This article needs additional citations for verification .(May 2011) |
Fanning is a revolver shooting technique in which the shooter uses one hand to hold the gun and pull the trigger, while using the other hand to cock back the hammer repeatedly in a slapping-like fashion without touching any other parts of the gun. This allows for the rapid firing of single-action revolvers, and the technique is used extensively in fast draw exhibitions.[ citation needed ]
Slip hammering is another similar revolver technique involving the use of one hand to pull the trigger and the other hand to repeatedly cock the hammer. The difference is that in slip hammering, both hands maintain grasp on the gun through an overwrapping grip, and only the thumb of the outside hand (typically the non-dominant hand) moves to flip back the hammer. This allows for quick shooting while maintaining a firmer control of the firearm than the fanning technique, but fatigues more easily as the muscles of the thumb are generally weaker and less staminous than the wrist muscles.
The idea (as spread by old western films) that gunslingers in the "Old West" fanned their revolvers in actual gunfights with any regularity is considered a caricature. It was done in shooting exhibitions (where trick marksmen entertained crowds with exotic shooting shows) and by many a curious target-practiser. It was probably not common in actual firefights, because it does not lend itself to most real-life tactical situations, accuracy, or the use of cover. One longtime firearms instructor, George L. Tooley, [1] said: "Fanning is hard on the revolver, in addition to being inaccurate, and is not recommended".
A slip gun is a revolver which has been modified to disconnect the trigger from the hammer, so as to cause it to fire by pulling back and releasing the hammer.[ citation needed ] Often the hammer spur is lowered, so the gun may be fired by wiping one's finger across the hammer. The only difference from fanning is that only one hand is needed, because in fanning one hand holds the gun and pulls back the trigger while the other hand knocks back the hammer repeatedly. Slip shooting is a little slower than fanning, but more accurate and practical since only one hand is needed. Slip guns were used for various types of rapid trick shooting in which the ability to instinctively rapid fire was crucial.
Thumbing has been used to refer to a similar action as fanning except instead of using the opposite hand to pull the hammer while the trigger is depressed, the thumb of the gun hand is used. This would be necessary if firing paired revolvers. [2] [ full citation needed ]
A firearm is any type of gun that uses an explosive charge and is designed to be readily carried and used by an individual. The term is legally defined further in different countries.
A revolver is a repeating handgun that has at least one barrel and uses a revolving cylinder containing multiple chambers for firing. Because most revolver models hold up to six cartridges, before needing to be reloaded, revolvers are commonly called six shooters or sixguns. Due to their rotating cylinder mechanism, they may also be called wheel guns.
In firearms terminology, an action is the functional mechanism of a breech-loading firearm that handles the ammunition cartridges, or the method by which that mechanism works. Actions are technically not present on muzzleloaders, as all those are single-shot firearms with a closed off breech with the powder and projectile manually loaded from the muzzle. Instead, the muzzleloader ignition mechanism is referred to as the lock.
A semi-automatic pistol is a handgun that automatically ejects and loads cartridges in its chamber after every shot fired. Only one round of ammunition is fired each time the trigger is pulled, as the pistol's fire control group disconnects the trigger mechanism from the firing pin/striker until the trigger has been released and reset.
The pepper-box revolver or simply pepperbox is a multiple-barrel firearm, mostly in the form of a handgun, that has three or more gun barrels in a revolving mechanism. Each barrel holds a single shot, and the shooter can manually rotate the whole barrel assembly to sequentially index each barrel into alignment with the lock or hammer, similar to rotation of a revolver's cylinder.
The CZ 52 is a semi-automatic pistol designed by two brothers, Jan and Jaroslav Kratochvíl, in the early 1950s for the Czechoslovak military. Around 200,000 vz. 52s were made by Česká Zbrojovka in Strakonice from 1952 to 1954. Before standardizing on the 7.62×25mm vz. 52, the Czechoslovak military used several domestic and foreign pistol models in three different calibers. After 30 years of military service, the vz. 52 was eventually replaced by the 9×18mm Makarov caliber vz. 82.
