Bailey-Moyes Dragonfly

Last updated

Bailey-Moyes Dragonfly
Moyes-Bailey Dragonfly.JPG
Bailey-Moyes Dragonfly 'C' with the Rotax 582 powerplant
Role Ultralight glider tug
National originAustralia/United States
Manufacturer Moyes Microlights
Bailey-Moyes Microlights
LiteFlite
Pitman Air
Designer Bob Bailey
Introduction1990
StatusIn production
Number builtmore than 100 (2011)
Unit cost
€30,000 (assembled, 2011)
The Moyes fleet at Forbes, New South Wales, Australia The Moyes fleet of Dragonflies at Forbes.JPG
The Moyes fleet at Forbes, New South Wales, Australia
Dragonflies towing hang gliders at Forbes, New South Wales, Australia. Moyes-Bailey Dragonflies Towing.JPG
Dragonflies towing hang gliders at Forbes, New South Wales, Australia.
Dragonfly on landing approach Dragonfly landing.JPG
Dragonfly on landing approach
Dragonfly Moyes-Bailey Dragonfly Overhead.JPG
Dragonfly
The Dragonfly's optional 50 Litre fuel tank gives 3 hours endurance Dragonfly long range fuel tank.JPG
The Dragonfly's optional 50 Litre fuel tank gives 3 hours endurance

The Bailey-Moyes Dragonfly is an Australian-American two-seats-in-tandem, high-wing, strut-braced, open cockpit, conventional landing gear-equipped ultralight aircraft. The aircraft has been in production since 1990 and was designed as a special-purpose tug for hang gliders and ultralight sailplanes. It is available as a complete aircraft or as a kit for amateur construction. The aircraft has been variously produced by Moyes Microlights, Bailey-Moyes Microlights and currently LiteFlite of Botany, New South Wales, all different iterations of the same company. [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11]

Contents

Design and development

The Dragonfly was developed in the late 1980s specifically as a hang glider tug for use in flatland areas where hang glider flying, which usually relies on hill launches, was not possible. This role requires an aircraft that can climb quickly at low speed. The Dragonfly achieves this goal, with a power-off stall speed of 17 kn (31 km/h) by using a large area wing of 170 square feet (16 m2) in conjunction with Junkers-style flaperons. The takeoff distance required to clear a 49 ft (15 m) high obstacle is 492 ft (150 m) while flying solo and 984 ft (300 m) at maximum weight, on level short dry grass with no wind at 59 °F (15 °C). [10] The aircraft has been successful as a hang glider tug and is also used for livestock mustering in its home country, as well as for recreational flying where STOL capabilities are required. [1] [2] [5] [6] [7] [8] [9] [11]

The aircraft is constructed of bolted 6061-T6 aluminium, with the two seats mounted on a fuselage boom tube that runs from the front rudder pedals to the tail. The landing gear consists of two main wheels on chrome molybdenum steel gear legs and axles, and a tail wheel configuration. The flexible steel axles work as shock absorbers during taxiing and landing. The tail wheel is steerable by means of the rudder pedals. [10] The standard Rotax 582 engine is mounted in pusher configuration behind the wing's trailing edge. The engine's liquid-cooling allows fast descents while towing, without subjecting the engine cylinders to shock-cooling. The wing is supported by a V-strut and jury struts. The wing and tail surfaces are covered in pre-sewn Dacron envelopes. A unique feature is the extended rudder post, which is supported by steel cables from the wings and used as a tow attachment point. The aircraft is equipped with dual controls for pilot training and the rear seat is removable when not needed. The aircraft takes about 200 hours to assemble from the kit. [1] [3] [4] [5] [6] [7] [8] [9] [11] [12]

The design is a Federal Aviation Administration approved special light-sport aircraft, produced by Pitman Air of Red Bluff, California. [13] [14]

Operational history

The Dragonfly has been exported to 12 countries, where it is primarily employed as a hang glider tug. [12]

Variants

Dragonfly
Original model powered by a 64 hp (48 kW) Rotax 582 two-stroke powerplant [8]
Dragonfly C
Improved model powered by a standard 64 hp (48 kW) Rotax 582 two-stroke engine, with the 80 hp (60 kW) Rotax 912UL four-stroke powerplant optional. The BMW 1100S engine can also be used. It can accept engines in a range from 50 to 115 hp (37 to 86 kW). [8] [9] [10]

Aircraft on display

Specifications (Dragonfly)

Data from Cliche and LiteFlite [1] [10] [12]

General characteristics

Performance

See also

Aircraft of comparable role, configuration, and era

Related Research Articles

The Advanced Aviation Explorer is a two-seat ultralight marketed in kit form, for amateur construction. It is a high-wing taildragger aircraft of pusher configuration with tandem seating.

