.45 Winchester Magnum

Last updated
.45 Winchester Magnum
Wildey Cartridges.JPG
A lineup of Wildey cartridges, with the .45 Winchester second from left.
TypePistol
Place of originUSA
Production history
Designer Winchester
Designed1977
ManufacturerWinchester
Produced1999
Specifications
Parent case.45 NAACO
Case type Rimless
Bullet diameter.452 in (11.5 mm)
Neck diameter.473 in (12.0 mm)
Base diameter.476 in (12.1 mm)
Rim diameter.480 in (12.2 mm)
Rim thickness.072 in (1.8 mm)
Case length1.198 in (30.4 mm)
Overall length1.575 in (40.0 mm)
Case capacity38  gr H2O (2.5 cm3)
Primer typeLarge pistol
Maximum pressure (SAAMI)40,000 psi (280 MPa)
Ballistic performance
Bullet mass/typeVelocityEnergy
230 gr (15 g) JHP Underwood1,600 ft/s (490 m/s)1,307 ft⋅lbf (1,772 J)
255 gr (17 g) HC FN Buffalo Bore1,400 ft/s (430 m/s)1,110 ft⋅lbf (1,500 J)
260 gr (17 g) Power-Point Winchester1,200 ft/s (370 m/s)831 ft⋅lbf (1,127 J)

The .45 Winchester Magnum is a .45 caliber rimless cartridge intended for use in semi-automatic pistols. The cartridge is externally a lengthened .45 ACP with a thicker web to withstand higher operating pressures. The 45 Win Mag is nearly identical in dimensions and loading to the .45 NAACO developed by the North American Arms Corporation for their Brigadier pistol, developed to supply to the Canadian Army after World War II. The army ultimately did not adopt the pistol and its non-NATO standard ammunition. [1]

Contents

The cartridge has been primarily used by small game hunters and metallic silhouette shooters. [2]

Specifications

Although the .45 Winchester Magnum may be based on the .45 ACP and have the same Rim and Base dimensions, the .45 Winchester Magnum has no parent case. The .45 Winchester Magnum case is redrawn with thicker walls and longer case. The thicker wall dimensions of the .45 Winchester Magnum are designed to accommodate a higher internal pressure (40,000 cup) than that of the .45 ACP (18,000 cup [21,000psi or 140MPa]).

General comments

The .45 Winchester Magnum had been on the drawing board for two years before its introduction, in 1979, by Winchester. The cartridge did not gain much popularity due to the intermittent availability of the Wildey and LAR Grizzly pistols. The cartridge was chambered in the Thompson-Center Contender single shot pistols. The cartridge was also chambered for the Freedom Arms Model 83 single-action revolver via an available optional cylinder. [3]

The .45 Winchester Magnum gained a following among IHMSA competitors as it provided the power and performance necessary to knock down targets at an extended range. The cartridge has been used by handgun hunters and is among the few semi-automatic pistol (as opposed to revolver) cartridges which have been adopted for this sport. [2]

See also

Related Research Articles

<span class="mw-page-title-main">.40 S&W</span> Pistol cartridge

The .40 S&W is a rimless pistol cartridge developed jointly by American firearms manufacturers Smith & Wesson and Winchester in 1990. The .40 S&W was developed as a law enforcement cartridge designed to duplicate performance of the Federal Bureau of Investigation's (FBI) reduced-velocity 10mm Auto cartridge which could be retrofitted into medium-frame semi-automatic handguns. It uses 0.40-inch (10 mm) diameter bullets ranging in weight from 105 to 200 grains.

<span class="mw-page-title-main">.45 ACP</span> Pistol cartridge designed by John Moses Browning

The .45 ACP or .45 Auto (11.43×23mm) is a rimless straight-walled handgun cartridge designed by John Moses Browning in 1904, for use in his prototype Colt semi-automatic pistol. After successful military trials, it was adopted as the standard chambering for Colt's M1911 pistol. The round was developed due to a lack of stopping power experienced in the Moro Rebellion in places like Sulu. The issued ammunition, .38 Long Colt, had proved inadequate, motivating the search for a better cartridge. This experience and the Thompson–LaGarde Tests of 1904 led the Army and the Cavalry to decide that a minimum of .45 caliber was required in a new handgun cartridge.