Double action refers to one of two systems in firearms where the trigger both cocks and releases the hammer.
Pump action is a type of manual firearm action that is operated by moving a sliding handguard on the gun's forestock. When shooting, the sliding forend is pulled rearward to eject any expended cartridge and typically to cock the hammer or striker, and then pushed forward to load a new cartridge into the chamber. Most pump-action firearms use an integral tubular magazine, although some do use detachable box magazines. Pump-action firearms are typically associated with shotguns, although it has also been used in rifles, grenade launchers, and other types of firearms. A firearm using this operating mechanism is colloquially referred to as a pumpgun.
A tactical light or weapon light is a flashlight used in conjunction with a firearm to aid low-light target identification, allowing the user to simultaneously aim a weapon and illuminate the target. Tactical lights can be handheld or mounted to the weapon with the light beam parallel to the bore. Tactical lights can also serve as a non-lethal weapon, used to temporarily blind and disorient targets or, in the case of a large handheld flashlight, to be used as a blunt weapon.
An automatic revolver also known as semi-automatic revolver, is a revolver that uses the recoil energy of firing for cocking the hammer and revolving the cylinder, rather than using manual operations to perform these actions. As semi-automatic firearms, the shooter must manually operate the trigger to discharge each shot.
Accurizing is the process of improving the accuracy and precision of a gun.
Point shooting is a practical shooting method where the shooter points a ranged weapon at a target without relying on the use of sights to aim. Emphasis is placed on fast draw and trying to score preemptive hits first. In close quarters combat, where life-threatening situations emerge very quickly, sighted marksmanship techniques become risky, so advocates of point shooting emphasize a less sighting-oriented style that prioritizes the tactical advantages of quick fire superiority and suppression.
Robert Adams was a 19th-century British gunsmith who patented the first successful double-action revolver in 1851. His revolvers were used during the Crimean War, the Indian Mutiny, the American Civil War, and the Anglo-Zulu War.
A trigger is a mechanism that actuates the function of a ranged weapon such as a firearm, airgun, crossbow, or speargun. The word may also be used to describe a switch that initiates the operation of other non-shooting devices such as a trap, a power tool, or a quick release. A small amount of energy applied to the trigger leads to the release of much more energy.
A hammerless firearm is a firearm that lacks an exposed hammer or hammer spur. Although it may not literally lack a hammer, it lacks an external hammer that the user can manipulate directly. One of the disadvantages of an exposed hammer spur is the tendency for it to get caught on items such as clothing; covering the hammer by removing the hammer spur reduces this from occurring.
The hammer is a part of a firearm that is used to strike the percussion cap/primer, or a separate firing pin, to ignite the propellant and fire the projectile. It is so called due to the fact that it resembles a hammer in both form and function. The hammer itself is a metal piece that forcefully rotates about a pivot point.
The Colt Paterson revolver was the first commercial repeating firearm employing a revolving cylinder with multiple chambers aligned with a single, stationary barrel. Its design was patented by Samuel Colt on February 25, 1836, in the United States, England and France, and it derived its name from being produced in Paterson, New Jersey. Initially this 5 shot revolver was produced in .28 caliber, with a .36 caliber model following a year later. As originally designed and produced, no loading lever was included with the revolver; a user had to partially disassemble the revolver to re-load it. Starting in 1839, however, a reloading lever and a capping window were incorporated into the design, allowing reloading without disassembly. This loading lever and capping window design change was also incorporated after the fact into most Colt Paterson revolvers that had been produced from 1836 until 1839. Unlike later revolvers, a folding trigger was incorporated into the Colt Paterson. The trigger became visible only upon cocking the hammer.
The following are terms related to firearms and ammunition topics.
The Tranter revolver was a double-action cap & ball revolver invented around 1856 by English firearms designer William Tranter (1816–1890). Originally operated with a special dual-trigger mechanism later models employed a single-trigger mechanism much the same as that found in the contemporary Beaumont–Adams revolver.
In firearms, a safety or safety catch is a mechanism used to help prevent the accidental discharge of a firearm, helping to ensure safer handling.