Van's Aircraft RV-9

Last updated

RV-9
VansRV-9AC-FBVP10.jpg
Van's Aircraft RV-9A
General information
Type Kit aircraft
National originUnited States
Manufacturer Van's Aircraft
Designer
Number built1173 (November 2022) [1]
History
Introduction dateEarly 2001 [2]
First flightDecember 1997 [3]

The Van's RV-9 and RV-9A are American two-seat, single-engine, low-wing homebuilt airplanes sold in kit form by Van's Aircraft of Aurora, Oregon. The RV-9 is the tail-wheel equipped version while the RV-9A features a nose-wheel. [4] [5] [6]

Contents

The RV-9 was built around a newly designed high aspect ratio wing, featuring a Roncz airfoil. It is similar in size and weight to the RV-6 and is externally similar to the RV-6 and the RV-7. [3] [7]

Development

2006 amateur built RV-9A G-CCZY-RV9A-Popham-4372.jpg
2006 amateur built RV-9A

The architect of the line of Van's aircraft, Richard VanGrunsven, designed the RV-9 as a departure from the concepts of the earlier RV series. The earlier members of the RV series, starting with the single seat RV-3, were all designed to have light handling, aerobatic capabilities along with high cruise speeds and short takeoff and landing (STOL) capabilities. The RV-9 was designed from the start as a two-place, side-by-side, touring aircraft and as such it forgoes the aerobatic capabilities and the lighter handling for more stability and economy. As such the design horsepower is 118–160 and the prototype was flown with a Lycoming O-235 powerplant of 118 hp (88 kW) as a proof-of-concept for the lower horsepower. [6]

As a result of the lessons learned over the years in producing the first five RV-series designs and the change in role for this aircraft, the RV-9 design incorporated many changes over previous designs.

The RV-9A was the first to use what Van's calls "matched-hole" components in that airframe parts are formed to the required contour and have all the rivet holes precisely located. The assembly jigs normally used to ensure alignment are not necessary and build time is much reduced. Later models, such as the RV-7 and RV-10, use this same manufacturing technique.

Compared to the similar RV-7, the RV-9 has a wing of increased span and higher aspect ratio using a Roncz airfoil. The RV-9 has a low stall speed, comparable to the Cessna 150, and docile handling suitable for low-time pilots. The cruise speed is a very respectable 167 mph (269 km/h) TAS even with the 118 hp (88 kW) engine. [6]

The RV-9 was offered after the RV-8, but before the RV-7 and shares many common parts with both aircraft, which reduces production costs. Like those aircraft, the RV-9 uses computer assisted design to produce a kit with pre-drilled rivet holes, thus greatly reducing assembly time for the builder.

The RV-9 is unique in Van's aircraft history in that the tricycle gear RV-9A version was flown first on June 15, 2000, three years before the tail wheel version flew. The later conventional landing gear equipped RV-9 was first flown by its designer in 2002. The RV-9A features solid circular spring steel landing gear with the nosewheel mounting tube welded to the engine mount. As in all nose-wheel equipped RV aircraft, the nosewheel is free castering and the aircraft is steered with differential braking. The brakes are mounted conventionally on the rudder pedal toes.

As of November 2022, 1173 RV-9s and RV-9As have been completed and flown. [1]

Specifications (RV-9A with Lycoming O-320)

An RV-9A - the nose wheel equipped version of the RV-9 at an ice strip fly-in near Ottawa, Ontario 2005 VansRV-9AC-GYXR04.jpg
An RV-9A – the nose wheel equipped version of the RV-9 at an ice strip fly-in near Ottawa, Ontario 2005

Data from Van's Aircraft [8] [9]

General characteristics

Performance

See also

Related development

Aircraft of comparable role, configuration, and era

Related Research Articles

<span class="mw-page-title-main">Barrows Bearhawk</span> American homebuilt aircraft

The Bearhawk, now also called the Bearhawk Four, is an American amateur-built aircraft, designed by Bob Barrows and produced by Bearhawk Aircraft of Fairview, OKlahoma. The aircraft is supplied as a kit or as plans for amateur construction.

