The B.A. Eagle was a light aircraft manufactured in the United Kingdom during the 1930s. It was a three-seat low-wing monoplane built by the "British Klemm Aeroplane Company" (which later became known as the British Aircraft Manufacturing Co.) Production was limited, with 43 aircraft built.
The British Klemm Aeroplane Company developed the B.K.1 Eagle, a three-seat light aircraft as a follow-up to the British Klemm Swallow, its licensed copy of the Klemm L.25. While similar in many respects to the Klemm Kl 32, it was an entirely independent design produced by G. Handasyde, the chief designer of British Klemm. It performed its maiden flight during early 1934.[1] Six of this initial version of the Eagle were built.[1]
As was the case with the Swallow, a revised version was introduced in 1935 when British Klemm was renamed the British Aircraft Manufacturing Co. This version, the B.A. Eagle II had a revised rudder and a deepened rear fuselage. A total of 37 Eagle IIs were built, including a single example fitted with a fixed undercarriage.
Eagle II in 1936
Design
The British Aircraft Eagle was a low-wing wooden monoplane with an enclosed cabin for the pilot and two passengers and a retractable undercarriage. It was almost entirely composed of wood; one prominent exception was the limited use of steel tubing in the structure of the forward portion of the fuselage, which permitted the doors to be both shaped and positioned continently.[2] Furthermore, while the majority of the covering was plywood, some areas were made of fabric (such as on the control surfaces) instead for economic reasons. Both the wings and the tail unit featured a relatively high aspect ratio (on both vertical and horizontal surfaces for the latter).[3] The tail unit was furnished with a particularly compact horn balance on the rudder, which effectively concealed the mass balance that was then in favour amongst aeronautical experts of the era. The fin was wire-braced and had a plywood covering while the stabiliser was adjustable and had a similar plywood covering.[4]
The pilot was provisioned with an adjustable seat that was located directly above the forward spar.[5] Two passengers could be accommodated in relative comfort at the back of the cabin; a locker for the stowage of luggage, accommodating up to three suitcases, was located behind the rear seat. Conventional flight controls were present; a lever in the floor between rudder pedals was used to apply the brakes, differential application of which could be used to steer the aircraft.[5] The roof of the cabin featured a pair of innovative ventilation devices, positioned either side of the pilot, through which the rate of cool air could be adjusted; the cabin windows were also slidable. The roof also featured several glazed lights that permitted a good visibility towards the rear of the aircraft as well; opaque sections were present to provide shade.[2] The nose of the aircraft was intentionally shaped to facilitate a favourable frontal field of view from both the front and back seats.[2]
The aircraft had a low-mounted cantilever wing that had a gentle dihedral.[4] This wing, which was composed of wood, tapered in terms of chord, thickness, and fold about the rear spar. There was a single lever on either each side of the aircraft, which was normally locked in position by a covering flap, that withdraws the bolts in both upper and lower fittings.[4] Its structure comprised a pair of wooden box spars, stringers, and ribs along with a plywood covering. The wing was fitted with narrow tapered ailerons equipped with mass balances that buried into the undersides of the wing.[4]
From an aerodynamic perspective, considerable attention was directed towards the minimisation of drag by having the smallest number of external excrescences and by the careful positioning of various components to avoid interference; this purpose was behind both the arrangement and form of the fillets between the wings and fuselage.[6] In flight, the aircraft exhibited no tendency towards buffeting across a wide range of speeds and altitudes. When fully laden by the carriage of two passengers and their luggage, distances of up to 650 miles could be traversed by the aircraft.[7] It required a relatively short take-off distance, less than 200 yards; and would steadily climb at only 70 MPH; the typical landing speed was between 40 and 50 MPH, at which speeds the aircraft still retained considerable lateral control.[2]
The undercarriage could be deployed with relative ease, requiring only a few turns of the handle positioned to the right of the pilot.[7] The mechanism locked itself in place while a strap was present to prevent the handle from being unintentionally moved. An indicator positioned directly in front of the throttle visually displayed the position of the undercarriage.[6] The deployed undercarriage was relatively clean in comparison to its competitors; its retraction increased the aircraft's speed by roughly 18 MPH. Whether being retracted or deployed, the mechanism was smooth and fairly quiet, to the point where pilots would typically only be able to hear the retraction of the tail wheel.[6] Unlike most contemporary British retractable undercarriages, each leg of the undercarriage was mounted so that both the shock absorber and the strut behind swung outwards (rather than outwards) on universal joints; the wheels were housed entirely within the wings when retracted.[6] They were kept in position by lateral struts, the tops of which could freely to move up and down inclined guides in the wings. When deployed, these lateral struts were at such an angle that they tended to push the crossheads at their tops harder against stops.[6]
It was typically powered by a single de Havilland Gipsy Major four-cylinder piston engine, capable of producing up to 130 hp.[4] It was installed on a welded steel tube mount. Fuel was housed within two tanks composed of duralumin, each of which had a capacity of 20 gallons (91 liters), within the wings.[4] It was supplied to the engine using a pair of fuel pumps that could be operated independently or together. Oil was housed with a single tank, the capacity ranging from 2-1/2_gal1on (11.4-liter) to 4-gallon (18.2-liter), dependent upon the engine used; this tank was flush with the cowling so that it would be cooled by the slipstream produced by the aircraft in flight.[8]
Operational history
Eagles were mainly sold to private owners, with a few also being used by flying clubs or as executive transports. In India, the Nawab of Sachin operated an Eagle as his personal aircraft.[9] Eagles were also used for air racing, with several being entered into the King's Cup Races between 1935 and 1937. Single examples were also entered into the MacRobertson Air Race of 1934 between Britain and Australia and the 1936 Schlesinger Race between England and South Africa. Neither aircraft completed the races.[1]
At the outbreak of the Second World War, seven Eagles were pressed into Royal Air Force (RAF) service in the UK, with two in Australia and one in Kenya.[10] However, the undercarriages proved to be somewhat vulnerable during this time; numerous airframes were written off due to undercarriage-related failures.[1] Two aircraft survived the conflict were subsequently flown by civil owners in Australia.