Eipper Quicksilver

Quicksilver is a line of single and two-place high wing, single-engine, ultralight aircraft that evolved from weight-shift hang gliders including Bob Lovejoy's High Tailer.

Chotia Weedhopper

The Weedhopper is an American high-wing, tractor configuration, tricycle gear, two-axis control ultralight aircraft originally developed by John Chotia during the height of the 1970s ultralight boom and introduced in 1977. When it was in production the aircraft was sold as a kit for amateur construction and could be assembled in 25-30 man-hours.

The Freebird II is a family of American side-by-side two-seat, high wing, tricycle gear, pusher configuration single engined kit aircraft originally designed for construction by amateur builders by the Freebird Airplane Company of Marshville, North Carolina and later Pro Sport Aviation of Wingate, North Carolina.

The Kolb Kolbra and King Kolbra are a family of American tandem two seater, high wing, strut-braced, pusher configuration, conventional landing gear-equipped ultralight aircraft that are produced in kit form by New Kolb Aircraft of London, Kentucky and intended for amateur construction.

The Loehle SPAD XIII is a family of American single-seat, biplane, conventional landing gear, single engine, ultralight aircraft produced in kit form by Loehle Aircraft for amateur construction. The aircraft meets the requirements of the US FAR 103 Ultralight Vehicles regulations when equipped with a lightweight engine.

Carlson Sparrow

The Carlson Sparrow is a family of American, high wing, strut-braced, single engine, ultralight aircraft that was designed by Ernst W. Carlson and produced by Carlson Aircraft of East Palestine, Ohio and later Skyline Technologies of Salem, Ohio for amateur construction.

Golden Circle Air T-Bird

The Golden Circle Air T-Bird is a family of high-wing, strut-braced, pusher configuration ultralight aircraft that was produced by Teratorn Aircraft of Clear Lake, Iowa from 1983 to 1989 and then Golden Circle Air of De Soto, Iowa from 1989 until the mid-2000s. In 2011 the aircraft were back in production by Indy Aircraft. The aircraft is produced as a kit for amateur construction.

Earthstar Thunder Gull

The Earthstar Thunder Gull is a family of cantilever high-wing, tricycle gear ultralight aircraft, manufactured by Earthstar Aircraft of Santa Margarita, California as a kit for amateur construction or as a completed aircraft.

Titan Tornado

The Titan Tornado is large family of cantilever high-wing, pusher configuration, tricycle gear-equipped kit aircraft manufactured by Titan Aircraft of Austinburg, Ohio for amateur construction.

SlipStream Genesis

The SlipStream Genesis is a family of American, strut-braced, high wing, pusher configuration, tricycle gear aircraft, produced in kit form, for amateur construction. Designed by Chuck Hamilton, the series were originally produced by Innovation Engineering of Davenport, Iowa and more recently by SlipStream International of Wautoma, Wisconsin.

The Arnet Pereyra Sabre II is an American, two-seats in side-by-side configuration, conventional landing gear-equipped, strut-braced, high-wing ultralight trainer that was produced by Arnet Pereyra Inc of Rockledge, Florida in kit form for amateur construction.

M-Squared Breese

The M-Squared Breese is a large family of high-wing, strut-braced, pusher configuration, tricycle gear, ultralight aircraft produced by M-Squared Aircraft of St. Elmo, Alabama in kit form, for amateur construction.

Raj Hamsa X-Air

The Raj Hamsa X-Air is an Indian, two-seat, high-wing, tricycle gear, tractor configuration, ultralight aircraft produced by Raj Hamsa Ultralights of Bangalore, Karnataka in kit form, for amateur construction.

