| LFU 205 | |
|---|---|
 | |
| Role | Experimental light aircraft |
| National origin | West Germany |
| Manufacturer | Leichtflugtechnik-Union (LFU) |
| First flight | 29 March 1968 |
| Status | Museum display |
| Primary user | Deutsches Zentrum für Luft- und Raumfahrt (DLR) |
| Number built | 1 |
The LFU 205 is a single-engined, four-seat, low-wing monoplane, that was built in the late 1960s entirely from glass reinforced plastic.
The Leichflugtechnik-Union (LFU) was a consortium formed by the Bölkow, Pützer and Rhein-Flugzeugbau companies specifically to produce an aircraft built entirely of glass reinforced plastic (GRP). The result, the LFU 205 was one of the first all-grp light aircraft. [1]
The LFU 205 is a single-engined, low-winged monoplane of conventional appearance apart from slight, 7° forward sweep on the moderately tapered wing. This carries Fowler flaps along the whole trailing edge inboard of the Frise ailerons. The tail surfaces are also straight tapered, with the vertical surfaces slightly swept. The tailplane is a single piece, all moving surface. There are two pairs of side by side seats under a large curved, rearward sliding, canopy. Fuselage and flying surfaces are monocoque structures using a grp sandwich with a smooth outer surface bonded to a corrugated inner skin, the latter formed from parallel 10 mm (0.4 in) tubes wrapped in glass fibre. The corrugations run chordwise, rib-like, in the wings and tail and circumferentially in the fuselage. The tail structures have a foam plastic core. [1] [2]
It is powered by a flat 4-cylinder, 200 hp (150 kW) Lycoming IO-360 engine and has a tricycle undercarriage with inward retracting main legs and an aft retracting nosewheel. [1] [2] The first flight was on 29 March 1968. [1]
The LFU 205 was intended as an experimental aircraft and only one was built. The initial flying programme was to test the constructional methods. [1] Since 1984 it has flown with the German Aerospace Centre (DLR) at Brunswick, Germany. It has been used in a research program into laminar flow aerofoils by fitting a "glove" of the new profile over the wings of the LFU 205 in the central sections inboard of the ailerons on both sides. One prime interest is in the transition region between laminar and turbulent flow, studied using infra-red imaging. The gloved regions are also instrumented to gain data on pressure and drag distributions and boundary layer behaviour. [3]
Data from The Observer's Book of Aircraft 1969 [1]
General characteristics
Performance
The Schneider ES-65 Platypus is a two-seater unflapped glider designed and built by Edmund Schneider Pty in Australia. A single prototype was built, which remains operational as of 2012.
The Aquila A 210 is a two-seat reinforced plastic light aircraft produced in Germany from 2002. It remains in production in 2022 as the updated A211.
The Bartini Stal-7 was a twin-engined transport aircraft designed and produced in the Soviet Union from 1934.
The Slingsby T.50 Skylark 4 was a British single seat competition glider built by Slingsby Sailplanes in the early 1960s. It sold in numbers and had success at national, though not world level competition.
The Polyt V is a single-engined, single-seat glider tug designed and built by graduates and students of the Technical University of Denmark. Only one was constructed but it has had a long active life.
The Johansen CAJO 59 was a Danish twin-engined amphibious flying boat. Built in the late 1960s, it achieved certification but did not go into production.
The Dyn'Aéro CR.100 is a French kit built single engine, two-seat monoplane, developed in the 1990s and intended as both an aerobatic trainer and a tourer, primarily for aero club use.
The I.S.T. L-17 Masang was a two-seat, single engine, low wing monoplane aircraft designed and built in the Philippine Republic in the mid-1950s. It was intended for both touring and training.
The Akaflieg Darmstadt D-34 sailplanes were a series of experimental single seat sailplanes, designed at the University of Darmstadt in the 1950s and early 1960s to explore the structural and aerodynamic advantages of the then emerging plastics and composite materials.
The Akaflieg Darmstadt D-40 is an experimental variable geometry single seat sailplane, fitted with almost full span, camber changing flaps for optimum aerodynamics in weak thermals and integrated into the wing so as to minimise flap tip drag. One flew successfully but the D-40, like other variable geometry sailplanes, was not commercialised.
The HKS-1 was a German 19 19 m (62.3 ft) span high performance two seat sailplane, designed around 1950 to use recent advances in laminar flow airfoils. To avoid premature transition from laminar flow caused by surface interruptions, the HKS-1 dispensed with hinged ailerons, flaps and spoilers and replaced them with a flexible trailing edge. Two were built, setting several records.
The experimental Hirth Hi-25 Kria was only the second glider constructed from glass reinforced plastic (GRP). Built in Germany in 1958, it was a single seat, 12 m (39.4 ft) span aircraft. Only one was built; it later flew for several years with Akaflieg Stuttgart.
The Ellison-Mahon Gweduck or Geoduck is an American twin-engine amphibious aircraft, built from composites to resemble the Grumman Widgeon.
The Kirigamine Mita is a training glider, seating two in tandem, designed in Japan in the early 1960s. A modified version, first flown in 1966, was produced in modest numbers.
The Kawasaki KAL-2 is a Japanese four/five seat, single engine aircraft, designed for both military and civil markets in the mid-1950s. Only two were completed.
The SGP M-222 Flamingo was an Austrian twin engine, four seat light aircraft, developed with a series of prototypes into the early 1960s. There was no series production.
The Nippi NP-100 Albatross was a Japanese two side-by-side seat motorized glider, powered by a ducted fan rather than the usual propeller. It did not go into production.
The Stephens Akro is a single engine monoplane designed in the United States for aerobatic competitions. It first flew in 1967 and proved very successful, leading to several developments of which one won seven US Championships and one World Championship between 1975 and 1982. The Extra EA-230 and Extra EA-300 were also Akro developments with over two hundred built.
The Speedtwin E2E Comet 1, originally named the Phillips ST1 Speedtwin, is a two-seat, twin engined aircraft designed in the UK to be capable of aerobatics and the only civil twin certified for intentional spinning. After a long development time, just two have been built.
The VFW-Fokker FK-3 is a single seat competition glider, built in Germany in the late 1960s. It had success at the Italian and Austrian national contests of 1968, resulting in a short production run the following year.
Media related to LFU 205 at Wikimedia Commons