| L.I | |
|---|---|
 | |
| Role | Heavy bomber aircraft |
| National origin | Germany |
| Manufacturer | Siemens-Schuckert |
| First flight | 1918 |
| Number built | 3 |
The Siemens-Schuckert L.I was a large, three-engined biplane bomber aircraft, built in Germany towards the end of World War I. It was a twin boom design, strongly influenced by the successful Caproni Ca.3. Three were built but not used operationally.
In 1918 Idflieg ordered a bomber which was to follow the layout of the three engine, twin boom Italian Caproni designs. It was originally called the G.III but was eventually moved into a new L category, intermediate between G and R, [1] the only aircraft ever to be so classified. [2]
The L.I was a large biplane with a wingspan of 32 m (105 ft). The wing was straight edged and of constant chord and divided into two outer bays on each side by three sets of parallel interplane struts and diagonal flying wires. Ailerons were fitted to both upper and lower planes, projecting behind the upper trailing edge and externally rod connected. On each side a square section tailboom or fuselage was joined to the wing structure between the innermost interplane struts and the central nacelle by more complicated bracing. A tractor 240 hp (179 kW) Maybach Mb.IV six cylinder water cooled inline engine was mounted in the nose of each boom and there was a gunner's position in the boom just aft of the wing trailing edge, equipped with a Parabellum MG14 7.92 mm (0.312 in) calibre machine gun. [1] [2]
The L.I was flown from a cockpit in the short central nacelle, which had a third Maybach engine in pusher configuration at the rear and another Parabellum equipped gunner's position in its nose. The fixed conventional undercarriage had pairs of mainwheels mounted under each outer engine and a tailskid on each boom. It also had a substantial nosewheel, mounted on the nacelle, to protect the L.I from damaging noseovers. [1] [2]
Three L.Is were built but the type was not used operationally. [1]
Data fromGerman Aircraft of the First World War. [1]
General characteristics
Performance
Armament
The Caproni Ca.4 was an Italian heavy bomber of the World War I era.
The Caproni Ca.1 was an Italian heavy bomber of the World War I era.
The Caproni Ca.2 was an Italian heavy bomber of the World War I era.
The Caproni Ca.37 was a ground attack aircraft designed and built in Italy by Caproni around 1916
The Zeppelin-Staaken R.VI was a four-engined German biplane strategic bomber of World War I, and the only Riesenflugzeug design built in any quantity.
The Friedrichshafen G.I was a prototype heavy bomber aircraft that was built in Germany by Flugzeugbau Friedrichshafen in 1915. It was Karl Gehlen's first design for the company, and although it was not produced in quantity, it provided the foundation for the later, highly successful bombers culminating in the G.III.
The Friedrichshafen FF.34 was a German biplane floatplane of the 1910s produced by Flugzeugbau Friedrichshafen.
The Grahame-White Ganymede was a prototype British heavy night bomber intended to serve with the Royal Air Force in the First World War. A large, three-engined, twin-boom biplane, the sole prototype Ganymede did not fly until after the war had ended, and although an attempt was made to convert the aircraft to an airliner, it was unsuccessful.
The Bristol Type 6 T.T.A was a British two-seat, twin-engine biplane, designed in 1915 as a defence fighter. Two prototypes were built, but the T.T.A. did not go into production.
The Vickers Type 161 was an unusual 1930s pusher biplane interceptor, designed to attack aircraft from below with a single upward-angle large calibre gun. The aircraft flew well but the concept was abandoned and only one was built.
The Siemens-Schuckert R.II was a prototype bomber aircraft built in Germany during World War I. It was one of six aircraft based on the Siemens-Schuckert R.I that were originally intended to be identical, but which each developed in a different direction and were designated as different aircraft types by the German Inspectorate of Flying Troops. Although the R.II was the first of the batch to be completed, it was the last accepted into military service, and then only as a trainer.
The Zeppelin-Staaken Riesenflugzeuge were a series of very large bomber aircraft - Riesenflugzeuge, usually powered by four or more engines, designed and built in Germany from 1915 to 1919.
The Siemens-Schuckert DDr.I was a World War I German twin engine, push-pull configuration triplane fighter aircraft. Only one was built, crashing on its first flight.
The LFG Roland G.I was a large prototype single-engine biplane bomber built in Germany in 1915, during World War I. It had a single engine buried in the fuselage driving pusher configuration propellers mounted on outriggers.
The LVG G.III was a large, twin engine triplane bomber built in Germany near the end of World War I. Only one was completed.
The Schütte-Lanz G.I was a large, twin engine, pusher configuration, experimental biplane built in Germany early in World War I. Only one was completed.
The Caudron Type C was a single seat French biplane, intended for military evaluation. Two were built in 1911.
The Caudron Type D was a French pre-World War I single seat, twin-boom tractor biplane, a close but slightly smaller relative of the two seat Caudron Type C. More than a dozen were completed, one exported to the United Kingdom, where they may also have been licence built, and three to China.
The Caproni Ca.61 was an Italian heavy day bomber aircraft of 1922. It was the final development of the Caproni three engine, twin boom biplane types developed during World War I, but it was not put into production.
The Caproni Ca.66 was an Italian night bomber designed to reequip the post-World War I Italian Air Force. Only two examples of the four-engined biplane were built.
 | Wikimedia Commons has media related to Siemens-Schuckert L.I . |