Development | |
---|---|
Designer | Alex McGruer |
Location | Canada |
Year | 1969 |
No. built | 400 |
Builder(s) | Grampian Marine |
Name | Grampian 30 |
Boat | |
Displacement | 8,600 lb (3,901 kg) |
Draft | 4.67 ft (1.42 m) |
Hull | |
Type | Monohull |
Construction | Fiberglass |
LOA | 29.75 ft (9.07 m) |
LWL | 25.50 ft (7.77 m) |
Beam | 9.50 ft (2.90 m) |
Engine type | Universal Atomic 4 gasoline engine |
Hull appendages | |
Keel/board type | fin keel |
Ballast | 3,870 lb (1,755 kg) |
Rudder(s) | internally-mounted spade-type rudder |
Rig | |
Rig type | Bermuda rig |
I foretriangle height | 36.90 ft (11.25 m) |
J foretriangle base | 11.00 ft (3.35 m) |
P mainsail luff | 31.00 ft (9.45 m) |
E mainsail foot | 12.00 ft (3.66 m) |
Sails | |
Sailplan | Fractional rigged sloop |
Mainsail area | 202.95 sq ft (18.855 m2) |
Jib/genoa area | 186.00 sq ft (17.280 m2) |
Total sail area | 388.95 sq ft (36.135 m2) |
The Grampian 30 is a Canadian sailboat, that was designed by Alex McGruer and first built in 1969. [1] [2]
The design was built by Grampian Marine in Canada between 1969 and 1977, with a total of 400 examples completed. The design is now out of production. [1] [3]
The Grampian 30 is a small recreational keelboat, built predominantly of fiberglass, with wood trim. It has a masthead sloop rig, a raked stem, a reverse transom and an internally-mounted spade-type rudder controlled by a wheel. It may be fitted with a fixed fin keel or, optionally a centreboard and stub keel. It displaces 8,600 lb (3,901 kg) and carries 3,870 lb (1,755 kg) of ballast. [1]
The boat has a draft of 4.67 ft (1.42 m) with the standard keel fitted. The centreboard version has a draft of 7.00 ft (2.13 m) with the centreboard extended and 3.00 ft (0.91 m) with it retracted, allowing ground transportation on a trailer. [1]
A tall mast version was also produced that has a mast about 4.5 ft (1.4 m) higher. [1]
The boat is fitted with a Universal Atomic 4 gasoline engine. The fuel tank holds 10 U.S. gallons (38 L; 8.3 imp gal) and the fresh water tank has a capacity of 15 U.S. gallons (57 L; 12 imp gal). [1]
The centreboard version has a PHRF racing average handicap of 201 with a high of 180 and low of 216. The tall mast model has a PHRF racing average handicap of 195 with a high of 186 and low of 207. All models have hull speeds of 6.77 kn (12.54 km/h). [4] [5] [6]
A Grampian 30 was run aground off Cape Hatteras in a severe storm. The crew remained on board while the boat was laid on its side for four hours as they had no escape in the storm. After the storm had abated and the tide went out, the boat was left high and dry. When the tide came back in the boat was floated off the shore. Back in port the only damage found was bent keel bolts. [7]
In a review Michael McGoldrick wrote, "Regardless of their size category, the various Grampian models have one thing in common - they offer a lot of boat for relatively little money... Some people find that it isn't the sleekest looking sailboat, and that its appearance may be a little dated, but the Grampian 30 is very much a modern 30 foot production fiberglass sailboat of the 1970s. While it has been suggested that this model doesn't quite live up to the Grampian 26's reputation as a good sailing boat, it does have a nice interior layout with loads of room." [8]
Similar sailboats
The Catalina 30 is a series of American sailboats, that were designed by Frank Butler and later by Gerry Douglas.
The Hunter 23 is an American trailerable sailboat, that was designed by Hunter Marine and first built in 1985.
The Nonsuch 26 is a Canadian sailboat, that was designed by Mark Ellis and first built in 1981. It is one of the series of Nonsuch sailboats.
The Hunter 306 is an American sailboat design, that was introduced in 2001.
The C&C 35, also called the Redwing 35, is a Canadian sailboat, that was designed by Cuthbertson & Cassian and first built in 1969.
The CS 30 is a Canadian sailboat, that was designed by Tony Castro and first built in 1984. The design is out of production.
The Mirage 30 is a Canadian sailboat, that was designed by American Robert Perry and first built in 1983. The design is out of production.
The DS-22 is a Canadian trailerable sailboat, that was designed by Bruce Kirby and first built in 1983.
The Alberg 30 is a Canadian sailboat, that was designed by Carl Alberg and first built in 1962.
The Viking 28 is a Canadian sailboat, that was designed by Cuthbertson & Cassian and first built in 1968.
The Aloha 30 is a Canadian sailboat, that was designed by Ron Holland and first built in 1986.
The C&C 32 is a Canadian sailboat, that was designed by C&C Design and first built in 1981.
The C&C 37 is a Canadian sailboat, that was designed by Robert W. Ball of C&C Design and first built in 1981.
The C&C 40 is a series of Canadian sailboats, that were all designed by C&C Design and first built in 1968.
The Aloha 28 is a Canadian sailboat, that was designed by Edward S. Brewer and Robert Walstrom and first built in 1972.
The Grampian 26 is a Canadian sailboat, that was designed by Alex McGruer and first built in 1967.
The Discovery 7.9 is a Canadian sailboat, that was designed by Alex McGruer and first built in 1975.
The Nonsuch 30 is a Canadian sailboat that was designed by Mark Ellis and first built in 1978. It was the first the series of Nonsuch sailboats and was scaled upwards and down, to form a complete line of boats, from the Nonsuch 22 to the Nonsuch 40.
The C&C 41 is a Canadian sailboat, that was designed by Robert W. Ball at the request of Jim Plaxton, who had purchased C&C Yachts in 1981. Plaxton wanted an International Offshore Rule racer and the resulting design went into production in 1981.
The Hunter 30 is an American sailboat that was designed by John Cherubini as a cruising boat and first built in 1973.