Wainfan Facetmobile

Last updated

FMX-4 Facetmobile
Facetmobile.png
The FMX-4 Facetmobile in flight
RoleHomebuilt Aircraft
National originUnited States
DesignerBarnaby Wainfan
First flightApril 22, 1993
Number built1

The Wainfan FMX-4 Facetmobile is an American homebuilt aircraft designed by Barnaby Wainfan, a Northrop Grumman aerodynamicist and homebuilt aircraft engineer.

Contents

While only one Facetmobile prototype was produced, it has become well known due to its unique nature. [1] The aircraft is unusual in that it is a lifting body – the whole aircraft acts as a low aspect ratio wing: a flat, angular lifting shape, unlike traditional aircraft which use distinct lift-generating wings attached to a non-lifting fuselage. [2] Also notably the aircraft's shape is formed of a series of 11 flat surfaces, somewhat similar to the body of the F-117 Nighthawk jet strike aircraft in using flat plates, but without separate wing structures. Although aerodynamic efficiency is reduced due to the simplistic shaping, that shaping reduces structural weight, improving payload mass fraction. [3]

Design and development

Shape

The FMX-4 Facetmobile shape forms 11 flat planes, plus two wingtip rudders. Three flat shapes form the bottom of the aircraft (slightly inclined front, flat middle, and sharply raised back), and eight form the top (one large downwards-sloping rear section, one thin nose section, and three inclined side panels per side). The wing section is an 18% thickness ratio, much thicker than the typical 12-15% thickness of normal light aircraft wings. At least one commercial model airplane kit of the Facetmobile is in production. [4]

The prototype FMX-4 Facetmobile crashed on October 13, 1995, after an in-flight engine failure. The aircraft landed at low speed into a barbed wire fence, which caused extensive skin, engine, and some structural damage, though there was no injury to the pilot, Barnaby Wainfan. [5] As of 2006, the aircraft has been partially repaired but not flown again.

Structure

The Facetmobile structure is composed of 6061 aluminum tubing fastened with Cherrymax rivets. The fuselage uses conventional fabric covering. The aircraft uses elevons and rudders for control. The landing gear is a fixed tricycle type. The large windshield sections are augmented by two floor-mounted windows. The aircraft is boarded through a bottom-mounted hatch. The aircraft has a BRS parachute system installed.

Variants

Wainfan has proposed two derivative aircraft based on the FMX-4 Facetmobile.

Specifications (Facetmobile FMX-4)

Data from

General characteristics

Performance

See also

Aircraft of comparable role, configuration, and era

Related Research Articles

The Wings of Freedom Flitplane is an American single-seat, high-wing, single-engine ultralight aircraft that is available as a kit aircraft or as plans for amateur construction from Wings of Freedom of Hubbard, Ohio.

<span class="mw-page-title-main">Slingsby Skylark 3</span> British single-seat glider, 1957

The Slingsby T.43 Skylark 3 was a single seat Open Class sailplane developed from the Skylark 2 with an extended wingspan. It won the 1960 World Gliding Championships.

<span class="mw-page-title-main">Kolb Mark III</span> Type of aircraft

The Kolb Mark III is a family of American side-by-side two seater, high wing, strut-braced, pusher configuration, conventional landing gear-equipped ultralight aircraft that is produced in kit form by New Kolb Aircraft of London, Kentucky, and intended for amateur construction.

The Iannotta I-66L San Francesco is a 1960s Italian ultralight designed to be homebuilt from plans. It has been powered by several flat-four engines in the 65-100 hp range and built in both single and two-seat tandem configurations. Only small numbers have been completed.

<span class="mw-page-title-main">Avid Flyer</span> Type of aircraft

The Avid Flyer is a family of American single engine, high-wing, strut-braced, conventional landing gear-equipped, two seat ultralight aircraft designed for kit construction in the 1980s. Its several variants sold in large numbers. In 1987 a Flyer became the first ultralight to land at the North Pole.