The Apex Eco 6 is the first of a family of Czech single and two seat flying wing ultralight trikes that were designed and produced by To-Mi Aviation and later by Apex Aviation. The aircraft were supplied as kits for amateur construction.

Airborne Edge

The Airborne Edge is a line of Australian two-seat ultralight trikes designed and produced by Airborne Windsports of Redhead, New South Wales. The aircraft are supplied as a completed aircraft and not as a kit.

The LiteWing Aircraft LiteTrike, also called The Lite Trike, is an American ultralight trike that was designed and produced by LiteWing Aircraft of Caryville, Tennessee in the late 1990s. The aircraft was supplied fully assembled.

The LiteWing Aircraft LiteWing, also called the Lite Wing Trike, is an American ultralight trike that was designed and produced by LiteWing Aircraft of Caryville, Tennessee in the late 1990s. The aircraft was supplied as a kit for amateur construction.

The J & J Ultralights Seawing is an American amphibious ultralight trike that was designed and produced by J & J Ultralights of Live Oak, Florida. The aircraft was supplied as a kit for amateur construction or as a complete aircraft.

Moyes Microlights

Moyes Microlights Pty Ltd is an Australian aircraft manufacturer that was based in Waverley, New South Wales and founded by hang gliding pioneer Bill Moyes. The company specializes in the design and manufacture of ultralight aircraft in the form of kits for amateur construction and ready-to-fly aircraft.

References

  1. 1 2 3 4 Cliche, Andre: Ultralight Aircraft Shopper's Guide 8th Edition, page B-73. Cybair Limited Publishing, 2001. ISBN   0-9680628-1-4
  2. 1 2 LiteFlite Pty Ltd (2006). "Welcome to the website of LiteFlite - Home of the Dragonfly" . Retrieved 4 February 2011.
  3. 1 2 Bertrand, Noel; Rene Coulon; et al: World Directory of Leisure Aviation 2003-04, pages 22-23. Pagefast Ltd, Lancaster OK, 2003. ISSN 1368-485X
  4. 1 2 Downey, Julia: 1999 Kit Aircraft Directory, Kitplanes, Volume 15, Number 12, December 1998, page 57. Primedia Publications. ISSN 0891-1851
  5. 1 2 3 Downey, Julia: 2001 Kit Aircraft Directory, Kitplanes, Volume 17, Number 12, December 2000, page 32. Kitplanes Acquisition Company. ISSN 0891-1851
  6. 1 2 3 Downey, Julia: 2002 Kit Aircraft Directory, Kitplanes, Volume 18, Number 12, December 2001, page 25. Kitplanes Acquisition Company. ISSN 0891-1851
  7. 1 2 3 Newby-Gonzalez, Tori: 2004 Kit Aircraft Directory, Kitplanes, Volume 20, Number 12, December 2003, page 67. Belvoir Publications. ISSN 0891-1851
  8. 1 2 3 4 5 Downey, Julia: 2005 Kit Aircraft Directory, Kitplanes, Volume 21, Number 12, December 2004, page 69. Belvoir Publications. ISSN 0891-1851
  9. 1 2 3 4 Bayerl, Robby; Martin Berkemeier; et al: World Directory of Leisure Aviation 2011-12, page 64. WDLA UK, Lancaster UK, 2011. ISSN 1368-485X
  10. 1 2 3 4 5 LiteFlite Pty Ltd (May 2009) Flight and Operations Manual - Bailey-Moyes Dragonfly (Revision 3)
  11. 1 2 3 Tacke, Willi; Marino Boric; et al: World Directory of Light Aviation 2015-16, page 67. Flying Pages Europe SARL, 2015. ISSN   1368-485X
  12. 1 2 3 LiteFlite Pty Ltd (2006). "Dragonfly" . Retrieved 4 February 2011.
  13. ↑ Federal Aviation Administration (26 September 2016). "SLSA Make/Model Directory" . Retrieved 2 March 2017.
  14. ↑ Pitman, Ed. "Pitman Air, Light Sport and Ultralight Aircraft". pitmanair.com. Retrieved 6 March 2017.
  15. ↑ Massey Air Museum (2011). "Airplanes you can see at the Museum". Archived from the original on 10 March 2015. Retrieved 4 March 2015.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.