Variants
B.K. Eagle
Initial production version, six built.
B.A. Eagle 2
Revised production version with modified structure, 37 built.
The Latécoère 28 was a long distance monoplane aircraft designed and produced by the French aircraft manufacturer Latécoère.
The Avia BH-21 was a fighter biplane designed and produced by the Czechoslovakian aircraft manufacturer Avia. First flown in January 1925, it served an important role in securing Czechoslovak national security during the Interwar period.
The Spartan Cruiser was a 1930s British three-engined transport monoplane for 6 to 10 passengers built by Spartan Aircraft Limited at East Cowes, Isle of Wight. It was a development of the Saro-Percival Mailplane for passenger use.
The Avia BH-11 was a two-seat monoplane sport aircraft designed and produced by the Czechoslovakian aircraft manufacturer Avia.
The Blériot 127 was a monoplane bomber aircraft developed and produced by the French aircraft manufacturer Blériot.
The Bréguet 390T, 392T and 393T were a family of French propeller-driven sesquiplane airliners designed and produced by the French aircraft manufacturer Bréguet.
The Caproni Ca.97 was a utility monoplane aircraft designed and produced by the Italian aircraft manufacturer Caproni. It had a range of powerplant arrangements, the aircraft could be flown with many as three radial engines, however, many were build with only the nose engine present or with only the two nacelle-mounted engines.
The Farman F.300 and F.310 were trimotor monoplane airliners designed and produced by the French aircraft manufacturer Farman Aviation Works.
The Fiat AS.1 was a light touring monoplane aircraft designed and produced by the Italian aircraft manufacturer Fiat.
The Hanriot H.43 was a military utility biplane designed and produced by the French aircraft manufacturer Hanriot. It was primarily used by the Aéronautique Militaire as a trainer aircraft during the interwar period.
The Nieuport-Delage NiD 640 was a four-passenger transport monoplane designed and produced by the French aircraft manufacturer Nieuport-Delage.
The Siebel Si 202 Hummel ("Bumble-bee") was a German light sportsplane of the late 1930s. It was an angular low-wing monoplane, which could be powered by a variety of small engines.
The Blackburn R.2 Airedale was a single-engine three-seat monoplane deck-landing aircraft for land and sea reconnaissance, built in the UK in 1924. Only two were built.
The de Havilland DH.81 Swallow Moth was aimed at the low-cost sporting aircraft market during the Great Depression. It was a single-engined two-seat low-wing monoplane; only one was built.
The Lemberger LD20b was a single-engine cantilever biplane designed to be easily towable behind a car. Built in Germany in 1971, it made several flights but did not enter production.
The I.S.T. XL-15 Tagak was a single-engine, twin-boom, high-wing monoplane designed after the I.S.T. XL-14 Maya and built in the Philippines in the mid-1950s. The result of a collaboration between a Government research institute and the Philippine Air Force, it was designed as a utility, liaison or ambulance aircraft and as a test bed for the use of local materials in aviation.
The Legrand-Simon LS.60 is a single-engine, high-wing monoplane seating two side-by-side. It was built in France in the early 1960s in response to a government competition for a club trainer. It won the competition but nevertheless failed to go into production; only the prototype, which still flies, was completed.
The Romano R.16 was a three engine, high wing monoplane designed for policing and other rôles in France's African colonies.
The CAMS 52 was a twin-engined floatplane torpedo-bomber. It was not ordered by the French Navy and only one CAMS 52 was completed. It first flew in the summer of 1930.
The Raab-Katzenstein RK.25 was a two-seat, low wing cantilever monoplane aircraft designed and built in Germany in the 1920s for fast touring. Three were built and one had some success in a 1928 international contest. Another was later re-engined and provided with cabin accommodation.
References
Citations
1 2 3 4 5 Jackson, Aubrey J. (1987). British civil aircraft, 1919-1972 Volume I (2nd., repr. with correctionsed.). London, UK: Putnam. pp.168–171. ISBN0851778089.
This page is based on this Wikipedia article Text is available under the CC BY-SA 4.0 license; additional terms may apply. Images, videos and audio are available under their respective licenses.
