All-number calling

Last updated

All-number calling (ANC) is a telephone numbering plan that was introduced into the North American Numbering Plan by the Bell System in the United States starting in 1958 [1] to replace the previous system of using a telephone exchange name as the first part of a telephone number. [2] The plan prescribed the format of a telephone number assigned to subscriber telephones to consist of ten digits, composed from a three-digit area code, a three-digit central office code, and a four-digit station number. This increased the number of effectively available central office codes in each numbering plan area (NPA) from 540 to 792, thereby staving off the threat of exhausting the number pool, which was forecast to occur by the late 20th century.

Contents

History

Bell System mapping of letters to dialed digits
dialed digitletters
1
2A B C
3D E F
4G H I
5J K L
6M N O
7P R S
8T U V
9W X Y
0Z

Until the 1950s, a typical telephone number in the United States and many other countries consisted of a telephone exchange name and a four- or five-digit subscriber number. The first two or three letters of the exchange name translated into digits given by a mapping typically displayed on the telephone's rotary dial by grouping the letters around the associated digit. The table (right) shows the typical assignment in the Bell System in use at the time. The letter Q was not used, and Z was translated to 0 (zero) on some dials, albeit never used in the name system. For example, a New Yorker's telephone number might have been CHelsea 2-5034, which a calling telephone subscriber would dial as the digit sequence 2425034, translating C to 2, and H to 4.

After World War II, the newly conceived nationwide numbering plan of 1947 sought to unify all local numbering plans by using a system of two central office letters and one digit to complete the office prefix, and four digits for line number. This system was referred to as 2L-5N, or simply 2-5. This plan was projected to be usable beyond the year 2000. However, with increasing demand for telephone service in the post-war decades, it became apparent by the late 1950s, that the system would be outgrown by about 1975. [3] The limitations for the usable leading digits of central office codes, imposed by using common names for central office names, and their leading two characters as guides for customer dialing could no longer be maintained when opening new central offices. By 1962 it was forecast that in 1985 the number of telephones in the nation would equal its population of 280 million and increase to 600 million telephones for 340 million people in 2000. [2] As a result, the North American telephone administrations first introduced letter combinations that could not be linked to a familiar pronounceable central office name in some highly populated states, such as New York.

The final solution to the growing threat of numbering exhaustion was decided by AT&T engineers and administrators from in-depth studies of all alternative methods. [2] It was decided to eliminate the restrictions of using names and lettered prefixes.

Partitioning of the NANP prefix space
under all-number-calling
000 — 099These 200 codes were used
as toll center and system codes
100 — 199
area
codes		service
codes		area
codes		central office
codes
200 — 210211212 — 219220 — 299
300 — 310311312 — 319320 — 399
400 — 410411412 — 419420 — 499
500 — 510511512 — 519520 — 599
600 — 610611612 — 619620 — 699
700 — 710711712 — 719720 — 799
800 — 810811812 — 819820 — 899
900 — 910911912 — 919920 — 999
152 area codes
8 special service codes		640 CO codes

This goal had been envisioned internally within AT&T for some time. In 1954, John Karlin directed a research project that investigated the memory capacity and dialing accuracy of employees when using seven-digit telephone numbers comprising only digits. [3] At that time, some directory publishing departments also began removing the entire central office name from telephone directories, preferring to only list the dialed letters of the prefix. The practice did not produce any adverse effects, [4] and opened the path for listing telephone numbers in the 2-5 style, where the two letters were unrelated to any pronounceable name.

Under all-number calling, the number of permissible central office prefixes increased from 540 to potentially 800, but the first two digits of the central office code were still restricted to the range 2 to 9, and the eight combinations that ended in 11 were reserved as special calling codes. [2] This increased the numbering pool for central office codes to 640, and resulted in the partitioning of the prefix space (000—999) according to the table at the right. [5]

All-number calling was first field-tested in Wichita Falls, Texas in 1958 with the installation of a new dial exchange. [3] The results indicated a substantial reduction of dialing errors over new system installations that used the 2-5 numbering system. In small communities the new system was met with little resistance. [6] In Council Bluffs, Iowa with c. 26,000 telephone subscribers, it also caused no major resistance in March 1960. [4] During larger scale introductions in California in 1962, this change sparked an intense outcry among urban users who considered all-digit dialing to be dehumanizing. [7] [8]

