Schweizer SGU 1-7

Last updated
SGU 1-7
Schweizer SGU 1-7 photo L'Aerophile April 1938.jpg
Role Open-class sailplane
National originUnited States
Manufacturer Schweizer Metal Aircraft Company
Designer Ernst and Paul Schweizer
First flight1937;87 years ago (1937) [1]
Number built2

The Schweizer SGU 1-7 is an American Open Class, single-seat, high-wing strut braced glider built by Schweizer Metal Aircraft Company of Elmira, New York. [2] [3]

Contents

The first 1-7 was built in 1937 and the second one was completed in 1939. [1] [3] [4]

The 1-7 was the first Schweizer aircraft which was produced as more than a single example and it was the first aircraft that the company sold. [2] [3]

Design and development

Schweizer Aircraft started construction of the 1-7 prototype 1937, shortly after the SGU 1-6 came in third in the 1937 Eaton Design Contest. The intention was that the winning design would be made available as drawings and kits for amateur construction and that Bureau of Air Commerce certification would be sought. [1]

The 1-6 had not fared well in the competition and none of the winners in the contest had proven as easy to construct as the contest organizers had hoped. As a result of the lessons learned in the Eaton contest a new clean-sheet design was started by the Schweizer brothers. [1]

The resulting single seater-seventh design (1-7) was quite different from the 1-6. The 1-6 had been an all-metal design including aluminum-covered wings and was the first all-metal glider ever built. [1]

The 1-7 was designed to use more traditional methods and has a steel-tube fuselage frame covered in aircraft fabric. The wing is a constant chord, single spar, strut-braced type, including jury struts. The wing and horizontal tail are built from aluminum with fabric covering. The aircraft was designed to be as simple and inexpensive as possible to construct, even at the cost of higher performance. [2]

The 1-7 design was never certified and both aircraft completed were registered as experimental amateur-built aircraft. [2] [4]

While only two Schweizer SGU 1-7s were built the type was the beginning of a long line of Schweizer gliders based upon this design. The 1-7 lead directly lead to the improved single place Schweizer SGU 1-19 and long-wing Schweizer SGU 1-20. With two seats installed the basic design became the Schweizer SGU 2-22 trainer and finally evolved into the Schweizer SGS 2-33. [1] [2]

Operational history

SGU 1-7 serial number 1 was completed in 1937. [1] It was later destroyed by mistake as scrap. [2]

SGU 1-7 serial number 2 was completed in 1939 and registered as N23026. [4] It had a long and storied career, [2] until its flight certificate expired in 2017. [5]

The aircraft was originally sold to the Altosaurus Soaring Club of North Conway, New Hampshire for USD$595. [6] This club was formed by a group of Harvard University skiers from the Schussverien Ski Club. They used the single-seat 1-7 to teach themselves to fly by auto tow and winch launch. The aircraft was thought by the club members to resemble a pterodactyl in flight and was painted with one on both sides of the aircraft's nose. [1]

The aircraft was sold in the 1950s to Lloyd Lichner then general manager of the Soaring Society of America, who flew it often in California, including at the cliff-soaring site at Torrey Pines. [2]

The aircraft was later owned by Ralph Heide of El Segundo, California in the 1980s. He carried out a complete restoration of the aircraft in the mid-1980s. [2]

Today 1-7 serial number 2 belongs to the National Soaring Museum. [3] [7]

Specifications

General characteristics

Performance

See also

Aircraft of comparable role, configuration, and era

Related lists

Related Research Articles

<span class="mw-page-title-main">Schweizer Aircraft</span> American aircraft manufacturer

The Schweizer Aircraft Corporation was an American manufacturer of sailplanes, agricultural aircraft and helicopters located in Horseheads, New York. It was incorporated in 1939 by three Schweizer brothers, who built their first glider, the SGP 1-1, in 1930. Previously the oldest privately owned aircraft company in the United States, Schweizer was acquired by Sikorsky Aircraft Corporation of Stratford, Connecticut in 2004, and became a diversified aerospace company. Schweizer Aircraft ceased operations in 2012. It was sold to Schweizer RSG in 2018 and production lines were opened in Fort Worth, Texas. The company was producing two helicopter models in 2021. The 300C and 300CBI

<span class="mw-page-title-main">Schweizer SGS 2-33</span> American training glider

The Schweizer SGS 2-33 is an American two-seat, high-wing, strut-braced, training glider that was built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 1-26</span> Type of aircraft

The Schweizer SGS 1-26 is a United States One-Design, single-seat, mid-wing glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGM 2-37</span> US touring motor glider, 1982

The Schweizer SGM 2-37 is a two-place, side-by-side, fixed gear, low wing motor glider.