<span class="mw-page-title-main">Thorp T-18</span> American homebuilt aircraft

The Thorp T-18 is an American, two-place, all-metal, plans-built, homebuilt aircraft designed in 1963 by John Thorp.

<span class="mw-page-title-main">Van's Aircraft RV-4</span> American kit aircraft

The Van's RV-4 is an American light homebuilt aircraft supplied in kit form by Van's Aircraft of Aurora, Oregon. It seats two people in a tandem seating configuration with the pilot accommodated in the front seat.

<span class="mw-page-title-main">Van's Aircraft RV-10</span> American kit aircraft

The Van's Aircraft RV-10 is a four-seat, single-engine, low-wing homebuilt airplane sold in kit form by Van's Aircraft. It is the first four-seat airplane in the popular RV series. The RV-10 first flew on 29 May 2003, and the first kit parts were delivered to a customer in September 2003.

<span class="mw-page-title-main">Van's Aircraft RV-7</span> American kit aircraft

The Van's RV-7 and RV-7A are two-seat, single-engine, low-wing homebuilt airplanes sold in kit form by Van's Aircraft. The RV-7 is the tail-wheel equipped version, while the RV-7A features a nose-wheel.

<span class="mw-page-title-main">Van's Aircraft RV-8</span> American kit aircraft

The Van's RV-8 is a tandem two-seat, single-engine, low-wing homebuilt aircraft sold in kit form by Van's Aircraft. The RV-8 is equipped with conventional landing gear, while the RV-8A version features tricycle landing gear. The design is similar to the earlier RV-4, although it is larger than that earlier model.

<span class="mw-page-title-main">Van's Aircraft RV-3</span> American kit aircraft

The Van's RV-3 is a single-seat, single-engine, low-wing kit aircraft sold by Van's Aircraft. Unlike many other aircraft in the RV line, the RV-3 is only available as a tail-wheel equipped aircraft, although it is possible that some may have been completed by builders as nose-wheel versions. The RV-3 is the genesis design for the rest of the RV series, all which strongly resemble the RV-3. The RV-4 was originally developed as a two-seat RV-3.

<span class="mw-page-title-main">Murphy Rebel</span>

The Murphy Rebel is a two- or three-seat, strut braced, high wing, taildragger monoplane which is sold in kit form by Murphy Aircraft in Chilliwack, British Columbia, Canada.

The Rans S-16 Shekari is an American single-engined, two-seat, low-wing, experimental amateur built aerobatic monoplane designed by Randy Schlitter, and produced by Rans Inc of Hays, Kansas, and sold as a kit for amateur construction.

<span class="mw-page-title-main">Phantom X1</span> Type of aircraft

The Phantom X1 is a single-engined, tractor configuration, single seat, cable-braced high wing tricycle gear-equipped ultralight aircraft that is produced by Phantom Aeronautics of Three Rivers, Michigan and available in kit form.

<span class="mw-page-title-main">Murphy Elite</span> Canadian homebuilt light aircraft

The Murphy Elite is a Canadian light aircraft that was designed and is produced by Murphy Aircraft of Chilliwack, British Columbia. The aircraft is supplied as a kit for amateur construction.

<span class="mw-page-title-main">Partenair Mystere</span> Canadian homebuilt light aircraft

The Partenair Mystere is a Canadian two-seat, pusher configuration monoplane that was designed by Partenair Design of Saint-Jean-sur-Richelieu, Quebec and intended for amateur construction from kits.

<span class="mw-page-title-main">Van's Aircraft RV-14</span> American homebuilt airplane

The Van's Aircraft RV-14 is an American aerobatic kit aircraft designed by Richard VanGrunsven and produced by Van's Aircraft. It was introduced at AirVenture in July 2012. The aircraft is supplied as a kit for amateur construction.