Karlin, the inventor of the all-number system, stated that he had been approached by a woman at a cocktail party, "Are you the John Karlin who is responsible for all-number dialing?" He proudly replied, "Yes, I am." She then asked him, "How does it feel to be the most hated man in America?" Opponents created a variety of organizations to oppose all-number calling, including the Anti-Digit Dialing League and the Committee of Ten Million to Oppose All-Number Calling to pressure AT&T to drop the plan. [9]

Other countries introduced similar transitions for eliminating exchange names. In the United Kingdom, the new system was known as all-figure dialling.

See also

Related Research Articles

<span class="mw-page-title-main">North American Numbering Plan</span> Integrated telephone numbering plan serving 20 North American countries

The North American Numbering Plan (NANP) is a telephone numbering plan for twenty-five regions in twenty countries, primarily in North America and the Caribbean. This group is historically known as World Zone 1 and has the international calling code 1. Some North American countries, most notably Mexico, do not participate in the NANP.

Telephone keypad Keypad that appears on some telephones

A telephone keypad is a keypad installed on a push-button telephone or similar telecommunication device for dialing a telephone number. It was standardized when the dual-tone multi-frequency signaling (DTMF) system was developed in the Bell System in the United States in the 1960s that replaced rotary dialing originally developed in electromechanical switching systems. Because of the installed abundance of rotary dial equipment well into the 1990s, many telephone keypads were also designed to produce loop-disconnect pulses electronically, and some could be optionally switched to produce either DTMF or pulses.

A toll-free telephone number or freephone number is a telephone number that is billed for all arriving calls instead of incurring charges to the originating telephone subscriber. For the calling party, a call to a toll-free number from a landline is free of charge.

Subscriber trunk dialling (STD), also known as subscriber toll dialing, is a telephone numbering plan feature and telecommunications technology for the dialling of trunk calls by telephone subscribers without the assistance from switchboard operators.

The telephone number prefix 555 is a central office code in the North American Numbering Plan, used as the leading part of a group of 10,000 telephone numbers, 555-XXXX, in each numbering plan area (NPA). It has traditionally been used only for the provision of directory assistance, when dialing -555-1212.

A telephone numbering plan is a type of numbering scheme used in telecommunication to assign telephone numbers to subscriber telephones or other telephony endpoints. Telephone numbers are the addresses of participants in a telephone network, reachable by a system of destination code routing. Telephone numbering plans are defined in each of the administrative regions of the public switched telephone network (PSTN) and in private telephone networks.

Seven-digit dialing is a telephone dialing procedure customary in some territories of the North American Numbering Plan (NANP) for dialing telephone numbers in the same numbering plan area (NPA). NANP telephone numbers consist of ten digits, of which the leading three are the area code. In seven-digit dialing it is not necessary to dial the area code. The procedure is also sometimes known as local format or network format.

All-figure dialling was a telephone numbering plan introduced in the United Kingdom starting in 1966 that replaced the traditional system of using initial letters of telephone exchange names as the first part of a telephone number. The change affected subscriber numbers in the cities of Birmingham, Edinburgh, Glasgow, Liverpool, London and Manchester which used the Director telephone system.

In telecommunications, a long-distance call (U.S.) or trunk call is a telephone call made to a location outside a defined local calling area. Long-distance calls are typically charged a higher billing rate than local calls. The term is not necessarily synonymous with placing calls to another telephone area code.

<span class="mw-page-title-main">Area codes 514 and 438</span> Telephone area codes for Montreal

Area codes 514 and 438 are telephone area codes of the North American Numbering Plan (NANP) for Montreal and most of its on-island suburbs, specifically the Island of Montreal and Île Perrot in the Canadian province of Quebec.

<span class="mw-page-title-main">Telephone exchange names</span> Alphabetic telephone numbering plan

A telephone exchange name or central office name was a distinguishing and memorable name assigned to a central office. It identified the switching system to which a telephone was connected, and facilitated the connection of telephone calls between switching systems in different localities.

