Zephyr | |
---|---|
Role | Single-seat sailplane |
National origin | United Kingdom |
Manufacturer | E. T. W. Addyman at Harrogate |
Designer | E. T. W. Addyman |
First flight | 1933 |
Number built | 1 |
The Addyman Zephyr was a one-off, single-seat sailplane designed and built by Erik Addyman in the UK for his own use in the 1930s.
Erik Addyman designed and built the single-seat Zephyr, his first design, in 1933. It was intended as a light wind sailplane, [1] combining a wing of modest aspect ratio with a nacelle cockpit and an open truss girder fuselage of the kind more common on primary gliders. It was a wooden-structured, largely fabric-covered aircraft. [2]
The two-spar wing had a straight leading edge and constant chord out to a little over half span, where the trailing edges of the ailerons, hinged at a slight angle to the spar, curved inwards to the wingtips. It was braced from above with pairs of wires from the spars to a central, inverted V-strut pylon and below by wires to the lower nacelle longerons. There were no flaps or air brakes. The central wing rib was continued rearward with the upper member of the open, flat, converging Warren girder fuselage, whose lower member joined the keel of the plywood- and fabric-covered nacelle just aft of the wing trailing edge. This placed the open single cockpit just forward of the wing leading edge. A central keel skid formed the main undercarriage, with assistance from a tail bumper. A narrow-span, triangular tailplane, wire braced above and below, carried longer-span elevators with rounded tips and a cut-out for the deep, rounded rudder hinged to small, triangular fin. [2]
The Zephyr flew for the first time in 1933. [2]
Only one Zephyr was built. [2] Based at Harrogate, [3] [4] where Addyman was honorary secretary of the Aircraft Club, it was often launched with a tow from a horse. [1] He flew it from many fields in central and north-western England up to the early part of World War II; [2] from 1940 there was a government ban on recreational glider flying. The Zephyr seems not to have flown again, [2] though substantial parts of it still (2010) exist in store. [3]
Data from Ellison [2]
General characteristics
The Addyman STG was a single seat primary glider, amateur designed and built in the United Kingdom in the mid-1930s.
The Cloudcraft Dickson Primary was a single-seat primary glider designed in the United Kingdom in 1930 to be constructed from plans. Many glider clubs in the UK and the British Empire flew them in the 1930s.
The Czerwiński Sparrow, sometimes known as the de Havilland Canada glider, was a single seat glider, designed and built by a group of de Haviiland engineers in Canada in 1942. It was intended to popularise gliding and be suitable for both basic training and thermal soaring.
The Nyborg T.G.N.1 was a single-seat experimental sailplane built in the early 1930s, its unusual wing design a scaled-up version of the wings of large birds.
The Payne I.C.1 was a primary glider built by members of a University gliding club in 1930. It was finished and prepared for flight but was damaged by wind and repairs were never completed.
The Radlock Trainer was a single seat primary glider designed and built by members of the Hull Experimental Gliding Club as a basic trainer for their own use in the early 1930s. It was a simple, single exposed seat, wooden glider with a parasol wing.
The Reynard R.4 Primary was an open seat primary glider with an open girder fuselage and a high, wire braced wing. It was designed and built in the UK in 1930 and a few served Gliding Clubs in England and Ireland.
The Bonomi BS.4 Basettino was a primary glider designed and built in Italy in the 1930s.
The Bonomi BS.8 Biancone was a single-seat training glider designed and built in Italy in the 1930s. It was developed from the Bonomi BS.7 Allievo Italia primary glider.
The Bonomi BS.11 Milano and BS.12 Roma were primary gliders designed and built in Italy in the 1930s. Only about six were produced.
The Bonomi BS.17 Allievo Cantù was a single seat training glider, designed and built in Italy in 1934 and widely used by flying clubs.
The Bonomi BS.24 Biposto Rome was an Italian dual control trainer designed for club use. Six were built in the mid-1930s.
The CAT 15 was a single-seat primary glider built in Italy just before the Second World War. Only one was constructed.
The Teichfuss Allievo Pavullo was an Italian single seat open frame primary glider, designed by Luigi Teichfuss of Pavullo and first flown in 1940. It was sold in two versions, strut and cable braced. A single two seat variant was also built.
The RRG Falke of 1930 was a secondary training glider designed by Alexander Lippisch in Germany and intended to provide better performance than his earlier RRG Prüfling whilst being easier to fly because of its inherent stability. It was sold as plans for both club and commercial production and was built in Germany and abroad.
The Jacobs Hols der Teufel was a single seat trainer glider produced in complete and plan forms in Germany from 1928. It was built and used worldwide.
The Schleicher Poppenhausen named after the town of Poppenhausen was a two-seat glider, available as a dual control advanced trainer, produced in Germany from 1928.
The Schneider ESG 31 Schlesierland (Silesia) was a representative of a group of German, 16 m span, one-off gliders, built by Schneider in Grunau from 1929 to at least 1931.
The Czajka or Kocjan Czajka after its designer was a Polish secondary training glider which was in continuous production from 1931 to the start of World War II. More than 160 were completed in Warsztaty Szybowcowe in Warsaw.
The MSrE M-20 was an Hungarian primary glider with a better performance than the first generation of such aircraft. One of its designers was Ernő Rubik and the MSrE M-20 was his first major contribution. Only one was built.