<span class="mw-page-title-main">Schweizer SGU 1-6</span> Type of aircraft

The Schweizer SGU 1-6 was a United States Open Class, single-seat, high-wing, pod-and-boom glider built by Schweizer Metal Aircraft Company of Elmira, New York.

The Schweizer SGP 1-1 is an American, amateur-built, single-seat, high-wing primary glider that was designed by Ernest Schweizer and constructed by the Mercury Glider Club between 1929 and 1930.

<span class="mw-page-title-main">Schweizer SGS 2-8</span> Type of aircraft

The Schweizer SGS 2-8 is an American two-seat, mid-wing, strut-braced, training glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 2-12</span> Two-seat low-wing training glider

The Schweizer SGS 2-12 is a United States two-seat, low-wing, training glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGU 1-19</span> American family of gliders

The Schweizer SGU 1-19 and Schweizer SGU 1-20 are a family of United States single-seat, high-wing, strut-braced, utility gliders built by Schweizer Aircraft of Elmira, New York.

The Schweizer SGS 1-21 is a United States single-seat, mid-wing, Open Class glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGU 2-22</span> American glider

The Schweizer SGU 2-22 is an American two-seat, high-wing, strut-braced, training glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 1-24</span> Type of aircraft

The Schweizer SGS 1-24, also referred to as the Schweizer-Burr SGS 1-24, is a United States single-seat, mid-wing, Open Class competition glider built by Howard Burr and Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 1-34</span> Glider built by Schweizer Aircraft

The Schweizer SGS 1-34 is a United States Standard Class, single-seat, high-wing glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 1-29</span> American sailplane

The Schweizer SGS 1-29 is an American single-seat, mid-wing, experimental laminar flow airfoil glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 2-32</span> American glider

The Schweizer SGS 2-32 is an American two-seat, mid-wing, two or three-place glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 1-35</span> Type of aircraft

The Schweizer SGS 1-35 is a United States 15 Meter Class, single-seat, mid-wing glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schweizer SGS 1-36 Sprite</span> Type of aircraft

The Schweizer SGS 1-36 Sprite is a United States, single-seat, mid-wing glider built by Schweizer Aircraft of Elmira, New York.

<span class="mw-page-title-main">Schultz ABC</span> Type of aircraft

The Schultz ABC was a 1930s American glider designed by Arthur B. Schultz.

The Scanlan SG-1A is an American, single seat, pod-and-boom, high-wing, strut-braced glider that was designed by Thomas W. Scanlan in 1970 and sold in the form of plans for amateur construction.

<span class="mw-page-title-main">Hütter Hü 17</span> Utility train glider

The Hütter Hü 17, is a German high-wing, strut-braced, single-seat, utility training glider that was designed by brothers Ulrich Hütter and Wolfgang Hütter in the 1930s.

References

  1. 1 2 3 4 5 6 7 8 Schweizer, Paul A: Wings Like Eagles, The Story of Soaring in the United States, page 56. Smithsonian Institution Press, 1988. ISBN   0-87474-828-3
  2. 1 2 3 4 5 6 7 8 9 Said, Bob: 1983 Sailplane Directory, Soaring Magazine, page 26. Soaring Society of America, November 1983. USPS 499-920
  3. 1 2 3 4 Activate Media (2006). "SGU 1-7 Schweizer". Archived from the original on 2002-05-06. Retrieved 2008-04-15.
  4. 1 2 3 Federal Aviation Administration (April 2008). "FAA Registry" . Retrieved 2008-04-29.
  5. ↑ Federal Aviation Administration (April 2024). "FAA Registry" . Retrieved 2024-04-18.
  6. ↑ Schweizer Aircraft Corporation (2006). "Schweizer Aircraft Corporation History". Archived from the original on 2008-03-10. Retrieved 2008-05-02.
  7. ↑ Munson, J. (n.d.). "Sailplanes in Our Collection". Archived from the original on 2011-05-16. Retrieved 2008-04-29.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.