| TP-1 / XCO-5 | |
|---|---|
 | |
| XCO-5 | |
| Role | Biplane fighter |
| National origin | United States |
| Manufacturer | Engineering Division |
| Designer | Alfred V. Verville and Virginius E. Clark |
| Number built | 2 |
The Engineering Division TP-1 was a two-seat biplane fighter designed by Alfred V. Verville and Virginius E. Clark at the United States Army Air Corps Engineering Division. [1] A second aircraft was completed as an observation biplane and designated the Engineering Division XCO-5. [1] [2]
The prototype TP-1 was built as the XTP-1 and tested at McCook Field in 1923. A biplane, the upper wing had a smaller span and narrower chord than the lower wing. [1] The XTP-1 was armed with five .30 in (7.62 mm) machine guns and fitted with a 423 hp (315 kW) Liberty 12 engine. [1] A second prototype was completed as an observation/reconnaissance aircraft with the designation XCO-5. [2]
The XCO5 needed a high-lift wing suitable for high-altitude work. New wings were prepared. The aerofoil was Joukowsky StAe-27A, a heavily cambered wingshape with a thick leading edge. The upper and lower wings had a pronounced stagger, with a total wing area of 600 ft2. As well as lining and insulating the cockpit, heat was taken from the engine exhaust. A cover over the top of the cockpit kept the heat in; a clear panel in the cover allowed the pilot to see his instruments. [3]
On October 10, 1928, Bill Streett and Albert William Stevens achieved an unofficial altitude record in the XCO-5 for aircraft carrying more than one person: 37,854 ft (11,538 m); less than 1,000 ft (300 m) short of the official single-person altitude record. [4] At that height they measured a temperature of −78 °F (−61 °C), cold enough to freeze the aircraft controls. [5] With frozen controls, Streett was unable to reduce altitude or to turn off the engine until some 20 minutes later when it ran out of fuel, after which he piloted the fragile experimental biplane down in a gentle glide and made a deadstick landing. [5]
United States Data from The American Fighter [6]
General characteristics
Performance
Armament
Related lists
The Vought XF3U was the prototype of a two-seat, all-metal biplane fighter, built by Vought Aircraft Company of Dallas, Texas for the United States Navy.
The Vought SBU-1 Corsair was a two-seat, all-metal biplane dive bomber built by Vought Aircraft Company of Dallas, Texas for the US Navy. Its design was based upon the F3U-1 two-seat fighter that was abandoned when the Navy decided not to obtain any more two-seat fighters.
The Thomas-Morse MB-3 was an open-cockpit biplane fighter primarily manufactured by the Boeing Company for the U.S. Army Air Service in 1922. The MB-3A was the mainstay fighter for the Air Service between 1922 and 1925.
The Consolidated P-30 (PB-2) was a 1930s United States two-seat fighter aircraft. An attack version called the A-11 was also built, along with two Y1P-25 prototypes and YP-27, Y1P-28, and XP-33 proposals. The P-30 is significant for being the first fighter in United States Army Air Corps service to have retractable landing gear, an enclosed and heated cockpit for the pilot, and an exhaust-driven turbo-supercharger for altitude operation.
The Aeromarine PG-1 was an American single-seat pursuit (fighter) and ground attack (PG) biplane developed by the Engineering Division of the United States Army and manufactured by the Aeromarine Plane and Motor Co..
The Curtiss 18T, unofficially known as the Wasp and by the United States Navy as the Kirkham, was an early American triplane fighter aircraft designed by Curtiss for the US Navy.
The LUSAC-11 was an early American two-seat fighter aircraft. It was a French design, commissioned and built in the United States during World War I and ordered in large numbers by the United States Army Air Corps, but these were cancelled at the end of the war, and only 30 were built. The type was used for experimental purposes, setting several altitude records during the 1920s.
The Berliner-Joyce OJ was an American biplane observation floatplane developed by the Berliner-Joyce Aircraft for the United States Navy during the early 1930s.
The Curtis XF13C was a carrier-based fighter aircraft built by Curtiss Aeroplane and Motor Company.
The Douglas XFD was a carrier-based biplane fighter aircraft designed for the United States Navy, and the first fighter to be built by the Douglas Aircraft Company. A victim of changing requirements, no production was undertaken.
The Pomilio FVL-8 was a biplane fighter aircraft built by Fabbrica Aeroplani Ing. O. Pomilio for Engineering Division of the Aviation Section, U.S. Signal Corps.
The Northrop XFT was an American prototype fighter aircraft of the 1930s. A single engined low-winged monoplane, it was designed and built to meet a United States Navy order for an advanced carrier based fighter. It exhibited poor handling, and was rejected by the Navy, the single prototype being lost in a crash. A variant, the Northrop 3A, also was unsuccessful.
The Boeing Model 42 was an American biplane aircraft developed from the Airco DH.4, taking advantage of the large number of aircraft left over after the end of World War I.
The Verville VCP was an American single-engined biplane fighter aircraft of the 1920s. A single example of the VCP-1 was built by the United States Army Air Service's Engineering Division, which was later rebuilt into a successful racing aircraft, while a second, modified fighter was built as the PW-1.
The Curtiss O-40 Raven was an American observation aircraft of the 1930s which was built and used in small numbers. A single example of the YO-40, a single-engined Sesquiplane with a retractable undercarriage was built, followed by four examples of a modified monoplane version, the O-40B, which remained in use until 1939.
The Vought V-141 was a prototype American single-seat fighter aircraft of the 1930s. It was a development of the unsuccessful Northrop 3-A design, but was itself a failure, being rejected by the United States Army Air Corps. The sole prototype was sold to the Japanese Army in 1937, but no production followed, with the type proving to be inferior to existing Japanese fighters.
The Orenco B was a prototype American fighter aircraft of World War I. It was a single-engined, single-seat biplane that flew in 1918. Although it demonstrated good performance, it did not enter large scale service.
The Thomas-Morse TM-24 was a prototype American two-seat observation aircraft of the 1920s. A single example was built in 1925, but no production followed.
The Engineering Division XCO-2 was an observation aircraft designed at the United States Army Air Corps Engineering Division.
The LVG D.IV was a German fighter plane built by LVG in World War I.
 | Wikimedia Commons has media related to Engineering Division TP-1 . |