark Company of Worcester, Massachusetts.

<span class="mw-page-title-main">Final Frontier Design</span> American Aerospace Design Company

Final Frontier Design is a seed-stage startup company that builds and tests spacesuits. The company's products both enable, and are enabled by, the more recent lower-cost access to space epitomized by NewSpace launch companies such as SpaceX, Virgin Galactic and XCOR Aerospace. FFD was awarded a Phase I SBIR in 2011 and developed pressure garment glove technology under this contract.

<span class="mw-page-title-main">Z series space suits</span> Series of prototype space suit models

The Z series is a series of prototype extra-vehicular activity (EVA) space suits being developed in the Advanced Extravehicular Mobility Unit (AEMU) project under NASA's Advanced Exploration Systems (AES) program. The suits are being designed to be used for both micro-gravity and planetary EVAs.

References

  1. 1 2 David Graziosi and Ryan Lee (January 2003). "I-Suit Advanced Spacesuit Design Improvements and Performance Testing" (PDF). ILC Dover, Inc. Archived from the original (PDF) on 2006-11-15.
  2. 1 2 Ogando, Joseph (September 13, 2004). "The Right Stuff". Design News. Archived from the original on October 9, 2006.
  3. "Weighing the Benefits of the I-suit". Astrobiology Magazine. October 20, 2005.
  4. 1 2 3 ILC Spacesuits & Related Products