<span class="mw-page-title-main">.357 Magnum</span> Revolver cartridge

The .357 Smith & Wesson Magnum, .357 S&W Magnum, .357 Magnum, or 9×33mmR, is a smokeless powder cartridge with a 0.357 in (9.07 mm) bullet diameter. It was created by Elmer Keith, Phillip B. Sharpe, and Douglas B. Wesson of firearm manufacturers Smith & Wesson and Winchester. The .357 Magnum cartridge is notable for its highly effective terminal ballistics.

<span class="mw-page-title-main">.32 ACP</span> Pistol cartridge designed by John Moses Browning

.32 ACP is a centerfire pistol cartridge. It is a semi-rimmed, straight-walled cartridge developed by firearms designer John Browning, initially for use in the FN M1900 semi-automatic pistol. It was introduced in 1899 by Fabrique Nationale, and is also known as the 7.65×17mmSR Browning or 7.65 mm Browning Short.

<span class="mw-page-title-main">.38 Super</span> Pistol cartridge designed by Colts Manufacturing Company, LLC

The .38 Super, also known as .38 Super +P, .38 Super Auto, .38 Super Automatic, .38 Super Automatic +P, or 9×23mmSR, is a pistol cartridge that fires a 0.356-inch-diameter (9.04 mm) bullet. It was introduced in the late 1920s as a higher pressure loading of the .38 ACP, also known as .38 Auto. The older .38 ACP cartridge propels a 130-grain (8.4 g) bullet at 1,050 ft/s (320.0 m/s), whereas the .38 Super pushes the same bullet at 1,280 ft/s (390.1 m/s). The .38 Super has gained distinction as the caliber of choice for many top practical shooting competitors; it remains one of the dominant calibers in IPSC competition.

<span class="mw-page-title-main">.45 Colt</span> Revolver cartridge designed by the U.S. Army

The .45 Colt (11.43×33mmR), is a rimmed, straight-walled, handgun cartridge dating to 1872. It was originally a black-powder revolver round developed for the Colt Single Action Army revolver. This cartridge was adopted by the U.S. Army in 1873 and served as an official US military handgun cartridge for 14 years.

<span class="mw-page-title-main">10mm Auto</span> Firearm cartridge

The 10mm Auto is a semi-automatic pistol cartridge introduced in 1983. Its design was adopted and later produced by ammunition manufacturer FFV Norma AB of Åmotfors, Sweden.

<span class="mw-page-title-main">.44 Magnum</span> Revolver cartridge designed by Elmer Keith and Smith & Wesson (S&W)

The .44 Remington Magnum, also known as .44 Magnum or 10.9x33mmR, is a rimmed, large-bore cartridge originally designed for revolvers and quickly adopted for carbines and rifles. Despite the ".44" designation, guns chambered for the .44 Magnum round, and its parent, the .44 Special, use 0.429 in (10.9 mm) diameter bullets. The .44 Magnum is based on the .44 Special case but lengthened and loaded to higher pressures for greater velocity and energy.

<span class="mw-page-title-main">.32 S&W Long</span> American handgun cartridge

The .32 S&W Long, also known as 7.65x23mm, is a straight-walled, centerfire, rimmed handgun cartridge, based on the earlier .32 S&W cartridge. It was introduced in 1896 for Smith & Wesson's first-model Hand Ejector revolver. Colt called it the .32 Colt New Police in revolvers it made chambered for the cartridge.

<span class="mw-page-title-main">Wildcat cartridge</span> Custom cartridge for firearms

A wildcat cartridge, often shortened to wildcat, is a custom cartridge for which ammunition and/or firearms are not mass-produced. These cartridges are often created in order to optimize a certain performance characteristic of an existing commercial cartridge, or may merely be intended as novelty items.