<span class="mw-page-title-main">Area codes 408 and 669</span> Area codes that serve the southern San Francisco Bay Area, California

Area codes 408 and 669 are telephone area codes in the North American Numbering Plan (NANP) in the U.S. state of California. The numbering plan area comprises most of Santa Clara County and Northern Santa Cruz County, and includes Gilroy, Morgan Hill, Saratoga, Los Gatos, Monte Sereno, Milpitas, Sunnyvale, Santa Clara, Cupertino, Campbell, and San Jose.

A telephone prefix is the first set of digits after the country, and area codes of a telephone number; in the North American Numbering Plan countries, it is the first three digits of a seven-digit phone number, 3-3-4 scheme. In other countries both the prefix and the number may have different lengths. It shows which exchange the remaining numbers refer to. A full telephone number is usually made up of +251, area code, prefix, and subscriber number.

020 Dialling code for London in the United Kingdom

020 is the national dialling code for London in the United Kingdom. All subscriber numbers within the area code consist of eight digits and it has capacity for approaching 100 million telephone numbers. The code is used at 170 telephone exchanges in and around Greater London as part of the largest linked numbering scheme in the United Kingdom. In common with all other British area codes the initial '0' is a trunk prefix that is not required when dialling London from abroad.

The expansion of the North American Numbering Plan (NANP) is an anticipated requirement to provide more telephone numbers to accommodate future needs beyond the pool of ten-digit telephone numbers in use since the inception of the NANP in 1947. An October 2020 analysis estimated that the current numbering plan would not be exhausted until after the year 2050.

The national conventions for writing telephone numbers vary by country. While international standards exist in the form of the International Telecommunication Union sector ITU-T issued recommendation E.123, national telephone numbering plans define the format and length of telephone numbers assigned to telephones.

<span class="mw-page-title-main">Telephone number</span> Sequence of digits assigned to a telephone subscription

A telephone number is a sequence of digits assigned to a landline telephone subscriber station connected to a telephone line or to a wireless electronic telephony device, such as a radio telephone or a mobile telephone, or to other devices for data transmission via the public switched telephone network (PSTN) or other public and private networks.

The original North American area codes were established by the American Telephone & Telegraph Company (AT&T) in the years immediately following World War II. Creating a comprehensive and universal, continent-wide telephone numbering plan was a basic requirement for nationwide Operator Toll Dialing which had the goal of speeding the connecting times for long-distance calling by eliminating intermediary telephone operators. It had the eventual benefit of direct distance dialing (DDD) by telephone subscribers. It established a uniform destination addressing and call routing system for all telephone networks in North America that had become an essential public service.

<span class="mw-page-title-main">Telephone exchange</span> Interconnects telephones for calls

A telephone exchange, telephone switch, or central office is a telecommunications system used in the public switched telephone network (PSTN) or in large enterprises. It interconnects telephone subscriber lines or virtual circuits of digital systems to establish telephone calls between subscribers.

In the North American Numbering Plan (NANP), interchangeable NPA and central office codes constituted a change in numbering plan design and policy, to mitigate exhaustion of the numbering resources of the ten-digit telephone numbers used in the closed numbering plan of the NANP.

References

  1. ↑ Alliance for Telecommunications Industry Solutions (ATIS), Numbering and Dialing Plans within the United States (ATIS-0300076), December 2008, p.7
  2. 1 2 3 4 Blair N.D., Cosgrove M.P. (AT&T), why all numbers?, Bell Telephone Magazine, Autumn 1962, p.10
  3. 1 2 3 AT&T, All-Number Calling Being Introduced In Bell System, Bell Laboratories Record 38(12) p.470 (December 1960)
  4. 1 2 Brooks J., Telephone: The First Hundred Years (1976) ISBN   0-06-010540-2, p. 271
  5. ↑ Bell Telephone Laboratories, Engineering and Operations in the Bell System (1984), p.119
  6. ↑ By the Numbers – TIME 1962-05-11.
  7. ↑ John Brooks, Telephone: The First Hundred Years," 1976. ISBN   0-06-010540-2.
  8. ↑ Stan Freberg, "Digit Dialing Demonstration"/"They Took Away Our MurrayHills", 1966
  9. ↑ Simon Romero. "Now You Need an Area Code Just to Call Your Neighbors." New York Times, May 7, 2001.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.