Fulcrum grip

Last updated

The Fulcrum grip is a four-mallet grip for vibraphone and marimba developed by vibraphonist and educator Ed Saindon. The aim of the grip is to use varying fulcrum positions and finger technique to achieve the control, speed, and power of a two-mallet grip while being able to use all four mallets.

Contents

Description

This grip is based on the positioning of the Burton grip, with two mallets being held loosely in each hand. However, while the Burton grip uses mainly wrist and arm motion to create the stroke, the Fulcrum grip uses finger control to manipulate the stroke. [1]

Burton grip Burton Grip.jpg
Burton grip
Fulcrum Grip. Note the fulcrum between thumb and index finger, and outside mallet tip out of the hand. Fulcrum Grip.jpg
Fulcrum Grip. Note the fulcrum between thumb and index finger, and outside mallet tip out of the hand.

By utilizing a fulcrum between the thumb and index finger, the mallets are allowed to come out of the palm of the hand before they are snapped back in by the fingers, like a two-mallet player or drummer with sticks in matched grip. [2] The result is increased control over dynamic range, speed, power, and efficiency in arm and wrist motion, producing a full sound with minimized mallet stroke height. [3]

Mallet comes out of the hand to be snapped in by the fingers. Small to mid, out of hand.jpg
Mallet comes out of the hand to be snapped in by the fingers.

The stroke of each mallet in this grip uses a vertical motion, with the mallet acting as an extension of the forearm. This eliminates the supinated, rotating motion of the forearm used by many four-mallet players which can lead to wrist, elbow, and arm injuries. [2] Because of the looseness of the grip, the mallets are commonly wrapped with tape to increase friction and diameter size. This also helps to reduce clicking sounds between the sticks. Two fulcrum points are used, each relating to a mallet interval spread: "small to mid-range" and "mid-range to large.” [3]

Small to mid-range spread

Fulcrum is between thumb and middle finger. Small to mid, third finger.jpg
Fulcrum is between thumb and middle finger.
Tight spread Small Spread.jpg
Tight spread

The fulcrum of the small to mid-range spread is located between the third finger and thumb. The tip of the third finger is held to the thumb side of the outside mallet to control the outside mallet and keep it in the palm of the hand. The thumb and second finger are held in a straight position along the inside mallet as it moves in a vertical upward-downward motion. The third finger is used to control the inside mallet as it comes out of the hand and to snap it back in.

Small-mid range inside mallet stroke.gif
Small to mid-range spread Small to Mid-Range Spread.jpg
Small to mid-range spread

To control the outside mallet stroke, the third and fourth fingers are used. [3]

Outside mallet is controlled by the third and fourth fingers. Small to mid, outside mallet.gif
Outside mallet is controlled by the third and fourth fingers.

Mid-range to large spread fulcrum

Full Spread Full Spread.jpg
Full Spread
Fulcrum is between the thumb and index finger. Outside mallet tip is out of the hand. Full spread, 2nd finger fulcrum.jpg
Fulcrum is between the thumb and index finger. Outside mallet tip is out of the hand.

The fulcrum of the mid-range to large spread is located between the thumb and the first joint of the second finger, like matched grip with a drumstick. The tip of the outside mallet is not held by the third finger and comes out of the palm of the hand to form a right angle with the inside mallet, almost perpendicular to the forearm. [2] The third, fourth, and fifth fingers are used to control the inside mallet and snap it back into the palm. [3]

Fulcrum is between the thumb and index finger. Outside mallet tip is out of the hand. Third, fourth, and fifth fingers manipulate the stroke. Full spread, inside mallet stroke.gif
Fulcrum is between the thumb and index finger. Outside mallet tip is out of the hand. Third, fourth, and fifth fingers manipulate the stroke.

The outside mallet is controlled by the third finger in conjunction with a pronated forearm movement. [2]

Outside mallet is controlled by middle (third) finger with pronated movement in the wrist, pivoting along the inside mallet. Full spread, outside mallet.gif
Outside mallet is controlled by middle (third) finger with pronated movement in the wrist, pivoting along the inside mallet.