<span class="mw-page-title-main">Glasair GlaStar</span> American homebuilt airplane

The Glasair GlaStar is an American amateur-built aircraft that was designed by Tom Hamilton and produced by Stoddard-Hamilton Aircraft and later Glasair Aviation. It was first flown in 1994 and was superseded in production by the Glasair Sportsman 2+2 c. 2005. When it was available the aircraft was supplied as a kit for amateur construction.

<span class="mw-page-title-main">Stoddard-Hamilton Glasair II</span> American homebuilt light aircraft

The Stoddard-Hamilton Glasair II is an American amateur-built aircraft that was designed by Tom Hamilton and produced by Stoddard-Hamilton Aircraft and later Glasair Aviation as a kit for amateur construction. It was first flown in 1989, and remained in production in 2012.

The Aero Concepts Discovery is an American amateur-built aircraft, produced by Aero Concepts of Florida. The aircraft is supplied as a kit for amateur construction.

<span class="mw-page-title-main">Backcountry Super Cubs Super Cub</span> American homebuilt aircraft

The Backcountry Super Cubs Super Cub, also referred to as the Supercub replica, is an American amateur-built aircraft, designed and produced by Backcountry Super Cubs of Douglas, Wyoming. The aircraft is based on the design of the Piper PA-18 Super Cub and is supplied as a kit for amateur construction.

<span class="mw-page-title-main">Custom Flight North Star</span> Canadian homebuilt light aircraft

The Custom Flight North Star is a Canadian amateur-built aircraft, designed by Morgan Williams and produced by Custom Flight of Tiny, Ontario. The aircraft is based on the Piper PA-18 Super Cub and is supplied as a kit for amateur construction.

<span class="mw-page-title-main">Ravin 500</span> South African homebuilt aircraft

The Ravin 500 is a South African amateur-built aircraft, designed and produced by Ravin Aircraft of Pretoria. The aircraft first flew on 15 September 2002 and is supplied as a kit for amateur construction or as a complete ready-to-fly aircraft.

The ARV Griffin is a Canadian homebuilt aircraft that was designed by Dave Marsden of the University of Alberta and produced by Canada Air RV and later by AC Millennium Corp, both of Edmonton. When it was available the aircraft was supplied as a kit for amateur construction.

References

  1. 1 2 Vans Aircraft (November 2022). "First Flights" . Retrieved November 18, 2021.
  2. ↑ Van's Aircraft. "Making the Decision - Kit Prices / Lead Times". vansaircraft.com. Archived from the original on March 30, 2001. Retrieved March 27, 2021.
  3. 1 2 Van's Aircraft (2008). "Introduction - About RV Kitplanes". Archived from the original on March 9, 2012. Retrieved September 21, 2008.
  4. ↑ Downey, Julia: 2008 Kit Aircraft Directory, Kitplanes, Volume 24, Number 12, December 2007, page 78. Primedia Publications. ISSN   0891-1851
  5. ↑ Vandermeullen, Richard: 2011 Kit Aircraft Buyer's Guide, Kitplanes, Volume 28, Number 12, December 2011, page 74. Belvoir Publications. ISSN   0891-1851
  6. 1 2 3 Bayerl, Robby; Martin Berkemeier; et al: World Directory of Leisure Aviation 2011–12, page 125. WDLA UK, Lancaster UK, 2011. ISSN   1368-485X
  7. ↑ Van's Aircraft (n.d.). "Van's RV-9/RV-9A" . Retrieved September 30, 2013.{{cite web}}: CS1 maint: year (link)
  8. ↑ Van's Aircraft (2008). "Specifications" . Retrieved September 30, 2013.
  9. ↑ Van's Aircraft (n.d.). "Performance" . Retrieved September 30, 2013.{{cite web}}: CS1 maint: year (link)
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.