A rim is an external flange that is machined, cast, molded, stamped, or pressed around the bottom of a firearms cartridge. Thus, rimmed cartridges are sometimes called "flanged" cartridges. Almost all cartridges feature an extractor or headspacing rim, in spite of the fact that some cartridges are known as "rimless cartridges". The rim may serve a number of purposes, including providing a lip for the extractor to engage, and sometimes serving to headspace the cartridge.

<span class="mw-page-title-main">.475 Wildey Magnum</span>

The .475 Wildey Magnum is a semi-automatic pistol cartridge designed for big game hunting in the Wildey pistol.

<span class="mw-page-title-main">Wildey</span> Semi-automatic pistol

The Wildey is a gas-operated, double-action or single-action pistol designed by Wildey J. Moore. It was designed to fire several high-pressure proprietary cartridges including the .45 Winchester Magnum and the .475 Wildey Magnum. They are currently being produced by USA Firearms Corp.-Wildey Guns of Winsted, Connecticut.

<span class="mw-page-title-main">.38 ACP</span> Pistol cartridge designed by John Moses Browning

The .38 ACP, also known as the .38 Auto or 9x23mmSR, is a semi-rimmed pistol cartridge that was introduced at the turn of the 20th century for the John Browning-designed Colt M1900. It was first used in Colt's Model 1897 prototype, which he did not produce. The metric designation for the round is 9×23mm SR (semi-rimmed), which is not to be confused with other 9×23mm cartridges.

<span class="mw-page-title-main">.32 H&R Magnum</span>

The .32 H&R Magnum is a rimmed cartridge designed for use in revolvers. It was developed and introduced in 1984 as a joint venture between Harrington & Richardson and Federal Premium Ammunition.

<span class="mw-page-title-main">Overpressure ammunition</span> Type of small arms ammunition

Overpressure ammunition, commonly designated as +P or +P+, is small arms ammunition that has been loaded to produce a higher internal pressure when fired than is standard for ammunition of its caliber, but less than the pressures generated by a proof round. This is done typically to produce rounds with a higher muzzle velocity and stopping power, such as ammunition used for defensive or hunting purposes. Because of this, +P ammunition is typically found in handgun calibers which might be used for defensive purposes.

<span class="mw-page-title-main">LAR Grizzly Win Mag</span> Semi-automatic pistol

The Grizzly Win Mag pistols were conceived, invented, designed, engineered and developed in the 1980s by the sole inventor, Perry Arnett, who licensed his patent for an interchangeable caliber semi-automatic pistol to L.A.R. Manufacturing Inc. Perry Arnett's designs were initially flawed and were improved upon by Heinz Augat. The L.A.R. Grizzly was the most powerful semi-automatic pistol ever commercially produced after the Desert Eagle.

.32 caliber is a size of ammunition, fitted to firearms with a bore diameter of 0.32 inches (8.1 mm).

The .45 Super is a powerful smokeless powder center fire metallic firearm cartridge developed in 1988 by Dean Grennell, a well-known writer in the firearms field as well as managing editor of Gun World magazine. It is dimensionally similar to the .45 ACP round but has a thicker case wall and is loaded to higher pressures, which offers an average 300 feet per second (91 m/s) improvement in muzzle velocity over the .45 ACP. The cartridge was co-developed by Tom Fergerson and Ace Hindman.

The .40 Super is a powerful automatic pistol cartridge developed in 1996 and introduced to the market by Triton Cartridge. The cartridge was co-developed by Fernando Coelho and Tom Burczynski.

References

  1. Dan Johnson (2009). "1911 Hot Rods". Intermedia Outdoors, Inc. Archived from the original on 2009-06-18. Retrieved 2011-11-21.
  2. 1 2 Wahl, Paul (1980). "First Gas Operated Semi-Auto Pistol". Popular Science . 216 (4): 148.
  3. "Freedom Arms Inc. Revolver Specifications" (PDF). Freedom Arms. 29 Oct 2009.