Playing chords

This grip facilitates playing high-velocity chord strokes using minimal motion in the wrists and arms. When playing a chord stroke, the mallets will start close to the bars of the vibraphone. They are pulled up using a subtle inward wrist motion and snapped down by the fingers. For a very full-sounding stroke, the mallets are allowed to come all the way out of the hand to reach a right angle perpendicular to the bars and are snapped down by the fingers. In combination with wrist and forearm movement this motion has the potential for a high-velocity, full-sounding chord stroke. [2]

The wrist "flicks" the mallets up so that the fingers can snap them down. Chords.gif
The wrist "flicks" the mallets up so that the fingers can snap them down.

Power and speed

Inside mallets pivot off the outside in the full spread. The fulcrum is between thumb and index finger. Full Spread-Inside Mallets.gif
Inside mallets pivot off the outside in the full spread. The fulcrum is between thumb and index finger.

The greatest level of power and speed is achieved by using the inside mallets in the full spread position, with the fulcrum between the thumb and index finger. This method allows maximum stroke height with minimal motion in wrist and arms, similar to two-mallet technique. The outside mallet forms a right angle that the inside mallet pivots off of. [2]

The power afforded to the inner mallets allows the player to use all four mallets when playing melodies, rather than just two leading mallets. This is achieved by smoothly transitioning between the two fulcrum points and various spreads to use each mallet comfortably and efficiently. [2]

See also

Related Research Articles

<span class="mw-page-title-main">Marimba</span> Wooden keyboard percussion instrument

The marimba is a musical instrument in the percussion family that consists of wooden bars that are struck by mallets. Below each bar is a resonator pipe that amplifies particular harmonics of its sound. Compared to the xylophone, the timbre of the marimba is warmer, deeper, more resonant, and more pure. It also tends to have a lower range than that of a xylophone. Typically, the bars of a marimba are arranged chromatically, like the keys of a piano. The marimba is a type of idiophone.

<span class="mw-page-title-main">Vibraphone</span> Mallet percussion instrument

The vibraphone is a percussion instrument in the metallophone family. It consists of tuned metal bars and is typically played by using mallets to strike the bars. A person who plays the vibraphone is called a vibraphonist,vibraharpist, or vibist.

<span class="mw-page-title-main">Thumb</span> First digit of the hand

The thumb is the first digit of the hand, next to the index finger. When a person is standing in the medical anatomical position, the thumb is the outermost digit. The Medical Latin English noun for thumb is pollex, and the corresponding adjective for thumb is pollical.

<span class="mw-page-title-main">Drum roll</span> Percussion technique

A drum roll is a technique used by percussionists to produce a sustained sound for the duration of a written note.

All drum figures are based upon three fundamental beats, technically called roll, single stroke, and flam...Sustentation is accomplished upon wind instruments by blowing into the instrument; it is accomplished upon the violin and the allied instruments by drawing the bow across the string; it is accomplished upon the drum and allied percussion instruments by the roll.

THE SNARE DRUM ROLL.

The roll consists of an even reiteration of beats sufficiently rapid to prohibit rhythmic analysis. To produce an impression of sustentation, these beats must be absolutely even both in power and in sequence. Uneven beats in a roll destroy the impression of sustentation. Evenness is then the primary quality to strive for in roll; speed is the secondary quality to strive for.

There are two possible ways of producing an absolutely even sequence: (1) hand alternation of single stroke and (2) hand alternation of double strokes...The snare drum roll is produced by hand alternation of double strokes.

The "open roll" is produced by [initially] slow hand alternation. Two strokes in each hand alternately are produced by wrist movement and each beat should follow its predecessor in clock-like precision.

<span class="mw-page-title-main">Percussion mallet</span> Object used to strike or beat a percussion instrument

A percussion mallet or beater is an object used to strike or beat a percussion instrument in order to produce its sound.

<span class="mw-page-title-main">Strike (attack)</span> Directed physical attack

A strike is a directed physical attack with either a part of the human body or with an inanimate object intended to cause blunt trauma or penetrating trauma upon an opponent.

<span class="mw-page-title-main">Circle changeup</span> Baseball pitch

In baseball, a circle changeup is a pitch thrown with a grip that includes a circle formation, hence the name circle changeup. The circle is formed by making a circle with the index finger, holding the thumb at the bottom of the ball parallel to the middle finger and holding the ball far out in the hand. The ball is thrown turning the palm out.