The Aydlett A-1 was a one-off, homebuilt aircraft constructed in the US in the 1960s. It was a single seat, single engine monoplane of conventional appearance, with an enclosed cockpit.

The Ginn-Lesniak Kestrel is a one-off homebuilt two seat sailplane, designed in the United Kingdom in the 1950s and flown in 1969.

The Air Est JCD 03 Pelican is a French mid-wing, twin tailed, flying wing single-seat motor glider that was designed by Jean-Claude Debreyer and produced by Air Est Services of Marly, Moselle and supplied as a kit for amateur construction or as a complete aircraft.

The St Croix Excelsior is an American ultralight aircraft that was designed by Chad Wille and Charles Wille, produced by St Croix Aircraft of Corning, Iowa and first flown in 1980. The aircraft was supplied in the form of plans for amateur construction with some hard-to-make parts available as well as partial kits.

<span class="mw-page-title-main">Peyret-Mauboussin PM X</span> 1920s French light aircraft

The Peyret-Mauboussin PM X, PM 4 or Mauboussin M.10 was a low power, single-seat, high wing cantilever monoplane. Only one was built but it set several records in the under 250 kg (550 lb) class both as a landplane and a floatplane.

<span class="mw-page-title-main">Halsted BH-1 Saffire</span> Type of aircraft

The Halsted BH-1 Saffire is a homebuilt aircraft design introduced in the early 1990s.

<span class="mw-page-title-main">Verhees D-Plane 1</span> Belgian homebuilt aircraft

The Verhees D-Plane 1 is a Belgian homebuilt flying wing, designed by Verhees Engineering and supplied as plans for amateur construction.

The Bonomi BS.19 Alca was a single seat, tractor configuration motor glider, designed and built in Italy shortly before World War II. It had an unusual retractable undercarriage used only for take-offs. Only one was built.

<span class="mw-page-title-main">Scheibe Specht</span> German two-seat glider, 1953

The Scheibe Specht is a tandem seat training glider produced in Germany in the early 1950s. More than fifty were built.

The IIL IS-10 was a high-performance, single-seat glider, designed and built in Romania in the early 1960s. It was the first Romanian aircraft to use laminar flow airfoils.

The IIL IS-12 was a two-seat glider, designed and built in Romania in 1960. It had a wooden wing but a metal fuselage and was constructed in parallel with the all-wood IS-13 for comparative tests. It was later followed by the IS-13a, a version with an all-metal wing.

The Sea Storm is an Italian homebuilt amphibious flying boat that was designed and produced by Storm Aircraft of Sabaudia. Storm Aircraft was originally called SG Aviation srl. When it was available the aircraft was supplied as a kit for amateur construction.

The Piel CP-40 Donald is a French homebuilt, single engine, single seat, high wing aircraft. It was first flown in the early 1950s, though the last of the three examples completed did not fly until almost forty years later.

<span class="mw-page-title-main">Caproni Ca.95</span> Type of aircraft

The Caproni Ca.95 was a large, three engine, long range, heavy bomber prototype built in Italy in 1929. It could carry a 1,600 kg (3,500 lb) bomb load and had three defensive gun positions. Only one was built.

The MIP Smyk, MIP from the initials of its Polish designers with Smyk meaning Brat or Kid, was an aerodynamically refined motor glider designed and built at Warsaw Technical University from 1935.

References

  1. ↑ Jack Cox (October 1994). "The Facetmobile". Sport Aviation.
  2. ↑ Barnaby and Lynn Wainfan's Facetmobile page, accessed October 24, 2006
  3. 1 2 NASA LARC NAG-1-03054 "Feasibility Study of the Low Aspect Ratio All All-Lifting Configuration as a Low-Cost Personal Aircraft", Barnaby Wainfan and Hans Neiubert, February 2004, accessed October 24, 2006
  4. ↑ Incredible Facetmobile, accessed October 24, 2006
  5. ↑ Wise, Jeff (January 2005). "The Daring Visionaries of Crackpot Aviation -- Barnaby Wainfan: Aero Ace Piecing it Together". Popular Science.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.