<span class="mw-page-title-main">Handle</span> Part of device designed to be held

A handle is a part of, or attachment to, an object that allows it to be grasped and manipulated by hand. The design of each type of handle involves substantial ergonomic issues, even where these are dealt with intuitively or by following tradition. Handles for tools are an important part of their function, enabling the user to exploit the tools to maximum effect. Package handles allow for convenient carrying of packages.

Stevens grip is a technique for playing keyboard percussion instruments with four mallets developed by Leigh Howard Stevens. While marimba performance with two, four, and even six mallets had been done for more than a century, Stevens developed this grip based on the Musser grip, looking to expanded musical possibilities. Stevens codified his grip and his approach to performance techniques developed during his studies at the Eastman School of Music in his 1979 book, Method of Movement for Marimba. In this book, Stevens explains that his grip is an evolution of the Musser grip, and it is sometimes called the Musser-Stevens grip.

<span class="mw-page-title-main">Burton grip</span> Type of four-mallet technique

The Burton grip is a method of holding two mallets in each hand in order to play a mallet percussion instrument, such as a marimba or a vibraphone, using four mallets at once. It was developed by jazz vibraphonist Gary Burton around the 1960s.

Wrist spin is a type of bowling in the sport of cricket. It refers to the cricket technique and specific hand movements associated with imparting a particular direction of spin to the cricket ball. The other spinning technique, usually used to spin the ball in the opposite direction, is finger spin. Wrist spin is bowled by releasing the ball from the back of the hand, so that it passes over the little finger. Done by a right-handed bowler, this imparts an anticlockwise rotation to the ball, as seen from the bowler's perspective; a left-handed wrist spinner rotates the ball clockwise.

<span class="mw-page-title-main">Anatomical terms of motion</span> Terms describing animal motion

Motion, the process of movement, is described using specific anatomical terms. Motion includes movement of organs, joints, limbs, and specific sections of the body. The terminology used describes this motion according to its direction relative to the anatomical position of the body parts involved. Anatomists and others use a unified set of terms to describe most of the movements, although other, more specialized terms are necessary for describing unique movements such as those of the hands, feet, and eyes.

The Moeller method, Moeller technique or whipping technique is a percussive stroke method that combines a variety of techniques with the goal of improving hand speed, power, and control while offering the flexibility to add accented notes at will.

Fulcrum is a drumming term. Traditionally, the fulcrum is said to denote the part of a percussionist's grip that is the main lever for the drumstick/mallet to rotate. This is usually created by the thumb + index finger, the thumb + middle finger, or a combination of the index, middle, and thumb.

In the sport of ten-pin bowling, there are many different ways in which to deliver the bowling ball in order to advance it toward the pins in an accurate and powerful manner. Generally, there are three basic forms of 10-pin bowling. The most basic form is known as stroking, which is the most classic form. The most powerful form is known as cranking, which imparts great leverage and maximum rotation on the ball, but sacrifices accuracy. In between the two is the domain of the tweener, who has characteristics of both, but does not truly fit into either category. A well-known variant of "tweening" is the power stroker.

<span class="mw-page-title-main">Hand</span> Extremity at the end of an arm or forelimb

A hand is a prehensile, multi-fingered appendage located at the end of the forearm or forelimb of primates such as humans, chimpanzees, monkeys, and lemurs. A few other vertebrates such as the koala are often described as having "hands" instead of paws on their front limbs. The raccoon is usually described as having "hands" though opposable thumbs are lacking.

<span class="mw-page-title-main">Golf swing</span> Action of a golf player hitting the ball with a golf club

The golf swing is the action by which players hit the ball in the sport of golf. The golf swing is a complex motion involving the whole body; the technicalities of the swing are known as golf stroke mechanics.

Damping is a technique in music for altering the sound of a musical instrument by reducing oscillations or vibrations. Damping methods are used for a number of instruments.

<span class="mw-page-title-main">Grip (percussion)</span>

In percussion, grip refers to the manner in which the player holds the percussion mallet or mallets, whether drum sticks or other mallets.

References

  1. Porter, Joe. “A New Six-Mallet Marimba Technique and Its Pedagogical Approach”, MA thesis, University of Lethbridge, 2011, pp 9.
  2. 1 2 3 4 5 6 7 Saindon, Ed. "The Fulcrum Grip". Percussive Notes, Nov. 2008, pp. 42-43.
  3. 1 2 3 4 Menasché, Emile. “The Fulcrum Grip”. Drum Corps International Magazine, Fall 2009. pp. 38.

Further reading